• Journal of the Korean Ceramic Society
• /
• v.45 no.12
• /
• pp.827-831
• /
• 2008

Spark plasma sintering (SPS) of AlN ceramics were carried out with ${Y_2}{O_3}$ as sintering additive at a sintering temperature $1,550{\sim}1,700^{\circ}C$. The effect of ${Y_2}{O_3}$ addition on sintering behavior and thermal conductivity of AlN ceramics was studied. ${Y_2}{O_3}$ added AlN showed higher densification rate than pure AlN noticeably, but the formation of yttrium aluminates phases by the solid-state reaction of ${Y_2}{O_3}$ and ${Al_2}{O_3}$ existed on AlN surface could delay the densification during the sintering process. The thermal conductivity of AlN specimens was promoted by the addition of ${Y_2}{O_3}$ up to 3 wt% in spite of the formation of YAG secondary phase in AlN grain boundaries because ${Y_2}{O_3}$ addition could reduced the oxygen contents in AlN lattice which is primary factor of thermal conductivity. However, the thermal conductivity rather decreased over 3 wt% addition because an immoderate formation of YAG phases in grain boundary could decrease thermal conductivity by a phonon scattering surpassing the contribution of ${Y_2}{O_3}$ addition.

• The Journal of the Acoustical Society of Korea
• /
• v.13 no.1
• /
• pp.5-13
• /
• 1994

This paper presents a study on Neural Networks for Phoneme Recognition and performs the Phoneme Recognition using TDNN (Time Delay Neural Network). Also, this paper proposes training algorithm for speech recognition using neural nets that is a proper to large scale TDNN. Because Phoneme Recognition is indispensable for continuous speech recognition, this paper uses TDNN to get accurate recognition result of phonemes. And this paper proposes new training algorithm that can converge TDNN to an optimal state regardless of the number of phonemes to be recognized. The recognition experiment was performed with new training algorithm for TDNN that combines backpropagation and Cauchy algorithm using stochastic approach. The results of the recognition experiment for three phoneme classes for two speakers show the recognition rates of $98.1\%$. And this paper yielded that the proposed algorithm is an efficient method for higher performance recognition and more reduced convergence time than TDNN.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.5 no.4
• /
• pp.335-342
• /
• 2000

A new control method for a single-phase active power filter, based on a load current estimation using a DC capacitor voltage of active power filter without sensing nonlinear load current, is proposed in this paper. Because the method proposed can remove the load current sensor in comparison with a conventional method sensing the load current and DC capacitor voltage together, it can make the active power filter easy installation, low cost, small size with no performance detriment. In addition, sample-hold technique and proportional control method is adopted to control the DC capacitor voltage and as no delay element such as LPF or PI control in the conventional method is used, the transient response is fast and good. Operation of a single-phase active power filter which consist of eight mode is explained according to utility voltage, compensation current and switch state, and compensation characteristics of active power filter using proposed method is verified by experiment.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.17 no.3
• /
• pp.755-761
• /
• 2013

Medium access control (MAC) protocols for wireless sensor networks make sensor nodes on state for energy-efficiency only when necessary. In this paper we present an energy efficient priority-based MAC protocol for energy-harvesting Wireless Sensor Networks (WSNs). For support priority-based packet transmission the proposed EEPB-MAC protocol uses the modified IEEE 802.15.4 beacon frames including priority bit, sender node address, and NAV value fields. A receiver node periodically wakes up, receives sender beacon frames, selects data sending sender, and broadcasts a beacon frame containing the selected sender's address. A receiver node selects sender node according to sender's data priority. A receiver nodes also adjust wake up period based on their energy states. Hence, the energy consumption of receiver node can be minimized. Through simulations and analytical analysis, we evaluate the performance of our proposed the EEPB-MAC protocol and compare it against the previous MACs. Results have shown that our protocol outperforms other MAC in terms of energy consumption, higher priority packet delivery delay.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.11 no.1
• /
• pp.190-197
• /
• 2010

The ACR (Access Control Router) of WiBro processes location registration of the Correspondent Node and Home Agent as the Correspondent Node moves between ACRs. Therefore, the location update cost is low compared with MIPv6. However, all packets which are sent and received are sent through the ACR, so as the number of mobile nodes that are managed by the ACR increases, the cost of packet delivery also increases. Therefore, the communication state of the ACR domain remains smooth when the ACR which manages the mobile node in the ACR domain has good performance. However, network delays occur unless the ACR performs well, so the role of the ACR is important. In this paper, we analysis performance of the ACR for efficient realization of the WiBro standard. By using the Deny Probability and the Total Profit of ACR performance and apply it to the Random Walk Mobility model as the mobility model.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.29 no.3
• /
• pp.235-241
• /
• 2009

