• 한국컴퓨터산업학회논문지
• /
• 제2권8호
• /
• pp.1015-1024
• /
• 2001

인터넷 환경이 급속도로 변화하면서, 관리해야하는 내부 네트워크의 규모도 커지게 되었다. 이에 따라서 보안의 중요성에 대한 인식이 확대되고, 내부 정보의 보호를 위해 많은 보안 시스템이 도입되었다. 그러나 분산된 보안 시스템들은 각각이 다른 사용자 인터페이스로 인하여 효율적인 보안관리가 어려울 뿐만 아니라 장애발생 시 일괄적이고 즉각적인 대처가 어렵고 관리 인력의 비대화를 야기 시킨다. 따라서 본 논문에서는 시스템의 일관적이고 통합적인 관리를 위해서 중앙에서 각 시스템의 상태를 파악하고 관리하는 통합보안관리시스템을 제안한다. 제안하는 통합보안관리시스템은 다중 에이전트를 이용함으로써 장애 대처가 빠르며, 각각의 보안 솔루션들에 대한 취약점을 최소화할 수 있고, 분산된 보안 시스템들을 일괄적으로 통제 및 관리할 수 있다.

• Journal of Nutrition and Health
• /
• 제33권4호
• /
• pp.464-476
• /
• 2000

The purpose of this study was to measure patient satisfaction with hosptial foodservices, and thereby identify areas for improvement and provides basic data for the introduction of total quality management into hospital foodservice in the Taegu·Kyungpook area. This survey was carried out on 676 hospitalized patients in 11 hospitals with over 200 beds to determine the quality satisfaction with foodservices. The subjects were 62.4% male and 37.6% female. Sixty-two percent of the subjects were over age 40, 46.7% were only educated to middle school or below, 41.8% were hospitalized for 1 - 10 days. Eighty-seven precent of the subjects did not receive any nutrition education. The expectation and perception grid showed that the high expectation to the low perception items were the seasoning of the meals, taste of the meals, and prompt dealings with meal complaints. The quality satisfaction values of all the attributes indicated a minus. The unsatisfied quality attributes were the opportunity to meet with a dietitian, seasoning of the meals, taste of the meals, explanation of the meals, and prompt dealings with meal complaints. Among the demographic characteristics, age, education, length of admission, and experience with nutrition education produced significant differences in the quality satisfaction scores. In conclusion, it would seem to be desirable that hospital foodservice department introduce selective menus, hygiene education for foodservice employees, standard recipes, quality assurance, and increase the meal rounding of dietitians in the patient foodservice.

• Clinical and Experimental Pediatrics
• /
• 제62권12호
• /
• pp.433-437
• /
• 2019

Acute pyelonephritis (APN) should be detected and treated as soon as possible to reduce the risk of the development of acquired renal scarring. However, in the medical field, urine culture results are not available or considered when the prompt discrimination of APN is necessary and empirical treatment is started. Furthermore, urine culture cannot discriminate APN among children with febrile urinary tract infection (UTI) (pyelitis, lower UTI with other fever focus). Therefore, the usefulness of urine culture for diagnostic purposes is small and the sampling procedure is invasive. Congenital hypoplastic kidney is the most common cause of chronic kidney injury in children. Thus, it is desirable that a main target be detected as early as possible when imaging studies are performed in children with APN. However, if APN does not recur, no medical or surgical treatment or imaging studies would be needed because the acquired renal scar would not progress further. Therefore, the long-term prognosis of APN in young children, particularly infants, depends on the number of recurrent APN, not other febrile UTI. New methods that enable prompt, practical, and comfortable APN diagnosis in children are needed as alternatives to urinary catheterization for urine culture sampling.

