• Journal of Biosystems Engineering
• /
• v.4 no.2
• /
• pp.53-63
• /
• 1979

The knowlege of thermal properties of rough rice has become of greate importance to the analysis of heat and mass transfer phenomenon in rice drying and storage process. Some information is available on the thermal properties of rough rice in foreign countries but is not available for these properties in Korea. A fundamental study was made to determine the thermal conductivity and thermal diffusivity of rough rice with line source method and to select current and resistance suitable for these properties from investigating the effect of current and resistance of heating wire on the temperature rise. The result of this study may be summarized as follows ; 1. Even through the power per unit length of heating wires is about the same, the tendency of temperature rise showed a little difference among them , and the suitable range of it for thermal properties was found to be 3.56-5.37w/m. 2. the most desirable resistance and current of heating wire was 18.40 ohm/m, 0.44 amperes among three kinds of heating wires and currents, respectively. because it took 13 minutes or so for the heating wire to reach equilibrium temperature. 3. The thermal conductivity of rough rice was 0.120-0.130 w/m$ ^\circ C$. and thermal diffusivity of it was $5.8210 $\times10^{-8} -9.7529 $\times10^{-8} m^2 /s.$ 4.The thermal conductivity showed a little difference in variation with resistance of heating wire but the variation of current of heating wire at the same resistance did not affect the thermal conductivity , and the thermal diffusivity was not affected by the variation of resistance and current.

• Journal of Biosystems Engineering
• /
• v.12 no.1
• /
• pp.31-38
• /
• 1987

In order to improve the traditional post harvest system in Korea, a model for mechanized rice drying and storage system was developed and introduced as the first part of the study(Park, 1986). As the second part of the study, capital requirement and cost of the model system was analyzed. Also, optimum size of the model system was estimated by comparing with the traditional harvest system. From the study, the following results can be concluded: 1. The capital requirement of the model system decreases as the model size increases. For example, a model system having 500 ton storage capacity requires 439,000 Won/ton. However it requires 313,200 Won/ton only, if the model size increases to 1000 ton. 2. Also, total cost of the model system decreases as the model size increases. For example, total costs of the model system having 500 ton and 1000 ton storage capacity are 101,208 Won/ton and 69,320 Won/ton, respectively. 3. The breakeven point (optimum size) of the model can be estimated around 630 ton storage capacity if the operation rate is assumed as 100%. However, the optimum size of the model is 710 ton, if the operation rate it assumed 80%.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.55 no.4
• /
• pp.339-349
• /
• 2010

The uses of the polypropylene bulk bags having the loading capacities more than 500 kg are increasing in Korea recently as a storage container for rough rice. This study was performed to obtain the basic information on the changes of temperature and relative humidity in the bulk-bag-stored high moisture rough rice during waiting for drying. At the moisture content more than 22% on wet weight basis of paddy, the bulk-bag inside temperature rose up to more than $40^{\circ}C$ and then slid down during storage. For example, in case of Hwaseongbyeo, 26.5% moisture content of rough rice (MCRR) harvested at 46 days after heading (DAH) showed $54.5^{\circ}C$ of peak temperature at 66.8 hours after bulk-bag loading, 22.5% MCRR harvested at 52 DAH exhibited $42.0^{\circ}C$ at 81.1 hours, and 19.7% MCRR harvested at 55 DAH displayed $38.9^{\circ}C$ at 119.0 hours. There were a good linear relationship between peak temperatures of bulk-bag inside and moisture contents of paddy ($r^2$=0.89 in 2005, and 0.87 in 2006), while the slope and intercept of the linear regression equation was affected by the environmental conditions such as ambient temperatures and microbial flora. The peak temperatures increased with the rate of about $2.74-3.33^{\circ}C$ per every 1% increase of moisture content at higher moisture contents of paddy than 19%. The relative humidity varied depending on bulk-bag inside temperature and rough rice moisture content, and showed the range of 94.2% to 99.9% in the central point of the bulk-bag. The results suggested that a rapid drying treatment as soon as possible was needed to produce a good quality of rice when the paddy of high moisture more than 22% on wet basis was harvested in a bulk-bag especially at high ambient temperature.

• Culinary science and hospitality research
• /
• v.21 no.1
• /
• pp.77-89
• /
• 2015

The objective of this study was to optimize processing conditions for the production of an instant puffed rice product using response surface methodology (RSM) and contour analysis. Sensory and texture qualities, and physical properties of the puffed rice were analyzed with various processing conditions related to drying and puffing temperature, and moisture content. Preference, color intensity, cohesiveness, rehydration ratio, density and lightness of the puffed rice product significantly varied depending on the processing conditions. The responses showed high $R^2$ values (0.623, 0.852, 0.735, 0.688, and 0.790) and lack-of-fit. Rehydration ratio was found to have a negative correlation with density in the condition of drying and puffing temperature. Lightness and preference scores of the puffed rice increased as the moisture content increased. According to RSM, the preference scores were very highly related to the moisture content, and the optimum processing conditions of the puffed rice product were at $40^{\circ}C$ of drying temperature, with 11.0% of moisture content, and at $232.7^{\circ}C$ of puffing temperature.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.12
• /
• pp.55-62
• /
• 1972

