• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• 1994.10a
• /
• pp.49-58
• /
• 1994

The methods of estimation of VTS effectivenss are compared and the worldwide literature related to the VTS effectiveness is reviewed. The review suggests three potential approaches ; simulation ; synthesis of expert opinion and statistical analysis of casualties. this study adopted dissimilar approaches to estimate the VTS effectiveness to the earlier studies ; the combination of synthesis of expert opinion and causal analysis of casualty. The VTS effectiveness is derived by multiplying casualty rate reduction factors by the effect level of causal factors. The development of casualty rate reduction factors was based on the questionnaire survey and the evolution of effect levels was based on the causal analysis using functional block diagram. According to these procedures the maximum benefit to be obtained through the introduction of a VTS system was approximately 46 percent overall. The collision reduction rate was estimated to be approximately 50 percent for a VTS system with advanced radar surveillance. And 47 percent of groundings 36 percent of rammings and 21 percent of founderings could be reduced by the introduction of VTS. These figures are more or less the same to the earlier studies. The VTS effectiveness by the different causal factor groups was examined. VTS may reduce about 68 percent of causal factors classified as environmental conditions 40 percent of human factors and 35 percent of technical factors in collision accidents. As a whole 60 percent of environmental factors 41 percent of human factors and 20 percent of technical factors may be prevented by a VTS. The key variable of the effectiveness percentage is the value of weight coefficient $\delta$. Therefore differing values for this input was discussed and the impact that these variations have on the VS effectiveness noted. As the results of sensitivity analysis of VTS effectiveness by $\pm$10 percent the effectiveness is varied approximately three to seven percent by casualty type. And the value is changed roughly four to eight percent by a $\pm$10 percent variation by different sub-areas.

• Journal of the Earthquake Engineering Society of Korea
• /
• v.10 no.6 s.52
• /
• pp.115-123
• /
• 2006

This paper presents long-term dynamic characteristics of a cable-stayed bridge where installed SHM (Structural Health Monitoring) system. Modal parameters such as natural frequencies and mode shapes are identified by modal analysis using three dimensional finite element model. The developed baseline model has a good correlation with measured natural frequencies identified from field ambient vibrations. By statistical data processing between measured natural frequencies and temperatures, it is demonstrated that the natural frequency is in linearly inverse proportion to the temperature. The estimation of temperature effects against frequency variations is performed. Mode shapes are identified from the TDD (Time Domain Decomposition) technique for ambient vibration measurements. Finally, these results demonstrate that the TDD method can apply to identify modal parameters of a cable-stayed bridge.

• Journal of Korea Water Resources Association
• /
• v.42 no.12
• /
• pp.1091-1102
• /
• 2009

This study developed an integrated approach to climate change and urbanization impact assessment by linking models of SDSM (statistical downscaling model), HSPF (hydrological simulation program?Fortran) and ICM (impervious cover model). A case study of the Anyangcheon watershed illustrated how the proposed framework can be used to analyze the impacts of climate change and urbanization in terms of flood control, water security and water quality. The evaluation criteria were the variations of flow and pollutant concentration duration curves. In this study, nine scenarios including three climate (present condition, A1B and A2) and three urbanization scenarios were analyzed using HSPF model. As a result, climate change is a large influence on the flowrate and the urbanization affects the pollutant concentration. Therefore, the impacts of both climate change and urbanization must be included into the watershed management and water resources planning for sustainable development.

• Spatial Information Research
• /
• v.20 no.4
• /
• pp.1-16
• /
• 2012

There is no doubt that the urban heat island (UHI) is a mounting problem in built-up environments, due to energy retention by the surface materials of dense buildings, leading to increased temperatures, air pollution, and energy consumption. To investigate the UHI, three-dimensional (3-D) information is necessary to analyze complex sites, including dense building clusters. In this research, 3-D building geometry information is combined with two-dimensional (2-D) urban surface information to examine the relationship between urban characteristics and temperature. In addition, this research introduces spatial regression models to account for the spatial spillover effects of urban temperatures, and includes the following steps: (a) estimating urban temperatures, (b) developing a 3-D city model, (c) generating urban parameters, and (d) conducting statistical analyses using both Ordinary Least-Squares (OLS) and Spatial Regression Models. The results demonstrate that 3-D urban characteristics greatly affect temperatures and that neighborhood effects are critical in explaining temperature variations. Finally, the implications of the results are discussed, providing guidelines for policies to reduce the UHI.

