• Korean Journal of Community Nutrition
• /
• v.5 no.2
• /
• pp.333-342
• /
• 2000

The purpose of this study was to evaluate microbiological quality for each stage of the kimbap manufacturing process in summer and winter. Under the various controlled conditions through the simulation, the time-temperature data were collected and the microbiological quality(including total plate count, coliforms, and fecal coliform count) were evaluated. To determine the expected shelf life of Kimbap, a microbiolgical analysis according to the length of the storage time was performed. The microbiological analysis on both sanitary and unsanitary utensils was compared. The microbiological quality of the raw materials of Kimbap in summer was not at an acceptable level, but that of the heat-treated raw materials of Kimbap met the requirement according to the standards set by the Natick Research Center. The number of the microorganisms of the unsanitary utensils and the Kimbap made from unsanitary utensils was more than the acceptable criteria. Sanitary management is necessary to prohibit cross-contamination and to manufacture Kimbap safely. Results from storage times and storage temperature conditions(chilled and room-temperature storage) showed that the expected shelf-life of the Kimbap with the room-temperature storage was as less than 3 hours in summer, while it was as 7-10 hours in winter.

• Journal of the Korean Society of Manufacturing Process Engineers
• /
• v.11 no.4
• /
• pp.1-6
• /
• 2012

This paper addresses the issue of Renewable Energy for Electricity Storage device is one of the NAS (Sodium-Sulfur) battery will be about the module. For safety reasons, not the actual battery cells using a dummy cell in the module's operating temperature setting to examine the characteristics of the insulation vacuum of the wall temperature and external temperature changes measured over time. Upper and lower boundaries of the wall vacuum insulation characteristics cotton C intervals over time, average $5^{\circ}C$, but the temperature is rising, 4C section with little temperature change did not occur. On the other hand, about $3^{\circ}C$ in section 4D, and it was confirmed that the temperature rises. Wall vacuum insulation characteristics over time to look at the experiments and measurements are described.

• Journal of Food Hygiene and Safety
• /
• v.14 no.1
• /
• pp.27-33
• /
• 1999

Phytic acid, making up 1~5% of the composition of many plant seeds and cereals, is known to form iron-chelates and inhibit lipid peroxidation. Thiobarbituric acid reactive substances (TBARS), as an indication of lipid peroxidation, were measured in beef round, chicken breast, pork loin, and halibut muscle after the meats were stored for 0, 1, 3, 5, and 7 days at various temperatures [frozen (~2$0^{\circ}C$), refrigerator (4$^{\circ}C$), and room temperature ($25^{\circ}C$)]. Phytic acid effectively inhibited lipid peroxidation in beef round, chicken breast, halibut, and pork loin muscle (p<0.05). The inhibitory effect of phytic acid was dependent on concentration, storage time, and temperature. At frozen temperature, the inhibitory effect of phytic acid was minimal, whereas at room temperature, the inhibitory effect of phytic acid was maximal, probably due to the variation of the control TBARS values. At the concentration of 10 mM, phytic acid completely inhibited lipid peroxidation in all the muscle foods by maintaining TBARS values close to the level of the controls, regardless of storage time or temperature (p<0.05). The rate of lipid peroxidation was the highest in beef round muscle, although they had a close TBARS value at 0 day. Addition of phytic acid to lipid-containing foods such as meats, fish meal pastes, and canned seafoods may prevent lipid peroxidation, resulting in improvement of the sensory quality of many foods and prolonged shelf-life.

• Nuclear Engineering and Technology
• /
• v.55 no.10
• /
• pp.3581-3590
• /
• 2023

High-temperature design evaluations were conducted on Type 316L stainless steel piping for a 700 ℃ large-capacity thermal energy storage verification test loop (TESET) under construction at KAERI. The hot leg piping with sodium coolant at 700 ℃ connects the main components of the loop heater, hot storage tank, and air-to-sodium heat exchanger. Currently, the design rules of ASME B31.1 and RCC-MRx provide design procedures for high-temperature piping in the creep range for Type 316L stainless steel. However, the design material properties around 700 ℃ are not available in those rules. Therefore, a number of material tests, including creep tests at various temperatures, were conducted to determine the insufficient material properties and relevant design coefficients so that high-temperature design on the 700 ℃ piping may be possible. It was shown that Type 316L stainless steel can be used in a 700 ℃ high-temperature piping system of Generation IV reactor systems or a renewable energy systems, such as thermal energy storage systems, for a limited operation time.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.25 no.3
• /
• pp.504-512
• /
• 1996

Changes in quality of cooked rice after microwave reheating were evaluated. Ceramic coated microwave oven reduced a reheating time(1 min). Storage temperature, storage time and microwave reheating did not affect the color value of cooked rice after microwave reheating. Hardness of cooked rice after microwave reheating decreased in frozen storage treatment. Photomicrographs of cross-section of cooked rice after microwave reheating showed restoration of starch. Effect of storage temperature and time were not significant in appearance, aroma, taste and texture of cooked rice after microwave reheating for sensory evaluation test.

