• Journal of The Korean Society of Agricultural Engineers
• /
• v.56 no.6
• /
• pp.11-18
• /
• 2014

Vulnerable areas by non-point source pollution and prioritizing control areas were researched using hydrological and geomorphological data, non-point source loads, and water quality data. Using overlay analysis, vulnerable areas were graded with various scenarios. Vulnerable areas were selected near the metro city with impermeable landuse because non-point source loads and water quality data had influence on overlay analysis to rank vulnerable area. Analysis scenarios and weighted values can be changed under regional characteristics and given conditions.

• Environmental Engineering Research
• /
• v.15 no.4
• /
• pp.231-237
• /
• 2010

With increased chemical and economic development activities in upstream areas, the amounts of pollutants released have increased, and as such, so has the need for positive management of water supply source areas. Although more than 90% of the water supply sources in Korea depend on direct intake from surface water, the interest in indirect intake, such as riverbank filtration water, has recently risen, with some local governments currently undertaking indirect intake. Even in cases of indirect intake, water supply source protection zones need to be assigned for the comprehensive control of pollutants. To establish water quality protection zones for indirect intake, the scope of the protection zones needed to reflect the hydrological features of the water-bearing deposits of each site. Water source protection areas were estimated and presented as the 1st (within a 100 m radius from an intake well) and 2nd (within a 2 km radius from an intake well) zones. The 1st zone was more sensitive; hence, the installation of various facilities should be prohibited, and the area should be regarded as off-limits. For the 2nd zone, appropriate management should prohibit and restrict activities already present in the water source protection zone.

• Journal of Korean Society for Atmospheric Environment
• /
• v.24 no.6
• /
• pp.662-673
• /
• 2008

Two hybrid receptor models, potential source contribution function (PSCF) and concentration weighted tracjectory (CWT), were compared for locating $PM_{2.5}$ sources contributing to the atmospheric $PM_{2.5}$ concentrations in Seoul. The source contribution estimates by chemical receptor model (CMB) receptor model were used to identify better source areas, Among the sources, soil, agricultural burning, marine aerosol, coal-fired power plant and Chinese aerosol were only considered for the study because these sources were more likely to be associated with the long-range transport of air pollutant. Both methods are based on combining chemical data with calculated air parcel backward trajectories. However, the PSCF analyses were performed with trajectories above the $75^{th}$ percentile criterion values, while the CWT analyses used all trajectories. This difference resulted in locating of different sources, which might be helpful to interpret locating of $PM_{2.5}$ sources, High possible source areas in source contribution of soil and agricultural burning contributing to the Seoul $PM_{2.5}$ were inland areas of Heibei and Shandong provinces (highest density areas of agricultural production and population) in China. The "Chinese aerosol" was used as a representative source for the $PM_{2.5}$ originated from urban area in China. High possible source areas for the aerosol were the cities in China where are relatively close to the receptor. This result suggests that Chinese aerosol is likely to be a useful tool in studies on source apportionment and identification in Korea.

• Journal of Korean Society for Atmospheric Environment
• /
• v.18 no.5
• /
• pp.393-400
• /
• 2002

Separation distance between industrial source and residential areas to avoid odor annoyance was investigated using AUSPLUME model. A Gaussian plume model (AUSPLUME) for the dispersion was used to calculate odor emission from ground level area source. Using the dispersion model to calculate ambient odor concentrations, the separation distance between industrial source and residental areas was defined by %HA (percentage of highly annoyed person) and odor percentile concentration (C98). The result was compared with the separation distance of various nation guidelines for livestock buildings. The calculated separation distance for industrial source showed similar pattern comparing with various guidelines for livestock buildings.

• Economic and Environmental Geology
• /
• v.27 no.4
• /
• pp.411-420
• /
• 1994

Euiseong sub-basin, one of three sub-basins in Kyungsang basin, consists of various sedimentary and igneous rocks of Cretaceous age. Kusandong tuff and Yucheon volcanic rocks from the sub-basin were collected for the anisotropy of magnetic susceptibility (AMS) study. Maximum directions of the AMS for Kusandong tuff and Yucheon volcanic rocks are used to detect possible source areas. Although the dispersion of the maximum directions of the AMS, mainly due to low susceptibility and/or low percent anisotropy of individual specimens, is rather large, it is possible to reveal several source areas for the volcanic rocks. Areas near the Keumseongsan and Hwasan, calderas in the study area, are identified as source areas for Yucheon volcanic rocks, while the western part of Sunamsan, another collapsed caldera in Euiseong sub-basin, is inferred to be the source area for Kusandong tuff. However, it is not possible to determine detailed source areas for groups of Yucheon volcanic rocks of different lithologies, because of poor degree of convergence of the maximum directions of the AMS results from the volcanic rocks. It is also concluded that several episodic volcanic activities centered at Keumseongsan and Hwasan calderas were responsible for the formation of Yucheon volcanic rocks in Euseong area.

• Journal of Korean Society on Water Environment
• /
• v.26 no.5
• /
• pp.761-767
• /
• 2010

This study introduces a model of territorial analysis on Chungcheongnam-do Nonsan-chun valley area, which gives an example of a method of selecting the management area for non-point pollution source from land use to help eliminate its source. High discharge load per unit area signify high level of land ratio with high level of basic unit of development load (including factory sites, school sites, roadways), which mean that there are a significant level of urbanization. It is these areas with the examination of the water quality of the nearby river that should be considered as the management area for non-point pollution source. Thus, the management area for non-point pollution source should be sought in areas with high discharge load per unit area and high density of water pollution area. When level of drainage is high the pollution density level is relatively lower, and when the level of drainage is low the density level is relatively higher. The level of pollution from non-point pollution source is much lower with more water flowing through. The possible non-point pollution source areas that were selected with these standards were then examined with the distance from the river, the slope angle, land usage, elevation, BOD discharge density load, T-N discharge density load, T-P discharge density load, and were given a level one through five. Out of the possible areas Nonsan-si Yeonmu-eup Anshim-li was the densest area, and it was given level one. The level one area should be examined further with the field analysis to be selected as the actual management area for non-point pollution source.

