• Journal of Korea Water Resources Association
• /
• v.33 no.6
• /
• pp.671-679
• /
• 2000

Regionalization technique using flow duration curve and spatial interpolation algorithm is developed for the purpose of estimating daily flow time series at ungauged station. In this study, we assumed a part of 8 gauging stations of Nakdong River basin as ungauged stations. Then, we generated flow duration curves and daily flow hydrographs by regionalization technique at ungauged stations. And we compared generated and observed hydrographs. The simulation results showed that the observed flows were well simulated by the proposed method and that the general patterns of the observed flows were satisfactorily reproduced by the regionalization technique. From these results, it is possible that we obtain daily flow information without application of labour intensive and time consuming deterministic models, which require complicating quantification of model parameter values. And we compared the regionalization techniques with the specific discharge method which is the most general approach in hydrological practice in Korea. The results showed that the regionalization technique was superior to specific discharge method.method.

• Journal of Soil and Groundwater Environment
• /
• v.22 no.4
• /
• pp.9-26
• /
• 2017

When a warm well located downgradient is captured by cold thermal plume originated from an upgradient cold well, the warm thermal plume is pushed further downgradient in the direction of groundwater flow. If groundwater flow direction is parallel to an aquifer thermal energy storage (ATES), the warm well can no longer be utilized as a heat source during the winter season because of the reduced heat capacity of the warm groundwater. It has been found that when the specific discharge is increased by $1{\times}10^{-7}m/s$ in this situation, the performance of ATES is decreased by approximately 2.9% in the warm thermal plume, and approximately 6.5% in the cold thermal plume. An increase of the specific discharge in a permeable hydrogeothermal system with a relatively large hydraulic gradient creates serious thermal interferences between warm and cold thermal plumes. Therefore, an area comprising a permeable aquifer system with large hydraulic gradient should not be used for ATES site. In case of ATES located perpendicular to groundwater flow, when the specific discharge is increased by $1{\times}10^{-7}m/s$ in the warm thermal plume, the performance of ATES is decreased by about 2.5%. This is 13.8% less reduced performance than the parallel case, indicating that an increase of groundwater flow tends to decrease the thermal interference between cold and warm wells. The system performance of ATES that is perpendicular to groundwater flow is much better than that of parallel ATES.

• Proceedings of the KIEE Conference
• /
• 1999.07d
• /
• pp.1621-1623
• /
• 1999

Recently, high voltage outdoor ploymer insulators have been widely used commercially owing to their excellent electrical and mechanical properties, superior comtamination flashover performance, light weight, easy installation or handing, no maintenance during service, competitive price and so on. compared to porcelaain and glass insulators. For instance, silicone rubber(SR) for polymeric insulators specially has much superior insulating and anti-pollution performance due to its specific hydrophobicity even in severe contaminated environments. We have investigated surface discharge current characteristics of silicone rubbers(SR) for HV outdoor composite insulation specimen under accelerated aging codition using a computer measuring system. The relations of average leakage current and surface discharge current repetition rates and discharge current amplitude, the distribution of discharge current amplitude were studied to investigate electrical conduction of silicone rubber surface with the salt fog condition.

• Child Health Nursing Research
• /
• v.26 no.1
• /
• pp.107-120
• /
• 2020

Purpose: This study was conducted to investigate the educational needs of parents of infants and toddlers with congenital heart disease (CHD) after hospital discharge. Methods: Qualitative content analysis was conducted of in-depth interviews of eight parents, and the results of an online survey of 171 parents were analyzed quantitatively. Results: Only 16.4% of parents reported that they had received education after hospital discharge on how to provide care for a child with CHD at home. The main reason why parents did not receive education on this topic was that they did not have sufficient opportunities or information (75.5%). In addition, 97.1% of parents stated that they needed educational programs that would be available at home after discharge. In terms of specific educational content, parents expressed the highest needs for education on the symptoms of CHD and ways to cope with them, the prognosis of CHD, and the growth and development of infants and toddlers with CHD. Conclusion: The study showed that parents' educational needs were high in many ways. However, the information and educational opportunities offered after discharge were insufficient compared to those needs. Further research is needed to develop post-hospital educational programs that meet their needs.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2000.05a
• /
• pp.820-823
• /
• 2000

The characteristics of wire deflection, surface roughness and roundness were observed on changing discharge time for electrical discharge machining(EDM) of tungsten carbide in various conditions of thickness. The wire deflection was decreased as increasing discharge time and wire tension, the gap of deflection was decreased after thickness 60mm and discharge time of 6$\mu\textrm{s}$ due to the changing from fundamental mode to vibration mode. The deflection is the smallest at the water specific resistivity of 7.5 kΩ ㆍcm. The deflection is found to be decreased as increasing dwell time, and the result is due to the vibration of the pressure and the amount of the dielectric. The component of copper(Cu) and zinc(Zn), which is the main material of wire electrode, was observed for rough wire-cutting EDM of STD-11. This phenomena is found to be decreased as the number of EDM is increased. But it will be improved by changing the material and the shape of wire. The roundness of middle is found to be worse than that of upper and it is increased as the thickness of material is increased.

