• Proceedings of the Korean Geotechical Society Conference
• /
• 2003.03a
• /
• pp.325-332
• /
• 2003

In general, soil characteristics are estimated through the sample gathered by field boring without considering sample disturbance. However, soil characteristics must be changed by the degree of sample disturbance. Therefore it be need to estimate the soil characteristic considering sample disturbance which can be occurred by the change of stress condition, sampling technique and handling method. On this study, we analyzed the sample disturbance by using the methods of volume change, residual effective stress, elastic modulus and the curve of consolidation tests. In order to estimate the relationship between sample disturbance and soil characteristics, we used the piston sample and the block sample. As the results, it should be considered in design that the disturbance of the block sample, which affects the strength and compression properties of clay, is smaller than the disturbance of piston sample.

• Geomechanics and Engineering
• /
• v.9 no.6
• /
• pp.743-755
• /
• 2015

It is well known that the quality of sample significantly determines the accuracy of soil parameters for laboratory testing. Although sampling disturbance has been studied over the last few decades, the theoretical investigation of soil disturbance due to sampling penetration has been rarely reported. In this paper, an analytical solution for estimating the soil disturbance due to sampling penetration was presented using cavity expansion method. Analytical results in several cases reveal that the soil at different location along the sample centerline experiences distinct phases of strain during the process of sampling penetration. The magnitude of induced strain is dependent on the position of the soil element within the sampler and the sampler geometry expressed as diameter-thickness ratio D/t and length-diameter ratio L/D. Effects of sampler features on soil disturbance were also studied. It is found that the induced maximum strain decreases exponentially with increasing diameter-thickness ratio, indicating that the sampling disturbance will reduce with increasing diameter or decreasing wall thickness of sampler. It is also found that a large length-diameter ratio does not necessarily reduce the disturbance. An optimal length-diameter ratio is suggested for the further design of improved sampler in this study.

• Journal of Ecology and Environment
• /
• v.36 no.2
• /
• pp.117-123
• /
• 2013

This study investigated the impact of the fire disturbance and the pattern of recovery of soil dwelling oribatid mite communities with respect to the resilience from the fire disturbance. Oribatid mites are important decomposer animals of plant debris in soil with the feeding habits of saprophagy and mycophagy. Massive wild fire reduced soil oribatid mite abundance and diversity. The impact varied relative to the intensity of the disturbance. The proportion of the species common to the non-disturbed natural site increased as the time after the disturbance elapsed, which implying some degree of naturalness occurring in reorganization phase of the oribatid mite community. From the sites with different degree of fire impact, we found higher diversity in intermediately disturbed sites than in severely disturbed or non-disturbed site, supporting the intermediate disturbance hypothesis. Also this study showed that with differential degree of disturbance plots, resilience pattern after the disturbance can be explored even with shorter period research relative to the ecological succession of community.

• Journal of Korean Society of Forest Science
• /
• v.106 no.2
• /
• pp.204-212
• /
• 2017

Soil disturbance caused by timber harvesting is widely recognized as a potential threat to forest utilization. The degree and extent of soil disturbance is believed to vary with respect to harvesting methods and logging machines. This study has conducted to assess the degree of soil disturbance associated with ground-based cut-to-length (GC) and cable yarding with whole tree (CW) harvesting methods. Soil disturbance was classified using a visual assessment of harvest unit. The properties of soils in different disturbance levels were also evaluated to understand the influence of timber harvesting on soil structure with soil core sampling method. The deep disturbance and soil compaction were observed in sites by 48% and 23% through harvesting areas for GC and CW logging methods, respectively. The results showed that logging machine and number of machine passage had significant influences on soil bulk density and porosity. Soil disturbance types such as rutted, slash cover, and compact were influenced by equipment travel trends in a GC method.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.51 no.5
• /
• pp.51-58
• /
• 2009

The total recovery ratio test on undisturbed clay soil sampling in the field and the finite element method analysis on modified static state of penetration process were conducted for the purpose of deciding the most important factor among the shape factors of thin wall tube. The adhesion between tube wall and soil did not decrease although internal clearance ratio of tube increased within the little change of tube area ratio. The most part of disturbance occurred in the tip of sampling tube during the penetration. The longitudinal displacement was larger than the lateral displacement because soil was confined laterally after being entered into tube, and also the longitudinal displacement was larger in the upper part of the sample tube than in the lower part.

• Korean Journal of Soil Science and Fertilizer
• /
• v.48 no.2
• /
• pp.105-118
• /
• 2015

