• Journal of Bio-Environment Control
• /
• v.8 no.1
• /
• pp.42-48
• /
• 1999

This study was executed to see the effects of Ca : K ratios in me.L$^{-1}$ -0:9, 1.5:7.5, 3:6, 4.5:4.5, 6:3 - in the nutrient solution on the photosynthesis, transpiration, growth and incidence of tipburn in butterhead ‘Omega’and Leaf ‘Grand Rapids’lettuce (Lactuca sativa. L) grown in nutrient film technique(NFT). The photosynthesis of both lettuces showed high in the Ca : K ratios of 3:6 and 4.5:4.5 regardless of species. But stomatal resistance of Grand Rapids was higher than that of Omega. The highest transpiration rate of them was shown in the Ca : K ratio of 3:6. The transpiration rate of developing leaves was lower than that of expanded leaves. It was seemed to have relation with incidence of tipbum in the developing leaves. The nutrient solution treatment without Ca developed less growth than that of other treatments, especially growth and development of apical part were inhibited, so that in the both of them incidence of tipburn appeared 100 percent. The incidence of tipburn in Omega appeared 25 percent in the Ca/K ratio of 1.5:7.5, but Grand Rapids did not show it according to the Ca/K ratio in nutrient solution. The highest growth in two species was also shown in the Ca/K ratio of 3:6 except nutrient solution without Ca. This study suggested that the unbalanced ratio of Ca/K affected Ca transport in two species because of the increase of stomatal resistance and diffusive resistance and the decrease of photosynthesis and transpiration.

• Journal of Korean Society of Water and Wastewater
• /
• v.20 no.5
• /
• pp.677-684
• /
• 2006

Electro-flotation(EF), a novel sludge thickening method, could improve the dewaterability of activated sludge. The gas(microbubbles) generated during EF decreased the solid-liquid separation time below 1/5 of the time required for gravity sedimentation. In addition, over 90% of the sludge volume reduction could be achieved by EF although the settling characteristics of the sludge was very poor. The SRF(specific resistance to filtration) of the thickened sludge by EF was much lower than that of the sludge thickened by gravity sedimentation. The SRF of the thickened sludge decreased exponentially with increase of gas generation rate of the EF system. Gas generation rate could be controlled by varying the current density of the electrode. Degasing of the microbubbles by vigorous mixing of the thickened sludge layer deteriorated the dewaterability of the sludge. Therefore, it is obvious that the gas bubbles entrapped in the thickened sludge play a key role in the observed dewaterability improvement.

• Journal of Life Science
• /
• v.19 no.5
• /
• pp.625-632
• /
• 2009

The purpose of this study was to examine the effect of exercise training on nitric oxide (NO) levels, mean arterial pressure (MAP), blood pressure (BP), and heart rate (HR) in college students. 5 subjects were randomly assigned to two experimental groups; an aerobic training group (ATG) and a resistance training group (RTG). In aerobic training, based on measured maximum oxygen consumption rate, 70% exercise intensity was applied and conducted for 60 min. In resistance training, 70% of 1-RM was performed for 90 min. Blood sampling was conducted 3 times during resting state, post-exercise, and after 30 minutes of recovery. The results are as followed. For the post training values of $VO_2max$, % body fat and MAP, there were significant differences in the ATG compared to pre training (p<0.05). However, there were no differences in the RTG between pre and post training. NO increased post training, during rest and at the end of exercise compared to pre training in the ATG (p<0.05). Also, the HR decreased in post training at the end of exercise (p<0.05), however, there were no significant differences in SBP and DBP between pre and post training in the ATG. The HR, SBP and DBP did not change at all in post training compared to pre training in the RTG. In conclusion, an increase in the production of Nitric Oxide (NO) concentration and $VO_2max$, decrease of body fat% and physiological variables (HR, BP, MAP) were shown to be more effective in aerobic training (AT) than resistance training (RT).

• Journal of Korea Foundry Society
• /
• v.28 no.3
• /
• pp.119-123
• /
• 2008

Wear test on two die steels for aluminum die casting was carried out by dipping and rotating the specimens into the molten aluminum maintained $680^{\circ}C{\sim}780^{\circ}C$. The rotating speed of the specimen was $4.5rpm{\sim}20.0rpm$. Diffusion layer was formed between the die steel and molten aluminum, and became thicker with dipping time. Wear rate was not proportional with the thickness of the diffusion layer, but was closely related to the density of the diffusion layer. Wear rate was little affected by the kind of die steel and by the microstructure such as martensite, tempered martensite, and pearlite. Specimen with nitrided surface showed good wear resistance, and its wear rate was decreased with increase in the thickness of nitrided layer. While whole surface was worn in heat treated specimens, wear of nitrided specimens was proceeded by pitting partially.

