• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2003년도 추계학술대회논문집
• /
• pp.784-787
• /
• 2003

Electrorheological(ER) and magnetorheological(MR) fluid-based dampers are typically analyzed using Bingham-plastic shear model under quasi-steady fully developed flow conditions. A Herschel-Bulkley constitutive shear flow relationship is that the linear shear stress vs. strain rate behavior of Bingham model is replaced by a shear stress that is assumed to be proportional to a power law of shear rate. This power is called the flow behavior index. Depending on the value of the flow behavior index number, varying degrees of post-yield shear thickening or thinning behavior can be analyzed. But it is not practical to analyze the damping force in a flow mode damper using Herschel-Bulkley model because it is needed to solve a polynomial equation. A useful guide is suggested to analyze the damping force in a damper using the Herschel-Bulkley model.

• Geomechanics and Engineering
• /
• 제21권4호
• /
• pp.357-369
• /
• 2020

Different from the conventional planar fracture and simplified Newton model, for power-law slurries with a lower water-cement ratio commonly used in grouting engineering, flow model in geological rough fractures is built based on ten standard profiles from Barton (1977) in this study. The numerical algorithm is validated by experimental results. The flow mechanism, grout superiority, and water plugging of pseudo plastic slurry are revealed. The representations of hydraulic grouting properties for JRCs are obtained. The results show that effective plugging is based on the mechanical mechanisms of the fluctuant structural surface and higher viscosity at the middle of the fissure. The formulas of grouting parameters are always variable with the roughness and shear movement, which play a key role in grouting. The roughness can only be neglected after reaching a threshold. Grouting pressure increases with increasing roughness and has variable responses for different apertures within standard profiles. The whole process can be divided into three stationary zones and three transition zones, and there is a mutation region (10 < JRCs < 14) in smaller geological fractures. The fitting equations of different JRCs are obtained of power-law models satisfying the condition of -2 < coefficient < 0. The effects of small apertures and moderate to larger roughness (JRCs > 10.8) on the permeability of surfaces cannot be underestimated. The determination of grouting parameters depends on the slurry groutability in terms of its weakest link with discontinuous streamlines. For grouting water plugging, the water-cement ratio, grouting pressure and grouting additives should be determined by combining the flow conditions and the apparent widths of the main fracture and rough surface. This study provides a calculation method of grouting parameters for variable cement-based slurries. And the findings can help for better understanding of fluid flow and diffusion in geological fractures.

• Proceedings of the National Institute of Ecology of the Republic of Korea
• /
• 제3권3호
• /
• pp.149-153
• /
• 2022

The degree distribution of the plant-pollinator network was identified by analyzing the data in the ecosystem and reproduced by a model of the growing bipartite mutualistic networks. The degree distribution of pollinator shows power law or stretched exponential distribution, while plant usually shows stretched exponential distribution. In the growth model, the plant and the pollinator are selected with probability P_p and P_A=1-P_p, respectively. The number of incoming links for the plant and the pollinator is l_p and l_A, respectively. The probability that the link of the plant selects the pollinator of the existing network given as $A_{k_i}=k^{{\lambda}_A}_i/{\sum}_i\;k^{{\lambda}_A}_i$, and the probability that the pollinator selects the plant is $P_{k_i}=k^{{\lambda}_p}_i/{\sum}_i\;k^{{\lambda}_p}_i$. When the nonlinear growth index is 𝛌_X=1 (X=A or P), the degree distribution follows a power law, and if 0≤𝛌_X<1, the degree distribution follows a stretched exponential distribution. The cumulative degree distributions of plants and pollinators of 14 empirical plant-pollinators included in Interaction Web Database were calculated. A set of parameters (P_A,P_P,l_A,l_P) that reproduces these cumulative degree distributions and a growth index 𝛌_X (X=A or P) were obtained. We found that animal takes very heterogenous connections, whereas plant takes a more flexible connection network.

• 한국산학기술학회논문지
• /
• 제11권11호
• /
• pp.4664-4670
• /
• 2010

본 연구에서는 기존 MIM Zone model과 새로이 유도한 모델과 비교를 통해 몇가지 결론을 도출하였다. MIM model 이 적용되면 immobile 영역에서의 초기농도는 기공의 형태에 의해 달라지는 보정계수에 의해 실제농도보다 저평가되었으며 이는 오직 확산이 기공의 가장 깊은 부분까지 시행된 이후에 유효함을 확인하였다. 물질이동계수, $\alpha$는 기공의 깊이에 따라 반비례하며, 유동 구역의 유속에는 종속되어지지 않는다. 기존의 MIM model 은 확산주도영역의 농도가 급속하게 감소하는 현상을 보여주는데 새로이 유도된 모델의 경우도 충분한 시간이 경과한후 비슷한 현상을 보였으며 이는 기존의 여러 실험에서 관찰된 power-law BTC 의 상반되는 결과를 보여준다.