• Water for future
• /
• v.9 no.1
• /
• pp.86-100
• /
• 1976

To study influences on the downstream, and the Gunsan harbor by setting up estuary of the Gumgang, available data which were collected from the measuring stations which were established within the river basin of which results attained are as follows: 1. The discharge can be calculated as the relationship between the discharge and precipitation in the basin is $R=4{\times}10^{-4}p^2$ or R=P-600 2. The discharge flow in to small resevoirs in the basin can be estimated as $QR=QS\frac{PR-600}{PS-600}(\frac{AR}{AS})$ 3. This daily average discharge at Kongju is 31% less than the during maximum probable discharge and that in Okcheon is 48% less than the daily maximum probable flood. 4. The maximum probable flood from the small stream in the basin can be estimated by a $Q=82.45A^{0{\cdot}464}$ 5. Sediments can be computed with Qs (suspended load)=1.41 $Q^{1{\cdot}42}$ and Qb (bed load)=165.2 $Q^{0{\cdot}705}$. 6. By setting up the specific estuary the tidal movement will be reduced to 93.6% on the average and the sedimentation is reduced to 96.0%. Upon review of overall analysis, the dead wate level of estuary of Gumgang will completely sedimented in next 30 years, therefore, the dredging work at Gunsan harbor is reduced to 73.6%, it is considered that life length will be extended about 52years taking account the existing condition.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2004.03a
• /
• pp.306-313
• /
• 2004

The microwave discharge ion engine generates plasmas of both the main ion source and the neutralizer using 4㎓ microwave without discharge electrodes and hollow cathodes, so that long life and durability against oxygen and air are expected. The MUSES-C “HAYABUSA” asteroid explorer installing four microwave discharge ion engines “$\mu$10s” was launched into deep space by M-V rocket No.5 on May 9, 2003. After vacuum exposure and several runs of baking for reduction of residual gas the ion engine system established the continuous acceleration of the spacecraft toward the asteroid “ITOKAWA”. The Doppler shift measurement of the communication microwave revealed the performance of ion engines, which is 8mN thrust force for a single unit with 3,200sec specific impulse at 23mN/㎾ thrust power ratio. At the end of 2003 the accumulated operational time exceeded 8,000 hour and unit. HAYABUSA will execute the Earth swing-by on June 2004 and arrive at the asteroid in 2005 and return to Earth in 2007.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.24 no.5
• /
• pp.160-168
• /
• 2010

This paper tried to find out NO generation and removal mechanisms in the space of the atmospheric pulsed barrier discharge using laser induced fluorescence method, which is a very effective approach to the measurement of spatio-temporal density of specific molecules. The propagation velocity of the primary streamer reaches about $2.7{\times}10^6$[m/s] and the secondary streamer is produced in the vicinity of positive electrode after the primary streamer finished. In this work, pulse Nd:Yag and Dye lasers are used for generating the specific wavelength of 226[nm], which is possible to excite NO molecules into $A^2{\Sigma}^+{\rightarrow}X^2{\prod}$(0,0) and fluorescence signals as the transition of $A^2{\Sigma}^+{\leftarrow}X^2$(0,2) is measured. For the effective removal of NO molecules in the plasma discharge process, the lower oxygen contents are needed and the influence of secondary streamer for the reduction mechanism of NO molecules is important

• Korean Journal of Adult Nursing
• /
• v.22 no.2
• /
• pp.190-199
• /
• 2010

Purpose: The purpose of this study was to determine the differences in the level of disease related knowledge, compliance of health behavior, and educational needs in relation to time (at discharge and 6 months after discharge) among patients underwent percutaneous coronary intervention (PCI). Methods: Data were collected from January 1, 2006 to September 30, 2006 and a total of 60 patients participated in the study. The survey was conducted in patients underwent PCI at the time of discharge right after discharge education was provided and at a follow up visit which was 6 months after discharge. Results: The level of disease related knowledge (p<.001), the compliance of health behavior (p<.001), educational need (p=.496), the sub-item of sexual life (p<.001), follow up (p<.001), diet (p=.021), stress (p<.001) in compliance of health behavior, and the sub-item of specific character of disease in educational needs (p=.015) were significantly different between discharge and 6 months after discharge. Conclusion: The results of this study suggested that further education should be provided to the patients underwent PCI regarding medication, smoking cessation, daily life and exercise at a time of 6 months after discharge in order to increase patient compliance of health behavior.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.31 no.4B
• /
• pp.309-314
• /
• 2011

Analysis of discharge characteristics through control gates at river crossing structures is important for an effective water level control and water resources management. In recent years, many river control structures in four major rivers are under construction but only few researches on discharge characteristics at control gates could be found in Korea. The discharge characteristics depend on both shape of control gates and the effects of downstream water-depth. In this research, classification index for discharge patterns (free weir, submerged weir, free orifice, submerged orifice) through a control gate were reviewed with $h_g/h_1$, $h_3/h_g$, and $h_3/h_1$. Classification criteria of discharge patterns were also suggested. Representative discharge estimation equations for each discharge patterns were adopted and discharge coefficients were developed from a hydraulic model for a specific control gate which will be constructed in Nakdong river. Reliability of the derived discharge equation and coefficients were confirmed by comparisons between the real discharge in a model and the predicted discharge from the results of this research.