• Journal of Korean Society on Water Environment
• /
• v.37 no.6
• /
• pp.442-448
• /
• 2021

Seawater desalination is a technology through which salt and other constituents are removed from seawater to produce fresh water. While a significant amount of fresh water is produced, the desalination process is limited by the generation of concentrated brine with a higher salinity than seawater; this imposes environmental and economic problems. In this study, characteristics of seawater from three different locations in South Korea were analyzed to evaluate the feasibility of crystallization to seawater desalination. Organic and inorganic substances participating in crystal formation during concentration were identified. Then, prediction and economic feasibility analysis were conducted on the actual water flux and obtainable salt resources (i.e. Na2SO4) using membrane distillation and energy-saving crystallizer based on multi-stage flash (MSF-Cr). The seawater showed a rather low salinity (29.9~34.4 g/L) and different composition ratios depending on the location. At high concentrations, it was possible to observe the participation of dissolved organic matter and various ionic substances in crystalization. When crystallized, materials capable of forming various crystals are expected. However, it seems that different salt concentrations should be considered for each location. When the model developed using the Aspen Plus modular was applied in Korean seawater conditions, relatively high economic feasibility was confirmed in the MSF-Cr. The results of this study will help solve the environmental and economic problems of concentrated brine from seawater desalination.

• Journal of Environmental Science International
• /
• v.19 no.12
• /
• pp.1421-1430
• /
• 2010

Polycyclic aromatic hydrocarbons (PAHs) were investigated in seawater and marine sediment from Anmyundo coastal area after oil spill. The concentrations of total PAHs in surface and bottom of seawater at August were 31.1 to 142.6 ng/L and 5.9 to 50.9 ng/L in August and November, respectively. The concentrations of PAHs in sediment were 21.0 to 102.9 ng/g D.W. and 32.3 to 57.4 ng/g D.W. in August and November, respectively. PAHs concentrations in seawater and sediment in August were higher than those in November about 2.5 and 1.4 times, respectively. Diagnostic ratio (PhA/AnT and FluA/Pyr) were investigated to identify source of PAHs in seawater and sediment. The PAHs in seawater originated from pyrolytic source and those in sediment originated from pyrolytic and petrogenic source. The glass, wood and coal origin was higher than petroleum origin on the combustion origin of PAHs in seawater and sediment. The seawater of Anmyundo costal area recovered from oil spill, but the sediments of that were weakly influenced by oil spill until now. Because this area is developed many fishing grounds, demanded Long Term Environmental Monitoring Program (LTEMP). The concentrations of PAHs on depth of sediments were investigated at station 8 and 10. The concentrations of PAHs were decreased with increasing depth.

• Journal of Advanced Marine Engineering and Technology
• /
• v.28 no.6
• /
• pp.1000-1009
• /
• 2004

The environment friendly calcareous deposit films were formed on steel plates by electrodeposition technique in natural seawater and synthetic solutions such as dissolved $\textrm{Mg}^{2+}$ and $\textrm{Ca}^{2+}$ ions at various potential conditions. The influence of potential conditions on composition ratio, structure and morphology of the electrodeposited films were investigated by scanning electron microscopy(SEM), energy dispersive spectroscopy(EDS) and X-ray diffractor (XRD). Accordingly, this study was provided a better understanding of the composition between the growth of $\textrm{Mg(OH)}_2$ and that of $\textrm{CaCO}_3$ during the formation of calcareous deposit films on steel substrate under cathodically electrodeposition in synthetic and natural seawater. The results showed that the formation of good overall calcareous deposited film in seawater can be achieved by controlling the Ca/Mg ratio according to interfacial pH with the effective use of the electro deposition technique.

• Ocean and Polar Research
• /
• v.28 no.3
• /
• pp.331-337
• /
• 2006

Organophosphorus pesticides (OPs) were analyzed in surface water samples from the Saemangeum environment. IBP was the most abundant among 10 OPs analyzed, and accounted fur over 95% of total amount of OPs. Concentrations of IBP measured in Mangyeong River water and surface seawater ranged from 670 to 1100ng/l and from 45 to 1000 ng/l, respectively. In general, a decreasing trend of OP concentrations towards open sea was observed. The concentrations of IBP and salinity demonstrated a strong correlation $(r^2=0.96)$. This indicates that IBP showed conservative behavior in the study area, and seawater dilution is a major factor affecting distribution and variation of OPs in the Sammgem environment.