• Advances in environmental research
• /
• v.3 no.3
• /
• pp.199-206
• /
• 2014

Dewatering is an extremely important step in wastewater treatment process to reduce the final sludge volume in order to minimize the cost of sludge transportation and disposal. In the present study, the effect of different sludge solids content (1, 2 and 3.8%) on the dewaterability of anaerobically digested sludge using Acidithiobacillus ferrooxidans and Acidithiobacillus thiooxidans was studied. The pH reduction rate was higher during initial process in the sludge having low solids content, but after 48 h of bioleaching, similar pH of below 3 was observed with all the different solids content. Bio-oxidation rate of $Fe^{2+}$ was initially higher in sludge with low solids content, but 100% $Fe^{2+}$ was oxidized within 60 h in all the three treatment levels. Compared to the control, specific resistance to filtration was reduced by 75, 78 and 80% in the sludge with a solids content of 1, 2 and 3.8% respectively, showing improvement in dewaterability with an increase in sludge solids content. Sludge effluent quality and sludge settling rate were also improved in treatments with higher solids content after the bioleaching process.

• Journal of The Korean Society of Agricultural Engineers
• /
• v.55 no.2
• /
• pp.21-27
• /
• 2013

The present study explored the way to desalinate seawater for agricultural irrigation using forward osmosis (FO) process using liquid fertilizer as draw solution. FO experiments were performed in a cross flow mode using flat sheet FO membrane. The effect of membrane orientation, flow rate, and draw solution concentration on the performance of forward osmosis was investigated by measuring water flux of forward osmosis membrane. The water flux when the draw solution was placed against the membrane active layer was lower than the water flux when the feed solution was placed against the membrane active layer. This results indicated that the decrease of effective osmotic pressure by dilutive internal concentration polarization was less than that by concentrative internal concentration polarization. Increasing flow rate from 66.7 to 133.1 $cm^3$/min resulted in increase of the water flux when the membrane active layer orient to draw solution and feed solution, respectively. The reduction of resistance to water flow increased water flux at higher flow rate. The water flux of FO membrane increased with increasing draw solution concentration from 10000 to 30000 mg/L. The water flux for $KH_2PO_4$ draw solution was similar to that for commercial fertilizer. Optimization of FO process would contribute to economically desalinate brackish water for agricultural use.

• Journal of the Korean Society of Safety
• /
• v.16 no.1
• /
• pp.18-24
• /
• 2001

The fatigue crack growth behavior of the SA516/70 steel which is used for pressure vessels was examined experimentally at room temperature, $-60^{\circ}C$,$-80^{\circ}C$ and $-100^{\circ}C$ with stress ratio of R=0.05, 0.1 and 0.3. Fatigue crack propagation rate da/dN related with stress intensity factor range ${\Delta}K$ was influenced by stress ratio in stable of fatigue crack growth (Region II) with an increase in ${\Delta}K$. The resistance of fatigue crack growth at low temperature is higher compared with that at room temperature, which is attributed to the extent of plasticity-induced by compressive residual stress according to the cyclic loads. Fractographic examinations reveal that the differences of the fatigue crack growth characteristics between room and low temperatures are mainly explained by the crack closure and the strengthening due to the plasticity induced and roughness induced.

• Proceedings of the Korean Society of Marine Engineers Conference
• /
• 2001.11a
• /
• pp.80-87
• /
• 2001

The fatigue crack growth behavior of the SA516/60 steel which is used for pressure vessels was examined experimentally at room temperature $25^{\circ}C, -30^{\circ}C, -60^{\circ}C, -80^{\circ}C, -100^{\circ}C$ and -l2$0^{\circ}C$ with stress ratio of R=0.05, 0.1 and 0.3. Fatigue crack propagation rate da/dN related with stress intensity factor range ΔK was influenced by stress ratio in stable of fatigue crack growth (Region II) with an increase in ΔK. The resistance of fatigue crack growth at low temperature is higher compared with that at room temperature, which is attributed to the extent of plasticity-induced by compressive residual stress according to the cyclic loads. Fractographic examinations reveal that the differences of the fatigue crack growth characteristics between room and low temperatures are mainly explained by the crack closure and the strengthening due to the plasticity induced and roughness induced.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.67 no.5
• /
• pp.644-650
• /
• 2018

According to a miniaturization and integration of electric device, a little size of fuse satisfying the current carrying capacity as well as an explosive tolerance and current interrupt rating are required. Fe-Ni alloy is applied to decrease an oxidation of fuse elements. A resistance and T.C.R(temperature coefficient of resistance) of a fuse are analyzed by changing a content of Ni And full rated current I-T curve from 1A to 6.3A has been tested. In order to an explosive energy, a straight wire type is selected to reduce a fuse melting time. An interrupt rating test was conducted by changing a content of Ni and the optimal content of Ni is to be 40%.

• Food Science and Preservation
• /
• v.15 no.2
• /
• pp.197-202
• /
• 2008

The effects of flour dough by addition of Poria Cocos Wolf powder were investigated in dough added with $0{\sim}5%$ powder by evaluation of dough. Rheological properties of dough by mixograph, farinograph, alveograph and extensograph, and scanning electron microscope. The water absorption rate and resistance were increased by Increase of Poria Cocos Wolf powder. Mixograph for dough stability and v/v point dough were increased in dough added $1{\sim}2$ percent of Poria Cocos Wolf powder. In water absorption, stability and valorimeter value of the dough increased in weakness of the dough, as revealed through farinogram, extensiblity, resistance to extension, and energy increased in R/E ratio, as revealed through extensogram. Scanning electron microscope of bread wasn't changed by Poria Cocos Wolf powder.