• Korean Journal of Microbiology
• /
• v.38 no.2
• /
• pp.144-151
• /
• 2002

For elucidating the relationship between the biosynthetic pathways for polyhydroxyslkanoates (PHAs) and 5-aminolevulinic acid (ALA), culture conditions for the production of these two biomaterials by Rhodopseudomonas sp. KCTC 1437 were investigated. Of the carbon substrates tested, acetic acid was the best carbon source for cell growth and PHA biosynthesis. When succinic acid was added as a co-substrate into culture medium, cell growth and PHA production were greatly increased up to 2.5 g/ι and 73% of dry cell weight, respectively. The PHA obtained from the carbon substrates tested was homopolyester of 3-hydroxybutyrate, while valeric acid was only effective for the production of copolyester consisting of 3-hydroxybutyrate and 3-hydroxyvalerate. Anaerobic light culture condition was better for PHA production and cell growth than anaerobic dark or aerobic dark culture condition. The organism was capable of synthesizing ALA when glycine and succinic acid were added to the culture medium. ALA was produced to ca.400 mg/ι when levulinic acid, soccinic acid, and glycine were repeatedly added with a reductant (sodim thioglycolate). However, the presence of glycine, levulinic acid and sodium glycolate inhibited the cell growth and the conversion of carbon substrates to PHA. From these results it is apparent that the production yields of PHA and ALA could not be increased simultaneously because the optimal conditions for the production of PHA and ALA are opposed to each other.

• Korean Journal of Microbiology
• /
• v.36 no.2
• /
• pp.155-160
• /
• 2000

Pseudomnas sp. HJ-2 is capable of producing a rubber-elastic polyhydroxyalkanoate (PHA) consisting of 3- hydroxybutyrate (3HB), 3-hydroxyvalerate (3HV), and 3-hydroxyheptanoate (3HHp) from heptanoic acid as the sole carbon source. The polyester produced was a blend of poly(3HB-co-3HV) and poly(3HHp). Although the mixing of poly(3HHp) fraction to poly(3HB-co-3HV) resulted in a decrease of modulus, the sole fraction of poly(3HB-co-3HV) with a high molar fraction of 3HV was shown to be an elastomer with the maximum percent strain of 740%. The biomass yield and the PHA synthesis were relatively high when the initial heptanoic acid concentration was 40 mM, and were significantly decreased when the substrate concentration exceeded 50 mM. The accumulation of PHA was stimulated by deficiency of nitrogen and phosphorus in the medium. The PHA contents and its monomeric compositions were greatly affected by pH and oxygen transfer rate. At pH 7.5, poly(3HB-~0.38% 3HV) was produced from heptanoic acid and a mixture of 95% 3HHp and 5% 3HV was produced at pH 8.0. Increased conten1 of 3HHp in the polyesters with lhe increasing oxygen transfer rate by agitation speed a1 a fixed aeration rate was observed.

• Korean Journal of Microbiology
• /
• v.52 no.4
• /
• pp.455-462
• /
• 2016

Pseudomonas aeruginosa P-5 is an unusual organism capable of synthesizing polyhydroxyalkanoates (PHAs) consisting of 3-hydroxyvalerate (3HV) and medium-chain-length (MCL) 3-hydroxyalkanoate (3HA) monomer units when C-odd alkanoic acids are fed as the sole carbon source. Evaluation of the substrate chain-length specificity of two P. aeruginosa P-5 PHA synthases ($PhaC1_{P-5}$ and $PhaC2_{P-5}$) by heterologous expression of $PhaC1_{P-5}$ and $PhaC2_{P-5}$ genes in Pseudomonas putida GPp104 revealed that $PhaC2_{P-5}$ incorporates both 3HV and MCL 3HAs into PHA, whereas $PhaC1_{P-5}$ favors only MCL 3HAs for polymerization. In order to obtain $PhaC2_{P-5}$ mutants with altered substrate specificity, site-specific mutagenesis for $PhaC2_{P-5}$ was conducted. Amino acid substitutions of $PhaC2_{P-5}$ at two positions (Ser326Thr and Gln482Lys) were very effective for synthesizing copolymers with a higher 3HV fraction. When recombinant P. putida GPp104 harboring double mutated $phaC2_{P-5}$ gene ($phaC2_{P-5}QKST$) was grown on nonanoic acid, 2.5-fold increase of copolymer content with 3.8-fold increase of 3HV fraction was observed. The $phaC2_{P-5}QKST$-containing Ralstonia eutropha PHB-4 supplemented with valeric acid also produced copolymers consisting of 3HV and 3-hydroxyheptanoate with a high 3HV fraction. These results suggest that recombinants containing $phaC2_{P-5}QKST$ could be useful for production of new PHA copolymers with improved material properties.