• Journal of the Korean Society for Marine Environment & Energy
• /
• v.13 no.3
• /
• pp.206-215
• /
• 2010

The multi-outlets were installed on the existing seawater exchange breakwater in order to improve seawater exchange rate at Jumunjin harbor. Physical and numerical model system were fulfilled for 4 cases to evaluate seawater exchange system which is able to discharge water remotely. The seawater circulation pattern and seawater exchange rate in the harbor were compared and analyzed. Consequently, total seawater exchange rate for CASE 1 was calculated 48% due to the dead zones which hinder seawater circulation in the harbor. Otherwise, the seawater exchange rates of CASE 2, CASE 3, and CASE 4 with the installation of the system were enhanced 19%, 15% and 17%, respectively compare to CASE 1.

• Journal of Ocean Engineering and Technology
• /
• v.23 no.6
• /
• pp.39-43
• /
• 2009

A flow and low temperature of deep seawater the biofouling properties in a seawater environment of different materials, such as a steel pipe, polyethylene pipe, and nylon net, used for ocean industries. Experiments in a real sea environment were performed to grasp the quantitative and qualitative biofouling from diatoms attached to materials by measuring the Chlorophyll-a density. Experimental samples were placed under five types of ocean environmental conditions and analyzed every month for five months. It is shown that the biofouling by diatoms was strongly affected by the seawater temperature for all of the experimental samples. It was found that diatoms mainly adhered to the nylon net, while crustaceans prefer polyethylene, under a high temperature condition. It is believed that the biofouling properties are strongly related to the surface roughness of a material. The biofouling under the low temperature condition of deep seawater was rare and stable for the experimental periods. The inside of a pipe conveying deep seawater can be presumed to remain clear without biofouling on the condition of a flow and low temperature of deep seawater.

• The Sea:JOURNAL OF THE KOREAN SOCIETY OF OCEANOGRAPHY
• /
• v.21 no.2
• /
• pp.58-66
• /
• 2016

We have evaluated the ammonium data in seawater as a potential short-term index for marine environment through the following steps. 1. reviewing of chemical characteristics of ammonium in seawater, 2. comparative relationships of ammonium data with other water quality indices such as DO, COD, and nutrients from Typical Marine Environment(TME) and Special Marine Environment(SME). Ammonium data generally represent negative correlation with DO, while positive correlation with COD. In particular, under frequent cases of seawater conditions showing similar concentration of COD or DO, we have limited choice of explanation for such situation. However ODIN(ODIN/RDIN) or RDIN(RDIN/TDIN) ratio could provide advanced information to understand these seawater conditions. Based on these results, we suggest ammonium data as a potential short-period index for transilient marine environment, such as benthic flux of bottom sediment, hypoxia, and algal bloom. Under overcoming several handicaps, ammonium data could be an useful tool for better understand short transformation of marine environment.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.29 no.2
• /
• pp.223-229
• /
• 2023

Seawater batteries are next-generation secondary batteries that use seawater as a cathode. They utilize marine resources to provide competitive prices, high eco-friendliness, and a structure suitable for marine applications. Based on these advantages, pouch types and prismatic types have been studied and developed assuming natural seawater exposure. However, because of the electrical characteristics of the secondary battery, its capacity and internal resistance vary depending on the use environment. These characteristics are not only utilized for predicting the life of a battery but also have a direct effect on the capacity and power suitable for a specific situation. Therefore, the internal resistance was analyzed in this study by measuring the capacity depending on the seawater battery use environment and the state-of-charge-open-circuit-voltage measurement method.

• Proceedings of the Korea Concrete Institute Conference
• /
• 1993.04a
• /
• pp.73-78
• /
• 1993

This study was performed for the purposes of estimating steel corrosion of concrete structures under the environment of seawater. The corrosion of steel was accelerated in artificial seawater with seven kinds of specimen which was embedded in mortar. By measuring choride content in mortar, half cell potential and corrosion area ratio, the degree of steel corrosion can be assumed.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2002.04a
• /
• pp.148-154
• /
• 2002

Groundwater Dam is one of the reliable techniques to get huge amount of groundwater abstraction for municipal, agricultural, drinking, industrial water supply system. It can be a major technique to solve water shortage problems when it based on the sufficient watershed, proper topology, and adequate aquifer distribution and pollution control. It is suggested that the two consecutive underground wall in the coastal area to prevent seawater intrusion beneath a single wall.