• Journal of Korean Society of Forest Science
• /
• v.99 no.5
• /
• pp.686-692
• /
• 2010

This study described the general pattern of genetic variation among ten teak (Tectona grandis Linn. f.) provenances in Myanmar and determined the most suitable seed sources for the plantation program in Bago Yoma region. Seeds of ten provenances were collected to cover the whole teak natural distribution in Myanmar and planted at four trial sites in Bago Yoma region in 1998. Seven years after planting, variation was assessed for growth, morphological characteristics and their correlation with geoclimatic factors. Statistical analysis using ANOVA revealed that there were significant differences in most of the traits measured among provenances, trial sites and provenance ${\times}$ site interaction at five percent level. A positive significant correlation (p<0.01) was found among most of the traits. The regression analyses between all traits and geoclimatic factors indicated the existence of ecoclinal variation in teak. Most of the traits were negatively correlated with the latitude while a positive significant correlation was found between longitude and C/B ratio, crown-diameter, average branch angle and leaf-remain. There was no significant correlation between the mean temperature and any other traits in this study. Furthermore, growth traits and crown diameter were positively correlated with the mean annual rainfall while negative correlation was found between the geographical distance and growth traits. Results indicate that the latitudinal pattern of teak genetic variations in growth performance was attributed to the limit of mean annual rainfall. Comparative assessment showed that local provenances were generally the best and could be use as suitable seed sources for the plantation program in the Bago Yoma region.

• Journal of the Korean Chemical Society
• /
• v.55 no.5
• /
• pp.733-740
• /
• 2011

Multiple regression analysis was used for the calculation of pKa values of 15 substituted benzaldoximes by using various types of descriptors as parameters. These descriptors are based on quantum mechanical treatments. They were derived by employing semi-empirical calculation represented by the PM3 model and an Abinitio method expressed by Hartree-Fock(HF) model performed at the 6-311 G(d, p) level of theory. The parameters tested for their ability to represent the variations observed in the experimental pKa(s) are atomic and structural properties including Muliken charges on the atoms of hydroxyl group and C=N bond, the angle $C_6-C_1-C_7$, and length of O-H bond. Molecular properties are also used like energies of HOMO and LUMO, hardness(${\eta}$), chemical potential(${\mu}$), total energy(TE), dipole of molecule(DM), and electrophilicity index(W). The relation between pKa values and each of these parameters of the studied compounds is investigated. Depending on these relations, two sets of parameters were constructed for comparison between the PM3 and HF methods. The results obtained favor the Abinitio method for such applications although both models proved to have high predictive power and have sufficient reliability to describe the effect of substituents on pKa values of benzaldoxime compounds under consideration which is clear from the values of correlation coefficient $R^2$ obtained and the consistency between the experimental and the calculated values.

• The Research Journal of the Costume Culture
• /
• v.19 no.2
• /
• pp.346-359
• /
• 2011

The purpose of this study was to examine students' reasons and standards for purchasing their casual upper garments through online shoppin. A questionnaire composed of 26 items in five-point Likert type (14 items for measuring reasons, and 12 items for measuring standards for their purchase) was administered. The subjects were 422 male and female students attending middle schools, high schools and colleges located in the metropolitan region of Daegu. For a statistical analysis, a $3{\times}2$ two way ANOVA design (3 levels of schools: middle school, high school and college and 2 sexes: male and female) was involved, and Turkey's HFD multiple comparisons were made. The results showed that the reasons for students' purchasing casual upper garments through online shopping malls were as follows: quality, availability of discount coupons and points, other benefits such as special promotions, gifts, the easy return of goods and refunds, and also no trial of wearing shirts even at off-line stores. Significant differences in purchasing reasons through online shopping were found among middle schoo, high school and college students. There were also significant differences between male and female students mostly found in three variations of purchasing reasons: ease of availability of garments in contemporary fashion, convenient shopping without any restriction on time, and the decision to purchase with help from consumers' recommendations. Significant differences among middle school, high school and college students were found in the following standards for the students' decision to purchase their casual upper garments through online shopping: affordability, color, design, style, payment safety, and ease of maintenance (cleaning and ironing). Differences between male and female students were found to be significant in the following categories: affordability, fashionable, brand name, free delivery, product quality, coordination with other clothes, and consumers' recommendations on the products concerned.

