• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.67 no.10
• /
• pp.1278-1285
• /
• 2018

For saving electricity bill, energy storage system(ESS) is being installed in factories, public building and commercial building with a Time-of-Use(TOU) tariff which consists of demand charge(KRW/kW) and energy charge(KRW/kWh). However, both of peak reduction and ESS special tariff are not considered in an analysis of initial cost payback period(ICPP) on ESS. Since it is difficult to reflect base rate by an amount of uncertain peak demand reduction during mid-peak and on-peak periods in the future days. Therefore, the ICPP on ESS can be increased. Based on this background, this paper presents the advanced analysis method for the ICPP on ESS. In the proposed algorithm, the representative days of monthly electricity consumption pattern for the amount of peak reduction can be found by the k­means clustering algorithm. Moreover, the total expected energy costs of representative days are minimized by optimal daily ESS operation considering both peak reduction and the special tariff through a mixed-integer linear programming(MILP). And then, the amount of peak reduction becomes a value that the sum of the expected energy costs for 12 months is maximum. The annual benefit cost is decided by the amount of annual peak reduction. Two simulation cases are considered in this study, which one only considers the special tariff and another considers both of the special tariff and amount of peak reduction. The ICPP in the proposed method is shortened by 18 months compared to the conventional method.

• Bulletin of the Korean Chemical Society
• /
• v.20 no.9
• /
• pp.1031-1034
• /
• 1999

Tin oxide films have been grown employing the chemical vapor deposition technique under reduced pressure conditions using tetramethyltin as the precursor and oxygen as the oxidant. An activation energy derived for the deposition reaction under representative deposition conditions has a value of 89±3 kJ mol-1, suggesting a typical kinetic control. Deposition rates of tin oxide films exhibit a near first order dependence on tetramethyltin partial pressure and a zeroth order dependence on oxygen partial pressure. This study provides the first quantitative information about the growth kinetics of tin oxide films from tetramethyltin by the cold-wall low-pressure chemical vapor deposition.

• Journal of Environmental Policy
• /
• v.10 no.1
• /
• pp.93-127
• /
• 2011

Investment on technology to obtain green energy is prevailing all over the world. The technology development project is more likely to involve multiple sub-projects, each of which is related to develop elementary technology when the project is larger and nation-wide. However, the methodologies identifying optimal combination of elementary technologies among the candidates have been very few. Hence, the purpose of this paper is to propose a novel methodology which provides an optimal combination of green energy technologies. To do so, to-be developed technologies are clustered with multiple categories. Among the technologies, based on Delphi method, the experts select a representative technology, which is indispensible to the green energy system and has the highest connectivity with other elementary technologies. Then the methodology selects an elementary technology from each technology category based on two metrics: Relatedness with representative technology and project risk. To show the feasibility of the proposed methodology, we applied the methodology to an actual windmill development project.

• KIEAE Journal
• /
• v.1 no.1
• /
• pp.45-52
• /
• 2001

This study aims to make a fundamental data for a policy-making decision in treatment and disposal of municipal solid wastes and presents a research data on the discharge properties of municipal solid wastes and making a unit of them in the Taegu metropolitan city. The results can be summarized as follows; survey the discharge properties of municipal solid wastes, calorific values and to present a research-data in supplying incineration-heat of wastes with the area of Sung-seo in Taegu. So, using fundamental data for planning and running wastes-incineration plants as well as trying to make better Urban Environmental Infra-structure. The results are obtained from the study. 1) The proportion of combustible wastes in Taegu increased from 89.6% to 94.47% during 1993~2000. However, the proportion of incombustibles decreased from 10.4% to 5.53% during 1993~2000. 2) The value of representative properties is about 1500~2000kcal/kg. So we can expect that it should be made use of energy-resources positively. 3) The heat from Sung-seo wastes-incineration plants is used to produce electronic-energy for wastes-incineration plants in summer season. The heat from Sung-sea wastes-incineration plants is in charge of 27% which of supplying the area of Sung-seo with district heating energy in winter season.

• Explosives and Blasting
• /
• v.33 no.1
• /
• pp.1-12
• /
• 2015

In this study, the domestic bench blasting sites were researched to set the blast coefficient C according to the type of rock and type of industry. With the use of the experimental data on the representative industrial explosives and the data of the manufacturers'data on explosives, powder coefficient e was set up. The blast coefficient C was 0.21~0.30 when the average value for 5 representative kinds of rocks including granite was searched. The blast coefficient C for quarrying, mining and construction sites were 0.22, 0.13 and 0.26 respectively. On the other hand, powder coefficient e was obtained in four elements such as reactive energy, ballistic mortar test, VOD, Langefors'strength per unit weight. e value for emulsion which is one of the representative explosives was found to be 1 while those of high performance emulsion and ANFO were found to be 0.9 and 1, respectively.

