• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.16 no.10
• /
• pp.2163-2170
• /
• 2012

A signal receiving system can measure and analyze frequency, pulse modulation, scan modulation, frequency modulation on pulse, phase modulation on pulse of RF signal. A signal receiving system should be verified under simulated RF signal environment prior to verification on operation in fields. This paper describes an effective method to generate simulated RF signals with considering operational scenario. The simulated RF signal generator can be effectively used to evaluate the performance of the signal receiver and reduce the test cost of the signal receiver.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.17 no.6
• /
• pp.31-38
• /
• 2003

Among mitigation techniques for electric and magnetic field (EMF) from an overhead transmission line a passive loop is a way that can be cheap and easily installed on the existing towers and have a satisfactory effect as well. However current induced in the passive loop causes transmission power loss and the phase imbalance increases since geometrical asymmetry of the transmission lines becomes larger. So in order to evaluate the power loss and the phase imbalance due to a passive loop, this paper represent a 345[kV] 1-circuit flat type transmission line as asymmetrical 3-phase distributed parameter line model where the effect of a passive loop is embedded in the line parameters, and then formulates differential equations. By solving these equations voltages and currents of each phase at receiving end become known. We find out that power losses occur differently at each phase and positive sequence component decreases at receiving end while negative sequence component increase. In general phase imbalance due to a passive loop is slight, but it increases in proportional to the induced current and length of section where the passive loop is installed. Thus the phase imbalance should be included in terms of cost for introducing a passive loop.

• The Transactions of the Korean Institute of Electrical Engineers
• /
• v.36 no.3
• /
• pp.171-178
• /
• 1987

A study of two phase chopper system with four separate groups of DC motors in powering. A novel two phase chopper system with four separate groups of DC motors which applies the principles of two phase chopper with two separate groups of DC motors is dealt with this article. The main circuit consists of eight sets of chopping parts, four diodes and four separate groups of DC motors. Four groups of DC motors are driven through the series and parallel connections to each other in accordance with the operating conditions of the choppers. Although the proposed chopper circuit requires more circuit elements than the conventional two phase chopper system with combined output or two phase chopper system with two separate groups of DC motors, it has the following advantages` (1). It is possible to drive twice as much motors as conventional system does, using esisting receiving-and equipments and motors. (2). It is possible to control load voltage continuously from 0 to source voltage by changing time-ratio from 0 to 1. (3). Load current division becomes equalized. Therefore it is possible to drive not only series motors but also shunt and separately exited motors. (4). When smoothing reactor L is small, harmonic components of the proposed circuit is not so large. Therefore, the value of L can be determined from viewpoints of allowable value of ripple-ratio and current unbalance factor.

• Proceedings of the KIEE Conference
• /
• 1998.07e
• /
• pp.1647-1649
• /
• 1998

This paper describes the power frequency voltage and its countermeasure when a 765 kV transmission line is directly connected to a 345 kV line and operated at 345 kV voltage. The summary of this result is as follows : The western route of 765 kV transmission line doesn't need any countermeasure to reduce the power frequency voltage at the receiving end. The eastern route of 765 kV transmission needs 100 Mvar(3 phase) capacity of shunt reactor at the receiving end to reduce the power frequency voltage. The use of shunt reactors in the 765 kV transmission lines has unexpected problems, one of which is induction of high voltages on a de-energized circuit of two parallel lines. This paper examined the problem of resonance on two parallel transmission circuits in one routes.

• Journal of Korea Society of Digital Industry and Information Management
• /
• v.9 no.3
• /
• pp.59-65
• /
• 2013

This paper presents a novel calibration method for a base station system adopting an antenna array. The proposed technique utilizes Zadoff-Chu sequence, which is included in the LTE pilot signal periodically, in order to compute the phase characteristic of each antenna channel. As the Zadoff-Chu sequence exhibits an excellent autocorrelation characteristic, it is possible for the receiving base station to retrieve the Zadoff-Chu sequence transmitted from each mobile terminal. In addition, we can obtain the phase characteristic of each antenna channel, which is the ultimate goal of the calibration procedure. The proposed calibration algorithm has been implemented using an FPGA (Field Programmable Gate Array). We have applied the proposed algorithm to an array consisting of 2 antenna elements for simplicity. the phase value implied to the first and second antenna path is very accurately calculated from the proposed procedure. From the experimental test, the proposed method provides accurate calibration results.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.23 no.4
• /
• pp.290-293
• /
• 2018

