• Advances in nano research
• /
• v.3 no.3
• /
• pp.169-176
• /
• 2015

Iron nanoparticles were made by using the modified coprecipitation technique. Usually the characteristics of synthesised particles depend upon the process parameters such as the ratio of the iron ions, the pH of the solution, the molar concentration of base used, type of reactants and temperature. A modified coprecipitation method was adopted in this study. A magnetic stirrer was used for mixing and the morphology and nature of particles were observed after synthesis. Nanoparticles were characterised through XRD. Obtained nanoparticles showed the formation of magnetite and maghemite under citric acid and oxalic acid as stabilisers respectively. The size of nanoparticle was greatly affected by the use of different types of stabilisers. Results show that citric acid greatly reduced the obtained particle size. Particle size as small as 13 nm was obtained in this study. The effects of different kinds of nucleating agents were also observed and two different types of nucleating agents were used i.e. potassium hydroxide (KOH) and copper chloride ($CuCl_2$). Results show that the use of nucleating agent in general pushes the growth phase of nanoparticles towards the end of coprecipitation reaction. The particles obtained after addition of nucleating agent were greater in size than particles obtained by not utilising any nucleating agent. These particles have found widespread use in medical sciences, energy conservation and electronic sensing technology.

• Korean Chemical Engineering Research
• /
• v.53 no.1
• /
• pp.39-45
• /
• 2015

We produced magnetite nanoparticles (MNPs) and a Mg-rich solution as a nano-adsorbent and a coagulant for water treatment, respectively, using a low-grade iron ore. The ore was leached with aqueous hydrochloric acid and its impurities were removed by solvent extraction of the leachate using tri-n-butyl phosphate as an extractant. The content of Si and Mg, which inhibit the formation of MNPs, was reduced from 10.3 wt% and 15.5 wt% to 28.1 mg/L and < 1.4 mg/L, respectively. Consequently, the Fe content increased from 68.6 wt% to 99.8 wt%. The high-purity $Fe^{3+}$ solution recovered was used to prepare 5-15-nm MNPs by coprecipitation. The wastewater produced contained a large amount of $Mg^{2+}$ and can be used to precipitate struvite in sewage treatment. This process helps reduce the cost of both sewage and iron-orewastewater treatments, as well as in the economic production of the nano-adsorbent.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.3 no.3
• /
• pp.198-202
• /
• 2002

Ethanolamine (ETA), instead of ammonia, increases pH in the secondary system water and inhibits the corrosion of iron, which improves the integrity of the steam generator tubes. The different physicochemical properties of ETA from ammonia provide the different effect on the dissolution and adsorption of corrosion products entering the steam generator and thus on the hideout returns of ionic impurities in the steam generator sludge pile. The objective of this study was to investigate those properties with increasing temperature. ETA is more adsorbed onto the iron oxides, which increases the solubility of them and also lowers the hideout returns due to the reduced impurities adsorbed.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.27 no.2
• /
• pp.296-304
• /
• 1998

The effects of common Korean dietary fiber-rich foods(dried sea mustard, Lentinus edodes and Korean radish leaves) on total gut transit time of diet, serum cholesterol level and mineral apparent absorption ration and tissue level were investigated. Twenty eight male were divided into 4 groups and were fed a control diet(containing 2% cellulose) and three fiber supplementary diet mixed with 10% of the above dietary fiber rich foods for 4 weeks, respectively. Body weight gain and food efficiency ration were not affected by the supplementary diet of fiber but the total gut transit time of diet was shortened in all dietary fiber groups. The Lentinus edodes reduced significantly serum total cholesterol and increased the HDL-cholesterol/total cholesterol ratio at 4th week without and effect on calcium and iron apparent absorptions and tissue levels of the minerals. Radish leaves decreased significantly iron apparent absorption ration with a tendency to increase iron retention in spleen and did not alter serum cholesterol level. Serum cholesterol concentration and calcium and iron apparent absorptions were not significantly altered by the ingestion of sea mustard, while it had more soluble dietary fiber than mushroom and radish leaves.

• Journal of Soil and Groundwater Environment
• /
• v.25 no.4
• /
• pp.28-34
• /
• 2020

Nitrate released from chemical fertilizer, animal wastes, and synthetic detergents can cause methemoglobinemia to infants, thus the standard in drinking water is set to 10 mg/L as World Health Organization recommended. In this study, zero-valent iron-modified rice straw biochar was used to reduce and remove nitrate in the aqueous phase. The rice straw biochar was prepared by pyrolyzing the biomass at 700℃ for 3 hours, and the biochar was modified using 1 M Fe(III), and the Fe(III) on the biochar was reduced to zero-valent iron using sodium borohydride. The modified biochar removed nitrate effectively, which removed more than 91% of nitrate. For the synthetic groundwater, the nitrate removal was lowered to 82% due to the presence of other anions.

