• The Korean Journal of Ceramics
• /
• 제2권3호
• /
• pp.125-130
• /
• 1996

Hematite iron ore and waste iron oxide sludge containing about 3-5 wt% $SiO_2$ were purified by three types of method developed on the basis of the Bayer process which is known as the purification process of bauxite ore. The basic principle of the developed methods lies in the fact that the impurities contained in the iron oxides, such as $SiO_2$ and $Al_2O_3$ are soluble in the alkaline reagents. Reaction of the raw materials with KOH was done in pressure vessel, at atmospheric pressure, and by both of these two. By the pressure vessel method $SiO_2$ content was reduced to below 0.5 wt% in the waste iron oxide sludge, while, in iron ore, $SiO_2$ remained at 2-3 wt%. The atmospheric pressure reaction rendered the waste iron oxide sludge $SiO_2$ content below 0.5wt% when the reaction temperature increased to above 90$0^{\circ}C$. The combined method of two previous methods was the most effective process and rendered the refined iron oxide about 300-400ppm of $SiO_2$. Using some refined iron oxides, Ba-ferrite was produced and magnetic properties were measured. The highest quality of magnetic properties obtained in this study were Br=2.09 G, bHc=1.99 KOe, iHc=4.54 KOe, $(BH)_{max}$=1.06 MGOe. Effect of sintering condition and chemical composition will be discussed.

• Journal of Microbiology
• /
• 제42권3호
• /
• pp.228-232
• /
• 2004

In this paper, we investigated the development of a simplified and rapid primary capture step for the recovery of M13 bacteriophage from particulate-containing feedstock. M13 bacteriophage, carrying an insert, was propagated and subsequently purified by the application of both conventional multiple steps and expanded bed anion exchange chromatography. In the conventional method, precipitation was conducted with PEG/NaCl, and centrifugation was also performed. In the single step expanded bed anion exchange adsorption, UpFront FastLine$\_$TM/20 (20mm i.d.) from UpFront Chromatography was used as the contactor, while 54$m\ell$ (H$\_$o/=15cm) of STREAMLINE DEAE (p=1.2 g/㎤) from Amersham Pharmacia Biotechnology was used as the anion exchanger. The performance of the two methods were evaluated, analysed, and compared. It was demonstrated that the purification of the M13 bacteriophage, using expanded bed anion exchange adsorption, yielded the higher recovery percentage, at 82.86％. The conventional multiple step method yielded the lower recovery percentage, 36.07％. The generic application of this integrated technique has also been assessed.

• 대한본초학회지
• /
• 제22권4호
• /
• pp.21-28
• /
• 2007

Objectives : Kyenegum has been popularly used long as the digestive. The purpose of this study was to investigate the purification and characteristics of protease obtained from Kyenegum crude enzyme. Methods : Kyenegum protease was purified by precipitation with ammonium sulfate followed by SP-Spharose ion exchange chromatography. The molecular weight of Kyenegum protease was estimated by SDS-PAGE electrophoresis. Results : Kyenegum protease was 3,087 units/mg protein specific activity, 14.5 purification fold and 9.8 % recovery. The molecular weight of protease was estimated to be 18 kDa. The isoelectric point was pI 8.97 and values of Km and Vmax of its were 48 mg/mL and 2 units/min, respectively. Conclusion : The result suggests that the protease obtained from Kyenegum has excellent stability of temperature, acid and collagen substrate specificity.

• 한국식품과학회지
• /
• 제48권6호
• /
• pp.542-547
• /
• 2016

The thermal properties of ramie leaf ${\beta}$-amylase (RBA) were examined to develop a novel process for enzyme purification. The thermostability of RBA extract prepared from ramie leaf powder was examined at various temperatures. RBA activity decreased slightly, whereas other carbohydrate-active enzymes, such as $\small{D}$-enzyme, were rapidly inactivated during 30 min incubation at $60^{\circ}C$. When the heat-treated extract was incubated with various substrates, maltose was produced exclusively as the major product, whereas the untreated crude extract produced maltose and other maltooligosaccharides. In sodium dodecyl sulfate-polyacrylamide gel electrophoresis analysis, fewer protein bands were observed for the heat-treated extract than the untreated extract, indicating that the thermostable RBA was partially purified and other thermolabile enzymes were eliminated. Thus, the treatment of the RBA extract at $60^{\circ}C$ for 30 min resulted in 5.4-fold purification with a recovery yield of 90%.

• Membrane and Water Treatment
• /
• 제1권1호
• /
• pp.1-12
• /
• 2010

Membrane distillation process was used for purification of pre-treated natural water (tap water). The rejection of inorganic and organic compounds in this process was investigated. The obtained rejection of inorganic solutes was closed to 100%, but the volatile organic compounds (VOCs) diffused through the membrane together with water vapour. The content of trihalomethanes (THMs) in the obtained distillate was two-three fold higher than that in the feed, therefore, the rejection of the total organic compounds present in the tap water was reduced to a level of 98%. The intensive membranes scaling was observed during the water separation. The morphology and composition of the fouling layer was studied using scanning electron microscopy coupled with energy dispersion spectrometry. The influence of thermal water pre-treatment performed in a heat exchanger followed by filtration on the MD process effectiveness was evaluated. This procedure caused that significantly smaller amounts of $CaCO_3$ crystallites were deposited on the membrane surface, and a high permeate flux was maintained over a period of 160 h.

