• 한국재료학회:학술대회논문집
• /
• 한국재료학회 1997년도 한국재료학회 추계학술발표회
• /
• pp.132-132
• /
• 1997

• 한국재료학회:학술대회논문집
• /
• 한국재료학회 2000년도 추계학술발표강연 및 논문개요집
• /
• pp.77-77
• /
• 2000

• 대한기계학회논문집A
• /
• 제26권6호
• /
• pp.1001-1007
• /
• 2002

To improve the performance of the PZT thin flms, each PZT and PT layer was alternately deposited on a Pt/Ti/Si$_3$N$_4$/SiO$_2$/Si substrate by a modified sol-gel solid precursor technique. For comparison, PZT thin films were also prepared with an identical method under the same conditions. XRD measurement revealed that the diffraction pattern of the multilayer film was due to the superimposition of the PZT and PT patterns. At 1㎑, a dielectric constant of 389 and 558, a dielectric loss of 1.2% and 1.1% were obtained for the PZT/PT and PZT thin films, respectively. If we consider the PT dielectric constant to be 260, it is clear that the dielectric constant of alternately deposited PZT/PT thin films was well adjusted. The PZT/PT thin film showed a low dielectric constant and a similar dielectric loss compared with those of the PZT film. The figures of merit on detectivity for the PZT/PT and PZT thin films were 20.3$\times$10$\^$-6/㎩$\^$-$\sfrac{1}{2}$/, and 18.7$\times$10$\^$-6/㎩$\^$-$\sfrac{1}{2}$/, and the figures of merit on voltage response were 0.038㎡/C and 0.028 ㎡/C, respectively. The high figures of merit for the PZT/PT film were ascribed to its relatively low dielectric constant when compared to the PZT thin films.

• 한국재료학회지
• /
• 제19권10호
• /
• pp.550-554
• /
• 2009

Unreported dielectrics based on the binary system of MgO-SiO$_2$ were investigated as potential candidates for microwave dielectric applications, particularly those demanding a high fired density and high quality factors. Extensive dielectric compositions having different molar ratios of MgO to SiO$_2$, such as 2:1, 3:1, 4:1, and 5:1, were prepared by conventional solid state reactions between MgO and SiO$_2$. 1 mol% of V$_2$O$_5$ was added to aid sintering for improved densification. The dielectric compositions were found to consist of two distinguishable phases of Mg$_2$SiO$_4$ and MgO beyond the 2:1 compositional ratio, which determined the final physical and dielectric properties of the corresponding composite samples. The increase of the ratio of MgO to SiO$_2$ tended to improve fired density and quality factor (Q) without increasing grain size. As a promising composition, the 5MgO.SiO$_2$ sample sintered at 1400 $^{\circ}C$ exhibited a low dielectric constant of 7.9 and a high Q $\times$ f (frequency) value of $\sim$99,600 at 13.7 GHz.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2002년도 하계학술대회 논문집 Vol.3 No.2
• /
• pp.1084-1087
• /
• 2002

The guard-ring type 3-terminal parallel plate electrodes proposed by ASTM D 150-81 and IEC 250 have been widely used for measurement of dielectric constants of solid dielectrics. However the method using this electrodes causes many uncertainty associated with the measurement errors of the diameter of the guarded electrode. the gap between guarded and guard-ring electrode. the distance of two active electrodes(the thickness of specimen), the roughness and contamination of surface of electrode and specimen. close adherence grade of electrode and specimen. In this paper. a new electrode system of cross capacitance type based on Thompson-Lampard theorem is designed and is employed for the measurement of dielectric constant. The results of simulation of guard-ring electrode and cross capacitance electrode using FEM program show that distance measurement between two electrodes in guard-ring electrode produces large uncertainty. on the other hand this effect in cross capacitance electrode is negligible. Furthermore. the air gap effects in the cross capacitance electrode is 5.6 times less sensitive than that in guard-ring electrode by assuming air gap of $50{\mu}m$.

• 한국세라믹학회지
• /
• 제27권2호
• /
• pp.187-194
• /
• 1990

Effects of MnO2 addition ranged from 0.0wt% to 5.0wt% on the microstructure and dielectric and piezoelectric properties of the Pb(Zr0.52 Ti0.48)O3 Ceramics have been investigated. The solubility limit of MnO2 in Pb(Zr0.52 Ti0.48)O3 is about 0.5wt%, and MnO2 as a valence state of Mn3+ is substituted for (Zr, Ti) lattice site in PZT solid-solution. The addition of MnO2 up to 0.5wt% in Pb(Zr0.52 Ti0.48)O3 brings increase of density, but decreased of grain size and tetragonality. Dielectric constant slightly decreases, but both coupling factor(Kp) and mechanical quality factor(Qm) increase with the addition of MnO2. However, excess amount of MnO2 addition more than 0.75wt% results in rapid decrease of resistance. Dielectric constant and tan $\delta$ increase due to the second phase and inhomogeneous Mn distribution.