This paper proposes a new magnetic resonant wireless power transfer system. Two transmitters are arranged to secure a range wider than the existing one-to-one resonance, thereby enhancing the practicality of the system. Two identical transmission units are arranged to strengthen the magnetic field and to subsequently increase the magnitude and distance of the power transmitted to the reception unit. A constant power can be maintained in a wide range through the phase control of different output powers according to the positions of the transmitting and receiving coils. A constant power can also be obtained by transmitting to the receiver. The experiment results show that the proposed method outperforms the conventional method.

• Journal of Korean Society for Quality Management
• /
• v.24 no.1
• /
• pp.1-9
• /
• 1996

Ritchken(1985) analyzes free replacement and pro-rata warranty policies for products receiving renewable warranies. He shows that for constant failure rates pro-rata warranty policies are more attractive to risk-averse manufacturers than shorter term free replacement policies that result in the same average warranty cost. This paper considers the case when product lifetimes distributions are of phase-type. When this is so, Ritchken's performance measures can be simplified considerably. It is found, that irrespective of the pattern of failure rates, pro-rata warranty policies are preferable to free replacement policies. But the warranty period of the equivalent free replacement policy decreases and then increases, as product reliability(the average time between failures) increases.

• Journal of Multimedia Information System
• /
• v.5 no.3
• /
• pp.155-162
• /
• 2018

Nowadays, the tracking technology of Quadrant Detector will become actual by new micro devices. Based on the past filed data of the reception experiment with COMETS satellite, we have studied on new device (AD8302, phase difference detector) was acquired and suspect its abilities. In 1998, we have developed a Quadrant Detector for mobile to track a weak signal from satellite on Ka band of COMETS. The Quadrant Detector is comprised of four dedicated feed components for reception under an environment of Nakagami - Rician fading, and one transmission and reception feed component. We were successful in receiving a 23 GHz beacon signal from ICE transponder of the COMETS and succeeded in tracking the satellite from a moving vehicle at speeds of approximately 10 ~ 20 Km/h on paved roads. In 2018, with new device AD8302, we have verified new QD system and performed a simulation, based on the past filed experiment. This new device shall be improving the tracking abilities from mobile body on the earth to the multimedia satellite.

• Economic and Environmental Geology
• /
• v.29 no.6
• /
• pp.733-738
• /
• 1996

Heavy metal equilibria in the Dongnam stream which receives the wastewater from mining activities are investigated to provide some basic data for the management of small stream with acid mine drainage. Saturation, undersaturation, and supersaturation of some heavy metal ions with respect to some mineral phases are evaluated by saturation index (logIAP/Ksp). The $Al^{3+}$ activities showed equilibrium with $AIOHSO_4$ solid phase below a pH of 6.0. The $Fe^{3+}$ activities appeared to be controlled by Fe $(OH)_{3(amorphous)}$ solid phase below a pH of 4.0. $Zn^{2+}$ activities appeared to be regulated by $ZnCO_3$ solid phase above a pH of 6.8. Some heavy metal activities appeared to be depended upon the pH.

• Journal of the Korean Society for Precision Engineering
• /
• v.11 no.2
• /
• pp.95-103
• /
• 1994

The purpose of this paper is to provide the experimenters who use the oblique incidence ultrasonic method for anisotropic elastic constants measurement eith some useful relations. In particular, the equivalence of the times of flight by the energy ad phase velocities, which is key to the oblique incidence method, is proved explicitly. This equivalence greatly simplifies the analysis of immersion measurement results. In oredr to correctly measure the transit time of an immersed sample using the oblique incidence, the receiving transducer should be shifted laterally, and an expression in given for this shift. A method for determining all nine elastic constants of an orthotropic material is briefly described and the measurement results are listed for SiC particulate reinforced A1 matrix composites.