• Biomolecules & Therapeutics
• /
• v.21 no.2
• /
• pp.161-169
• /
• 2013

The objective of this study was to enhance the oral bioavailability (BA) of zanamivir (ZMR) by increasing its intestinal permeability using permeation enhancers (PE). Four different classes of PEs (Labrasol$^{(R)}$, sodium cholate, sodium caprate, hydroxypropyl ${\beta}$-cyclodextrin) were investigated for their ability to enhance the permeation of ZMR across Caco-2 cell monolayers. The flux and $P_{app}$ of ZMR in the presence of sodium caprate (SC) was significantly higher than other PEs in comparison to control, and was selected for further investigation. All concentrations of SC (10-200 mM) demonstrated enhanced flux of ZMR in comparison to control. The highest flux (13 folds higher than control) was achieved for the formulation with highest SC concentration (200 mM). The relative BA of ZMR formulation containing SC (PO-SC) in plasma at a dose of 10 mg/kg following oral administration in rats was 317.65% in comparison to control formulation (PO-C). Besides, the $AUC_{0-24\;h}$ of ZMR in the lungs following oral administration of PO-SC was $125.22{\pm}27.25$ ng hr $ml^{-1}$ with a $C_{max}$ of $156.00{\pm}24.00$ ng/ml reached at $0.50{\pm}0.00$ h. But, there was no ZMR detected in the lungs following administration of control formulation (PO-C). The findings of this study indicated that the oral formulation PO-SC containing ZMR and SC was able to enhance the BA of ZMR in plasma to an appropriate amount that would make ZMR available in lungs at a concentration higher (>10 ng/ml) than the $IC_{50}$ concentration of influenza virus (0.64-7.9 ng/ml) to exert its therapeutic effect.

• Nuclear Engineering and Technology
• /
• v.52 no.2
• /
• pp.417-428
• /
• 2020

Investigations of the commercial aircraft impact effect on nuclear island infrastructures have been drawing extensive attention, and this paper aims to perform the safety assessment of Generation III nuclear power plant (NPP) buildings subjected to typical commercial aircrafts crash. At present Part III, the local damage of the rigid components of aircraft, e.g., engine and landing gear, impacting the steel concrete (SC) structures of NPP containment is mainly discussed. Two typical SC target panels with the thicknesses of 40 mm and 100 mm, as well as the steel cylindrical projectile with a mass of 2.15 kg and a diameter of 80 mm are fabricated. By using a large-caliber air gas gun, both the projectile penetration and perforation test are conducted, in which the striking velocities were ranged from 96 m/s to 157 m/s. The bulging velocity and the maximal deflection of rear steel plate, as well as penetration depth of projectile are derived, and the local deformation and failure modes of SC panels are assessed experimentally. Then, the commercial finite element program LS-DYNA is utilized to perform the numerical simulations, by comparisons with the experimental and simulated projectile impact process and SC panel damage, the numerical algorithm, constitutive models and the corresponding parameters are verified. The present work can provide helpful references for the evaluation of the local impact resistance of NPP buildings against the aircraft engine.

• Journal of the Korean Ceramic Society
• /
• v.42 no.12 s.283
• /
• pp.787-792
• /
• 2005

A symmetrical LSCF $(La_{0.6}Sr_{0.4}Co_{0.2}Fe_{0.8}O_{3-\delta})\;ScSZ(89ZrO_2-10Sc_2O_3-1CeO_2)/LSCF$ electrochemical cell with a GDC (Gadolinium-Doped Ceria, $90CeO_2-10Gd_2O_3$) interlayer that was inserted between the LSCF cathode and ScSZ electrolyte was fabricated, and the electrochemical performance of these cells was evaluated. The GDC interlayer was deposited on a ScSZ electrolyte using a screen-printing technique. The GDC interlayer prevented the unfavorable solid-state reactions at the LSCF/ScSZ interfaces. The LSCF cathode on the GDC interlayer had excellent electrocatalytic performance even at $650^{\circ}C$. The Area Specific Resistance (ASR) was strongly dependent on the thickness and heat-treatment temperature of the GDC interlayer. The impedance spectra showed that the cell with a $15\~27{\mu}m$ thick GDC interlayer heat-treated at $1200^{\circ}C$ had the lowest ASR.

