• Journal of the Korean Institute of Gas
• /
• v.27 no.3
• /
• pp.134-140
• /
• 2023

Activated carbon is a carbonaceous material mainly used as a gaseous or liquid adsorbent. As fire-related accidents occur consistently due to the accumulation of heat of adsorption and oxidation of volatile organic compounds, the explosive characteristics and thermal stability of powdered and granular activated carbon made from coal and coconut shells were evaluated. As a result of the particle size analysis, the powdered activated carbon was in the particle size range (0.4~3) ㎛, and thermal properties such as exothermic onset temperature and decomposition behavior were analyzed using a differential scanning calorimetry and a thermogravimetric analysis. As a result of the evaluation of the explosion hazards for dust, both coal-based and coconut-based powdered activated carbon are classified as St1 class with weak explosion, but this is a relative and does not mean that the explosion hazards is absolutely low. Therefore, it is necessary to establish countermeasures for reducing the damage.

• Journal of the Korean institute of surface engineering
• /
• v.56 no.6
• /
• pp.393-400
• /
• 2023

Acetone, a metabolite detected from the exhaled breath of people doing a diet, can be used for non-invasive monitoring of diet efficiency. Thus, gas sensors with rapid response and recovery characteristics to acetone need to be developed. Herein, we report ultrafast acetone sensors using Ce-doped In₂O₃ nanoparticles prepared by the one-pot microwave-assisted hydrothermal method. The pure In₂O₃ sensor shows a high response and fast response time (τ_res = 6 s) upon exposure to 2 ppm acetone at 300 ℃, while exhibiting a relatively sluggish recovery speed (τ_recov = 1129 s). When 20 wt% Ce is doped, the τ_recov of the sensor significantly decreased to 45 s withholding the fast-responding characteristic (τ_res = 6 s). In addition, the acetone response (resistance ratio, S) of the sensor is as high as 5.8, sufficiently high to detect breath acetone. Moreover, the sensor shows similar acetone sensing characteristics even under a highly humid condition (relative humidity of 60%) in terms of τ_res (6 s), τ_recov (47 s), and S (4.7), demonstrating its high potential in real applications. The excellent acetone sensing characteristics of Ce-doped In₂O₃ nanoparticles are discussed in terms of their size, composition, phase, and oxygen adsorption on the sensing surface.

• Korean Journal of Environmental Agriculture
• /
• v.27 no.3
• /
• pp.225-230
• /
• 2008

Objective of this study was to access the environmental impacts of the use of discharge water from municipal waste water treatment plant as alternative irrigation resources during drought season for rice cultivation. For the field experiments, it was observed that plant growth and yield characteristics at 20 days of alternative irrigation period with application of FAST (fertilizer application based on soil test) 50% were relatively the same as the control. For the surface water quality, it appeared that $EC_i$ (electrical conductivity of irrigation water) and SAR (sodium adsorption ratio) values of DMWT (discharge waters from municipal wastewater treatment plant) irrigation were twofold higher than those of ground water irrigation as the control regardless of fertilization levels. For the irrigation periods, there were not significantly difference between 10 and 20 days of treatments, but $EC_i$ and SAR values of surface water were highest at 30 days of irrigation periods at initial rice growing stages. Generally, $EC_i$ values of percolation water in all the treatments were gradually increasing until 30days after irrigation, and then decreasing to harvest stage. Overall, it might be considered that there was possibility to irrigate DMWT with application of FAST 50% for 20 days of drought periods at rice transplanting season. Furthermore, efficiency rate of alternative irrigation water for 20 days of drought period was 32.7% relative to the total annual irrigation water for rice cultivation.

• Korean Journal of Soil Science and Fertilizer
• /
• v.30 no.3
• /
• pp.234-241
• /
• 1997

The effects of bulk densities(${\rho}_b$) on saturated hydraulic conductivity (Ksat) and solute elution patterns were investigated from five different bulk densities ranging from $1.1Mg/m^3$ to $1.5Mg/m^3$ with each increment of $0.1Mg/m^3$. The hydraulic conductivities observed were divided into two stages: (1) a linearly decrease with increase in bulk density up to $1.4Mg/m^3$, (2) a steady state where the bulk density is greater than $1.4Mg/m^3$. Using the saturated hydraulic conductivity at the steady state, we figured out the equation describing the correlation between bulk densities(${\rho}_b$) and saturated hydraulic conductivity(Ksat) as follows: $Ksat=-19.2({\rho}_b{^2})+6{\rho}_b+15.5$, (r=0.985). Electrical conductivity(EC) measured from the leachate of the soil column showed that EC at the same pore volume were decreased with an increase in the bulk density from $1.2g/cm^3$, $1.5g/cm^3$, as shown in the time taken to collect the same pore volume at each respective bulk density. The maximum relative concentrations (C/Co=1) from the breakthrough curves for the anions of $Cl^-$, $NO_3{^-}$ and $SO_4{^{2-}}$, which are weakly adsorbed on the soil particles, moved to the right of the graph, while a distinctive retardation occurs at the bulk density between $1.3Mg/m^3$ and $1.4Mg/m^3$. The time taken to recover about 90% of indigenous sulphate was approximately twice as those of chloride and nitrate, resulting in slightly stronger adsorption characteristics for sorption sites on the soil surface. Thus, we can conclude that the salt accumulation in green house soil might be significantly influenced by it's bulk density at the soil depth, as well as the adsorption capacity of ions for the sorption sites in soils.

