• Journal of the Korea Concrete Institute
• /
• v.11 no.3
• /
• pp.171-179
• /
• 1999

The present research investigated the interaction among loading level, corrosion rate and flexural deflection of reinforced concrete beams. 10cm$\times$15cm$\times$110cm reinforced concrete beams were prepared and subjected to different levels of flexural loading, including 0%, 45% and 75% of the ultimate load. The beams with either a pre-load or a sustained load were also exposed to a laboratory environment with ponding and wetting/drying cycling at room temperature. Half cell potential and galvanized current measurements were taken to monitor corrosion process of reinforcing steel. After corrosion initiation, external current was applied to some of the beams to accelerate corrosion propagation. The beam deflections were recorded during the entire tests. The results indicate that loading level has significant effect on corrosion rate. The beams under a sustained load had much higher corrosion rate than the pre-loaded and then unloaded beams. Significant corrosion may result in an increase in beam deflection and affect serviceability of the structure. The present research may provide an insight into structural condition evaluation and service life predictions of reinforced concrete.

• Korean Journal of Food Science and Technology
• /
• v.41 no.1
• /
• pp.32-36
• /
• 2009

The physical properties of freeze-dried Aloe vera gel powders were examined according to the influence of the concentration degrees of the gel solutions as raw materials during freeze-drying. As a pre-treatment prior to freeze-drying, the gel solutions were vacuum-concentrated at three concentration levels (g water/g solids): high (H), 76; medium (M), 119; and low (L), 159. The water contents of the three powder samples were almost the same. For their viscosity measurements, non-Newtonian fluid behavior with shear thinning was observed in samples H and M, whereas Newtonian liquid behavior was found in sample L. In electrical conductivity measurements, sample H showed the highest conductivity upon dissolving the powder in water. For their water sorption isotherms, sample H was analyzed to have the least amount of bound water. Finally, it was determined that the degree of concentration caused only slight differences in the physical properties of freeze-dried Aloe gel powders.

• Journal of Advanced Marine Engineering and Technology
• /
• v.27 no.2
• /
• pp.280-288
• /
• 2003

We need refrigeration system which can maintain the freshness of agricultural products, because of being distance from a tiller to a consumer. Vacuum Pre-cooling system has an advantage in quality maintenance through vapid cooling down by using latent heat of evaporation of stored products. A number or thawing methods in current use have also several disadvantages in thawing time. discoloration mass loss caused by drying, capital costs and running cost. These damages are, it is claimed, either eliminated or improved by the vacuum thawing system. An experimental study on the pre-cooling for the bean sprouts and cabbage, and thawing for hairtail and croaker by the low temperature vacuum system were carried out. The cabbage cooling time with this Pre-cooling vacuum system took about 60 minutes to reach from $23.2^{circ}C to 4.5^{\circ}C$ at 5 mmHg abs. ($6.66\times10^{-4}$ MPa). The croaker thawing time with this low temperature vacuum thawing system took about 170 minutes to reach from $-10.3^{circ}C to -0.8^{\circ}C$ at 20 mmHg abs ($2.67\tiems10^{-3}$MPa). The vacuum Pre-cooling and thawing system have merits compared with present systems in their short intervals to cool down and to thaw without any quality losses.

• Korean Journal of Environmental Agriculture
• /
• v.36 no.2
• /
• pp.113-118
• /
• 2017

BACKGROUND: The carbon (C) isotope ratio (${\delta}^{13}C$) of dissolved organic C (DOC) is an indicator of water pollution source. In this study, the potential use of two pre-treatments for the ${\delta}^{13}C$ analysis, alkaline persulfate oxidation coupled with carbonate precipitation (precipitation) and freeze drying (drying), were compared to suggest a more feasible pre-treatment method. METHODS AND RESULTS: Two reference materials with different ${\delta}^{13}C$ values were used for the experiments; chemical grade glucose ($-12.0{\pm}0.02$‰) and pig manure compost extract ($-23.3{\pm}0.04$‰). In the precipitation method, the measured ${\delta}^{13}C$ values were consistently lower than the theoretically calculated values as dissolved $CO_2$ could not be removed due to the alkaline property of the reagents and the dissolution of air $CO_2$ into the alkaline solution. The drying method also resulted in more negative ${\delta}^{13}C$ than the calculated ${\delta}^{13}C$; however, the difference was systematic ($3.9{\pm}0.3$‰) and there was a strong correlation (${\delta}^{13}C_{calculated}=0.87{\times}{\delta}^{13}C_{measured}-0.624$, $r^2=0.98$) between the calculated and measured ${\delta}^{13}C$. Calibration of ${\delta}^{13}C$ using the relationship between the calculated and the measured ${\delta}^{13}C$ values produced reliable and accurate ${\delta}^{13}C$ values. CONCLUSION: Our results suggest that the drying method is more accurate pre-treatment method to minimize the influence of air $CO_2$ compared to the precipitation method for the determination of ${\delta}^{13}C$ of DOC.

