• Proceedings of the KIEE Conference
• /
• 2008.10b
• /
• pp.445-447
• /
• 2008

The CCTV systems is the most extensively used for a burglar proof, a crime prevention and a Prevention forest fires etc. The CCTV systems which is used in present is a PAN/TILT form. We want to control of CCTV systems motion by Up/Down, Left/Right, Zoom In/Out, Focus, TELE. We design a 8051 microcontroller board and a Key Controller and a Relay Controller. We conformed its feasibility through the simulation.

• Proceedings of the KIEE Conference
• /
• 1999.07a
• /
• pp.483-485
• /
• 1999

Recently, distributed control network system has been widely applied to on-board control system than conventional relay logic with control wire. This paper presents two configuration of driver's desk system using TCN(Train Communication Network). One is configured with TCN, the other is partial adoption of TCN.

• Journal of Advanced Navigation Technology
• /
• v.20 no.3
• /
• pp.182-189
• /
• 2016

In this paper, we propose a buoy system based on multi-hop relay networks for ocean observation. The proposed system consists of various sensor modules, a gateway, wireless communication modules, and a remote monitoring site. The sensor modules are integrated with various communication interfaces and connected to the gateway of the proposed buoy system with an unified protocol based on controller area network (CAN)-bus. In order to communicate with the remote monitoring site and extend the coverage, the proposed system uses long-term evolution (LTE) router and XBee mesh network modules. The field test results show that the proposed system can extend the coverage using the proposed multi-hop relay network.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.21 no.10
• /
• pp.1849-1854
• /
• 2017

Recently, RF energy harvesting, in which energy is collected from the external RF signals, is considered as a promising technology to resolve the energy shortage problem of wireless sensors. In addition, it is important to guarantee secure communication between sensors for implementing Internet-of-Things. In this paper, we propose a power splitting-based network analog coding for maximizing a physical layer security in 2-hop networks where the wireless-powered relay can harvest energy from the signals transmitted by two sources. We formulate systems where two sources, relay, and eavesdropper exist, and find an optimal power splitting ratio for maximizing the minimum required secrecy capacity using an exhaustive search. Through simulations under various environments, it is demonstrated that the proposed scheme improves the minimum required secrecy capacity by preventing the eavesdropper from overhearing source signals, compared to the conventional scheme.

• Journal of Communications and Networks
• /
• v.14 no.6
• /
• pp.640-652
• /
• 2012

Many studies have investigated the smart grid architecture and communication models in the past few years. However, the communication model and architecture for a smart grid still remain unclear. Today's electric power distribution is very complex and maladapted because of the lack of efficient and cost-effective energy generation, distribution, and consumption management systems. A wireless smart grid communication system can play an important role in achieving these goals. In this paper, we describe a smart grid communication architecture in which we merge customers and distributors into a single domain. In the proposed architecture, all the home area networks, neighborhood area networks, and local electrical equipment form a local wireless mesh network (LWMN). Each device or meter can act as a source, router, or relay. The data generated in any node (device/meter) reaches the data collector via other nodes. The data collector transmits this data via the access point of a wide area network (WAN). Finally, data is transferred to the service provider or to the control center of the smart grid. We propose a wireless cooperative communication model for the LWMN.We deploy a limited number of smart relays to improve the performance of the network. A novel relay selection mechanism is also proposed to reduce the relay selection overhead. Simulation results show that our cooperative smart grid (coopSG) communication model improves the end-to-end packet delivery latency, throughput, and energy efficiency over both the Wang et al. and Niyato et al. models.

