• Journal of Korea Water Resources Association
• /
• v.30 no.2
• /
• pp.177-191
• /
• 1997

The influences of the space allocation of design rainfall and partition of the subbasin on the characteristics of urban storm runoff was investigated for the 6 drainage basins by applying SWMM model. It show the deviation of -54.68∼18.77% in the peak discharge when we applied the composed JUFF quantiles to the two zones which are divided by upper and lower region of the basin. Then it is compared with the value for the case of using uniform rainfall distribution all over the drainage. Therefore, it would be helpful to decrease the flood risk when we adopt the space distribution of the design rainfall. The effects of the partitioning the drainage on the computing result shows various responses because of the surface characteristics of the each basin such as slope, imperviousness ratio, buy we can get closer result to the measured value as we make the subbasin detailed. If we use the concept of the skewness and area ratio when we determine the width of subbasin, we can improve the computed result even with fewer number of subbasins. We expect reasonable results which close into the measured results in the range of relative error, 25%, when we divide the basin into more than 3 subbasins and the total urban drainage area is less than 10$\textrm{km}^2$.

• Journal of Environmental Science International
• /
• v.23 no.10
• /
• pp.1673-1691
• /
• 2014

Although most natural disaster related studies conducted in Korea recently have been related to typhoons or severe rainstorms, the occurrence frequency of disasters due to windstorms or rainstorms is also high. To reduce the strong wind damage caused by strong windstorms due to climate change, basic studies of strong winds are necessary. Therefore, in this study, the types and representative cases of windstorms that were observed to have been higher than 14 m/s, which is the criterion for strong-wind warnings from the Korea Meteorological Administration, were selected from among those windstorm cases that occurred on the Korean Peninsula for 10 years to conduct a statistical analysis of them and determine their synoptic meteorological characteristics. The cases of windstorms occurring on the Korean Peninsula were divided into six weather patterns according to the locations of the anticyclones/cyclones. Among these types, the SH type, which occurs when Siberian Highs expand into the Korean Peninsula, showed the highest occurrence frequency, accounting for at least the majority of the entire occurrence frequency of windstorms together with that of the EC type, which occurs when cyclones develop on the East Sea, and there was no clear yearly trend of the occurrence frequencies of windstorms. The monthly occurrence frequencies of windstorms were formed mainly by typhoons in the summer and the Siberian Highs in the winter, and the months with the highest windstorm occurrence frequencies were December and January, in which mainly the SH and EC type windstorms occurred. March showed the next highest occurrence frequency with10 times, and SH windstorms occurred the most frequently in March, followed by the CC, SC, and EC types of windstorms, in order of precedence. Therefore, attention to these types of windstorms is required. Countermeasures against storm and flood damage in Korea targeting the summer should be re-reviewed together with pre-disaster prevention plans, because cases of storm and flood damage due to windstorms occur more frequently than those due to typhoons, and they occur throughout the year.

• Journal of the Korean Institute of Navigation
• /
• v.13 no.3
• /
• pp.45-65
• /
• 1989

Various typhoon data near Yongil Bay, Korea from 1961 to 1985 were collected with some critria and analyzed with the help of the computer. Introducing the pressure profile models and predicting the typhoon wind and wave fields, the 100-year design wave parameters were calculated. Additionally, the wave data at the southeast coast of Korea were statistically analyzed. The deep water wave climate of this bay indicated that Typhoon Brenda, 1985 had wave characteristics of 100-year return period, Typhoon model and storm surge model studies were made for this typhoon. These, including other design parameters, were introduced into the calculation of total design water depth.

• Water Engineering Research
• /
• v.3 no.2
• /
• pp.123-134
• /
• 2002

A developed Quantitative Flood Forecasting (QFF) model was applied to the mid-Atlantic region of the United States. The model incorporated the evolving structure and frequency of intense weather systems of the study area for improved flood forecasting. Besides using radiosonde and rainfall data, the model also used the satellite-derived characteristics of storm systems such as tropical cyclones, mesoscale convective complex systems and convective cloud clusters associated with synoptic atmospheric conditions as Input. Here, we present results from the application of the Quantitative Flood Forecasting (QFF) model in 2 small watersheds along the leeward side of the Appalachian Mountains in the mid-Atlantic region. Threat scores consistently above 0.6 and close to 0.8 ∼ 0.9 were obtained fur 18 hour lead-time forecasts, and skill scores of at least 40% and up to 55 % were obtained.