• Analytical Science and Technology
• /
• v.22 no.6
• /
• pp.488-497
• /
• 2009

In this study, analytical methodology for several organic fatty acids (OFA: propionic acid (PA), butyric acid (BA), isovaleric acid (IA), and valeric acid (VA)) designated as new offensive odorants in Korea (as of year 2010) was investigated along with some odorous VOCs (styrene, toluene, xylene, methyl ethyl ketone, methyl isobutyl ketone, butyl acetate, and isobutyl alcohol). For this purpose, working standards (WS) containing all of these 13 compounds were loaded into adsorption tube filled with Tenax TA, and analyzed by gas chromatography (GC) system thermal desorber interfaced with. The analytical sensitivities of organic fatty acids expressed in terms of detection limit (both in absolute mass (ng) and concentration (ppb)) were lower by 1.5-2 times than other compounds (PA: 0.24 ng (0.16 ppb), BA: 0.19 ng (0.11 ppb), IA: 0.15 ng (0.07 ppb), and VA: 0.28 ng (0.13 ppb)). The precision of BA, IA, and VA, if assessed in terms of relative standard error (RSE), maintained above 5%, while the precison of other compounds were below 5%. The reproducibility of analysis improved with the aid of internal standard calibration (PA: $1.1{\pm}0.4%$, BA: $10{\pm}0.46$, IA; $12{\pm}0.3%$, VA: $4{\pm}0.1%$), respectively. The results of this study showed that organic fatty acid can be analyzed using adsorption tube and thermal desorber in a more reliable way to replace alkali absorption method introduced in the odor prevention law of the Korea Ministry of Environment (KMOE).

• Korean Journal of Soil Science and Fertilizer
• /
• v.45 no.2
• /
• pp.227-234
• /
• 2012

Recently, the population of toxic and/or unusable jellyfish is increasing during summer along the east coast of Korea, causing massive economical and ecological damage to fisheries, nuclear power plant and marine environment. To solve this problem, this study was carried out using jellyfish as a potential soil additive for horticulture. The jellyfish was solidified and homogenized, then mixed with a commercial bed soil. Allium tuberosum ROTH was planted to control bed soil (BS) and jellyfish powder mixed bed soil groups (Mixed bed soil, MBS), and following parameters were measured during five weeks: water content, electrical conductivity and growth of leaves. At the end of the experiment, bacterial community structures of each pot were analyzed by DGGE. The relative water adsorption of jellyfish powder was about 2.5 times greater compared to its dry weight. The water content of MBS group was significantly higher than BS group 6.5 to 14.2%, and the electric conductivity of MBS group was measured around 2.8 dS/m where BS group was resulted average of 1.8 dS/m. However, the leaves of BS group were grown 30% longer compared to MBS group. DGGE analysis of MBS group was shown in high number of phylum Bacteroidetes and increased diversity of Sphingobacteriia compared to BS group. Jellyfish powder as a soil additive surely will be a good candidate as humectant and microbiota stimulator, although there are several obstacles such as high electrical conductivity and residual alum salt which used for solidification of jellyfish.

• Applied Chemistry for Engineering
• /
• v.20 no.4
• /
• pp.407-410
• /
• 2009

18~19 wt% $KMnO_4$/$SiO_2-Al_2O_3$ with Si/Al = 1/5 and 1/10, and 20 wt% $KMnO_4$/$Al_2O_3$ were prepared by solvent evaporation method. Catalytic activity of ethylene abatement over those samples were evaluated and compared under the conditions of GHSV $1125h^{-1}$, ethylene gas (ethylene 0.2%, air 99.8%, relative humidity 50%) at 30, 40, 60 and $120^{\circ}C$ using a fixed-bed reactor. $KMnO_4$/$SiO_2-Al_2O_3$ was showed better performance than $KMnO_4$/$Al_2O_3$ by 170~210% at 30, $40^{\circ}C$, and by 60% at 60, $150^{\circ}C$, respectively.

