• Geomechanics and Engineering
• /
• v.9 no.3
• /
• pp.329-344
• /
• 2015

Cratering tests in rock are generally carried out to identify its fragmentation characteristics. The test results can be used to estimate the minimum amount of explosives required for the target volume of rock fragmentation. However, it is not easy to perform this type of test due to its high cost and difficulty in securing the test site with the same ground conditions as the site where blasting is to be performed. Consequently, this study investigates the characteristics of rock fragmentation by using the hydrocode in the platform of AUTODYN. The effectiveness of the numerical models adopted are validated against several cratering test results available in the literature, and the effects of rock mass classification and ground formation on crater size are examined. The numerical analysis shows that the dimension of a crater is increased with a decrease in rock quality, and the formation of a crater is highly dependent on a rock of lowest quality in the case of mixed ground. It is expected that the results of the present study can also be applied to the estimation of the level and extent of the damage induced by blasting in concrete structures.

• The Journal of the Petrological Society of Korea
• /
• v.5 no.1
• /
• pp.21-34
• /
• 1996

Contact-metamorphosed calc-silicate hornfels of the Hwanggangni formation adjacent to Daeyasan granite in Goesan are characterized by the mineral assemblages. tremolite-clinozoisite-alkali feldspar-calcite, diopside-grossular-vesuvianite, and wollastonite-diopside-phlogopite-grossular-vesuvianite, indicating low $X_{CO_2}$ condition during contact metamorphism. Two trends of fluid-rock interactions are recognized; combination of infiltration and buffering in the outer portion of the aureole and fluid-dominated behavior in the most part of the aureole. Modal abundance of diopside produced during metamorphism was measured in order to estimate fluid/rock ratios and permeabilities with the assumption that equivalent volume of fluids estimated from the fluid/rock ratios flow through the rock body. The calculated fluid/rock rations and permeabilities range from 0.6 to 9 and $10^{-19}$ to $10^{-17}$ meabilities in the calc-silicate hosted contact aureoles and expected values during progressive metamorphism by theories.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.11 no.5
• /
• pp.588-597
• /
• 1999

Sokkuram grotto, a UNESCO cultural heritage in Kyongju Korea, was originally covered with crushed rocks over its dome with ventilating holes. The grotto was perfectly preserved for more than 12 centuries until the upper structure was replaced with a concrete dome in the early 20th century to protect from total collapse. Since then, heavy dew formed on the granite surface to seriously damage the sculptures until it was further remodeled with air-conditioning facilities in the 60s. It is considered that the original upper porous structure had a dehumidifying capability. This research is made to unveil the dehumidifying mechanism of the rock layer during the rainy season in that area. A rock layer and a concrete layer are tested in a temperature/humidity-controlled room. No dew formation is observed for the two specimen for continued sunny days or continued rainy days. However, heavy dew formed on the concrete surface for a sunny day after long rainy days. It is thought that the sun evaporates water on the ground and dew is formed at the surface as the highly humid air touches the yet cold concrete. On the contrary, no dew formation is observed for the rock layer at any time. Even in the above worst situation, air flows downward through the cool rock layer and moisture is removed before reaching inside. Temperature measurement, flow visualization, observation of dew formation and measurement of air velocity are made to verify the mechanisms.

• Geomechanics and Engineering
• /
• v.23 no.2
• /
• pp.127-137
• /
• 2020

To study the reverse fault formation process and the stress evolution feature, a simulation test system of reverse fault formation is developed based on the analysis of reverse fault formation mechanism. The system mainly consists of simulation laboratory module, operation console and horizontal loading control system, and data monitoring system. It can represent the fault formation process, induce fault crack initiation and simulate faults of different throws. Simulation tests on reverse fault formation process are conducted by using the simulation test system: horizontal loading is added to one side of the model. the bottom rock layer cracks under the effect of the induction device. The crack dip angle is about 29°. A reverse fault is formed with the expansion of the crack dip angle towards the upper right along the fracture surface and the slippage of the hanging wall over the foot wall. Its formation process unfolds five stages: compressive deformation of rock, local crack initiation, reverse fault penetration, slippage of the hanging wall over the foot wall and compaction of fault plane. There is residual structural stress inside rock after fault formation. The study methods and results have guiding and referential significance for further study on reverse fault formation mechanism and rock stress evolution.

• The Journal of Engineering Geology
• /
• v.2 no.2
• /
• pp.173-200
• /
• 1992

The quality of groundwater in the central part of Taegu City is influenced by upstreams of Sin-stream and Beomeo-stream because the stream waters are main source of the groundwater, and chemical composition of the upstream waters has close relationship with andesite and monzonite in the igneous rock terrain. The pH of upstreams are weak acid ~ neutral in the igneous rock area and weak alkaline in the sedimentary rock area. Contents of $Ca^{2+}$ and $Mg^{2+}$ in the streams are apparently high, and $Na^{+}$ content is only slightly high in the sedimentary rock area. But $K^{+}$ content is lower in the Panyaweol formation area than in the monzonite area. The contents of heavy metals and $N0_3^{-}$ are also higher in the sedimentary rock area of residential sections and industrial complexes than those in the igneous rock area. The groundwater is contaminated in comparison to the upstream water of the igneous rock areas, and there are some differences in pollution level between the Panyaweol formation area of residential sections and the Haman formation area of industrial complexes. K, Na, Ca, Mg, Cl, $SO_4$ and $NO_3$ contents in the Haman formation area are relatively higher than those in the Panyaweol formation area. But pH is nearly equal in the two areas. The content of heavy metal ions is still lower than the drinking water standard of Korea and only slightly differs in the two sedimentary rock areas. But the groundwater in the Haman formation area is considerably contaminated by Kongdanstream and Dalseo-stream.