In order to study the biolgiocal effects of dry back following EMS (Ethyl methane sulfonate) treatment on seeds of 'Dunghan Shali' that belongs to indica-type rice with various presoaking(24, 36, and 40 hrs respectivily) and treatment time(l, 2 and 3 hrs respectivily), this experiment was done. Seedling heights of wet seeds presoaked for 36 hrs was only greatly decreased with EMS treatment compared with other periods. In germination rate of wet seeds, all of these damage was not changed. For the drying back seeds, otherwise, seedling height and germination rate were greatly reduced depend upon the time of treatment and presoaking as well as storage effects after drying back. Reduction patterns, both seedling height and germination rate, between 1 week and 8 weeks after dry back were quite similar. The other experiment was carried out in order to study for the influences on the seedling growth as biological damage with EMS and MMS(Methyl methane sulfonate) treatments among different varieties. The indica-type rice varieties; Taichung Native No.1, Dunghan Shali and IR-8, were used as the experimental materials. From this trial some results were obtained as follows; 1. Both seedling growth and germination rate on all varieties, used, MMS, treatment showed more toxic effects than those of EMS treatment. 2. Seeding growth injury of rice seeds dried back was increased gradually, and then was approached the maximum at 6-8 days after storing. In IR-s variety, otherwise, growth damage was appeared a little. Germination rate of these were quite smilar, even though chemical used is different and storage period was prolonged. 3. It was showed clearly that varietal differences of chemical mutagene treatments were recognized.

• Korean Journal of Food Science and Technology
• /
• v.27 no.5
• /
• pp.680-689
• /
• 1995

Rice based infant foods of carrot, of beef, and of egg for 4-6 month old infants were prepared using freeze drying (FD) process. The optimum moisture content prior to FD and the plate temperature in the drier were determined with the use of response surface methodology. For all the infant foods under this study, FD time was longer as the initial moisture content was higher and the plate temperature was lower. Brittleness of the dried infant foods increased as the moisture content decreased and the plate temperature increased. Among the sensory attributes, hydration rate, uniformity, and smoothness were greater with increased moisture content and with decreased plate temperature. Ease to spoon increased as moisture content increased and mouthcoating increased as both the moisture content and the plate temperature increased. Optimum moisture content and plate temperature for the FD of carrot, beef and egg foods were 88.5% and $34^{\circ}C$, 88.5% and $28^{\circ}C$, and 87.3% and $39^{\circ}C$, respectively.

• Journal of Biosystems Engineering
• /
• v.12 no.2
• /
• pp.38-43
• /
• 1987

An experimental study was conducted to develop a thin-layer rewetting equation of short grain rough rice of Akihikari variety. Four thin-layer rewetting equations were experimentally determined from $25^{\circ}C$ to $45^{\circ}C$ and 70%RH to 85%RH conditions. Diffusion, Henderson, Page, and Thompson equations widely used as thin-layer drying equations were selected. Experimental data were fitted to these equations using linear regression analysis except diffusion equation. The diffusivity in the diffusion equation was determined by optimization method. Four equations were highly significant. In order to compare the goodness of fit of each equation, the error mean square of each equawas calculated. The diffusion model was not a very good model because the error mean square was very large. The other three models showed the same level or error mean square and could predict satisfactorily the rewetting rate or short grain rough rice.

• Proceedings of the Korean Society for Agricultural Machinery Conference
• /
• 2003.02a
• /
• pp.112-117
• /
• 2003

우리나라의 미곡종합처리장(Rice Processing Complex, RPC)은 1991년 시범사업으로 2개소가 설치된 이래 2002년 말 현재 328개소가 설치 운영되고 있다. 현재 RPC는 벼의 수확 후 처리공정을 일관화 한 시설일 뿐만 아니라 쌀 유통의 중심시설로 성장하였다. RPC의 건조시설은 대부분이 열풍건조와 상온통풍건조를 조합하여 사용할 수 있도록 설계되어 있다. 열풍건조에는 순환식건조기와 연속식건조기가 이용되고 있으며, 상온통풍건조에는 원형철제빈(사일로)이 주로 이용되고 있으며 일부 사각빈이 이용된다. 원형철제빈은 벼의 건조와 저장을 겸용하고 있다. (중략)

• Korean Journal of Food Science and Technology
• /
• v.30 no.1
• /
• pp.77-81
• /
• 1998

Rice germ oils were extracted from common and dried rice germ $(80^{\circ}C,\;6\;hr)$, and their oxidative stabilities were evaluated by measuring acid value, peroxide value and fatty acid composition during storage at $40^{\circ}C\;and\;60^{\circ}C$. The acid values of all lipids were slightly changed during storage, but peroxide values (POV) were greatly dependent on storage temperature. The POVs of the dried germ oil and the refined rice bran oil were 146.2 meq/kg and 15.1 meq/kg, respectively after 31 days storage at $40^{\circ}C$. However after 24 days of storage at $60^{\circ}C$, the POVs of the dried germ oil and the refined rice bran oil were 151.7 meq/kg oil and 219.6 meq/kg oil, respectively. Major fatty acids were linoleic (39.8%) and oleic acid (34.7%) in rice germ oil, and oleic (40.1%) and linoleic acid (38.1%) in rice bran oil. The major fatty acid compositions were not greatly influenced by drying and storage temperature but linoleic acid decreased about half during storage.

• Korean Journal of Food Science and Technology
• /
• v.33 no.1
• /
• pp.55-59
• /
• 2001

Pressure-puffing system or extruder has been used to puff rice kernel or rice flour. Most of the study on rice puffing were the effect of process conditions such as moisture content and heating temperature on physical and chemical characteristics of popped rice. The study on mechanism and development of instant puffed rice like popcorn has been limited. Extruded waxy rice pellets were puffed in a microwave oven after drying and conditioning. Extruded pellets were formed with extrusion conditions of $20{\sim}27%$ moisture content, 2.76 MPa $CO_2$ gas injection pressure and 200 rpm screw speed. Under these conditions, puffed waxy rice pellets in microwave oven had low density and soft texture. Density and texture of puffed waxy rice pellet could be optimized by control of moisture content, $CO_2$ gas injection pressure and screw speed that affect significantly when puffing extruded waxy rice pellet.