This study was carried out to investigate the effects of profile disturbance with different artificial accumulation history on physico-chemical properties of soil under plastic film house. The investigations included soil profile description using soil column cylinder auger F10cm x h110cm, in situ and laboratory measurements of soil properties at five sites each at the cucumber (Site Ic ~ Vc) and grape (Site Ig ~ Vg) plastic film houses with artificial soil accumulation. The sites except sites Ic, IVc, IVg and Vg, belong to ex-paddy area. The types of accumulates around root zone included sandy loam soil for 3 sites, loam soil for 1 site, saprolite for 2 sites, and multi-layer with different accumulates for 3 sites. Especially, Site IIg has mixed plow zone (Ap horizon) with original soil and saprolite, whereas disturbed soil layers of the other sites are composed of only external accumulates. The soil depth disturbed by artificial accumulation ranged from 20 cm, for Site IIg, to whole measured depth of 110 cm, for Site IVc, Vc, and Site IVg. Elapsed time from artificially accumulation to investigation time ranged from 3 months, Site IIc, to more than 20 years, Site Vg, paddy-soil covering over well-drained upland soil during land leveling in 1980s. Disturbed top layer in all sites except Site Vg had no structure, indicating low structural stability. In situ infiltration rate had no correlation with texture or organic matter content, but highest value with highest variability in Site IIIc, the shortest elapsed time since sandy loam soil accumulation. Relatively low infiltration rate was observed in sites accumulated by saprolite with coarse texture, presumably because its low structural stability in the way of weathering process could result in relatively high compaction in agro-machine work or irrigation. In all cucumber sites, there were water-transport limited zone with very low permeable or impermeability within 50 cm under soil surface, but Site IIg, IIIg, and Vg, with relatively weak disturbance or structured soil, were the reverse. We observed the big change in texture and re-increase of organic matter content, available phosphate, and exchangeable cations between disturbed layer and original soil layer. This study, therefore, suggest that the accumulation of coarse material such as saprolite for cultivating cash crop under plastic film house might not improve soil drainage and structural stability, inversely showing weaker disturbance of original soil profile with higher drainage.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2008.03a
• /
• pp.134-141
• /
• 2008

To evaluate the engineering properties of soil, the laboratory test always is carried out using samples obtained from the field. There are many studies to estimate the effect of sampling disturbance. The objective of this study appraises the disturbance using the shear wave velocity. The new shelby tube which three transducers are installed every 20cm interval is used. To laboratory tests, the large-scale consolidometer (calibration chamber) is used. During 1cm penetration, the shear wave velocity is measured by every transducer. The initial sampling disturbance is assessed through the velocity difference from bottom to right upside transducer. After finishing the sampling, the velocity is still measured every time to assess the soil disturbance in shelby tube itself. Through the measured velocity, the effect of disturbance is appraised. This study suggests that the sampling disturbance of shelby tube is effectively evaluated using shear wave velocity.

• The Korean Journal of Ecology
• /
• v.16 no.2
• /
• pp.191-198
• /
• 1993

The relationships between microbial activity and disturbance level of soil were investigated from 15 parks in Seoul and undisturbed area. The physico-chemical characteristics of soil and dehydrogenase activity(DHA) as an index of soil microbial activity were analysed. There were ranges of 3.84~7.37 in pH, 9.63~40.33% in moisture content, 3.41~21.49% in organic matter, 0.36~0.79g/g in water holding capacity and 0.03~0.53% in total nitrogen investigated sites. DHA values of soil were 8.64~$146.76{\mu}g/g$ in park soil and 545.14~$1, 198.80{\mu}g/g$ in undisurbed area. DHA of park soil with high traffic density and contamination source from human activities was much lower than that of undisturbed area. DHA was positively correlated with moisture content, organic matter, water holding capacity and total nitrogen.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.32 no.4C
• /
• pp.149-157
• /
• 2012

In order to investigate the soil disturbance induced by anchor-shoe for PVD installation and the anchoring mechanism, a new two dimensional testing system was developed. By using the developed testing system, 1g and centrifuge model tests were performed, simulating the driving-retrieval process of both conventional symmetric anchor shoe and new asymmetric anchor shoe. Various size anchor-shoes were simulated and the results were compared. The images recorded during the installation were analyzed by image processing technique. The results of the image analysis presented the clay disturbance depending on the size and type of anchor shoe. In addition, from the retrieval process, the anchoring mechanism was revealed and the holding capacity was measured. As results, the size of anchor shoe influences the soil disturbance and holding capacity. The new asymmetric anchor shoe reduces the soil disturbance and improves anchoring performance.

• Geomechanics and Engineering
• /
• v.23 no.6
• /
• pp.513-521
• /
• 2020

In this paper, due to the need for cutting cement-soil group pile composite foundation under the 7-story masonry structure of Zhenghe District and the shield tunnel of Zhengzhou Metro Line 5, a field test was conducted to directly cut cement-soil single pile composite foundation with diameter Ф=500 mm. Research results showed that the load transfer mechanism of composite foundation was not changed before and after shield tunnel cut the pile, and pile body and the soil between piles was still responsible for overburden load. The construction disturbance of shield cutting pile is a complicated mechanical process. The load carried by the original pile body was affected by the disturbance effect of pile cutting construction. Also, the fraction of the load carried by the original pile body was transferred to the soil between the piles and therefore, the bearing capacity of composite foundation was not decreased. Only the fractions of the load carried by pile and the soil between piles were distributed. On-site monitoring results showed that the settlement of pressure-bearing plates produced during shield cutting stage accounted for about 7% of total settlement. After the completion of pile cutting, the settlements of bearing plates generated by shield machine during residual pile composite foundation stage and shield machine tail were far away from residual pile composite foundation stage which accounted for about 15% and 74% of total settlement, respectively. In order to reduce the impact of shield cutting pile construction on the settlement of upper composite foundation, it was recommended to take measures such as optimization of shield construction parameters, radial grouting reinforcement and "clay shock" grouting within the disturbance range of shield cutting pile construction. Before pile cutting, the pile-soil stress ratio n of composite foundation was 2.437. After the shield cut pile is completed, the soil around the lining structure is gradually consolidated and reshaped, and residual pile composite foundation reaches a new state of force balance. This was because the condensation of grouting layer could increase the resistance of remaining pile end and friction resistance of the side of the pile.