• Journal of electromagnetic engineering and science
• /
• 제6권2호
• /
• pp.110-116
• /
• 2006

A reflective array type surface acoustic wave(SAW) dispersive delay line(DDL) with high time-bandwidth at the V/UHF-band is designed and fabricated for compressive receiver applications. This type of the SAW DDL has the properties of the relative bandwidth of 20 %, the time delay of 49.89 usec, the insertion loss of 38.5 dB and the side lobe rejection of 39 dB. In comparison with a commercial SAW DDL, the insertion loss, amplitude ripple and side lobe rejection are improved by $1.5dB{\pm}0.6dB$ and 4 dB respectively. Using the fabricated SAW DDL, the prototype of the compressive receiver is developed. It is composed of RF converter, fast tunable LO, chirp LO, A/D converter, signal processing unit and control unit. This prototype system shows a fine frequency resolution of below 30 kHz with high scan rate.

• Current Optics and Photonics
• /
• 제2권1호
• /
• pp.27-33
• /
• 2018

We report the physical implementation of a tunable photonic microwave delay line filter based on injection locking of a single Fabry-Perot laser diode (FP-LD) to a reflective semiconductor optical amplifier (RSOA). The laser generates equally spaced multiple wavelengths and a single tapped-delay line can be obtained with a dispersive single mode fiber. The filter frequency response depends on the wavelength spacing and can be tuned by the temperature of the FP-LD varying lasing wavelength. For amplitude control of the wavelengths, we use gain saturation of the RSOA and the offset between the peak wavelengths of the FP-LD and the RSOA to decrease the amplitude difference in the wavelengths. From the temperature change of total $15^{\circ}C$, the filter, consisting of four flat wavelengths and two wavelengths with slightly lower amplitudes on both sides, has shown tunability of about 390 MHz.

• Current Optics and Photonics
• /
• 제2권6호
• /
• pp.563-567
• /
• 2018

We propose and experimentally demonstrate a simple tunable photonic microwave band-pass filter with high resolution using a reflective semiconductor optical amplifier (RSOA) and an optical time-delay line. The RSOA is used as a gain medium for generating cross-gain modulation (XGM) effect as well as an optical source. The optical source provides narrow spectral width by self-injection locking the RSOA in conjunction with a partial reflection filter with specific center wavelength. Then, when the RSOA is operated in the saturation region and the modulated recursive signal is injected into the RSOA, the recursive signal is inversely copied to the injection locked optical source due to the XGM effect. Also, the tunability of the passband of the proposed microwave filter is shown by controlling an optical time-delay line in a recursive loop.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2009년도 제40회 하계학술대회
• /
• pp.1515_1516
• /
• 2009

A 440MHz wireless and passive surface acoustic wave (SAW) based micro-sensor was developed for simultaneous measurement of temperature and humidity. The developed sensor is composed of a SAW reflective delay lines structured by an IDT (Inter-Digital Transducer), four reflectors and humidity sensitive film (polyimide). Polyimide was dry-ecthed by RIE (Reactive Ion Etching) to obtain high roughness, which gives the large reaction area resulting in high sensitivity. In wireless testing using a network analyzer, sharp reflection peaks with high S/N ratio, small signal attenuation, and few spurious peaks were observed in the time domain. High sensitivity towards the temperature and humidiy were also observed in the large concentration range. The obtained sensitivity was $16.8^{\circ}/^{\circ}C$ for temperature sensor and $15.8^{\circ}$/%RH for humidity sensor.

• 마이크로전자및패키징학회지
• /
• 제16권1호
• /
• pp.13-19
• /
• 2009

상대습도와 $CO_2$ 기체의 실시간 동시 감지가 가능한 표면탄성파(SAW: Surface Acoustic Wave) 기반의 무선, 무전원 센서가 개발되었다. 본 소자는 $41^{\circ}YX\;LiNbO_3$ 기판 위에 만들어졌으며, 반사 지연선의 구조로 이루어져 있다. 본 논문의 반사 지연선은 양방향 감지가 가능한 Interdigital transducer(IDT)와 10개의 리플렉터(reflector)로 이루어져 있다. 감지 필름은 Teflon AF 2400과 친수성의 $SiO_2$층이 이용되었으며, 이는 각각 $CO_2$와 상대 습도의 감지를 담당한다. 소자의 제작에 앞서 최적의 소자 설계 조건들을 도출하기 위해 Couple of mode(COM) 모델링이 실시되었다. 시뮬레이션 결과를 반영하여 소자의 제작이 진행되었으며, 네트워크 분석기를 이용하여 무선 측정이 실시 되었다. 시간 영역에서 측정된 반사계수 $S_{11}$은 높은 신호 대 잡음 비, 작은 신호 감쇠, 적은 허위 피크를 보였다. 제작된 소자는 각각 $75{\sim}375ppm$의 $CO_2$ 범위와 $20{\sim}80%$의 상대 습도 범위에서 측정되었으며, 각각 $2^{\circ}/ppm$의 $CO_2$ 민감도, $7.45^{\circ}/%$의 상대습도에 대한 민감도를 보였고, 좋은 선형성과 반복성을 보였다. 또한 민감도 측정 과정에서 온도와 습도의 보상 과정을 거쳐 더욱 정확한 민감도를 갖도록 하였다.

• 대한전자공학회논문지TC
• /
• 제43권1호
• /
• pp.33-40
• /
• 2006

Single phase unidirectional transducer (SPUDT), 리플렉터, 웨이퍼 본딩 패키지로 구성된 표면탄성파 (surface acoustic wave, SAW) 기반 압력센서가 개발되어 졌다. Coupling of Mode (COM) 모델링에 의한 소자의 시뮬레이션 및 최적 설계 변수가 얻어졌다. Finite Element Methods (FEM)를 통해 주어진 압력에 따른 다이어프램 벤딩, 스트레인/스트레스 변화 및 SAW 속도변위가 미리 예측되어졌다. 유출된 최적 설계 변수를 이용 440 MHz SAW 기반 압력센서가 41o YX LiNbO3 기판 위에서 제작되어졌다. 고 S/N 비, 임펄스 리프렉션 피크, 작은 에러 피크가 관찰되어졌다. 측정된 S11 결과는 COM 모델링 및 FEM 시뮬레이션 결과와 일치함을 보였다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2009년도 제40회 하계학술대회
• /
• pp.1545_1546
• /
• 2009

This paper reports a novel wireless love-wave biosensor on $41^{\circ}$ YX $LiNbO_3$ piezoelectric substrate and $SiO_2$ guiding layer for Immunoglobulin G (IgG) detection by protein binding. Different from the traditional biosensors based on surface acoustic wave (SAW) oscillator structured by delay line/resonators, a 440MHz reflective delay line consists of SPUDTs and three reflectors placed on $41^{\circ}$ YX $LiNbO_3$ in a row was fabricated as the sensor element. Good linearity, reproducibility, and high sensitivity were observed in the IgG concentration range 1~65nM. Unique advantages as high sensitivity, passive and simple measurement system are present over currently available other biosensors.