Composite wood materials are very sensitive to water and inspection without any coupling medium of a liquid is really needed to wood materials due to the permeation of coupling medium such as water. However, air-coupled ultrasound has obvious advantages over water-coupled experimentation compared with conventional C-scanner. In this work, it is desirable to perform contact-less nondestructive evaluation to assess wood material homogeneity. A wood material was nondestructively characterized with non-contact and contact modes to measure ultrasonic velocity using automated data acquisition software. We have utilized a proposed peak-delay measurement method. Also through transmission mode was performed because of the main limitation for air-coupled transducers, which is the acoustic impedance mismatch between most materials and air. The variation of ultrasonic velocity was found to be somewhat difference due to air-coupled limitations over conventional scan images. However, conventional C-scan images are well agreed with increasing the resin-infiltrated time as expected. Finally, we have developed a measurement system of an ultrasonic velocity based on data acquisition software for obtaining ultrasonic quantitative data for correlation with C-scan images.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.13 no.1
• /
• pp.140-152
• /
• 1989

The study on the penetration of sprays during the initial phase of injection period, i.e. ignition delay period, in high speed small D.I. diesel engines are strongly affected by such behavior. To investigate the penetration of the sprays injected through single cylinderical orifice, a mathematical model was developed and compared with experimental results. In this model, radial heterogeneity of fuel density in the spray, transiency of injection pressure difference, and spray outrunning phenomenon were considered simultaneously. Experiments on the behaviors of sprays in the high pressure air chamber were conducted at various injection pressure differences and different levels of back air pressure. The behaviors of sprays injected into the chamber through the conventional Bosch injection pump were visualized with side stroboscopic illumination. Comparison of the experimental results with predictions from the mathematical model confirmed the validity of the model. It was also found that during the initial phase of the injection period the penetration of sprays vs. time appeared to have two transition points; one corresponded to disintegration point of liquid fuel jet, the other to the beginning of steady state injection.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.26 no.1
• /
• pp.88-100
• /
• 1990

Since sea state changes engine load instantaneously, the speed governing apparatus is essential for marine engine to maintain constant speed regardless of the load. As governing apparatuses, mechanical, pneumatic, and electric governors have been employed. But, recently, according to the introduction of low speed-ling stroke engines to increase thermal efficiency, the development of governor which has better response characteristics is requisite. In this paper, to design the governor that meets above requirement, author made a performance test for the existing PID control digital governor with the aid of computer simulation, and investigated digital governor applying the optimal control algorithm, then, executed computer simulation by the same way. As the result of simulations, found that the former let engine have large overshoot and long settling time at low speed, on the other hand, the latter made engine have better response. If we design and invent a good observer for delay time element so that the optimal control theory can be applied, better governor will be expected.

• Journal of the Korean Society of Physical Medicine
• /
• v.15 no.3
• /
• pp.51-59
• /
• 2020

PURPOSE: The purpose of this study was to provide clinical basic data to reduce pain and improve function by comparing neck muscle activity and neck alignment using self-stretching and passive stretching exercises for chronic neck pain caused by forward head posture. METHODS: The subjects were divided into 15 subjects assigned to perform self-stretching exercise and 15 subjects assigned to perform passive stretching exercise. The intervention was conducted for a total of 4 weeks. The muscle activity in the neck was measured by surface electromyography (EMG) before intervention, and craniovertebral and cranial rotation angles were measured by X-ray. The 4-week intervention was conducted and the above items re-measured in the same manner and analyzed. RESULTS: Muscle activity within both groups after intervention using self-stretching or passive stretching exercise was significantly different (p < .05)(p < .01). Neck alignment of both groups was significantly different (p < .001)(p < .01). Further, muscle activities of the upper trapezius and splenius capitis muscles showed significant differences (p<.05). Lastly, neck alignment showed statistically significant difference (p < .05). CONCLUSION: Self-stretching exercise activated motor nerves as a posture correction exercise, thereby improving inhibition of muscle activity, muscle contraction delay, and pathological conditions of the muscle. For future research, interventions of self-stretching exercise will be needed for patients with chronic back pain accompanied by forward head posture, and various clinical studies on postural improvement of forward head posture by maintaining a normal muscle tone state are needed.

• Journal of Korean Society on Water Environment
• /
• v.29 no.1
• /
• pp.66-73
• /
• 2013

Total Maximum Daily Loads (TMDLs) system was introduced to manage pollution load of watershed and to improve water quality of unit watershed so that it is possible to protect dringking water soureces. Load allocation observation is the most important factor in TMDLs system. Because if load allocation is not observed, it is difficult to achieve water quality goal of unit watershed. Also it is impossible to improve water quality of the drinking water sources. Therefore it is necessary to apply some kind of sanctions (penalty) in case of excess of load allocation. The sanctions have to be, however, applied differently based on various reduction plan types, i.e., using the reduction load planed in 2nd phase, delay the completion, additional reduction in 2nd phase, error of the pollution sources, etc. Moreover, the penalty load should be properly imposed, lest it should be overburden the provence. The reduction load trade inter province must be restrictively permmitted only the same unit watershed.