• Journal of Environmental Science International
• /
• v.19 no.8
• /
• pp.971-981
• /
• 2010

The objectives of this study were to measure ambient total gaseous mercury (TGM) concentrations in Seoul, to analyze the characteristics of TGM concentration, and to identify of possible source areas for TGM using back-trajectory based hybrid receptor models like PSCF (Potential Source Contribution Function) and RTWC (Residence Time Weighted Concentration). Ambient TGM concentrations were measured at the roof of Graduate School of Public Health building in Seoul for a period of January to October 2004. Average TGM concentration was $3.43{\pm}1.17\;ng/m^3$. TGM had no notable pattern according to season and meteorological phenomena such as rainfall, Asian dust, relative humidity and so on. Hybrid receptor models incorporating backward trajectories including potential source contribution function (PSCF) and residence time weighted concentration (RTWC) were performed to identify source areas of TGM. Before hybrid receptor models were applied for TGM, we analysed sensitivities of starting height for HYSPLIT model and critical value for PSCF. According to result of sensitivity analysis, trajectories were calculated an arrival height of 1000 m was used at the receptor location and PSCF was applied using average concentration as criterion value for TGM. Using PSCF and RTWC, central and eastern Chinese industrial areas and the west coast of Korea were determined as important source areas. Statistical analysis between TGM and GEIA grided emission bolsters the evidence that these models could be effective tools to identify possible source area and source contribution.

• The Korean Journal of Quaternary Research
• /
• v.21 no.2
• /
• pp.77-79
• /
• 2007

The source regions of Asian Dusts (Yellow Sands) in the western part of China are investigated, and the soil samples are collected samples for approximately 15 days during the spring of 2005. Particle sizes of sediments are analyzed and compared with each other. These grain-size analyses from the source areas can be compared Particle sizes between loess deposits and desert sands in western part of China and desert areas show distinctive differences. Loess deposits are predominantly composed of fine sands and silts. The distinction between the final characteristics of Asian Dust particles arrived in Korea and characteristics during transportation can be recognized comparison with the Asian Dust particles collected where the dust particles settled down. The characteristics of Asian Dust particle sizes can provide the basic information regarding the transportation history from the source region.

• Journal of Korean Society on Water Environment
• /
• v.23 no.4
• /
• pp.434-439
• /
• 2007

Amended Water Quality Environment Preservation Law enacted that the areas where nonpoint pollution is serious can be designated as Nonpoint Source Management Region. According to Section 54 of Water Quality Environment Preservation Law, corresponding watersheds are areas where runoff from nonpoint pollution source may deteriorate river and lake water quality, residents' health and property, and ecosystem. The criteria are as followings; i) where nonpoint source contribution result in or will result in significant ecological destruction, iii) national or local industrial complexes and cities having population greater than one million where nonpoint source managements are necessary, iv) where specific measurement is necessary because of its geological and stratigraphic characteristics. In this research, detailed designation criteria was developed reflecting current nonpoint source management situation and its discharge characteristics. Depending on the result, target regions were also suggested. In additions, it will be desirable that the target regions are prioritized considering institutional execution availability, stakeholder's agreement, and connection with existing nonpoint source pollution management measures.

• Proceedings of the Korean Environmental Health Society Conference
• /
• 2004.06a
• /
• pp.92-106
• /
• 2004

Elemental dry deposition fluxes were measured using dry deposition plates from March to June 1998 in Seoul, Korea. During this spring sampling period several yellow sand events characterized by long-range transport from China and Mongolia impacted the area. Understanding the impact of yellow-sand events on atmospheric dry deposition is critical to managing the heavy metal levels in the environment in Korea. In this study, the measured flux of a primarily crustal metal, Al and an anthropogenic metal, Pb was used with two hybrid receptor models, potential source contribution function (PSCF) and residence time weighted concentration (RTWC) for locating sources of heavy metals associated with atmospheric dry deposition fluxes during the yellow-sand events in Seoul, Korea. The PSCF using a criterion value of the 75th percentile of the measured dry deposition fluxes and RTWC results using the measured elemental dry deposition fluxes agreed well and consistently showed that there were large potential source areas in the Gobi Desert in China and Mongolia and industrial areas near Tianjin, Tangshan, and Shenyang in China. Major industrial areas of Shenyang, Fushun, and Anshan, the Central China loess plateau, the Gobi Desert, and the Alaskan semi-desert in China were identified to be major source areas for the measured Pb flux in Seoul, Korea. For Al, the main industrial areas of Tangshan, Tianjin and Beijing, the Gobi Desert, the Alashan semi-desert, and the Central China loess plateau were found to be the major source areas. These results indicate that both anthropogenic sources such as industrial areas and natural sources such as deserts contribute to the high dry deposition fluxes of both Pb and Al in Seoul, Korea during yellow-sand events. RTWC resolved several high potential source areas. Modeling results indicated that the long-range transport of Al and Pb from China during yellow-sand events as well as non yellow-sand spring daytimes increased atmospheric dry deposition of heavy metals in Korea.