• Journal of the Korean Society of Environmental Restoration Technology
• /
• v.8 no.1
• /
• pp.100-107
• /
• 2005

As a result of this study, vitality of natural monuments (large trees) looks relatively good but they require continuous management. Also, the management for condition recovery and condition maintenance, and minimum measures are needed at least to avoid natural calamity. Major points induced are as follows : The first, although most of natural monument large trees showed favorable growth environment, most of them are aged and have dense twigs with requirement for weed trimming to remove complicated and unnecessary branches. In addition, as most of large trees grow alone in a large space with potential natural calamity, thus, minimum measures are required at least. Secondly, change in electric resistance in surveyed large trees was relatively favorable, however, large trees with soil covering showed high electric resistance and were found to have low vitality. As shown, this study was conducted to find out the measurement techniques of natural monuments, Basic foundation is suggested through the measurement of electric resistance, and the vitality of natural monuments; more accurate investigation will be remained for further discussion.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.67 no.8
• /
• pp.1055-1061
• /
• 2018

Recently, due to the rapid development of electric vehicle and energy storage system, it is emphasized for battery management system to be needed and to be improved. BMS carries out various movement for optimization the use of the energy and safe use of secondary battery, these movement of BMS start at high wattage shunt fixed resistor which performs a function for detecting current among the BMS components. In addition, for the safe operation of secondary battery, the reliability of current voltage variation detected from shunt should be secured, and for corresponding characteristics, the quality of Temperature coefficient of resistance for BMS shunt and the quality of Thermo electromotive force all must be excellent. For these reasons, this study comes up with the stabilization plan for thermo electromotive force and temperature coefficient of resistance of BMS shunt resistor which is key to secondary battery operation.

• Journal of Applied Biological Chemistry
• /
• v.43 no.4
• /
• pp.185-191
• /
• 2000

Pest insect control is dependent on about 200 insecticides that work by relatively few mechanisms. The targets they disrupt are mostly involved in the nervous system, respiratory chain, growth and development, or the gut. The major nerve targets are: acetylcholinesterase for the organophosphates and methylcarbamates; the nicotinic acetylcholine receptor for the neonicotinoids; the $\gamma$-aminobutyric acid receptor for several chlorinated hydrocarbons and fipronil; the voltage-gated sodium channel for DDT and pyrethroids. Selection of resistant strains often confers cross-resistance to some or all other insecticides working at the same site. The toxicological properties of different compounds acting on the same target are increasingly considered together, summating the risk even though the compounds are of quite diverse chemical types. Continuing attention is also being given to secondary targets not involved in the primary mechanism of toxicity but instead in side effects that must be considered in the overall safety evaluation. Research on insecticide targets is important in learning to keep up with resistance and changing concepts and policies on safety. These relationships are illustrated by recent studies in the Environmental Chemistry and Toxicology Laboratory of the University of California at Berkeley.

• Genomics & Informatics
• /
• v.21 no.1
• /
• pp.5.1-5.13
• /
• 2023

Neisseria gonorrhoeae is a Gram-negative aerobic diplococcus bacterium that primarily causes sexually transmitted infections through direct human sexual contact. It is a major public health threat due to its impact on reproductive health, the widespread presence of antimicrobial resistance, and the lack of a vaccine. In this study, we used a bioinformatics approach and performed subtractive genomic methods to identify potential drug targets against the core proteome of N. gonorrhoeae (12 strains). In total, 12,300 protein sequences were retrieved, and paralogous proteins were removed using CD-HIT. The remaining sequences were analyzed for non-homology against the human proteome and gut microbiota, and screened for broad-spectrum analysis, druggability, and anti-target analysis. The proteins were also characterized for unique interactions between the host and pathogen through metabolic pathway analysis. Based on the subtractive genomic approach and subcellular localization, we identified one cytoplasmic protein, 2Fe-2S iron-sulfur cluster binding domain-containing protein (NGFG RS03485), as a potential drug target. This protein could be further exploited for drug development to create new medications and therapeutic agents for the treatment of N. gonorrhoeae infections.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.60 no.2
• /
• pp.186-193
• /
• 2024

Most fishing nets used in fish cage aquaculture are made of synthetic fibers such as polyamide (PA) and polyethylene (PE). Therefore, it is challenging to maintain the internal volume of the fish cage due to biofouling, which can increase the load on the cage or reduce dissolved oxygen levels by impeding smooth current flow. To address this issue, research has been conducted to replace conventional synthetic fiber cage nets with brass nets, demonstrating certain benefits such as improved productivity and ease of fish cage management. However, given the need for a more thorough examination of brass fishing net weaving technology and performance, this study assessed the optimal weaving method for brass fishing nets to be used in fish cages. Additionally, it provided essential data for the practical application of brass fishing nets by evaluating their weight, tensile strength, elongation, fatigue resistance, and wear resistance. The study concluded that weaving brass fishing nets using the chain link method ensures durability, ease of installation, and compact storage in a scroll-like form. Moreover, due to their superior fatigue and wear resistance properties, brass nets can offer increased utility if appropriate net diameter and length are selected to compensate for their higher weight per unit area and relatively higher cost compared to existing fiber fishing nets.

