• 콘크리트학회지
• /
• 제8권6호
• /
• pp.163-172
• /
• 1996

최근 많은 양의 폐타이어가 발생됨에 따라 사회적 문제로 대두되고 있는 실정이며, 이에 대한 재활용은 각 분야에서 활발하게 연구되고 있다. 건설 분야에서는 폐타이어를 냉각 분쇄하여 만든 분말을 시멘트 콘크리트에 혼입하여 사용하는 연구가 많이 수행되고 있다. 시멘트 콘크리트에 폐타이어 분말을 혼입하여 사용할 때는 폐타이어 분말과 시멘트경화체 사이에서 접착성의 문제로 기초적 성질이 저감된다. 본 연구에서는 시멘트 모르터 내부에서 폐타이어 분말의 접착력을 증진시키기 위하여 시멘트 혼화용 폴리머 중의 하나인 스티렌 부타디엔 고무(SBR)라텍스를 사용하여 기초적 성질을 개선하고자 하였다. 실험결과 SBR 코팅 폐타이어 분말을 혼입한 시멘트 모르터는 코팅하지 않은 폐타이어 분말을 사용한 경우보다 기초적 성질이 개선되는 것으로 나타났으며, 또한 폴리머 시멘트비 10%를 사용한 SBR 라텍스 혼입 폴리머 시멘트 모르터의 경우에도 기초적 성질이 개선되었다.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 1996년도 가을 학술발표회 논문집
• /
• pp.51-57
• /
• 1996

The purpose of this study is to improve the properties by increasing of the adhesion strength of styrene-butadiene rubber(SBR) latex coated powdered rubber in cement mortar. SBR-modified mortar using powdered rubber is also tested as the same method. From the test results, the cement mortar using SBR latex coated powdered rubber have a good mechanical properties compared with that using uncoated powdered rubber. The mechanical properties of SBR-modified mortar using powdered rubber with polymer-cement ratios of 10% are also improved.

• 공업화학
• /
• 제29권4호
• /
• pp.399-404
• /
• 2018

타이어 트레드 컴파운드와 천연 및 합성 고무 접착제 종류에 따른 가황 전/후의 점착력과 접착력 차이를 비교하였다. 가황 전 점착력은 모든 트레드에서 천연고무 시멘트가 가장 강하고, 시간의 경과에 따른 점착력 감소도 천연고무 시멘트가 합성고무 시멘트보다 낮았다. 가황 전 점착력은 시멘트에 사용된 고무의 유리전이온도에 영향을 받았으며, 천연고무가 합성고무에 비해 시간의 경과에 따른 점착력 감소도 적었다. 가황 후 접착력은 천연고무 시멘트가 천연고무가 주성분인 트레드에 강하게 접착하지만 합성고무가 주성분인 트레드에는 약하게 접착했다. 반면 유화중합 SBR, 용액중합 SBR 시멘트는 모든 트레드 컴파운드에 강하게 접착하였고, 시멘트 고무의 가황 속도가 느릴수록 강한 접착력을 보였다.

• 미생물학회지
• /
• 제12권3호
• /
• pp.147-148
• /
• 1974

A small amount of Duco cement or Elmer's clear cement was dropped on a slide glass and immediately spread with a glass rod or woden stick a thin film on the surface. After approximately 1 minute a small amount of rubber cement was spread on the top of the film of Duco cement using the same method as described earlier. It was important that the rubber cement be smeared before the Duco cement dried out. These two kinds of cements must not be mixed. It was better to make the film of the rubber cement slightly thicker than the film of Duco cement. This composite film may be used up to several months after preparation. The sample leaf was placted on the slide, prepared with adhesive and the leaf surface was passed on the film with the thumb. The pressing was done so the leaf surface was completely in contact with the film. Then the leaf was peeled from the slide.

• Computers and Concrete
• /
• 제11권1호
• /
• pp.63-73
• /
• 2013

In this study, the effect of reducing cement by proportional addition of waste powder rubber on the performance of concrete under impact three-point bending loading were investigated experimentally and numerically. Concrete specimens were prepared by adding 5%, 10% and 20 % of rubber powder as filler to the mix and decreasing the same percentage of cement. For each case, three beams of $50mm{\times}100mm{\times}500mm$ were loaded to failure in a drop-weight impact machine by subjecting them to 20 N weight from 300mm height, while another three similar beams were tested under static load. The bending load-displacement behavior was analyzed for the plain and rubberized specimens, under static and impact loads. A three dimensional finite-element method simulation was also performed by using LUSAS V.14 in order to study the impact load-displacement behavior, and the predictions were validated with the experimental results. It was observed that, despite decreasing the cement content, the proportional addition of powder rubber until 10% could yield enhancements in impact tup, inertial load and bending load.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 1991년도 가을 학술발표회 논문집
• /
• pp.99-106
• /
• 1991

Result of an experimental study on the manufacture, the mechanical properties and waterightness of pitch-based carbon fiber reinforced fly ash.cement composites are presented in this paper. The carbon fiber reinforced fly ash.cement composites using early strength cement, silica powder and a small amount of stylene butadiene rubber latex are prepared with carbon fiber, foaming agents and mixing conditions. As a result, the mechanical and plysical properties such as compresive, tensile and flectural strengths, watertightness and cement composites are improved by using a small amount of stylene butadiene rubber latex.

