• 생물환경조절학회지
• /
• 제8권1호
• /
• pp.42-48
• /
• 1999

반결구 상추 ‘Omega’와 잎상추 ‘Grand Rapids’의 m 재배에서 배양액내 Ca : K 비율이 광합성, 증산, 생육 및 tipburn 발생에 미치는 영향을 밝히고자 실험을 수행하였다. 반결구 상추와 잎상추 두 종 모두 광합성은 Ca : K 비율 3:6과 4.5:4.5에서 높았으며, 기공 저항은 잎상추가 반결구 상추보다 낮았다. 증산율은 3:6의 Ca : K 비율에서 두 종 모두 가장 높았으며, 잎상추의 증산율이 반결구 상추보다 높아 종간 차이를 보였다. 엽위에 따른 증산율은 완전 전개잎에 비해 미숙잎에서 낮았는데, 이것은 미숙잎에서 tipburn 발생이 많은 것과 깊은 관계가 있는 것으로 보였다. Ca 결핍구인 Ca : K 비율 0:9처리는 두 종 모두 극단적인 생육 저하와 함께 tipburn이 100% 발생하였으며, 반결구 상추는 Ca : K 1.5:7.5 처리에서도 tipburn이 25% 발생하였으나, 잎상추에서는 나타나지 않았다 작물 생육은 Ca 결핍구를 제외한 두 종 모두 Ca : K 3:6 처리에서 가장 높았다. 배양액의 Ca과 K의 불균형은 기공저항과 확산저항을 높여 광합성과 증산의 감소를 유도함으로써 Ca 이동에 영향을 미친 것으로 보였다.

• 상하수도학회지
• /
• 제20권5호
• /
• pp.677-684
• /
• 2006

Electro-flotation(EF), a novel sludge thickening method, could improve the dewaterability of activated sludge. The gas(microbubbles) generated during EF decreased the solid-liquid separation time below 1/5 of the time required for gravity sedimentation. In addition, over 90% of the sludge volume reduction could be achieved by EF although the settling characteristics of the sludge was very poor. The SRF(specific resistance to filtration) of the thickened sludge by EF was much lower than that of the sludge thickened by gravity sedimentation. The SRF of the thickened sludge decreased exponentially with increase of gas generation rate of the EF system. Gas generation rate could be controlled by varying the current density of the electrode. Degasing of the microbubbles by vigorous mixing of the thickened sludge layer deteriorated the dewaterability of the sludge. Therefore, it is obvious that the gas bubbles entrapped in the thickened sludge play a key role in the observed dewaterability improvement.

• 생명과학회지
• /
• 제19권5호
• /
• pp.625-632
• /
• 2009

결과적으로 본 연구에서 서로 다른 두 집단(RTG, ATG)의 비교시 저항성 트레이닝 집단(RTG)보다 유산소 트레이닝 집단(ATG)에서 산화질소(NO) 농도가 더 높게 나타났으며, 이는 지속적인 유산소 형태의 트레이닝이 간헐적인 저항성 형태의 트레이닝 보다 더 많은 산화질소(NO)가 생성 된다는 것을 알 수 있었다. 또한 심박수(HR)와 혈압(BP), 평균동맵압(MAP)의 감소에도 저항성 트레이닝(RT)보다는 유산소 트레이닝(AT)이 효과적이라는 것을 알 수 있었다. 그러나 유산소 트레이닝(AT)에 비해 저항성 트레이닝(RT)에서 유의하진 않았지만 산화질소(NO) 농도가 증가된 것은 주목할 만한 결과이다. 이러한 결과로 볼 때, 단기간일 지라도 혈관이완 및 자율신경계 도움을 줄 수 있는 것은 유산소 트레이닝(AT) 임을 알 수 있었고 이는 일반적으로 운동을 선택할 시(근력과 근비대를 제외한 운동) 도움을 줄 수 있다고 사료된다. 또한 추후 연구에서는 12주 이상의 장기간의 트레이닝을 통해 저항성 트레이닝(RT)이 혈관이완의 직접적인 척도인 산화질소(NO) 농도에 관한 연구가 필요시 된다.

• 한국주조공학회지
• /
• 제28권3호
• /
• pp.119-123
• /
• 2008

Wear test on two die steels for aluminum die casting was carried out by dipping and rotating the specimens into the molten aluminum maintained $680^{\circ}C{\sim}780^{\circ}C$. The rotating speed of the specimen was $4.5rpm{\sim}20.0rpm$. Diffusion layer was formed between the die steel and molten aluminum, and became thicker with dipping time. Wear rate was not proportional with the thickness of the diffusion layer, but was closely related to the density of the diffusion layer. Wear rate was little affected by the kind of die steel and by the microstructure such as martensite, tempered martensite, and pearlite. Specimen with nitrided surface showed good wear resistance, and its wear rate was decreased with increase in the thickness of nitrided layer. While whole surface was worn in heat treated specimens, wear of nitrided specimens was proceeded by pitting partially.

