• Journal of the Korean Chemical Society
• /
• v.38 no.3
• /
• pp.246-253
• /
• 1994

The simultaneous analysis of 11 semi-volatile organic acid compound which are listed as priority pollutants by EPA, were performed by GC/MS-SIM(selected ion monitoring). Two extraction procedures, sonication extraction and Soxhlet extraction, were studied as an extraction and concentration method for priority pollutants in soil. Accurecy and precision of the methods were measured by the calculation of mean recovery, mean relative standard deviation, and method detection limit. Finally, limitations and prospects were discussed.

• Environmental Analysis Health and Toxicology
• /
• v.22 no.1 s.56
• /
• pp.49-55
• /
• 2007

Three kind of ASE (Accelerated Solvent Extraction) and SPMDs (Semi-Permeable Membrane Devices) combined methods (ASE-SPMDs, ASE-accelerated SPMDs and SPMDs without extraction) and general Soxhlet-GPC were compared each other for the analysis of PCDD/FS in sediment. The average recovery rate of three types ASE and SPMDs combined methods (108.1%) were higher than that of the Soxhlet-GPC (79.5%) for three samples in each method using surrogate internal standards. The average coefficient of variation (10%, $2.1{\sim}25.2%$) for each congener of PCDD/Fs shows the reasonable results. Total PCDD/Fs concentrations after SPMDs without extraction were quite low, but those after ASE-SPMDs and ASE-accelerated SPMDs methods were close to the Soxhlet-GPC. Thus, the ASE-SPMDs and ASE-accelerated SPMDs methods are considered as the excellent pre-treatments method because they need less solvent and time without quality degradation.

• Biotechnology and Bioprocess Engineering:BBE
• /
• v.6 no.6
• /
• pp.433-437
• /
• 2001

The extraction of panaxynol and panaxydol from Korean ginseng was found to be op-timal at 55$^{\circ}C$ for the shaking method, 80$^{\circ}C$ for the soxhlet method, and 65$^{\circ}C$ for the supercritical extraction method. The amount of extracted panaxydol and panaxynol, and their increased over a period of 12 h with the shaking method. The soxhlet method produced an extract with the largest panaxydol/panaxynol ratio. A reduced particle size enhanced extraction, however the ration of panaxydol/panaxynol decreased. Swelling in water was found to be detrimental for the extrac-tion of panaxydol and panaxynol.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.44 no.6
• /
• pp.50-57
• /
• 2012

In this study, the beeswax extraction methods using organic solvents were examined to develop a optimal dewaxing technology for beeswax-treated Hanji. Thermally-aged beeswax-treated Hanji was dewaxed using four types of extraction methods including dipping, Soxhlet extraction, ultrasonic washing and shaking methods. Then, the aging stability of the dewaxed Hanji was evaluated in terms of variations in paper strength and in the color of the printed area with muk. The experimental results suggested that the dewaxing methods allowing solvent to flow during extraction showed superior extraction efficiency. The dipping method in which the organic solvent does not flow showed the slowest extraction rate of beeswax compared to three other methods. In terms of variations in tensile strength and folding endurance, however, no obvious differences in the aging stability were observed amongst these four extraction methods. Regarding the aging stability in terms of the color of the printed area with muk, Soxhlet extraction method showed the best performance of dewaxing.

• Korean Chemical Engineering Research
• /
• v.53 no.6
• /
• pp.717-722
• /
• 2015

D-limonene included in citrus fruits is obtainable to extract essential oil as well as separate the oil ingredient. Soxhlet extraction, a type of SDE (Simultaneous steam Distillation and solvent Extraction), was used to extract limonene from tangerine peel. HPLC analysis was performed to quantify extracted d-limonene by using reversed-phase HPLC column. Results of HPLC analysis showed that the optimal extraction time was 2 hours in any solvent, and the extracted amounts of d-limonene in tangerine peel (per g tangerine peel) were 7.77 mg, 0.49 mg, and 0.28 mg in ethyl alcohol, n-hexane, and ether. Because yield was the highest in using ethyl alcohol as a solvent, polarity is stronger factor to effect on yield of extraction than boiling point.

• KOREAN JOURNAL OF PACKAGING SCIENCE & TECHNOLOGY
• /
• v.1 no.1
• /
• pp.20-28
• /
• 1995

The conditions of Soxhlet extraction and HPLC analysis were examined for the determination of antioxidants used for polyolefins manufacturing. The extraction with methylene chloride in a Soxhlet apparatus for 10 hours and above provides almost complete recovery of the additives from polyolefins. The determination of the antioxidants including BHT, Irganox 1076, Irganox 1010 and Irgafos 168 could be successfully performed by using reversed-phase HPLC under gradient elution where the baseline separation of all four antioxidants in a single run was possible. In addition, the antioxidants inherently contained in commercial LLDPE and OPP films were identified and quantitatively determined.