• 한국전기전자재료학회논문지
• /
• 제29권7호
• /
• pp.404-407
• /
• 2016

In this study, to develop low temperature sintering capacitor composition ceramics with the good dielectric properties, $(Ba_{0.86}Ca_{0.14})(Ti_{0.85}Zr_{0.12}Sn_{0.03})O_3$ (BCTZ) ceramics were prepared by the conventional solid-state reaction method. The effects of $B_2O_3$ addition on the dielectric properties and microstructure was investigated. The XRD patterns demonstrated that all the specimens showed Perovskite phase, and secondary phases are indicated in the measurement range of XRD. And also, temperature coefficient of capacitance(TCC) of all the specimen sintered at $1,180^{\circ}C$ showed +3~-56% except for x=0.006. For all the specimens, observed one peak was tetragonal cubic difuse phase transition temperature(Tc), which is located in the vicinity of room temperature.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1994년도 추계학술대회 논문집
• /
• pp.8-12
• /
• 1994

Solid solutions $Sr_2$($Ta_{1-x}$$Nb_{x}$)$_2$$O_{7}$ (x = 0.0 - 1.0) composed of strontium-tantalate (low Curie temperature) and strontium-niobate (high Curie temperature) were prepared by the conventional mixed oxide method and the molten salt synthesis method (flux method). Phase relation, sintering temperature, grain-orientation and dielectric properties were investigated for sintered ceramic samples with different compositions. Both Curie temperature and dielectric constant at Curie temperature were increased, and sintering behavior and the degree of grain-orientation were improved with the increase of Nb content. Single phase $Sr_2$$Nb_2$$O_{7}$ powder was synthesized by using flux method at lower temperatures, and sintering temperature was also reduced by using flux method derived powder than using mixed-oxide derived powder. Sintering characteristics and dielectric properties of specimens prepared by flux method were better than those derived through the conventional method.

• E2M - 전기 전자와 첨단 소재
• /
• 제8권2호
• /
• pp.158-164
• /
• 1995

Solid solutions Sr$_{2}$(Ta$_{1-x}$ Nb$_{x}$)$_{2}$O$_{7}$, (x=0.0-1.0), composed of strontium tantalate(Tc=-107.deg. C) and strontium-niobate(Tc=1342.deg. C) were prepared by the conventional mixed oxide method and the flux method(molten salt synthesis method). Phase relation, sintering temperature, grain-orientation and dielectric properties for sintered ceramic samples were investigated with different compositions. Both Curie temperature and dielectric constant at Curie temperature were increased, and sintering behavior and the degree of grain-orientation were improved with the increase of Nb content. The single phase Sr$_{2}$(Ta/sib 1-x/Nb$_{x}$)$_{2}$O$_{7}$ powder was synthesized by using the flux method at lower temperatures, and sintering temperature was also reduced by using the flux method-derived powder than using the mixed oxide-derived powder. Sintering characteristics and dielectric properties of the specimens prepared by the flux method were better than those derived through the conventional mixed oxide method.thod.hod.

• 한국세라믹학회지
• /
• 제38권12호
• /
• pp.1167-1173
• /
• 2001

텅스텐브론즈 구조를 가지는 Sr$_{x}Ba_{1-x}Nb_{2}O_{6}$(SBN) (0.3$\le$x$\ge$0.7) 세라믹스를 고상반응법으로 합성하고 Sr/Ba의 비에 따른 유전특성을 조사하였다. SBN 세라믹스는 Sr/Ba의 비가 증가함에 따라 상전이 온도는 낮아지고 상전이 온도에서의 최대 유전율은 증가하였다. 또한 SBN 세라믹스는 Sr 함량에 따른 relaxor 거동을 정량화하여 평가하였는데, Sr/Ba의 비가 증가할수록 유전율은 더욱 완만해지는 것을 관찰할 수 있었다. 이러한 실험 결과를 텅스텐브론지 구조를 가진 SBN 세라믹스의 결정구조 관점에서 해석하였다.