• Journal of the Korean earth science society
• /
• v.36 no.6
• /
• pp.543-552
• /
• 2015

This study examines the processes of rock weathering and tafoni formation targeting tafoni at Mt. Cheonsaeng, Gumi-si, Gyeongsangbuk-do. In the study area, a frequency of tafoni is high in conglomerate and conglomeratic sandstone among regional sedimentary rocks, which means that an initial stage of the formation begins a breakaway of gravel from bedrock and also exfoliation from rock surface. Geomorphologically tafoni have intensively been developed at the southfacing slope with exposed rocks, which means that its formation was favorably controlled by environmental conditions including strong influences of mechanical weathering in winter and chemical weathering in summer times. The results of measuring water content at a tafoni-bearing rock surface using GIS interpolation analysis indicate that moisture rate in/around tafoni is higher than the periphery. Thus, it is considered that moisture distribution at a rock surface plays a role in its formation. Analysis of percipitation and secondary minerals induced by chemical weathering is in progress.

• Structural Engineering and Mechanics
• /
• v.68 no.1
• /
• pp.95-101
• /
• 2018

The low rate of penetration and short lifetime of drilling bit served as the most common problems encountered in hard formation drilling, thus leading to severe restriction of drilling efficiency in oil and gas reservoir. This study developed a new local impact drilling method to enhance hard formation drilling efficiency. The limitation length formulas of radial/lateral cracks under static indentation and dynamic impact are derived based on the experimental research of Marshall D.B considering the mud column pressure and confining pressure. The local impact rock breaking simulation model is conducted to investigate its ROP raising effect. The results demonstrate that the length of radial/lateral cracks will increase as the decrease of mud pressure and confining pressure, and the local impact can result in a damage zone round the impact crater which helps the rock cutting, thus leading to the ROP increase. The numerical results also demonstrate the advantages of local impact method for raising ROP and the vibration reduction of bit in hard formation drilling. This study has shown that the local impact method can help raising the ROP and vibration reduction of bit, and it may be applied in drilling engineering.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2002.03a
• /
• pp.253-260
• /
• 2002

Chemical weathering processes related with mineralogical characters and ground water condition are very essential engineering problems in soluble rock masses. Detailed geological mapping were performed and 8 samples were collected from the 2 formations including various rock faces to deduce the possibility of the limestone cavity formation and their mechanism. Petrological descriptions and various petro-mineralogical experiments such as XRD analysis, clay mineral analysis, absorptivity test, impurity analysis were conducted to evaluate the cavity making processes. Laboratory solubility test for rock specimen were also carried out under the strong acid (pH=1) condition. From the experimental data and geological mapping data, it is found that the formation of limestone cavities in limestones are strongly related with geological structures such as beddings, cleavages and the contents of impurities rather than CaCO$_3$contents. In case of dolomites, rock textures, grain size, amounts and types of clay minerals as well as geological structures are major controlling factors of cavity forming processes

• Tunnel and Underground Space
• /
• v.16 no.1 s.60
• /
• pp.38-49
• /
• 2006

LNG storage in lined rock cavern demands various techniques concerned with rock mechanics, thermo-mechanics and hydrogeology in design, construction and maintenance stage. LNG pilot cavern was constructed in Daejeon in order to verify these techniques. In this paper, evaluation of drainage system and ice ring formation was studied by numerical simulation. By Modflow analysis in the viewpoint of aquifer and Seep/W analysis in the viewpoint of flow system, it was verified that the drainage system in the pilot cavern was efficiently operated. Since ice ring formation can be simulated by interactive relation between heat transfer and water flow, coupled analysis of those was performed. In this analysis, the position of ice ring was presumed and it was demonstrated that the formation is affected by velocity and direction of groundwater flow.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2009.03a
• /
• pp.999-1008
• /
• 2009

A series of sedimentary rocks which are formed in the Tertiary are distributed around Samcheok(Samcheok-Pukpyoung basin), Younghae(Younghae basin), Pohang(Pohang basin), Gyeongju(Yangnam basin), Ulsan(Ulsan basin), Jeju(Seogyuipo formation) in the southern region of the Korean Peninsula. This study concerned with geological, geophysical, geotechnical properties of the unconsolidated rocks in the Pohang area. A consolidated rocks are classified as hard rock - soft rock - weathered rock - residual soil follows in degree of weathering. But unconsolidated rocks has soil properties as well as rock's at the same time. The results of field excursion, boring, borehole-logging, rock testing, geophysical survey, laboratory test are soft rock range, but the durability of the rock until the residual soil from the weathered rock. We accomplished the rock mass classification of the unconsolidated rocks.