• Bulletin of the Korean Chemical Society
• /
• v.20 no.6
• /
• pp.689-695
• /
• 1999

Supercritical fluid extraction (SFE), ultrasonic extraction (USE), and accelerated solvent extraction (ASE) were compared with the well known Soxhlet extraction for the extraction of polychlorinated biphenyls (PCBs) and polychlorinated dibenzo-p-dioxins(PCDDs) from the XAD-2 resin which was used to adsorb PCDDs in the atmosphere. XAD-2 resin spiked with five PCDDs was chosen as a sample. The optimum conditions for the extraction of PCDDs by SFE were turned out to be the use of CO2 modified with 10% toluene at 100 ℃ and 350 atm, with 5 min static extraction followed by 20 min dynamic extraction. SFE gave a good extraction rate with good reproducibility for PCDDs ranging from 68 to 98%. The ultrasonic extraction of PCDDs from XAD-2 was investigated and compared with other extractions. A probe type method was compared with a bath type. Two extraction solvents, toluene and acetone were compared with their mixture. The use of their mixture in probe type, with 9 minutes of extraction time, was found to be the optimum condition. The average recovery of the five PCDDs for USE was 82-93%. Accelerated solvent extraction (ASE) with a liquid solvent, a new technique for sample preparation, was performed under elevated temperatures and pressures. The effect of tem-perature on the efficiency of ASE was investigated. The extraction time for a 10 g sample was less than 15 min, when the organic solvent was n-hexaneacetone mixture (1 : 1, v/v). Using ASE, the average recoveries of five PCDDs ranged from 90 to 103%. SFE, USE, and ASE were faster and less laborious than Soxhlet extraction. The former three methods required less solvent than Soxhlet extraction. SFE required no concentration of the solvent extracts. SFE and ASE failed to perform simultaneous parallel extractions because of instrumental limitations.

• Journal of Food Hygiene and Safety
• /
• v.14 no.4
• /
• pp.365-371
• /
• 1999

Microwave-assisted extraction (MAE) is known as a more environmental-friendly process with economic advantages in terms of less time, less solvent, less energy and less waste than the current reflux method that is time-consuming. MAE was applied to extract three pesticides (quintozene, tolclofos-methyl and procymidone) from ginseng in a pesticide residue analysis and eliminate pesticide contaminants from ginseng prior to production of the ginseng extracts. The optimal conditions for pesticide extraction from ginseng were 50% in power (150 watts), 2 minutes, 20 mL hexane and 2.0 g sample. The results of optimal conditions were compared with those of Soxhlet method (7 hours, 150 mL hexane). The recoveries between two methods were almost same while time and amount of solvent used in MAE were significantly decreased in comparing with those in the Soxhlet methods. When the 45% ethyl alcohol as a extraction solvent was applied to eliminate pesticides from ginseng prior to the production of the ginseng extracts, it was found that 100% quintozene, 69％ tolclofos-methyl and 83% procymidone were eliminated from ginseng. The data showed that MAE may be used to eliminate pesticide contaminants in ginseng prior to making the ginseng extracts.

• Journal of Korean Society for Atmospheric Environment
• /
• v.16 no.6
• /
• pp.595-606
• /
• 2000

In order to compare analytical conditions for measuring PAHs(polycyclic aromatic hydrocarbons) in ambient air, a series of experiment were conducted using three different types of extraction methods that include:(1) accelerated solvent extraction (ASE), (2) soxhlet, and (3) sonification methods. Efficiency and relevant analytixal parameters for each of these methods were examined on five different types of solvents that include:(1) 10% diethyl ether in n-hexane(v/v), (2) dichloromethane, (3)cyclohexane.(4) toluene, and (5) Benzene: ethanol (4:1). Comparison of extraction efficiency for various combinations between methods and solvents was made through an application of both internal and external standard calibration techniques. The extraction efficiency tests, when checked using both internal and external standards, allowed us to derive meaningful comparison among different techniques and among solvents.

• Korean Chemical Engineering Research
• /
• v.57 no.2
• /
• pp.301-304
• /
• 2019

Microwave was designed for lipid extraction from green algae (Spirulina platensis). Microalgae-solvent (various solvents) were extracted and heated using microwave at 600 W for around 40 min. The maximum yield obtained within this period was 12.530% of lipid compared to just 1.293% for Soxhlet extraction. Lipid analysis revealed that those with higher essential fatty acid content consist of saturated fatty acid (SAFA) and polyunsaturated fatty acid (PUFA) which could be used for biodiesel production.