• Bulletin of the Korean Chemical Society
• /
• 제23권2호
• /
• pp.325-329
• /
• 2002

In this study, the dependency of the behavior of propagating front on the reaction condition in frontal polymerization reaction has been studied. We have used some multifunctional acrylates as a monomer and ammonium persulfate as an initiator for the polymerization reactions. In frontal polymerization, a method of producing polymeric materials via a thermal front that propagates through the unreacted monomer/initiator solution, the behavior of self propagating front shows various dynamic patterns depending on the reaction condition. We have obtained some spin modes of propagating front in the number of 'hot spots' or 'spin heads' by changing the reaction condition. The effect of the reactor tube diameter on the mode of propagating front has also been studied by using some reactor tubes with different size of tube diameter and it has been examined in some detail by adopting an experimental method of two-tubes system.

• 환경위생공학
• /
• 제16권4호
• /
• pp.62-68
• /
• 2001

The advantages of hydrogen peroxide dissolution method were no discharge of noxious matter when dissolution of iron wire which used as the center supporter, reactions occur in room temperature and easy to recover dissolved iron. This study was aimed at gathering the basic data of iron wire dissolution- recovery process and proposes the reaction condition of iron wire dissolution- recovery process rind the factors influencing those reactions. The results were as follows : 1 . Hydrogen peroxide dissolution method used hydrochloric acid as the catalyst. 1. In the dissolution of iron wire(1.668 g), the condition of reaction was E1702(30 ml), HCI(20 ml) and $H_2O$(200 ml) ; time of the reaction was 18 min. P.W.(Piece weight) was 7.75 mg, and C.R. was $2.34{\;}{\Omega}$ 2. In the dissolution of iron wire(1.529 g), the condition of reaction was H7O2(30 ml), HCI(20 ml) and $H_2O$(200 ml), time of the reaction was 21 min., P.W.(Piece weight) was 7.73 mg, and C.R. was $2.35{\;}{\Omega}$. Hydrogen peroxide dissolution method used sulfuric acid as the catalyst. 1. In the dissolution of iron wire(0.834 g), the condition of reaction was $H_2O$(65 ml), $H_2SO_4$(5 ml) and 1702(5 ml) ; time of the reaction was 5 min.30 sec, P.W.(Piece weight) was 7.74 mg, and C.R. was $2.33{\;}{\Omega}$ 2. In the dissolution of iron wire(1.112 g), the condition of reaction was $H_2O$(65 ml), $H_2SO_4$(5 ml) and $H_2O_2$(5 ml) ; time of the reaction was 4 min.30 sec, P.W.(Piece weight) was 7.75 mg, and C.R. was $2.33{\;}{\Omega}$. Hydrogen peroxide dissolution method used hydrochloric acid and sulfuric acid as the catalyst confirmed a clean technology, because there were not occurred a pollutant discharged in the existing method.

• Molecular & Cellular Toxicology
• /
• 제5권2호
• /
• pp.108-112
• /
• 2009

Alzheimer's disease(AD) is a neurodegenerative disorder characterized pathologically by senile plaques, neurofibrillary tangles, and synapse loss. Especially, extracellular beta-amyloid (Abeta) deposition is a major pathological hallmark of Alzheimer's disease (AD). In AD senile plaques, high level of iron and car-bonylated Abeta were detected. Iron has a Lewis acid property which can increase the electrophilicity of carbonyls, which may react catalytically with nucleophiles, such as amines. Hence, this study investigated whether or not iron could promote the carbonylation of amine with malondialdehyde (MDA) in the physiological condition. As the basic study, we examined that iron might promote the conjugation reaction between propylamine, monoamine molecule and MDA in the physiological condition. As the concentration of iron increased, the fluorescence intensity produced from the conjugation reaction increased in a dose-dependent manner. Instead of propylamine, we applied the same reaction condition to Abeta 1-40 peptide, one of major components founded in AD senile plaques for the conjugation reaction. As the result, the fluorescence intensity produced from the conjugation reaction between Abeta 1-40 peptide and MDA showed the similar trend to that of the reaction used with propylamine. This study suggests that iron can accelerate the conjugation reaction of MDA to Abeta 1-40 peptide and play an another important role in deterioration of AD brain.

• Preventive Nutrition and Food Science
• /
• 제15권4호
• /
• pp.309-315
• /
• 2010

A grilled-type shrimp flavor was developed through the Maillard reaction to reduce or mask fish odor or off-flavor in seafood. Model systems were created by using enzymatic hydrolysate of shrimp and adding precursors to increase flavor quality and stability. Amino acid precursors such as cysteine and methionine, sugar precursors such as glucose, xylose, ribose, and sucrose, and one particular compound of glucosamine were tried and their flavor qualities were tested by sensory evaluation. Also, the optimum reaction condition was investigated using the pH values of pH 5, 6, 7, and 8 with reaction times of 1 hr, 2 hr and 3 hr after the best precursors were determined. The best condition of the precursors for grilled-type shrimp flavor was the mixtures of methionine, threonine, xylose, and glucosamine. The optimum reaction condition was at pH 8.0 and 2 hr reaction time.