• Microbiology and Biotechnology Letters
• /
• v.49 no.2
• /
• pp.148-156
• /
• 2021

Single-chain antibodies against epidermal growth factor receptor variant III (EGFRvIII) are potentially promising agents for developing antibody-based cancer treatment strategies. We described in our previous study the successful expression of an anti-EGFRvIII scFv antibody in Escherichia coli. However, we could also observe the formation of insoluble aggregates in the periplasmic space, limiting the production yield of the active product. In the present study, we investigated the mechanisms by which growth conditions could affect the expression of the soluble anti-EGFRvIII scFv antibody in small-scale E. coli NiCo21(DE3) cultures, attempting to maximize production. The secreted scFv molecules were purified using Ni-NTA magnetic beads and protein characterization was performed using SDS-PAGE and western blot analyses. We used the ImageJ software for protein quantification and determined the antigen-binding activity of the scFv antibody against the EGFRvIII protein. Our results showed that the highest percentage of soluble scFv expression could be achieved under culture conditions that combined low IPTG concentration (0.1 mM), low growth temperature (18℃), and large culture dish surface area. We found moderate-yield soluble scFv production in the culture medium after lactose-mediated induction, which was also beneficial for downstream protein processing. These findings were confirmed by conducting western blot analysis, indicating that the soluble, approximately 30-kDa scFv molecule was localized in the periplasm and the extracellular space. Moreover, the antigen-binding assay confirmed the scFv affinity against the EGFRvIII antigen. In conclusion, our study reveals that low-speed protein expression is preferable to obtain more soluble anti-EGFRvIII scFv protein in an E. coli expression system.

• Journal of electromagnetic engineering and science
• /
• v.4 no.4
• /
• pp.175-182
• /
• 2004

When the M-ary signal experiences the Rayleigh fading, the diversity schemes can reduce the effect of fading since the probability that all the signals components will fade simultaneously is reduced considerably. The symbol error probabilities for various M-ary signals, such as MDPSK(M-ary DPSK) and MPSK(M-ary PSK), are mathematically derived for the Selection Combining 2(SC-2) and Selection Combining 3(SC-3) demodulation system which requires a less complex receiver than Maximum Ratio Combining(MRC). The propagation model used in this paper is the frequency-nonselective slow Rayleigh fading channel corrupted by the Additive White Gaussian Noise(AWGN). The numerical results presented in this paper are expected to provide information for the design of radio system using M-ary modulation method for above mentioned channel environment.

• Korean Journal of Environment and Ecology
• /
• v.14 no.2
• /
• pp.119-126
• /
• 2000

충남 사문암 지역인 광천, 홍성, 백동, 대흥 및 유구지역의 토양, 식물체(참억새, 쑥, 리기다소나무) 및 지표수, 갱내수의 중금속 함량을 분석한 결과 사문암 토양의 Ni, Cr 및 Co 원소가 변성암 토양에 비하여 10~13배높았으며 이 원소들이 serpentine factor로 생각된다 사문암 지역간에는 이들원소의 차이가 뚜렷하지 않았다 변성암 토양식물에서보다 사문암 토양 식물에서 Ni, Cr, Co등이 높았다 리기다소나무의 원소 흡수량은 비교적 낮았고 3종 식물에서 대체로 뿌리의 원소 함량이 지상부 함량보다 높았으며 사문암 토양에서는 Ni, Cr, Co, Mo, Sc, As 및 Fe 원소들이 쑥보다 참억새에서 높았다 사문암 토양에서 생육하는 식물체 지상부의 생물학적 흡수계수는 Ni, Cr, Co, Zn, Sc, As 및 Fe 원소는 참억새에 높고Zn은 쑥에서 높았다,. 사문암 토양에서 뿌리로부터 지상부로의 원소 전이는 Ni, Cr, Co, Zn As 및 Fe 원소에 대해 쑥에서 높았고 Mo와 Sc 원소는 리기다소나무에서 높았다. 따라서 사문암 토양에서 참억새가 중금속의 흡수율은 높고 중금속에 대한 내성은 강할 것으로 사료된다 대흥지역에서 광산의 오염이 지표수 및 갱내수의 Ni. Cr, Co, Zn 및 Fe 등의 원소 농도를 높게 하였으며 비오염 계류는 오염계류의 원소 농도를 희석시켰다.