• Aerospace Engineering and Technology
• /
• v.10 no.2
• /
• pp.56-64
• /
• 2011

In this paper, the characteristics of LCL set-up parameters for the satellite load distribution are analyzed under the electrical system environment, implemented the LCL circuits and evaluated the performance and its behaviour. Recently, it is implemented the load distribution circuit by latching current limiter(LCL) rather than conventional fuse and relay for the protection of the satellite power system from a fault load. The LCL circuit is composed of the electrical components, not mechanical parts with the fuse and relay. When detected the over current on a fault load, it is activated to maintain the trip-off level for set-up time and then cut-off the load power by the active control. It is more flexible and provided a chance to reuse of the load in case of temporarily event, but the fuse and relay can't be used again after activating due to the physical disconnection. However, for implementation of LCL circuit, it should be carefully considered the behavior of the LCL circuit under the worst electrical system environment and applied it to define the set-up parameters related with over-current inhibition.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.40 no.1
• /
• pp.43-51
• /
• 2015

Upcoming cellular networks such as LTE-advanced and IEEE 802.16m are enhanced by relay stations to support high data rate multimedia services and minimize the shadow zone with low cost. Enhancing the relay stations, however, divides the multihop cellular network into smaller microcells and the distance between microcells is closer, which intends large intra-cell and inter-cell interference. Especially the access link on downlink in the OFDMA cellular network is the throughput bottleneck due to the severe interference caused by base stations and relay stations transmitting large data to mobile stations simultaneously. In this paper, we present interference aware channel allocation algorithm to avoid severe interference on multihop cellular networks with random topology. Proposed algorithm increases SINR(signal to interference plus noise ratio) and decreases number of required control messages for channel allocation, so that increases overall throughput on the networks.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.18 no.3
• /
• pp.713-718
• /
• 2014

This paper proposed a real-time monitoring system that can realize effective operation of snowplows each of the local autonomous entities secures to cope with disasters in Korea like a wintertime heavy snowfall and also can promptly cope with the spot facing a heavy snowfall disaster by doing real-time monitoring on the information of the snow-removal site and the mobility of the vehicles. Also, the study has designed a relay terminal analysis tool so that the proposed system can analyze all kinds of controlling information and diagnose the relay terminal effectively. The proposed system can realize effective and emergent coping with the situations of a heavy snowfall disaster through real-time routing trace as well as effective work progress within a short time by doing real-time monitoring on the information about the status of snow-removal work and vehicle controlling for snow-removal work as well as the location information of snow-removal vehicles in the situations of a heavy snowfall.

• The KIPS Transactions:PartC
• /
• v.9C no.3
• /
• pp.407-412
• /
• 2002

A FR-ATM interworking function that has FR and ATM interfaces, should guarantee the QoS of both frame relay and ATM networks. The IWF requires the policing mechanisms for FR and ATM respectively, and needs to map the traffic parameters each other. In this case, traffic parameter mapping and policing function are performed independently. In the aspect of FR traffic policing, this function degrades processor performance if it is worked by software, or includes additional hardware function. The best way to solve this is to integrate this function into ATM function because ATM is performed by well defined hardware already. In this paper we propose the integrated traffic control mechanism. That is, frames are segmented to cells first, and then policing mechanism is applied to the cells to guarantee the FR QoS. Therefore proper policing algorithm is essential to the integrated FR traffic mechanism. The evaluations are done with simulations in comparison of existing FR algorithms, ATM VBR and GFR policing algorithms, and the proposed algorithm.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.10 no.3
• /
• pp.950-975
• /
• 2016

Device-to-Device (D2D) communication underlaying cellular networks is a promising add-on component for future radio communication systems. It provides more access opportunities for local device pairs and enhances system throughput (ST), especially when mobile relays (MR) are further enabled to facilitate D2D links when the channel condition of their desired links is unfavorable. However, mutual interference is inevitable due to spectral reuse, and moreover, selecting a suitable transmission mode to benefit the correlated resource allocation (RA) is another difficult problem. We aim to optimize ST of the hybrid system via joint consideration of mode selection (MS) and RA, which includes admission control (AC), power control (PC), channel assignment (CA) and relay selection (RS). However, the original problem is generally NP-hard; therefore, we decompose it into two parts where a hierarchical structure exists: (i) PC is mode-dependent, but its optimality can be perfectly addressed for any given mode with additional AC design to achieve individual quality-of-service requirements. (ii) Based on that optimality, the joint design of MS, CA and RS can be viewed from the graph perspective and transferred into the maximum weighted independent set problem, which is then approximated by our greedy algorithm in polynomial-time. Thanks to the numerical results, we elucidate the efficacy of our mechanism and observe a resulting gain in MR-aided D2D communication.