• Advances in environmental research
• /
• 제3권3호
• /
• pp.199-206
• /
• 2014

Dewatering is an extremely important step in wastewater treatment process to reduce the final sludge volume in order to minimize the cost of sludge transportation and disposal. In the present study, the effect of different sludge solids content (1, 2 and 3.8%) on the dewaterability of anaerobically digested sludge using Acidithiobacillus ferrooxidans and Acidithiobacillus thiooxidans was studied. The pH reduction rate was higher during initial process in the sludge having low solids content, but after 48 h of bioleaching, similar pH of below 3 was observed with all the different solids content. Bio-oxidation rate of $Fe^{2+}$ was initially higher in sludge with low solids content, but 100% $Fe^{2+}$ was oxidized within 60 h in all the three treatment levels. Compared to the control, specific resistance to filtration was reduced by 75, 78 and 80% in the sludge with a solids content of 1, 2 and 3.8% respectively, showing improvement in dewaterability with an increase in sludge solids content. Sludge effluent quality and sludge settling rate were also improved in treatments with higher solids content after the bioleaching process.

• 한국농공학회논문집
• /
• 제55권2호
• /
• pp.21-27
• /
• 2013

The present study explored the way to desalinate seawater for agricultural irrigation using forward osmosis (FO) process using liquid fertilizer as draw solution. FO experiments were performed in a cross flow mode using flat sheet FO membrane. The effect of membrane orientation, flow rate, and draw solution concentration on the performance of forward osmosis was investigated by measuring water flux of forward osmosis membrane. The water flux when the draw solution was placed against the membrane active layer was lower than the water flux when the feed solution was placed against the membrane active layer. This results indicated that the decrease of effective osmotic pressure by dilutive internal concentration polarization was less than that by concentrative internal concentration polarization. Increasing flow rate from 66.7 to 133.1 $cm^3$/min resulted in increase of the water flux when the membrane active layer orient to draw solution and feed solution, respectively. The reduction of resistance to water flow increased water flux at higher flow rate. The water flux of FO membrane increased with increasing draw solution concentration from 10000 to 30000 mg/L. The water flux for $KH_2PO_4$ draw solution was similar to that for commercial fertilizer. Optimization of FO process would contribute to economically desalinate brackish water for agricultural use.

• 한국안전학회지
• /
• 제16권1호
• /
• pp.18-24
• /
• 2001

The fatigue crack growth behavior of the SA516/70 steel which is used for pressure vessels was examined experimentally at room temperature, $-60^{\circ}C$,$-80^{\circ}C$ and $-100^{\circ}C$ with stress ratio of R=0.05, 0.1 and 0.3. Fatigue crack propagation rate da/dN related with stress intensity factor range ${\Delta}K$ was influenced by stress ratio in stable of fatigue crack growth (Region II) with an increase in ${\Delta}K$. The resistance of fatigue crack growth at low temperature is higher compared with that at room temperature, which is attributed to the extent of plasticity-induced by compressive residual stress according to the cyclic loads. Fractographic examinations reveal that the differences of the fatigue crack growth characteristics between room and low temperatures are mainly explained by the crack closure and the strengthening due to the plasticity induced and roughness induced.

• 한국마린엔지니어링학회:학술대회논문집
• /
• 한국마린엔지니어링학회 2001년도 추계학술대회 논문집(Proceeding of the KOSME 2001 Autumn Annual Meeting)
• /
• pp.80-87
• /
• 2001

The fatigue crack growth behavior of the SA516/60 steel which is used for pressure vessels was examined experimentally at room temperature $25^{\circ}C, -30^{\circ}C, -60^{\circ}C, -80^{\circ}C, -100^{\circ}C$ and -l2$0^{\circ}C$ with stress ratio of R=0.05, 0.1 and 0.3. Fatigue crack propagation rate da/dN related with stress intensity factor range ΔK was influenced by stress ratio in stable of fatigue crack growth (Region II) with an increase in ΔK. The resistance of fatigue crack growth at low temperature is higher compared with that at room temperature, which is attributed to the extent of plasticity-induced by compressive residual stress according to the cyclic loads. Fractographic examinations reveal that the differences of the fatigue crack growth characteristics between room and low temperatures are mainly explained by the crack closure and the strengthening due to the plasticity induced and roughness induced.

• 전기학회논문지
• /
• 제67권5호
• /
• pp.644-650
• /
• 2018

According to a miniaturization and integration of electric device, a little size of fuse satisfying the current carrying capacity as well as an explosive tolerance and current interrupt rating are required. Fe-Ni alloy is applied to decrease an oxidation of fuse elements. A resistance and T.C.R(temperature coefficient of resistance) of a fuse are analyzed by changing a content of Ni And full rated current I-T curve from 1A to 6.3A has been tested. In order to an explosive energy, a straight wire type is selected to reduce a fuse melting time. An interrupt rating test was conducted by changing a content of Ni and the optimal content of Ni is to be 40%.

• 한국식품저장유통학회지
• /
• 제15권2호
• /
• pp.197-202
• /
• 2008

백복령분말의 첨가량에 따른 밀가루 반죽의 품질특성에 미치는 영향을 알아보기 위하여 백복령분말을 $0{\sim}5%$의 비율로 첨가하여 반죽의 물리적 특성을 비교 분석한 결과는 다음과 같다. 백복령분말을 첨가한 Mixograph에서는 midline peak time는 분말첨가에 따라 $1{\sim}2%$에서는 증가하였고 $3{\sim}5%$에서는 대구조보다 감소하였다. Midline peak height는 대구조보다 모두 감소하였다. 주사현미경관찰은 백복령분말 첨가량이 증가할수록 기공이 크고 불균일하였다. Farinogragh 특성 중 반죽의 점조도와 수분 흡수율은 백복령분말의 첨가량이 증가할수록 증가하였고, 반죽 형성시간과 안정도는 감소하였다. 주사현미경에서는 백복령분말 첨가량이 증가할수록 기공이 거칠고 크게 나타났다.