• Journal of the Korean Society of Safety
• /
• v.33 no.4
• /
• pp.1-7
• /
• 2018

This paper is analyzed for the thermal characteristics(1 year) of the 6 components(DC breaker, DC filter(including capacitor and discharge resistance), IGBT(Insulated gate bipolar mode transistor), AC filter, AC breaker, etc.) of a photovoltaic power generation-based PCS(Power conditioning system) below 20 kW. Among the modules, the discharge resistance included in the DC filter indicated the highest heat at $125^{\circ}C$, and such heat resulting from the discharge resistance had an influence on the IGBT installed on the rear side the board. Therefore, risk priority through risk priority number(RPN) of FMEA(Failure modes and effects analysis) sheet is conducted for classification into top 10 %. According to thermal characteristics and FMEA, it is necessary to pay attention to not only the in-house defects found in the IGBT, but also the conductive heat caused by the discharge resistance. Since it is possible that animal, dust and others can be accumulated within the PCS, it is possible that the heat resulting from the discharge resistance may cause fire. Accordingly, there are two options that can be used: installing a heat sink while designing the discharge resistance, and designing the discharge resistance in a structure capable of avoiding heat conduction through setting a separation distance between discharge resistance and IGBT. This data can be used as the data for conducting a comparative analysis of abnormal signals in the process of developing a safety device for solar electricity-based photovoltaic power generation systems, as the data for examining the fire accidents caused by each module, and as the field data for setting component management priorities.

• Journal of the Korean Society of Environmental Restoration Technology
• /
• v.16 no.1
• /
• pp.83-97
• /
• 2013

This study was carried out to suggest an experimental base in selecting the drought resistance of plants. Adopting the natural drought method, this paper studies the drought resistance of 12 kinds of ground cover plants. focusing on analyzing the changes of relative water content on leaf, relative electric conductivity and chlorophyll content in 12 kinds of plants, and and the relation between soil water content under drought stress. The drought resistance of the plants were subject to laboratory and rooftop drought resistance treatments. The Logistic model of nonlinear regression analysis was used to evaluate the lethal time that were predicted with the range of 10.4~30.1d on roof top, and 19.5~39.0d on hothouse. The result shows that with the increase of stress time, relative water content and chlorophyll content on leaf were in a downward trend; the relative electric conductivity was upward tendency. Among 12 species of ground cover plants, exclude Pulsatilla koreana, Ainsliaea acerifolia were selected for rooftop plants because they showed resist drought strongly and took adaptive ability.

• Journal of Plant Biotechnology
• /
• v.4 no.1
• /
• pp.1-6
• /
• 2002

Plants have developed a sophisticated battery of defence responses to protect themselves against attempted pathogen ingress. Manipulation of these defence mechanisms may provide significant opportunities for crop improvement. While plant resistance genes have had a long service history in plant breeding, they possess significant limitations. Recent advances are now providing significant insights into strategies designed to increase the field durability of this class of genes. Hypersensitive cell death is a common feature underlying the deployment of plant defence responses against biographic pathogens. In contrast, necrotrophic pathogens actively kill plant cells. Recently, transgenic plants have been developed that either promote or suppress cell death, providing resistance against either biotrophic or necrotrophic pathogens respectively. Methyl-jasmonate is a key signalling molecule in the establishment of resistance against some fungal pathogens. Increasing the concentration of this molecule in plant cells has been shown to increase resistance against Botrytis cineria, without significantly imparting plant growth or development. Due to the multifarious infection strategies employed by plant pathogens, how-ever, it is unlikely a single commercial product will prove a panacea for global disease control. Future stategies will more likely entail an integrated disease management approach.

• Corrosion Science and Technology
• /
• v.19 no.2
• /
• pp.57-65
• /
• 2020

As competition among global automakers intensifies, demand for materials that are better in price and performance is increasing. While steel and plastic materials compete for automotive fuel tanks, plastic materials have advantages such as light weight for automobiles. However, they have high prices. Accordingly, in this paper, four types of Zn-X plated steel sheets, electroplating (X = none, Sn) and galvannealed (X = Fe, Fe-Mg), were manufactured and their applicability as a fuel tank material was evaluated. Nano-composite coating solution with good conductivity was treated on the surface of plated steels using a roll coater and then cured through induction furnace to improve corrosion resistance. Quality characteristics such as corrosion resistance, fuel resistance to diverse gasoline and diesel fuels, and seam weldability were evaluated for the above plated steels. Their properties were compared and analyzed with conventional Zn-Ni electroplating steels. Among the above plated steels, Zn-Fe-Mg galvannealed steels coated with nano-composite coating exhibited better properties than other steels. Detailed experimental results suggest that evenly distributed Mg elements on the coating layer play a key role in the enhanced quality performance.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2009.11a
• /
• pp.141-148
• /
• 2009

The purpose of this paper is to propose a standard test methods of resistance to root penetration for waterproofing and rootproofing membrane using green roof system. Green roof system is considered to be an important subject in construction industry for green growth project. At the same time, we have to consider the counterplan for protection the damage of waterproofing layer and concrete substrate from the penetration of plant root. But many kinds of materials for protection from root penetration are using in construction field. But the performance of those materials is not clear, and there is not test methods for the evaluation of performance. So in this paper, based on the research results of 4 institutes during four years and foreign cases, we made a standard test methods of resistance to root penetration for waterproofing and rootproofing membrane using green roof system. This test method deals with about environmental condition of laboratory, experimental facilities, kinds of plant, specimen of test, management methods, evaluation duration and documents, etc.