• 대한기계학회논문집B
• /
• 제31권1호
• /
• pp.99-108
• /
• 2007

In this study, the NOx formation characteristics of one-dimensional $CH_4$/Air premixed flame using detailed-kinetic chemistry are examined numerically. The combustor length and the amount of heat loss are varied to investigate the effect of residence time and heat loss on the NOx formation in a post-flame region. In the flame region, NO is mainly produced by the Prompt NO mechanism including $N_2$O-intermediate NO mechanism over all equivalence ratios. However, thermal NO mechanism is more important than Prompt NO mechanism in the post-flame region. In the case of adiabatic condition, the increase of combustor length causes the remarkable increase of NO emission at the exit due to the increase of residence time. On the other hand, NO reaches the equilibrium state in the vicinity of flame region, considering radiation and conduction heat losses. Furthermore the NO, in the case of $\phi$=1.2, is gradually reduced in the downstream region as the heat loss is increased. From these results, it can be concluded that the controls of residence time and heat loss in a combustor should be recognized as an important NOx reduction technology.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2000년도 춘계학술대회논문집B
• /
• pp.949-955
• /
• 2000

Numerical study with detailed chemistry has been conducted to investigate the NOx formation and structure in $CH_4/Air-CO_2$ counterflow diffusion flames. The importance of radiation effect is identified and the role of $CO_2$ addition is addressed to thermal and chemical reaction effects, which can be precisely specified through the introduction of an imaginary species. Also NO separation technique is utilized to distinguish the contribution of thermal and prompt NO formation mechanisms. The results are as follows : The radiation effect is dominant at low strain rates and it is intensified by $CO_2$ addition. Thermal effect mainly contributes to the changes in flame structure and the amount of NO formation but the chemical reaction effect also cannot be neglected. It is noted that flame structure is changed considerably due to the addition of $CO_2$ in such a manner that the path of methane oxidation prefers to take $CH_4 {\rightarrow}CH_3{\rightarrow}C_2H_6{\rightarrow}C_2H_5$ instead of $CH_4 {\rightarrow}CH_3{\rightarrow}CH_2{\rightarrow}CH$. At low strain rate(a=10) the reduction of thermal NO is dominant with respect to reduction rate, but that of prompt NO is dominant with respect to total amount.

• Restorative Dentistry and Endodontics
• /
• 제29권4호
• /
• pp.339-345
• /
• 2004

The aim of this study was to measure and compare the micro shear bond strengths of the following dentin bonding systems to the dentin surfaces under simulated pulpal pressure: All Bond $2^{\circledR},{\;}Second^{\circledR},{\;}AdheSE^{\circledR}$, Adper Prompt $L-Pop^{\circledR}$. The occlusal surfaces of 180 extracted human molars were prepared so the dentin bonding surfaces could be exposed. The teeth were randomly assigned to 3 equal groups of 60 each and subdivided. The dentin surfaces were treated with the above mentioned bonding system and resin composite cylinders were built up under a simulated pulpal pressure when saline (Group II) or diluted bovine serum (Group III) was used as the pulpal fluid. As a control. the same procedures were performed in the dried dentin surfaces (Group I). After one day of storage in water. the micro shear bond strengths were measured using an EZ tester. Group II and III showed significantly lower shear bond strength than Group I statistically (p < 0.05). $SEbond^{\circledR}{\;}and{\;}AdheSE^{\circledR}$ showed no difference among the different dentin condition. In the Adper Prompt $L-Pop^{\circledR}$. a simulated pulpal pressure were applied to the specimens using diluted bovine serum. which showed a higher strength than the specimens in which saline was used (p < 0.05).