• Advances in concrete construction
• /
• 제11권5호
• /
• pp.409-417
• /
• 2021

The incorporation of non-biodegradable tyre waste in cement-based material has gained more interest towards sustainable construction these days. Crumb rubber (CR) from waste tyre is an alternative for sand replacement in low strength applications. Many researchers have studied CR cement-based materials produced by normal mixing (NM) method and reported a significant decrease in compressive strength due to CR. To compensate this strength loss, this research aims to study the innovative incorporation of CR in cement composite via the preplaced mixing (PM) method. In this investigation, cement composite was produced with NM and PM methods by replacing sand with 0%, 50%, and 100% CR by volume. The test results showed no significant difference in terms of densities of cement composite prepared with both mixing methods. However, cement composite prepared with PM method had lower strength reduction (about 10%) and lowered drying shrinkage (about 20%). In addition, the sound absorption coefficient and noise reduction coefficient of CR cement composite prepared by PM method were in similar range as those prepared with NM method. Overall, the results demonstrate that the PM method is promising, and the maximum replacement level of 50% is recommended for CR in the cement composite.

• 공업화학
• /
• 제5권5호
• /
• pp.786-794
• /
• 1994

폴리머-시멘트 모르타르의 강도와 내구성에 대하여 검토하였다. 폴리머-혼화제로서 styrene-butadiene rubber(SBR) 라텍스, ethylene-vinyl acetate(EVA) 에멀젼 및 polyacrylic ester(PAE) 에멀젼을 사용하고, 폴린머-시멘트 비를 다양하게 변화시켜(5, 10, 15, 20 wt%) 공시체를 제작하였다. 내구성의 평가시험으로는 동결융해시험, 내산성시험 및 내열성 시험을 수행하였다. 폴리머-시멘트 모르타르의 내동해성은 폴리머-시멘트비가 증가될수록 현저히 향상되었으나 내산성과 내열성은 저하되었다. SBR 폴리머-시멘트 모르타르의 강도(압축 및 휨강도)는 폴리머-시멘트비가 증가될수록 향상되었으나 EVA 및 PAE 폴리머-시멘트 모르타르는 폴리머-시멘트비 10wt%에서 최대치를 나타내었다.

• Advances in concrete construction
• /
• 제4권1호
• /
• pp.49-69
• /
• 2016

This work investigates the mechanical properties of conventional concrete (CC) and self compacting concrete (SCC) using fine rubber and silpozz were accompanied by a comparative study between conventional rubberized concrete (CRC) and self compacting rubberized concrete (SCRC). Fine rubber (FR) from scrap tires has replaced the fine aggregate (FA) and Silpozz has been used as a replacement of cement at the proportions of 5, 10 and 15%. Silpozz as a partial replacement of cement in addition of superplasticiser (SP) increases the strength of concrete. Fresh concrete properties such as slump test, compaction factor test for CRC, whereas for SCRC slump flow, $T_{500}$, V-funnel, L-box, U-box, J-ring tests were conducted along with the hardened properties tests like compressive, split tensile and flexural strength test at 7, 28 and 90 days of curing. The durability and microstructural behavior for both CRC and SCRC were investigated. FR used in the present study is 4.75 mm passing with fineness modulus 4.74.M30 grade concrete is used with a mix proportion of 1:1.44:2.91 and w/c ratio as 0.43. The results indicate that as FR quantity increases, workability of both CRC and SCRC decreases. The results also show that the replacement of natural fine aggregate (NFA) with FR particles decreases the compressive strength with the increase of flexural strength observed upto 5% replacement of FR. Also replacement of cement with silpozz resulted enhancement of strength in SCRC.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 1999년도 학회창립 10주년 기념 1999년도 가을 학술발표회 논문집
• /
• pp.319-322
• /
• 1999

The adhesion properties of polymer cement mortars for cement concrete repair were evaluated with respect to polymer-cement ratios and the surface conditions of cement concrete substrate. Styrene-butadiene rubber (SBR) was used as an additive for polymer cement mortars. The adhesion strength of cement mortar was smaller than that of polymer cement mortar. The adhesion strengths to the dry surfaces of substrate were larger than those to the wet surfaces, indicating that the dryness of substrate increased the adhesion strength in repairing concrete structures.