• The Journal of Advanced Prosthodontics
• /
• v.10 no.1
• /
• pp.8-17
• /
• 2018

PURPOSE. The study aimed to identify the accuracy and reproducibility of preparations made by gypsum materials of various colors using quantitative and semi-quantitative three-dimensional (3D) approach. MATERIALS AND METHODS. A titanium maxillary first molar preparation was created as reference dataset (REF). Silicone impressions were duplicated from REF and randomized into 6 groups (n=8). Gypsum preparations were formed and grouped according to the color of gypsum materials, and light-scanned to obtain prepared datasets (PRE). Then, in terms of accuracy, PRE were superimposed on REF using the best-fit-algorithm and PRE underwent intragroup pairwise best-fit alignment for assessing reproducibility. Root mean square deviation (RMSD) and degrees of similarity (DS) were computed and analyzed with SPSS 20.0 statistical software (${\alpha}=.05$). RESULTS. In terms of accuracy, PREs in 3D directions were increased in the 6 color groups (from 19.38 to $20.88{\mu}m$), of which the marginal and internal variations ranged $51.36-58.26{\mu}m$ and $18.33-20.04{\mu}m$, respectively. On the other hand, RMSD value and DS-scores did not show significant differences among groups. Regarding reproducibility, both RMSD and DS-scores showed statistically significant differences among groups, while RMSD values of the 6 color groups were less than $5{\mu}m$, of which blue color group was the smallest ($3.27{\pm}0.24{\mu}m$) and white color group was the largest ($4.24{\pm}0.36{\mu}m$). These results were consistent with the DS data. CONCLUSION. The 3D volume of the PREs was predisposed towards an increase during digitalization, which was unaffected by gypsum color. Furthermore, the reproducibility of digitalizing scanning differed negligibly among different gypsum colors, especially in comparison to clinically observed discrepancies.

• KIISE Transactions on Computing Practices
• /
• v.23 no.12
• /
• pp.660-669
• /
• 2017

In order to improve user accessibility and interactivity, system scalability, service speed, and a non-standard internet web environment, we developed a Web-based geovisualization system of oceanographic information using HTML5 and dynamic particles. In particular, oceanographic and meteorological data generated from a satellite remote sensing and radar measurement and a 3-dimensioanl numerical model, has the characteristics of a heterogeneous large-capacity multi-dimensional continuous spatial and temporal variability, based on geographic information. Considering those attributes, we applied dynamic particles represent the spatial and temporal variations of vector type oceanographic data. HTML5, WebGL, Canvas, D3, and Leaflet map libraries were also applied to handle various multimedia data, graphics, map services, and location-based service as well as to implement multidimensional spatial and statistical analyses such as a UV chart.

• Genomics & Informatics
• /
• v.17 no.4
• /
• pp.48.1-48.6
• /
• 2019

Over the last decade, genome-wide association studies (GWASs) have provided an unprecedented amount of genetic variations that are associated with various phenotypes. However, previous GWAS were mostly conducted in European populations, and these biased results for non-Europeans may result in a significant reduction in risk prediction for non-Europeans. An issue with the early GWAS was the winner's curse problem, which led to misleading results when constructing the polygenic risk scores (PRS). Therefore, more non-European population-based studies are needed to validate reported variants and improve genetic risk assessment across diverse populations. In this study, we validated 422 variants independently associated with glycemic indexes, liver enzymes, and type 2 diabetes in 125,872 samples from a Korean population, and further validated the results by assessing publicly available summary statistics from European GWAS (n = 898,130). Among the 422 independently associated variants, 284, 320, and 361 variants were replicated in Koreans, Europeans, and either one of the two populations. In addition, the effect sizes for Koreans and Europeans were moderately correlated (r = 0.33-0.68). However, 61 variants were not replicated in both Koreans and Europeans. Our findings provide valuable information on effect sizes and statistical significance, which is essential to improve the assessment of disease risk using PRS analysis.