• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.28 no.6
• /
• pp.497-500
• /
• 2017

This paper proposes a circularly polarized microstrip antenna using an I-shape ground slot perturbation and a perpendicular feeding network. The proposed antenna consists of the symmetrical and perpendicular feeding and the microstrip square radiator loaded with the I-shape ground slot perturbation. The left-handed circular polarization(LHCP) formed by a 90-degree phase difference can be radiated by the perpendicular feeding network and the ground slot perturbation. An implemented antenna is designed for the use in the satellite communication system operated in S-band of 2.2 GHz, and is to be the 91 MHz of -10 dB bandwidth. The measured results of the antenna gain, far-field radiation pattern, and axial ratio agree well with the simulation results.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.43 no.7 s.349
• /
• pp.156-161
• /
• 2006

In this paper, an E-patch antenna on the U-shaped ground plane is designed and experimental studied. In order to reduce to cross-polarization level and to enhance the gain of the microstrip patch antenna, a U-shaped ground plane is employed in the microstrip patch antenna. As a main radiator, an E-shaped patch is used to reduce the antenna size as small as possible. Also to enhance the bandwidth of the antenna, a substrate of the lowest permittivity of which thickness as thick as possible is used and a rectangular patch is overlaid on the air substrate of the E-shaped patch antenna. The radiation characteristics of the antenna are calculated by CST Microwave Studio 5.0 simulation software. Experimental results show that by increasing the height of the sidewall of the ground plane, the antenna gain is increased and the cross-polarization level is decreased.

• Aerospace Engineering and Technology
• /
• v.10 no.2
• /
• pp.20-28
• /
• 2011

The electro-optical payload of a low-earth orbit satellite is thermally decoupled with the bus, which supports a payload for a mission operation. The payload has a cooling unit of FPA(Focal Plane Assembly) which has a thermal behavior increasing its temperature instantly during an operation in order to dissipate a waste heat into the space. The FPA cooling unit should include a radiator and heatpipes with a sufficient performance in worst hot condition, and a heater design to maintain its temperature above a minimum allowable temperature in the worst cold condition. In this paper, we analyzed the thermal requirements and the heater design constraints from the thermal analysis results for the current thermal design of the FPA cooling unit and the design elements of the better heater design were found.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38A no.10
• /
• pp.885-892
• /
• 2013

The main advantage of ESPAR antenna is that ESPAR antenna requires only a single RF chain for reduction of transceiver's hardware complexity, as compared to conventional MIMO system. In conventional MIMO system, each data symbol is mapped to each antenna. But, each data symbol is mapped to each orthogonal basis pattern in ESPAR antenna system. In this paper, we design beamspace MIMO system using ESPAR antenna with single RF chain for MIMO system of low-complexity and low power consumption. And then, we analyze performance of beamspace MIMO according to each PSK modulation. Performance of beamspace MIMO system is similar to performance of conventional MIMO system. As a result of analyzing the performance of beamspace MIMO system using higher-order PSK modulation. we can confirm that performance characteristic of beamspace MIMO system with low complexity and low power consumption is similar to digital communication of signal domain.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.10 no.7
• /
• pp.1131-1137
• /
• 1999

In this paper, a novel design method of an apertured coupled microstrip patch antenna with the single feeding structure is proposed for dual resonance frequencies with mutually perpendicular polarizations. The characteristics of this antenna are experimentally investigated. In order to achieve this goal, a new type of square patch with double notches is used as a radiator and the crossed slot and the bended mictrostrip feeder are adopted for the dual polarizations in the aperture-coupled structure. For the application of the proposed antenna, a Ku-band Tx/Rx $2\times$ subarray antenna is designed and manufactured. Also, the applicability of the antenna as a ground terminal is examined through performance analysis. According to the measurement, the gain of the antenna is 10dBi at the center frequencies of Tx and Rx, the side lobe level is lower than -13dB, and the cross polarization lebel is below 17 dB.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.10 no.7
• /
• pp.1022-1032
• /
• 1999

The radiation characteristics of a microstrip circularly-polarized aperture-patch $8\times8$ array antenna are investigated at X-band. The radiator consists of a truncated square aperture on the ground plane with an inclined rectangular patch inside, and it is coupled by a microstrip line on the opposite side of the ground. The element spacing of the array was chosen as $0.8\lambda_0$so as to minimize the mutual coupling and maximize the gain. A corporate feed network was employed to distribute the power to each element through four Wilkinson and two T-junction dividers. Measurement results for the $8\times8$ array at 10 GHz showed a directivity of 26.3 dBi, a gain of 22.2 dBi, an axial ratio of 2.97 dB, and a side lobe level of -12.7dB. It was observed that when the array size increases, the directivity increases while the efficiency decreases.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.10 no.7
• /
• pp.1138-1147
• /
• 1999

In this paper, two types of $2\times2$ Rx/Tx microstrip patch antenna are proposed to implement Ku-band satellite communications. The single-fed dual resonance patch antenna as the first type derives perpendicular polarizations at two resonant frequencies from a single patch radiator, using aperture coupling via a bended single-feeding line and a cross-shaped slot. The double-fed dual resonance patch antenna as the second type implements dual resonance with mutually orthogonal polarizations by mixing the two feeding mechanisms of the microstrip line and the aperture coupling. Especially, in the double-fed dual resonance antenna case, air-gap is introduced to broaden the bandwidth. Through measurement, each of the two types of antenna was verified to function properly both Rx and Tx. The double-fed dual resonance antenna shows excellent performance in the bandwidth and the crosspolarization characteristics.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.18 no.1 s.116
• /
• pp.24-30
• /
• 2007

A windmill-shaped loop antenna is designed for polarization diversity. Its circumference is almost 10 times that of a conventional small loop antenna whose circumference is less than ${\lambda}/10$ but its the radiation pattern is omni-directional. An identical parasitic element is placed over the radiator to match the antenna input impedance. An equivalent transmission line and RLC circuit models are shown to fully describe for the windmill-shaped loop antenna. The proposed antenna has a bandwidth of 6 % with input VSWR less than 2:1 and a polarization purity of 15 dB at 2.6 GHz, and the gain of 1.5 dBi. The simulated and measured results show fairly good agreement.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.25 no.6
• /
• pp.619-627
• /
• 2014

In this paper, we designed a blade antenna for VHF-UHF band(500 MHz~3 GHz) to be used as aircraft antennas. Unlike previously reported researches that use high-dielectric materials and insert rectangular extended grounds, the antenna structure was designed by optimizing the curvature of both a radiator and an extended ground whose shape is varied by changing the exponent of an n-th polynomial. Based on the optimized structure, we measured impedance matching and gain performances to evaluate the antenna in the VHF-UHF band(500 MHz~3 GHz). As a result, we confirmed that the antenna shows matching characteristics of less than -6 dB and has average gains of greater than -5 dBi in the entire VHF-UHF band.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.3
• /
• pp.315-320
• /
• 2010

In this paper, an internal TDMB(Terrestrial Digital Multimedia Broadcasting) antenna for mobile phone is proposed. The overall dimension of designed antenna with substrate is 30 mm$\times$5 mm$\times$0.6 mm. The proposed antenna consists of a meander type radiator which is connected front- and back-plane of Kapton substrate by via hole and parasitic element for tuning the resonant frequency. And to compensate the electric length of desired frequency, passive inductor is used for matching element. Measured gain of the implemented antenna -17.6 dBi at 174 MHz, -13.01 dBi at 195 MHz, and -14.9 dBi at 216 MHz.