• 한국안전학회지
• /
• 제17권3호
• /
• pp.81-89
• /
• 2002

The runaway reaction was analyzed experimently and theoretically at the batch styrene suspension polymerization process. In the experiments, the reaction temperature with time was measured at various experimental conditions. According to the experimental results, the risk of the runaway reaction was increased with increasing the ratio of the monomer(styrene, M) to the dispersion medium(water, W), the concentration of the initiator(BPO), and the monomer mass, respectively. And simulation results showed that the runaway reaction was significantly affected by the reaction rate constant of the propagation and that the phenomena of the runaway reaction occurred at about 70% conversion. Also, we found that the runaway reaction did not occur under the operating condition of below 0.5 for M/W, approximate 3 wt% BPO, and below 75$^{\circ}C$ for the cooling temperature.

• Bulletin of the Korean Chemical Society
• /
• 제24권2호
• /
• pp.189-192
• /
• 2003

The reaction of 4-(2-methylaziridin-1-yl)-3-ureidobenzotrifluorides 4 with triphenylphosphine, carbon tetrachloride, and triethylamine (Appel's condition) led to the corresponding carbodiimides 5, which underwent intramolecular cycloaddition reaction with aziridine under the reaction condition to give the benzimidazolefused heterocycles, 2,3-dihydro-1H-imidazo[1,2-a]benzimidazoles 8 and 12,13-dihydro-5H-benzimidazo[2,3-b] [1,3]benzodiazepines 9.

• 한국수소및신에너지학회논문집
• /
• 제15권4호
• /
• pp.283-290
• /
• 2004

The single-step process for conversion of syngas to DME give higher conversion than the syngas-to-methanol process. This arises because of a synergy among the three simultaneous reaction, methanol synthesis, methanol dehydration and water gas shift reaction, in the process. we would find the optimal condition of the process which these advantages. The optimal condition of DME synthesis reaction over a commercial $Cu/Zn/Al_2O_3$ catalyst and Hybrid catalyst in a fixed bed reactor. The syngas-to-dimethyl ether conversion was examined on various reaction condition (Temperature 473~553K, $H_2/CO$ ratio 1~3, Pressure 30'50atm, GHSV 1000~4000).

• 열처리공학회지
• /
• 제36권1호
• /
• pp.33-39
• /
• 2023

In this study, the effect of mixing condition of raw material powders possessing various particle size and particle size distribution on thermite reaction efficiency was investigated. When fine raw powders are used, rather the reaction yield tends to decrease due to agglomeration. In contrast, coarse raw powders make deteriorate the contact area between raw material powders containing Al reducing agent. To ensure the optimal thermite reaction efficiency, it is required to optimize a mixture condition of raw material powders prior to thermite reaction. From the current experiment, the maximum thermite reaction efficiency is 77%, which came from Nb₂O₅ + NiO +Al mixtures with size distribution from 9.25 to 22.63 ㎛.

• Bulletin of the Korean Chemical Society
• /
• 제7권6호
• /
• pp.472-477
• /
• 1986

The reaction of (E)- or (Z)-1-alkenylmercuric chlorides with acrylic acid derivatives in the presence of 10 mol% of lithium trichloropalladate ($LiPdCl_3$) and an equimolar amount of cupric chloride, as a reoxidant for the palladium, in acetonitrile at room temperature gave the corresponding (E,E)- or (E,Z)-2,4-dienoic acid derivatives stereospecifically in moderate to good yields. The reaction of (E)- or (Z)-3-chloromercuripropenoic acid with olefins under the reaction condintion described above similarly gave good yields of (E,E)- or (Z,E)-2,4-dienoic acids stereospecifically. A side reaction, the homocoupling of alkenylmercuric chlorides, could be minimized by employing the condition described above. However, in the reaction of 3-chloromercuripropenoic acid with olefins under the present condition, the homocoupled side reaction product was not produced.

• 한국환경과학회지
• /
• 제4권1호
• /
• pp.91-103
• /
• 1995

The reaction rate, equilibrium, and flow injection analysis methods were fundamentally evaluated for the determination of aqueous ammonia. The selected indophenol blue method was based on the formation of indophenol blue in which ammonium ion reacted with hypochlorite and phenol in alkaline solution. In the optimized reaction condition, the reaction followed 1st order reaction kinetics and the final product was stable. The absorbance measurements before and after the equilibrium were utilized for the reaction rate and equilibrium methods. The reaction rate methods, based on the relative analytical signals for the possibility of eliminating interferents, were shown to have good linear calibration curves but the detection limit and the calibration sensitivity were poorer than those in the equilibrium method. The detection limits were 32-49 pub and 24 pub for the reaction rate and equilibrium methods, respectively In the flow injection analysis, the absorbance was measured before the equilibrium reached and thus resulted in 30% reduction of calibration sensitivity. However, the detection limit was 11 ppb, indicating that the peak-to-peak noise for the blank was remarkably improved. Compared to the manual methods, the optimized experimental condition in a closed reaction system reduced the blank absorbance and the inclusion of ammonia from the atmosphere was prevented. In addition, highly reproducible mixing of sample and reagents and analytical data extracted from continuous recording showed excellent reproducibility.