• KSBB Journal
• /
• v.19 no.6 s.89
• /
• pp.427-432
• /
• 2004

The purpose of this study is to investigate the feasibility of a cosolvent-modified supercritical $CO_2\;(scCO_2)$ extraction technique for the production of licorice extracts with high levels of glabridin. The effects of various parameters such as the type and amount of modifiers, extraction temperature ($40{\sim}80^{\circ}C$) and pressure ($10{\sim}50.0\;MPa$) on the extraction efficiency were examined at a fixed flow rate of 1 mL/min. The organic solvent extraction with pure methanol was also conducted for a quantitative comparison with the $scCO_2$ extraction. The recovery of glabridin from licorice was found to be extremely small for pure $scCO_2$. However, the addition of modifiers such as ethanol and acetone to $scCO_2$ resulted in a significant improvement in the recovery of glabridin. The recovery of glabridin was observed to increase with pressure at a constant temperature. Furthermore, the purity of the glabridin obtained from the $scCO_2$ extraction was higher compared with the organic solvent extraction.

• Journal of the Korean Ceramic Society
• /
• v.43 no.6 s.289
• /
• pp.369-375
• /
• 2006

[ $(Ba_{0.5}Sr_{0.5})_{0.99}Co_{x}Fe_{1-x}O_{3-{\delta}}$ ] [x=0.8, 0.2](BSCF) powders were synthesized by a Glycine-Nitrate Process (GNP) and the electrochemical performance of the BSCF cathode on a scandia stabilized zirconia, $[(Sc_{2}O_3)_{0.11}(ZrO_2)_{0.89}]-1Al_{2}O_3$ was investigated. In order to prevent unfavorable solid-state reactions between the cathode and zirconia electrolyte, a GDC ($Gd_{0.1}Ce_{0.9}O_{2-{delta}}$) buffer layer was applied on ScSZ. The BSCF (x = 0.8) cathode formed on GDC(Buffer)/ScSZ(Disk) showed poor electrochemical property, because the BSCF cathode layer peeled off after the heat-treatment. On the other hand, there were no delamination or peel off between the BSCF and GDC buffer layer, and the BSCF (x = 0.2) cathode exhibited fairly good electrochemical performances. It was considered that the observed phenomenon was associated with the thermal expansion mismatch between the cathode and buffer layer. The ohmic resistance of the double layer cathode was slightly lower than that of the single layer BSCF cathode due to the incorporation of platinum particle into the BSCF second layer.

• Journal of the Korean Ceramic Society
• /
• v.45 no.12
• /
• pp.760-765
• /
• 2008

In this study, the effects of small amounts (${\leq}3\;mol%$) of Li doping on the sintering characteristics and electrochemical performance of $(ZrO_2)_{0.89}(ScO_{1.5})_{0.1}(CeO_2)_{0.01}$ (ScSZ) were investigated. By adding 3 mol% lithium, the densification temperature of ScSZ was reduced from the conventional temperature of $1400^{\circ}C$ to $1200^{\circ}C$. It was found that Li doping also led to changes in the Zr:Sc ratio at the grain boundaries. Correspondingly, the dispersion of lithium zirconia at the grain boundaries accelerated the growth of ScSZ grains and increased the grain boundary resistance at temperatures below $450^{\circ}C$. At elevated temperatures of $450{\sim}750^{\circ}C$, the electrical conductivity of the ScSZ after doping remained almost unchanged under air and reducing atmospheres. These results suggest that the addition of lithium is promising for use in low temperature co-firing of ScSZ-based components for intermediate temperature solid oxide fuel cells.

• BMB Reports
• /
• v.42 no.11
• /
• pp.731-736
• /
• 2009

The generation of functional recombinant antibodies from hybridomas is necessary for antibody engineering. However, this is not easily accomplished due to high levels of aberrant heavy and light chain mRNAs, which require a highly selective technology that has proven complicated and difficult to operate. Herein, we attempt to use an alkaline phosphate (AP)-fused form of single-chain variable fragment (scFv) for the simple identification of a hybridoma-derived, functional recombinant antibody. As a representative example, we cloned the scFv gene from a hybridoma-producing mouse IgG against branched-chain keto acid dehydrogenase complex-E2 (BCKD-E2) into an expression vector containing an in-frame phoA gene. Functional recombinant antibodies were easily identified by conventional enzyme-linked immunosorbent assay (ELISA) by employing scFv-AP fusion protein, which also readily serves as a valuable immuno-detective reagent.