• Analytical Science and Technology
• /
• v.7 no.3
• /
• pp.329-338
• /
• 1994

The retention behaviors of natural gas components were studied on a single column by gas chromatography. The dead time, $t_0$ was obtained by using extrapolation of homologous series to determine capacity factors. The plots of retention data for homologous series and carbon number at different temperatures were shown to converge into a single point, which point was determined as a dead time. The results of the effect of temperature on the column efficiency for n-butane exhibited the plate number, N incerased with temperature, but the resolution among the fast eluted components decreased. The adsorption enthalpy (${\Delta}H^0{_{ads}}$) for each component on 28% DC 200 stationary phase was determined, and in order to investigate the retention behaviors of natural gas components the regression analysis of log $t_R$, log k' and log ${\alpha}$ vs. van der Waals volume(Vw), molecular connectivity index(X) and hydrophobic fragmental constant(f) were carred out. Good correlation was found between log k' vs. Vw, and log k' vs. f. The correlations between the physical properties of natural gas and the physical parameters were investigated by the linear regression analysis. The relationships between Vw vs. molecular weight and heating value(${\Delta}H_{comb}$), X vs. boiling point, and f vs. molecular weight, boiling point and heating value exhibited the high correlation coefficient more than 0.99. Using the regression equation between the heating value of natural gas and Vw the predicted heating values from $C_6$ to $C_{10}$ showed good agreement with those reported in the literature within 0.2% relative error.

• Journal of Korean Society of Environmental Engineers
• /
• v.33 no.10
• /
• pp.717-722
• /
• 2011

Currently, melamine is being used variously in our lives such as resins, flame retardants, adhesive, laminate etc. And understandably sewer of stream of wastewater containing Melamine has also increased. GHS (Globally Harmonized System of Classification and Labelling of Chemicals) of EU safety guidelines says that it can cause cancer. Still, study on toxicity of Melamine is going on. In this research, melamine contamination level of the Han River and River Basin was analyzed by HPLC/UV. And the experiments of GAC adsorption were conducted and the model was studied. We collected the 3 same samples at the suburbs of Paldang Dam located in the relative upstream in Han River and Ttukseom amusement park, the downstream region and collected samples equally at the Hongreung stream, Wangsuk stream, Cheonggye stream among streams flowing into Han River and then measured Melamine concentration after purification. As a result, melamine was not detected at the suburbs of Paldang Dam and it was detected at Ttukseom amusement park, the downstream of it, in the concentration of $0.312{\mu}g/L$. The Wangsuk stream with $0.578{\mu}g/L$ highest Cheonggye stream and Hongreung stream was detected with each $0.197{\mu}g/L$ and $0.325{\mu}g/L$. Although the concentration was low in general, melamine detection could be checked at most point. In 1970, the world capacity of Melamine was estimated at 200,000 ton, with current production estimated to be 1,400,000 ton. Melamine of Han River and rivers flowing into Han River is present at low concentration but pollution will increase in the future due to increase of use. Depending on the size of activated carbon in the experiment were slightly different. But the breakthrough model is almost identical.

• Journal of the Mineralogical Society of Korea
• /
• v.17 no.3
• /
• pp.235-243
• /
• 2004

Illite has been known to adsorb Cs preferentially to other alkali cations, especially at lower Cs concentration due to the frayed edge site. This frayed edge site was only verified by isotherm experiments, but not by other analytical methods. To investigate the Cs sorption properties on the surface of illite, artificially weathered illite with increasing frayed edge sites was reacted with Cs at different solution concentrations. The illite was weathered f3r 1 hour, 2 days, 14 days in 0.001 M HCl solution. With increasing reaction time, increasing amount of K in solution was observed, indicating formation of frayed edges by weathering, which was also verified by XRD, SEM, and TEM analysis. Original and weathered illites were converted to the homoionic Na form and reacted with $10^{-3}$ / ～ $10^{-7}$ M CsCl solutions for 24 hour. The aspect of Cs sorption was clearly distinguished around $10^{-5}$ M Cs concentration. The relative Cs amount sorbed on illite at low concentration (<10$^{-5}$ M) was higher than high concentration and increased with decreasing Cs concentration. In general, the amount of sorbed Cs increases with increasing weathering time and this trend is more noticeable at lower concentration while not much differentiated with weathering time at high concentration. These results indicate that the selective Cs sorption site exists in illite at low concentration, known as frayed edge site, and the number of those sites increases with weathering time.