• Analytical Science and Technology
• /
• v.31 no.1
• /
• pp.31-38
• /
• 2018

The energy recovery rate estimation method proposed through the Waste Control Act does not take into account the energy used in practice. In addition, the method for measuring a lower heating value, which is the main factor of the energy recovery rate, was carried out through a small sampling amount, and thus the representative value of the waste was not reflected. With the revised estimation method (Notification No. 2015-215 of the Ministry of Environment), the energy recovery rate should be estimated based on the actual amount of energy used, and a heat balance method was proposed as a way to estimate the lower heating value. In this study, the lower heating value was estimated for seven industrial waste incineration facilities according to the revised estimation method. All data used in the estimations were achieved from measurement instruments applied to each of the incinerators and through direct measurements taken by the operators for the purposes of calculation. As a result, the lower heating value was estimated to be about 3,404.7 kcal/kg for the seven industrial waste incineration facilities.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2011.11a
• /
• pp.702-704
• /
• 2011

For the representative of the poor performance of liquid fuel(Jet A-1), the physical properties effests of different additive ratios in the liquid fuel have been investigated. The mixed liquid fuel could be analyzed by principal factor of liquid fuel such as, density, viscosity and caloric value. This additives will be usefully applied to high energy density liquid fuel development.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.18 no.11
• /
• pp.62-71
• /
• 2017

This study classified cities across South Korea according to their urban characteristics, selecting representative cities for respective types, and drawing a relationship among urban characteristic elements, carbon emissions, and the energy consumption of cities. For the classification of cities, the elements of the urban characteristics were examined through a review of the related literature. Factor analysis was then carried out to select the variables from among these elements. The absolute coefficient value found in the analysis was set as a standard. A classification of cities across the country was performed using these variables, and representative cities were chosen for a comparison of the characteristics of each type. For an analysis of the relationships among the urban characteristics according to the type of city, the greenhouse gases, and the energy consumption of cities, emissions of greenhouse gases, electricity consumption, and oil consumption of the representative cities were compared and analyzed by correlation analysis. The analysis results indicated that the cause of greenhouse gas emissions and electricity consumption varies according to the elements of the characteristics of the representative cities, even when they show similar emissions and consumption.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.24 no.4
• /
• pp.348-356
• /
• 2014

To understand the relationship between road-traffic noise and urban components such as population, building, road-traffic and land-use, the city of Cheongju that already has road-traffic noise maps of daytime and nighttime was selected for this study. The whole area of the city is divided into square cells of a uniform size and for each cell, the urban components are estimated. A spatial representative noise level for each cell is determined by averaging out population-weighted facade noise levels for noise exposure population within the cell during nighttime. The relationship between the representative noise level and the urban components is statistically modeled at the cell level. Specially, we introduce a spatial auto regressive model and a spatial error model that turns out to explain above 85 % of the noise level. These findings and modeling methods can be used as a preliminary tool for environmental planning and urban design in modern cities in consideration of noise exposure.

• The Journal of the Korea Contents Association
• /
• v.22 no.6
• /
• pp.557-566
• /
• 2022

The purpose of this study is to understand the correlation between Master Jin Bodhi and practicing Medicine Buddha, and to examine the concept and value of the method of asceticism related to practicing Medicine Buddha. Accordingly, as a result of collecting and analyzing a wide range of literature data on Master Jin Bodhi, Master Jin Bodhi was able to capture and present various historical sources of using various method of asceticism based on practicing Medicine Buddha. In addition, the concept and value of the method of asceticism about The Method of Great Illuminated Asceticism, Throwing Five Parts of the Body, and Energy Bagua were considered and presented as representative practices among the various practices taught to modern people in physical and mental weaknesses across the world. This study is of academic significance in that it clearly distinguishes the concepts and unique values of each of the The Method of Great Illuminated Asceticism, Throwing Five Parts of the Body, and Energy Bagua based on the results of the correlation between Master Jin Bodhi and practicing Medicine Buddha. Nevertheless, this study did not fully reveal the historical causality of the process of expanding Master Jin Bodhi's method of asceticism related to practicing Medicine Buddha, and has limitations in not considering the concept and value of the method of asceticism other than the The Method of Great Illuminated Asceticism, Throwing Five Parts of the Body, and Energy Bagua. Specific methods for further research were suggested.