• Journal of the Korean Ceramic Society
• /
• v.38 no.4
• /
• pp.307-307
• /
• 2001

Combustion process with citrate was used to produce the LiMn$_2$O$_4$powder. Precursors are pre-ignited in open air followed by post-heating in the range from $600^{\circ}C$ to 80$0^{\circ}C$ for 4h. With varying the molar ratio (R) of ethylene glycol (EG) to citric acid (CA) from 0 to 4, the effect of EG content on powder characteristics is evaluated. Vacuum drying promote the auto-ignition at room temperature. With small addition of EG metal ion was selectively segregated with organic substances and undesired lithium evaporation occurred during post-heating. LiMn$_2$O$_4$phase which is produced by combustion reaction was decomposed back to Mn$_3$O$_4$because the reaction temperature was higher than 95$0^{\circ}C$. With increasing EG content, the homogeneity of LiMn$_2$O$_4$powder increased and specific surface area increased. And lithium evaporation during vacuum drying and/or ignition also increased.

• Food Engineering Progress
• /
• v.13 no.3
• /
• pp.216-220
• /
• 2009

The several functional properties of freeze-dried powder of Aloe vera gel was examined as influenced by pre-concentration degrees of the gel solution. As a pre-treatment prior to freeze drying, the gel solution was vacuum-concentrated by three levels (unit: g-water/g-solids) - high (H), 76; medium (M), 119; low (L), 159. In FT-IR spectra, the sample H showed the highest absorbance in the range of 1600-1550 $cm^{-1}$ and 1450-1400 $cm^{-1}$, which corresponded to level of the acetyl group in glucomannan. The sample H of freeze-dried powder was the highest in polysaccharide content, jack bean urease inhibition rate, and FAC (fat adsorption capacity). It could be inferred that the sample H had an effect on Helicobacter pylori inhibition and fat adsorption suppression according to urease inhibition rate and FAC, respectively.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.34 no.7
• /
• pp.1098-1102
• /
• 2005

Properties of rice flours prepared from milled and broken rice produced by pre-washing and subsequent drying process were investigated. Compared to untreated ordinary milled rice, pre-washing process slightly increased lightness of rice flour, while decreased yellowness. Both WAI and WSI were higher in the flour from pre-washed rice, and gel consistency was the highest in the flour from pre-washed broken rice. Pre-washed rice showed increased amylograph peak viscosity and reduced setback values. On the other hand, pre-washed broken rice showed decreased peak viscosity and increased setback values. Differential scanning calorimetry (DSC) results showed that the pre-washing process reduced gelatinization onset- and peak temperatures, with increased gelatinization enthalpy. Total bacteria and yeast count were lower in the pre­washed rice, suggesting the pre-washing process could partially eliminate microbial contamination of ordinary milled rice.

• Proceedings of the PSK Conference
• /
• 2003.10b
• /
• pp.236.3-237
• /
• 2003

Fine particles of water-soluble pharmaceuticals were prepared using a new micronization method, Carbon Dioxide Assisted Nebulization in a Bubble Dryer(CAN-BD). The process utilized mixtures of CO$_2$ in aqueous solution at supercritical conditions to form an emulsion. The aerosols were dried with pre-heated nitrogen, and the drying chamber was operated at near atmospheric pressure. The dry particles were collected on membrane filter at the bottom of the drying chamber. Several processing parameters such as flow rate, temperature, pressure, solid concentration and processing scale were accessed using NaCl, human serum albumin, and granulocyte-colony stimulating factor as model pharmaceuticals. (omitted)

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2023.05a
• /
• pp.179-180
• /
• 2023

In this study, the performance of the prediction model was compared and analyzed using DNN and LSTM learning models to predict the amount of dry shrinkage of the concrete. As a result of the analysis, DNN model had a high error rate of about 51%, indicating overfitting to the training data. But, the LSTM learning model showed a relatively higher accuracy with an error rate of 12% compared to the DNN model. Also, the Pre_LSTM model which preprocess data, showed the performance with an error rate of 9% and a coefficient of determination of 0.887 in the LSTM learning model.

• Journal of Mushroom
• /
• v.21 no.4
• /
• pp.222-227
• /
• 2023

Mushrooms have a unique taste and aroma, so in the processing of mushroom products with other ingredients, a separate pre-processing step is often taken to eliminate the mushroom aroma. In this study, we analyzed the changes in the concentration of volatile compounds according to drying conditions to promote the activation of processing using the fruiting bodies of yellow oyster mushrooms(Pleurotus citrinopileatus) and pink oyster mushrooms(P. djamor). The caps and stipes of yellow oyster and pink oyster mushrooms were separated and freeze-dried at -70℃ for 120 hours. Subsequently, they were hot air-dried at temperatures of 40, 50, 60, and 70℃ for 24, 24, 16, and 12 hours, respectively. The dried samples were pulverized and quantitatively analyzed by SPME-GC-MS. In the case of yellow oyster mushrooms, the concentration of t-2-nonenal in caps and stipes during freeze-drying was 164.43 ㎍/g d.w. and 174.80 ㎍/g d.w., respectively, whereas during hot air-drying, it significantly decreased to 0.35~3.41 ㎍/g d.w. and 0.98~59.88 ㎍/g d.w. In a similar manner, for pink oyster mushrooms, the concentration of 1-octen-3-ol during freeze-drying in caps and stipes was 31.05 ㎍/g d.w. and 176.17 ㎍/g d.w., respectively, whereas during hot air-drying, it significantly decreased to 1.59~9.66 ㎍/g d.w. and 1.96~15.77 ㎍/g d.w. Furthermore, most volatile compounds showed a tendency to decrease in concentration as the temperature during hot air-drying increased.