• 한국생물공학회:학술대회논문집
• /
• 한국생물공학회 2003년도 생물공학의 동향(XII)
• /
• pp.501-504
• /
• 2003

A novel prepurification method was developed aiming at increasing yield and purity, also reducing solvent usage for purification of paclitaxel. This method was a simple and efficient procedure, for the isolation and prepurification of paclitaxel from the biomass of Taxus chinensis, consisting of micelle formation, followed by two steps of precipitation. The use of a micelle and precipitation in the prepurification process allows for rapid separation of paclitaxel from interfering compounds and dramatically reduces solvent usage compared to alternative methodologies. This prepurification process serves to minimize the size and complexity of the HPLC operations for paclitaxel purification. This process is readily scalable to a pilot plant and eventually to a production environment where multikilogram quantities of material are expected to be produced. As much as possible, the process has been optimized to minimize solvent usage, complexity, and operating costs.

• 한국전산유체공학회지
• /
• 제22권1호
• /
• pp.1-7
• /
• 2017

The mixing of water and chemicals is an important process in the water purification plant. In this paper, we compare PDM(pump diffusion mixer) and hydraulic mixer at the basin in the mixing process. The proper flow rates are predicted and compared in both mixers using CFD technique. As a result, the flow rate of purifier chemical liquid should be 5% of that of water for the optimal performance of mixing process. The characteristics of the two mixing methods are compared with each other for strong and weak points on the operation of the purification system, discussed in the view point of CFD simulations.

• 생명과학회지
• /
• 제14권2호
• /
• pp.225-228
• /
• 2004

나타마이신 배양액을 4$^{\circ}C$와 실온에서 14일 동안 보관하였을 때, 4$^{\circ}C$에서는 나타마이신의 활성이 80% 이상 유지되었으나 실온에서는 27%로 급격하게 감소하였다. 이러한 사실은 나타마이신의 손실을 최소화하기 위해서는 최단 시간 내에 배양액으로부터의 나타마이신을 회수할 필요성과 장기간 보관 시에는 4$^{\circ}C$이하에서 보관할 필요성을 제시하고 있다. 효율적인 나타마이신 정제과정을 개발하기 위해 배양액으로부터의 나타마이신의 추출 용매 및 적정 사용량에 대해 조사한 결과 2g의 나타마이신을 추출하는데 1 l의 methanol을 사용하는 것이 가장 효율적이었다. 확립된 나타마이신 추출에 필요한 methanol의 양과 Diaion HP-20을 이용한 column chromatography를 적용하여 4.2 g의 나타마이신이 함유된 1,800 ml의 배양액으로부터 2.9 g의 나타마이신을 획득하였다. 본 연구에서 개발된 정제과정을 통해 순도가 96.6%이고 회수율이 69.1%인 나타마이신을 얻을 수 있었다.

• 상하수도학회지
• /
• 제32권6호
• /
• pp.487-497
• /
• 2018

Water quality improvement processes for stagnant area consist mainly of technologies applying vegetation and artificial water circulation, and these existing technologies have some limits to handle pollution loads effectively. To improve the purification efficiency, eco-friendly technologies should be developed that can reinforce self-purification functions. In this study, a multi-functional floating island combined with physical chemical biological functions ((1) flotation and oxidization using microbubbles, (2) vegetation purification and (3) bio-filtration with improved adsorption capacity) has been developed and basic experiments were performed to determine the optimal combination conditions for each unit process. It has been shown that it is desirable to operate the microbubble unit process under conditions greater than $3.5kgf/cm^2$. In vegetation purification unit process, Yellow Iris (Iris pseudacorus) was suggested to be suitable considering water quality, landscape improvement and maintenance. When granular red-mud was applied to the bio-filtration unit process, it was found that T-P removal efficiency was good and its value was also stable for various linear velocity conditions. The appropriate thickness of filter media was suggested between 30 and 45 cm. In this study, the optimal design and operating parameters of the multi-functional floating island have been presented based on the results of the basic experiments of each unit process.

• 공업화학
• /
• 제32권3호
• /
• pp.290-298
• /
• 2021

천연 흑연의 음극재 적용을 위하여 정제 공정을 실시하였으며, 공정에 따른 흑연의 구조적 변화와 불순물 함량이 음극 특성에 미치는 영향을 고찰하였다. 천연 흑연은 불화암모늄과 황산을 동일 비로 하여 사용량을 달리한 산처리 및 온도(800~2500 ℃)를 달리한 열처리를 통하여 화학적/물리적으로 정제되었다. 산을 이용한 불순물 제거는 한계가 있었으며, 이후 진행된 2500 ℃까지의 열처리를 통해 Si과 같은 일부 원소를 제외하고 대부분의 불순물이 전량 제거되는 것을 확인하였다. 복합 정제 공정에 따라 제조된 흑연 음극재의 특성이 향상되었으며, 구조와 불순물 함량 변화는 각각 용량 및 속도 특성과 초기 쿨롱 효율에 지배적인 영향을 미쳤다. 복합 정제 공정은 흑연 구조를 향상시켰으며, 불순물을 효율적으로 제거하여 SEI층 형성 억제 및 Li⁺ 삽입 공간 확대를 통해 리튬 이온 전지의 성능을 향상시켰다.