• Journal of The Institute of Information and Telecommunication Facilities Engineering
• /
• v.4 no.1
• /
• pp.15-21
• /
• 2005

One of the core technology in WDM-PON system is a generation and modulation technique of the optical source in Optical Network Unit (ONU). In this paper, we propose a reflective semiconductor optical amplifier (RSOA) as a modulator in WDM-PON system. Its performance is analyzed by simulation and actual experimentation. Using RSOA in WDM-PON system as a modulator, it obtains higher gain compared to the conventional SOA due to the double pass gain effect. Furthermore RSOA can provide high gain with comparatively low input power. This is very helpful when we set up the actually system because using lower input power, it can reduce the load of the driving circuit which makes very economical module structure. Therefore, when RSOA is used as a modulator, not only it gives noise suppression effect, but also provides certain amount of gain as well. In addition, comparing with conventional SOA which gives fairly large insertion loss, RSOA can provides more important merits.

• Current Optics and Photonics
• /
• v.2 no.1
• /
• pp.27-33
• /
• 2018

We report the physical implementation of a tunable photonic microwave delay line filter based on injection locking of a single Fabry-Perot laser diode (FP-LD) to a reflective semiconductor optical amplifier (RSOA). The laser generates equally spaced multiple wavelengths and a single tapped-delay line can be obtained with a dispersive single mode fiber. The filter frequency response depends on the wavelength spacing and can be tuned by the temperature of the FP-LD varying lasing wavelength. For amplitude control of the wavelengths, we use gain saturation of the RSOA and the offset between the peak wavelengths of the FP-LD and the RSOA to decrease the amplitude difference in the wavelengths. From the temperature change of total $15^{\circ}C$, the filter, consisting of four flat wavelengths and two wavelengths with slightly lower amplitudes on both sides, has shown tunability of about 390 MHz.

• Journal of the Optical Society of Korea
• /
• v.15 no.3
• /
• pp.222-226
• /
• 2011

We demonstrated the feasibility of an amplified wavelength-division multiplexed passive optical network (WDM-PON) architecture based on broadband light source (BLS) seeded optical sources and a novel bidirectional reach extender. Our bidirectional reach extender could provide an amplification of both downstream and upstream signals as well as a BLS output for the upstream WDM signal generation. An error-free 1.25 Gb/s signal transmission over a 100-km long single-mode fiber was achieved in a bidirectional WDM-PON using BLS seeded reflective semiconductor optical amplifier (RSOA) sources.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.43 no.5 s.347
• /
• pp.35-44
• /
• 2006

Reflective semiconductor optical amplifiers(R-SOAs) were designed with high gain, wide optical bandwidth, high thermal reliability and wide modulation bandwidth in TO-can package for the transmitter of wavelength division multiplexed-passive optical network(WDM-PON) application. Double trench structure and current block layer were introduced in designing the active layer of R-SOA to enable high speed modulation. The injection power requirement and the viable temperature range of WDM-PON system are experimentally analysed in based on Amplified Spontaneous Emission(ASE)-injected R-SOAs. The effect of the different injection spectrum in the gain-saturated R-SOA was experimentally characterized based on the measurements of excessive intensity noise, Q factor, and BER. The proposed spectral pre-composition method reduces the bandwidth of injection source below the AWG bandwidth and thereby avoids spectrum distortion impeding the intensity noise reduction originated from the amplitude squeezing.

• Korean Journal of Optics and Photonics
• /
• v.19 no.3
• /
• pp.219-223
• /
• 2008

To realize a widely tunable laser diode, a polymer coupled-ring reflector is hybrid- integrated with reflective semiconductor optical amplifier. Even though ring-ring and ring-bus coupling ratios are changed by fabrication errors in waveguide width and height, they remain very close to the single peak condition, ensuring high yield in fabrication. The tuning range is observed to be about 35 nm, maintaining the side mode suppression ratio of about 30 dB.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.6B
• /
• pp.583-591
• /
• 2011

We presents the architecture of the 2.5 Gbps hybrid PON link which can increase of the transmission distance and link capability, and split ratio by using a colorless DWDM-PON and O/E/O based reach extender into an existing G-PON link. A RSOA based DWDM-PON to apply the feeder fiber can provide a link capacity of 32 larger that of a legacy G-PON. The reach extender converts the wavelength of DWDM-PON to G-PON through GTC frame regeneration at the remote node, and can provide a burst reset signal in order to extract upstream burst signal, simultaneously. The proposed hybrid PON enable a legacy G-PON to operate over the maximum 60 km distance with a 128-way split per WDM wavelength.