• Journal of Institute of Control, Robotics and Systems
• /
• v.19 no.2
• /
• pp.102-106
• /
• 2013

A cooperative navigation method for cooperative flight of UAVs is proposed. The commonly used navigation method for UAVs is based on GNSS measurements. However, when it is not available by jamming or other causes, an alternative method is needed. In this paper, it is shown that UAVs equipped with inertial sensors, passive sensor and wireless communication link can perform accurate navigation through sharing information with each other. Firstly, the appropriate roles for sensors and wireless communication link are assigned. Secondly, a filter to perform navigation cooperative is constructed. Finally, the boundedness of estimation error of the filter under small initial estimation error is analyzed. The simulation results show that the proposed method can reduce navigation errors effectively.

• Journal of Institute of Control, Robotics and Systems
• /
• v.21 no.2
• /
• pp.102-107
• /
• 2015

In this paper, we propose a technique of drowsiness detection using a histogram for vehicle safety. The drowsiness of vehicle drivers is often the main cause of many vehicle accidents. Therefore, the checking of eye images in order to detect the drowsiness status of a driver is very important for preventing accidents. In our suggested method, we analyse the changes of a histogram of eye region images which are acquired using a CCD camera. We develop a drowsiness detection system using this histogram change information. The experimental results show that the proposed method enhances the accuracy of detecting drowsiness to nearly 97%, and can be used to prevent accidents due to driver drowsiness.

• Journal of Institute of Control, Robotics and Systems
• /
• v.22 no.5
• /
• pp.361-366
• /
• 2016

In this paper, we propose a technique for drowsiness detection using the histogram and edge information of eyes. The drowsiness of vehicle drivers is the main cause of many vehicle accidents. Therefore, the checking of eye images in order to detect the drowsiness status of a driver is very important for preventing accidents. In our suggested method, we analyze the changes of the histograms and edges of eye region images, which are acquired using a CCD camera. The experimental results show that our proposed method enhances the accuracy of detecting drowsiness to nearly 99%, and can be used for preventing vehicle accidents caused by the driver's drowsiness.

• Journal of Institute of Control, Robotics and Systems
• /
• v.6 no.4
• /
• pp.247-253
• /
• 2000

In this paper, we deal with the full range control problem of nonlinear boiler systems subject to complex actuator constraints. Firstly, $H\infty$ loop shaping design procedure［10］ is used for the controller design. Secondly, modified high-gain feedback［11］ for the loop shaping controller is adopted for the anti-windup function and the bumpless transfer technique between controllers is proposed for the full range control of nonlinear systems. Finally, the performance of the proposed controller is demonstrated through the simulation studies.

• Journal of Institute of Control, Robotics and Systems
• /
• v.6 no.4
• /
• pp.254-260
• /
• 2000

This paper deals with the development of fault tolerant control for a nonlinear boiler system with noise and disturbance. The MCMBPC(Multivariable Constrained Model Based Predictive Control) is adopted for the control of the specific boiler turbin model. The fault detection and diagnosis are accomplished with the Kalman filter and two bias estimators. Once a fault is detected, two Bias estimators are driven to estimate the fault and to discriminate Process fault and sensor fault. In this paper, a fault tolerant control scheme combining MCMBPC with a fault compensation method based on the bias estimator is proposed. The proposed scheme has been applied to the nonlinear boiler system and shown a satisfactory performance through some simulations.

• Journal of Institute of Control, Robotics and Systems
• /
• v.4 no.1
• /
• pp.32-37
• /
• 1998

This paper deals with the implementation of a robust multivariable controller using DSP board and the application to real systems. The LQG/LTR (Linear Quadratic Gaussian with Loop Transfer Recovery) controller proposed by Doyle et al.[1,2] is adopted to design the control system. A helicopter propeller setup is taken as the controlled system in the current paper, and the mathematical model is derived to design the multivariable controller. The performance of the controller is evaluated via simulations, and implementation and application to the MIMO system shows that the control performances are satisfactory and superior to those of the PID controller.

• Journal of Institute of Control, Robotics and Systems
• /
• v.17 no.12
• /
• pp.1210-1218
• /
• 2011

GA (Genetic Algorithms) are efficient for searching for global optima but may have some problems such as premature convergence, convergence to local extremum and divergence. These phenomena are related to the evolutionary operators. As population diversity converges to low value, the search ability of a GA decreases and premature convergence or converging to local extremum may occur but population diversity converges to high value, then genetic algorithm may diverge. To guarantee that genetic algorithms converge to the global optima, the genetic operators should be chosen properly. In this paper, we analyze the effects of the selection operator, crossover operator, and mutation operator on convergence properties, and propose the sweeping method of mutation probability and elitist propagation rate to maintain the diversity of the GA's population for getting out of the premature convergence. Results of simulation studies verify the feasibility of using these sweeping operators to avoid premature convergence and convergence to local extrema.

• Journal of Institute of Control, Robotics and Systems
• /
• v.19 no.11
• /
• pp.974-978
• /
• 2013

AVI (Automatic Vision Inspection) systems automatically detect defect features and measure their sizes via camera vision. AVI systems usually report different measurements on the same defect with some variations on position or rotation mainly because different images are provided. This is caused by possible variations from the image acquisition process including optical factors, nonuniform illumination, random noises, and so on. For this reason, conventional area based defect measuring methods have problems of robustness and consistency. In this paper, we propose a new defect size measuring method to overcome this problem, utilizing volume information that is completely ignored in the area based defect measuring method. The results show that our proposed method dramatically improves the robustness and consistency of defect size measurement.

• Journal of Institute of Control, Robotics and Systems
• /
• v.19 no.12
• /
• pp.1094-1098
• /
• 2013

AVI (Automatic Vision Inspection) systems automatically detect defect features and measure their sizes via camera vision. Defect detection is not an easy process because of noises from various sources and optical distortion. In this paper the acquired images from a TFT panel are enhanced with the adoption of an HVS (Human Visual System). A human visual system is more sensitive on the defect area than the illumination components because it has greater sensitivity to variations of intensity. In this paper we modified an MTF (Modulation Transfer Function) in the Wavelet domain and utilized the characteristics of an HVS. The proposed algorithm flattens the inner illumination components while preserving the defect information intact.

• Journal of Institute of Control, Robotics and Systems
• /
• v.18 no.3
• /
• pp.175-180
• /
• 2012

A nonlinear navigation filter for biomimetic robot using analytic approximation of mean and covariance of state variable is proposed. The approximations are performed at the time update step in the filter structure. The mean is approximated to the 3rd order of Taylor's series expansion of true mean and the covariance is approximated to the 3rd order either. The famous EKF is a nonlinear filtering method approximating the mean to 1st order and the covariance to the 3rd order. The UKF approximate them to the higher orders by numerical method. The proposed method derived a analytical approximation of them for navigation system and therefore don't need so called sigma point transformation in UKF. The simulation results show that the proposed method can be a good alternative of UKF in the systems which require less computational burden.