• Journal of the Korean Ceramic Society
• /
• v.18 no.3
• /
• pp.157-162
• /
• 1981

A converter slag has been heat-treated above melting point at reduced condition by cokes. As the result, most iron was separated. To make hydraulic compounds, calcium oxide was added to the reduced converter slag and the mixtures were sintered. This modified converter slag clinker mainly contained tricalcium silicate and calcium aluminates, and have a great potential to be a good hydraulic cement. The hydrates of the hydraulic compounds and gypsum with and without granulated slags, were mainly C-S-H, ettringite, calcium monosulfoaluminate hydrate, calcium aluminate hydrate, and $Ca(OH)_2$

• Journal of the Korean Society for Railway
• /
• v.15 no.4
• /
• pp.376-380
• /
• 2012

A study on the iron-loss reduction of 110kW-class Interior Permanent Magnet Synchronous Motor (IPMSM) for Light Railway Transit (LRT) is conducted. In general, the iron loss of IPMSM depends on the characteristics of core material and non-oriented electrical steel is used as a core material of IPMSM. In order to reduce the iron-loss of IPMSM, both non-oriented electrical steel and grain oriented electrical steel are applied as core material. Iron loss of 110kW-class IPMSM can be reduced approximately 40% comparing to an existing IPMSM by applying grain oriented electrical steel to the stator teeth.

• Journal of Korea Foundry Society
• /
• v.31 no.2
• /
• pp.66-70
• /
• 2011

Hot dip aluminizing (HDA) is widely used in industry for improving corrosion resistance of material. The formation of intermetallic compound layers during the contact between dissimilar materials at high temperature is common phenomenon. Generally, intermetallic compound layers of $Fe_2Al_5$ and $FeAl_3$ are formed at the Al alloy and Fe substrate interface. In case of cast iron, high contact angle of graphite existed in the matrix inhibits the formation of intermetallic compound layer, which carry with it the disadvantage of a reduced reaction area and mechanical properties. In present work, the process for the removal of graphite existed on the surface of specimen has been investigated. And also HDA was proceeded at $800^{\circ}C$ for 3 minutes in aluminum alloy melt. The efficiency of graphite removal was increased with the reduction of particle size in sanding process. Graphite appears to be present both in the region of melting followed by re-solidification and in the intermetallic compound layer, which could be attributed to the fact that the surface of cast iron is melted down by the formation of low melting point phase with the diffusion of Al and Si to the cast iron. Intermetallic compound layer consisted of $Fe(Al,Si)_3$ and $Fe_2Al_5Si$, the layer formed at cast iron side contained lower amount of Si.

• The Korean Journal of Physiology and Pharmacology
• /
• v.3 no.6
• /
• pp.631-640
• /
• 1999

The present study investigated the stimulatory effects of iron (or ascorbate) on cyclosporine-induced kidney mitochondrial damage. Damaging effect of $50\;{\mu}M$ cyclosporine plus $20\;{\mu}M\;Fe^{2+}$ on mitochondrial lipids and proteins of rat kidney and hyaluronic acid was greater than the summation of oxidizing action of each compound alone, except sulfhydryl oxidation. Cyclosporine and $100\;{\mu}M$ ascorbate showed an enhanced damaging effect on lipids but not on proteins. The peroxidative action of cyclosporine on lipids was enhanced with increasing concentrations of $Fe^{2+}.$ Ferric ion $(20\;{\mu}M)$ also interacted with cyclosporine to stimulate lipid peroxidation. Damaging action of cyclosporine on mitochondrial lipids was enhanced by ascorbate $(100\;{\mu}M\;and\;1\;mM)$. Iron chelators, DTPA and EDTA, attenuated carbonyl formation induced by cyclosporine plus ascorbate. Cyclosporine $(100\;{\mu}M)$ and $50\;{\mu}M\;Fe^{2+}$ $(or\;100\;{\mu}M\;ascorbate)$ synergistically stimulated degradation of $2-{\alpha}$ deoxyribose. Cyclosporine $(1\;to\;100\;{\mu}M)$ reduced ferric ion in a dose dependent manner, which is much less than ascorbate action. Addition of $Fe^{2+}$ caused a change in absorbance spectrum of cyclosporine in $230{\sim}350$ nm of wavelengths. The results show that cyclosporine plus iron (or ascorbate) exerts an enhanced damaging effect on kidney mitochondria. Iron and ascorbate appear to promote the nephrotoxicity induced by cyclosporine.

• Korean Chemical Engineering Research
• /
• v.46 no.6
• /
• pp.1029-1038
• /
• 2008

Transition-metal-oxide-incorporated hydrotalcites were prepared by hydrothermal reaction of their synthetic mixtures containing precursors of transition metal oxides and their properties of nitrogen dioxide adsorption was investigated. The dispersion of transition metal oxides on the hydrotalcites and the amount and the state of nitrogen dioxide adsorbed on them were examined by using XRD, SEM, XPS, nitrogen adsorption, a gravimetric adsorption system, FT-IR spectroscopy and temperature programmed desorption techniques. Transition metal oxides were mainly incorporated on their surface and the incorporation of iron and nickel oxides to the hydrotalcites increased their adsorption amounts of nitrogen dioxide. The dispersion of iron oxide on the hydrotalcites was effective in increasing the amount of nitrogen dioxide adsorption, while too much amount of iron oxide incorporation reduced the amount of nitrogen dioxide adsorption due to masking of surface basic sites by agglomerated iron oxide. Although the incorporation of iron oxide to the hydrotalcites lowered the adsorption strength of nitrogen dioxide, the incorporation of it with a proper amount enhanced the amount of nitrogen dioxide adsorption and the stability against the hydrothermal treatment.