• Journal of Power Electronics
• /
• 제8권1호
• /
• pp.10-22
• /
• 2008

The wind-driven doubly fed induction generator (DFIG) is currently under pressure to be more grid-compatible. The main concern is the fault ride-through (FRT) requirement to keep the generator connected to the grid during faults. In response to this, the paper introduces a novel model and new control scheme for the DFIG. The model provides a means of direct stator power control and considers the stator transients. On the basis of the derived model, a robust linear quadratic (LQ) controller is synthesized. The control law has proportional and integral actions and takes account of one sample delay in the input owing to the microprocessor's execution time. Further, the influence of the grid voltage imperfection is mitigated using frequency shaped cost functional method. Compensation of the rotor current pulsations is proposed to improve the FRT capability as well as the generator performance under grid voltage unbalance. As a consequence, the control system can achieve i) fast direct power control without instability risk, ii) alleviation of the problems associated with the DFIG operation under unbalanced grid voltage, and iii) high probability of successful grid FRT. The effectiveness of the proposed solution is confirmed through simulation studies on 2MW DFIG.

• 천문학회보
• /
• 제43권2호
• /
• pp.43.3-43.3
• /
• 2018

We develop a model for broadband spectral energy distribution (SED) of Pulsar Wind Nebulae (PWNe). The model assumes that electrons/positrons in the pulsar wind are injected into and stochastically accelerated in the pulsar termination shock. We consider two scenarios: a stationary one-zone case and a time-evolving multi-zone case. In the latter scenario, flow properties in the PWNe (magnetic field, bulk speed) are modeled to vary in time and space. We apply the model to the broadband SED of the pulsar wind nebula 3C 58. From the modeling, we find that a broken power-law injection is required with the maximum electron energy of ~200 TeV.

• Ocean Systems Engineering
• /
• 제12권1호
• /
• pp.87-142
• /
• 2022

An analysis for the computation of Fatigue Damage Index (FDI) under the effects of the various combination of the ocean loads like random waves, current, platform motion and VIV (Vortex Induced Vibration) for a certain design water depth is a critically important part of the analysis and design of the marine riser platform integrated system. Herein, a 'Computer Simulation Model (CSM)' is developed to combine the advantages of the frequency domain and time domain. A case study considering a steel catenary riser operating in 1000 m water depth has been conducted with semi-submersible. The riser is subjected to extreme environmental conditions and static and dynamic response analyses are performed and the Response Amplitude Operators (RAOs) of the offshore platform are computed with the frequency domain solution. Later the frequency domain results are integrated with time domain analysis system for the dynamic analysis in time domain. After that an extensive post processing is done to compute the FDI of the marine riser. In the present paper importance is given to the nature of the current profile and the VIV. At the end we have reported the detail results of the FDI comparison with VIV and without VIV under the linear current velocity and the FDI comparison with linear and power law current velocity with and without VIV. We have also reported the design recommendations for the marine riser in the regions where the higher fatigue damage is observed and the proposed CSM is implemented in industrially used standard soft solution systems (i.e., OrcaFlex^*TM and Ansys AQWA^**TM), Ms-Excel^***TM, and C++ programming language using its object oriented features.

• 대한전기학회논문지:전력기술부문A
• /
• 제49권10호
• /
• pp.509-515
• /
• 2000

This paper addresses a damping control strategy of Static Synchronous Series Compensator(SSSC) and analysis model for stability study. The effect of injected voltage source generated by SSSC is modelled as equivalent load. This model is thought to be reasonable for the stability study because the dynamics of SSSC is very fast compared with that of power system. Damping controller of SSSC is based on Transient Energy Function method. The proposed control strategy is insensitive to the operating conditions like power flow level because control law depends on the phase angles. The proposed analysis model and control strategy was confirmed by WSCC 9 bus system and two area system. Especially, the robustness of proposed control strategy is demonstrated with respect to multiple operating conditions in two area system.

• 전기학회논문지P
• /
• 제67권4호
• /
• pp.175-182
• /
• 2018

In recent years, micro-grid has been widely focused on the fields of renewal energy systems. This paper proposes a novel robust power converter control against arbitrary electric load changes for islanded micro-grid topology. First, we provide a state-space representation of our micro-grid model including power converter and electric load circuit. And then a state feedback control method is applied to construct a nominal control framework. Next, we propose a robust adaptive control law to enhance a control performance against unexpected load perturbation. In addition, we analytically investigate a passivity property for the micro-grid model and carry out computer simulation to demonstrate superiority and reliability of the proposed control methodology.

• Advances in materials Research
• /
• 제6권1호
• /
• pp.45-63
• /
• 2017

In this article, static deflection and buckling of functionally graded (FG) nanoscale beams made of porous material are carried out based on the nonlocal Timoshenko beam model which captures the small scale influences. The exact position of neutral axis is fixed, to eliminate the stretching and bending coupling due to the unsymmetrical material change along the FG nanobeams thickness. The material properties of FG beam are graded through the thickness on the basis of the power-law form, which is modified to approximate the material properties with two models of porosity phases. By employing Hamilton's principle, the nonlocal governing equations of FG nanobeams are obtained and solved analytically for simply-supported boundary conditions via the Navier-type procedure. Numerical results for deflection and buckling of FG nanoscale beams are presented and validated with those existing in the literature. The influences of small scale parameter, power law index, porosity distribution and slenderness ratio on the static and stability responses of the FG nanobeams are all explored.