• Nuclear Engineering and Technology
• /
• 제49권4호
• /
• pp.700-709
• /
• 2017

This work looks at the effect of changes in kinetic parameters on simultaneous reactivity insertions and beam tube flooding in a typical material testing reactor-type research reactor with low enriched high density ($U_3Si_2-Al$) fuel. Using a modified PARET code, various ramp reactivity insertions (from $0.1/0.5 s to $1.3/0.5 s) plus beam tube flooding ($0.5/0.25 s) accidents under uncontrolled conditions were analyzed to find their effects on peak power, net reactivity, and temperature. Then, the effects of changes in kinetic parameters including the Doppler coefficient, prompt neutron lifetime, and delayed neutron fractions on simultaneous reactivity insertion and beam tube flooding accidents were analyzed. Results show that the power peak values are significantly sensitive to the Doppler coefficient of the system in coupled accidents. The material testing reactor-type system under such a coupled accident is not very sensitive to changes in the prompt neutron life time; the core under such a coupled transient is not very sensitive to changes in the effective delayed neutron fraction.

• Nuclear Engineering and Technology
• /
• 제51권7호
• /
• pp.1758-1764
• /
• 2019

As the safety level of nuclear power plants (NPPs) relates to the safety of individuals, society, and the environment, it is important to establish NPP safety goals. In Korea, two quantitative health objectives and one large release frequency (LRF) criterion were formally set as quantitative safety goals for NPPs by the Nuclear Safety and Security Commission in 2016. The risks of prompt and cancer fatalities from NPPs should be less than 0.1% of the overall risk, and the frequency of nuclear accidents releasing more than 100 TBq of Cs-137 should not exceed 1E-06 per reactor year. This paper reviews the hierarchical structure of safety goals in Korea, its relationship with those of other countries, and the relationships among safety goals and subsidiary criteria like core damage frequency and large early release frequency. By analyzing the effect of the release of 100 TBq of Cs-137 via consequence analysis codes in eight different accident scenarios, it was shown that meeting the LRF criterion results in negligible prompt fatalities in the surrounding area. Hence, the LRF criterion dominates the safety goals for Korean NPPs. Safety goals must be consistent with national policy, international standards, and the goals of other counties.

• Nuclear Engineering and Technology
• /
• 제51권2호
• /
• pp.533-538
• /
• 2019

The mechanical-collimation imaging is the most mature technology in prompt gamma (PG) imaging which is considered the most promising technology for beam range verification in proton therapy. The purpose of the present study is to compare the performances of two mechanical-collimation PG cameras, knife-edge (KE) camera and multi-slit (MS) camera. For this, the PG cameras were modeled by Geant4 Monte Carlo code, and the performances of the cameras were compared for imaginary point and line sources and for proton beams incident on a cylindrical PMMA phantom. From the simulation results, the KE camera was found to show higher counting efficiency than the MS camera, being able to estimate the beam range even for $10^7$ protons. Our results, however, confirmed that in order to estimate the beam range correctly, the KE camera should be aligned, at least approximately, to the location of the proton beam range. The MS camera was found to show lower efficiency, being able to estimate the beam range correctly only when the number of the protons is at least $10^8$. For enough number of protons, however, the MS camera estimated the beam range correctly, errors being less than 1.2 mm, regardless of the location of the camera.

• Nuclear Engineering and Technology
• /
• 제54권6호
• /
• pp.2213-2220
• /
• 2022

The maximum dose delivery at the end of the beam range provides the main advantage of using proton therapy. The range of the proton beam, however, is subject to uncertainties, which limit the clinical benefits of proton therapy and, therefore, accurate in vivo verification of the beam range is desirable. For the beam range verification in spot scanning proton therapy, a prompt gamma detection system, called as gamma electron vertex imaging (GEVI) system, is under development and, in the present study, the performance of the GEVI system in spot scanning proton therapy was predicted with Geant4 Monte Carlo simulations in terms of shift detection sensitivity, accuracy and precision. The simulation results indicated that the GEVI system can detect the interfractional range shifts down to 1 mm shift for the cases considered in the present study. The results also showed that both the evaluated accuracy and precision were less than 1-2 mm, except for the scenarios where we consider all spots in the energy layer for a local shifting. It was very encouraging results that the accuracy and precision satisfied the smallest distal safety margin of the investigated beam energy (i.e., 4.88 mm for 134.9 MeV).