• IEMEK Journal of Embedded Systems and Applications
• /
• v.2 no.3
• /
• pp.155-163
• /
• 2007

In Ad Hoc Networks, a connection breaks due to the irregular movement of mobile nodes and the inherent characteristics of the wireless medium such as the interference and the multi-path fading. AODV, a typical on-demand routing protocol in Ad Hoc networks, uses Destination sequence numbering for loop-free, but it may cause RREQ broadcast storm problem. This paper proposes AODV_ods that does not need destination sequence number, in routing message and routing table without routing loop. To show the effectiveness of the proposed scheme, we performed extensive simulation with NS-2. The simulation results show that the proposed ADOV_ods efficiently uses wireless bandwidth compare to the original AODV. Finally AODV ods reduces the routing overhead, end to end delay and increases the overall packet delivery ratio.

• Journal of Korean Society of Water and Wastewater
• /
• v.21 no.3
• /
• pp.287-294
• /
• 2007

When we use the circular pipes for wastewater and storm water, we should be known the characteristics of the flow for accurate design. To elevate the design accuracy, we want to know the profile of flow. The roughness coefficient in the Manning equation is constant, but in actuality changed with the relative depth in circular pipe. This study was conducted to calculate the relative normal depth in changing the roughness coefficient (named relative roughness coefficient) with the relative depth in the analysis of gradually varied flow in the circular pipe by Newton-Raphson method. We performed the analysis of gradually varied flow using the relative normal depth and the relative roughness coefficient. We presented the 12 flow profiles with the relative depth and the relative roughness coefficient in circular pipe. The flow classification considering relative depth in circular pipe is available to analyse gradually varied flow profiles.

• Journal of Environmental Science International
• /
• v.7 no.4
• /
• pp.415-424
• /
• 1998

In the rainfalll-runoff relation, consideration of the spatial movement of storms is very unportant in designing a hydraulic structure or evaluating an environmental influence for land usage. Because of thins reason, this study has suggested the finite element model which consider the spatial movement of a storm and it was applied on a small river basin(Wi stream basin). In the application of the model, the basin was treated as a pivot point and the storms are simulated 10 movement in each directions. As a result, It shows that the storms moving from north to south have higher peak discharge and faster peak time than the storms moving in other directions. So these characteristics have to be considered In the designation of a hydraulic structure or evaluation of an environmental influence.

• International Journal of Ocean System Engineering
• /
• v.2 no.1
• /
• pp.1-7
• /
• 2012

The cross-shore sediment transport in a coastal region causes the important changes in beach morphological properties. The accurate estimation of the cross-shore sediment transport is important for the designing of the marine structures such as seawalls, jetties, breakwaters etc, and the preventing coastal erosion and accretion due to on-off shore sediment transportation. In this study, the experiments on cross- shore sediment transport carried out in a laboratory wave channel for initial beach slopes of 1/8, 1/10 and 1/15. Using the regular waves with different deep-water wave steepness generated by a pedal-type wave generator, the geometrical characteristics of beach profiles under storm conditions and the parameters affecting on-off shore sediment transport are investigated for the beach materials having medium diameters of $d_{50}$=0.25, 0.32, 0.45, 0.62 and 0.80 mm. The experimental results obtained from this study compared with previous experimental work and found to be of the same magnitude as the experimental measurements and followed the expected basic trend.

• Wind and Structures
• /
• v.12 no.3
• /
• pp.179-204
• /
• 2009

A physical and numerical steady flow impinging jet has been used to simulate the bulk characteristics of a downburst-like wind field. The influence of downdraft tilt and surface roughness on the ensuing wall jet flow has been investigated. It was found that a simulated downdraft impinging the surface at a non-normal angle has the potential for causing larger structural loads than the normal impingement case. It was also found that for the current impinging jet simulations, surface roughness played a minor role in determining the storm maximum wind structure, but this influence increased as the wall jet diverged. However, through comparison with previous research it was found that the influence of surface roughness is Reynolds number dependent and therefore may differ from that reported herein for full-scale downburst cases. Using the current experimental results an empirical model has been developed for laboratory-scale impinging jet velocity structure that includes the influence of both jet tilt and surface roughness.

• Journal of Ocean Engineering and Technology
• /
• v.34 no.2
• /
• pp.128-135
• /
• 2020

When high waves and storm surge strike simultaneously, the characteristics of the fluid field change drastically from overtopping according to the wave runup height to overflow through a transition state that combines overtopping and overflows. However, an estimation model or evaluation method has not yet been established because there is not enough engineering data. This study developed a wave overtopping-overflow transition model based on a full-scale experiment involving wave overtopping and overflow transition, which appropriately reproduced the effect of waves or the temporal change in inundation flow. Using this model to perform a calculation for the wave overtopping and overflow transition process under typical circumstances, this study determined the wave runup height and features of the inundation flow under time series changes as an example.