• Journal of Food Hygiene and Safety
• /
• v.12 no.1
• /
• pp.55-62
• /
• 1997

This study was carried out to investigate the microbiological and chemical properties of natural water during storage. The water samples were taken at the time of purchase and the opened bottles and unopened bottles stored at the temperature of 4$^{\circ}C$, 18$^{\circ}C$, and 3$0^{\circ}C$. The bacterial content normally rose to 2.06$\times$102 CFU/$m\ell$ for the unopened bottles and 2.91$\times$102 CFU/$m\ell$ for the opened bottles after 2 weeks of storage, and 1.21$\times$102 CFU/$m\ell$ and 2.64$\times$102, respectively, after 24 weeks of storage. The number of viable cells of bacteria peaked more rapidly at the storage temperature of 3$0^{\circ}C$ than 18$^{\circ}C$. But the total samples were found to be negative for coliforms test during the study period. The average range of pH value was from 7.39 to 7.76. The results showed that the nitrates and chlorides satisfied the Korea Drinking Water Quality Standards during the storage period of 24 weeks. However, the undesirable changes of the taste and odor were detected within 2 weeks and 3 weeks, respectively.

• Food Science and Preservation
• /
• v.4 no.3
• /
• pp.227-235
• /
• 1997

The internal breakdown of Fuji apple during CA storage classified as watercore breakdown, low temperature breakdown and CO2 injury. This study was undertaken to investigate the watercore breakdown injury factors of Korean Fuji apple during CA storage. The development of internal breakdown was more increased with the larger size, the later harvest time and the hither CO2 gas level. But in internal breakdown fruit of the titratable acidity and soluble solid decreased significantly, the pH of fruit juice and the production of carbon dioxide was greatly increased. The best gas levels of CA storage was 2% oxygen and 3% carbon dioxide. Thus, the predictable parameters of internal breakdown of fruit were increase in pH on decrease titratable acidity within 2 months of CA storage, increase carbon dioxide. So, it was found that the best CA sotrage for internal breakdown control of fruit during CA storage was delayed CA storage methods after low temperature storage immediate harvest of apple and than took a step. The delayed CA storage after low temperature storage for 2 months was more effective in the prevention of development of internal breakdown than immediate CA storage after harvest.

• Journal of Bio-Environment Control
• /
• v.25 no.4
• /
• pp.262-269
• /
• 2016

The objective of this study was to evaluate the effect of storage temperature on fruit quality attributes and physiological disorders including peel blackening in 'Sangjudungsi' persimmon (Diospyros kaki Thunb.) fruit stored in air at -1, 0.5 or $3^{\circ}C$ for up to 3 months. Higher storage temperature reduced ethylene production but not respiration rate, compared with lower storage temperature. Flesh firmness decreased continuously as storage time passed but firmness was reduced rapidly in the fruits stored at higher storage temperature. Fresh weight loss increased at higher storage temperatures. Soluble solids content was higher at lower storage temperature than at higher storage temperature. All color variables ($L^*$, $a^*$, $b^*$) were reduced by lower storage temperature, compared with higher storage temperature, regardless of tissue regions. Fruit softening increased as storage duration advanced and with the increase in storage temperature. Results indicated that the 'Sangjudungsi' persimmon fruits stored at higher storage temperature ($3^{\circ}C$) could not retain fruit quality properly on account of lower flesh firmness and higher incidence of peel blackening and fruit decay, compared with lower storage temperature.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.22 no.10
• /
• pp.719-726
• /
• 2010

In this paper, the appropriate thermal storage time of an air-conditioning system with slab thermal storage was considered by use of summer measurement values. Two standards of heat extraction rate and criterion function were established as the standard that evaluates appropriateness. When heat extraction rate was a standard, zero hour and seven hours were obtained as appropriate thermal storage time, in the case of evaluation by energy consumption and running cost individually. Also, when criterion function was a standard, the difference between energy consumption and running cost was small, it was because the weight function to room air temperature deviation was much bigger than heat extraction rate.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.18 no.3
• /
• pp.395-405
• /
• 2020

Compartment fire tests were performed using kerosene and Jet A-1 as fire sources to evaluate the relationship between flame temperature and opening size. The tests were performed for a fire caused by the release of kerosene owing to vehicle impact, and for a fire caused by the release of Jet-A-1 owing to airplane collision. The compartment fire tests were performed using a 1/3-scale model of a metal storage cask when the flame temperature was deemed to be the highest. We found the combustion time of Jet-A-1 to be shorter than that of kerosene, and consequently, the flame temperature of Jet-A-1 was measured to be higher than that of kerosene. When the opening was installed on the compartment roof, even though the area of the opening was small, the ventilation factor was large, resulting in a high flame temperature and long combustion. Therefore, the position of the opening is a crucial factor that affects the flame temperature. When the metal storage cask was stored in the compartment, the flame temperature decreased proportionally with the energy that the metal storage cask received from the flame.