• KOREAN JOURNAL OF PACKAGING SCIENCE & TECHNOLOGY
• /
• v.30 no.1
• /
• pp.1-14
• /
• 2024

As awareness of environmental issues continues to grow, there is an escalating demand for recycling and repurposing byproducts of agricultural and food production processes and their conversion to high-value products. Coffee is the most widely consumed beverage globally; during coffee beverage processing and consumption, byproducts such as coffee silverskin (CS), spent coffee grounds (SCGs), and oil are generated. Despite containing beneficial materials such as cellulose, hemicellulose, lignin, lipids, and bioactive substances, these byproducts are typically discarded in landfills or incinerated. The utilization of CS, SCGs, and oil in the development of packaging materials holds significant potentials toward the realization of a sustainable society. To this end, considerable research efforts have been dedicated to the development of high-value materials derived from coffee byproducts, including functional fillers, polymer composites, and biodegradable polymers. Notably, CS and SCGs have been employed as functional fillers in polymer composites. Additionally, lipids extracted from SCGs have been used as plasticizers for polymers and cultured with microorganisms to produce biodegradable polymers. This review focuses on the research and development of polymer/CS and polymer/SCG composites as well as cellulose extraction and utilization from CS and SCGs and its applications, oil extraction from SCGs, and cultivation with microorganisms using extracted oil for polyhydroxyalkanoates(PHA) production.

• Korean Journal of Microbiology
• /
• v.53 no.3
• /
• pp.200-207
• /
• 2017

A new approach to the solubilization of waste activated sludge (WAS) using alginate-quaternary ammonium complex beads was investigated under controlled mild alkaline conditions. The complex beads were prepared by the reaction of sodium alginate (SA) with 3-(trimethoxysilyl)propyl-octadecyldimethylammonium chloride (TSA) in acid solution, followed by crosslinking with $CaCl_2$. Treatment of WAS with SA-TSA complex beads was effective for enhancing the efficacy of WAS solubilization. The highest value of soluble chemical oxygen demand (SCOD) concentration (3,900 mg/L) was achieved after 10 days of treatment with 30% (v/v) SA-TSA complex beads. The WAS solubilization efficacy of the complex beads was also evaluated by estimating the concentrations of volatile fatty acids (VFAs). The maximum value of VFAs was 2,961 mg/L, and the overall proportions of VFAs were more than 75% of SCOD. The main components of VFAs were acetic, propionic, iso-butyric, and butyric acids. These results suggest that SA-TSA complex beads might be useful for enhancing the solubilization of WAS. The potential use of VFAs as the external carbon substrate for the production of polyhydroxyalkanoate (PHA) by a mixed microbial culture (MMC) was also examined. The enrichment of PHA-accumulating MMC could be achieved by periodic feeding of VFAs generated from WAS in a sequencing batch reactor. The composition of PHA synthesized from VFAs mainly consisted of 3-hydroxybutyrate. The maximum PHA content accounted for 25.9% of dry cell weight. PHA production by this process is considered to be promising since it has a doubly beneficial effect on the environment by reducing the amount of WAS and concomitantly producing an eco-friendly biopolymer.

• Journal of Microbiology and Biotechnology
• /
• v.9 no.6
• /
• pp.847-853
• /
• 1999

A Pseudomonas sp. strain that is capable of utilizing dicarboxylic acids as a sole carbon source was isolated from activated sludge by using the enrichment culture technique. This organism accumulated polyhydroxyalkanoates (PHAs) with an unusual pattern of monomer units that depends on the carbon sources used. Polyhydroxybutyrate (PHB) homopolyester was synthesized from glucose or small $C_{-even}$ alkanoic acids, such as butyric acid and hexanoic acid. Accumulation of PHB homopolyester was also observed in the cells grown on $C_{-odd}$ dicarboxylic acids, such as heptanedioic acid and nonanedioic acid as the sole carbon sources. In contrast, a copolyester consisting of 6 mol% 3-hydroxybutyrate (3HB) and 94 mol% 3-hydroxyvalerate (3HV) was produced with a PHA content of as much as 36% of the cellular dry matter. This strain produced PHAs consisting both of the short-chain-length (SCL) and the medium-chain-length (MCL) 3-hydroxyacid units when heptanoic acid to undecanoic acid were fed as the sole carbon sources. Most interestingly, polyester consisting of significant amount of relevant fractions, 3HB, 3HV, and 3-hydroxyheptanoate (3HHp), was accumulated from heptanoic acid. According to solvent fractionation experiments, the polymer produced from heptanoic acid was a blend of poly(3HHp) and of a copolyester of 3HB, 3HV, and 3HHp units. The hexane soluble fractions contained only 3HHp units while the hexane-insoluble fractions contained 3HB and 3HV units with a small amount of 3HHp unit. The copolyester was an elastomer with unusual mechanical properties. The maximum elongation ratio of the copolyester was 460% with an ultimate strength of 10 MPa, which was very different from those of poly(3HB-co-3HV) copolyesters having similar compositions produced from other microorganisms.

• KSBB Journal
• /
• v.29 no.6
• /
• pp.399-404
• /
• 2014

Production of biodegradable polymer polyhydroxyalkanoates (PHAs) from industrial wastes exhibits several advantages such as recycle of waste and the production of high valuable products. To this end, this study aimed at isolating from the sewage treatment plant a PHA producing bacterium capable of utilizing wastes generated from biodiesel and food industries. A Bacillus cereus strain capable of producing poly(3-hydroxybutyrate) [P(3HB)] was isolated, which was followed by confirmation of P(3HB) accumulation by gas-chromatographic analyses. Then, the effects of nutrient limitation on P(3HB) production by B. cereus was first examined. Cells cultured in a minimal medium under the limitation of nitrogen, potassium and sulfur suggested that nitrogen limitation allows the highest P(3HB) accumulation. Next, production of P(3HB) was examined from both waste of biodiesel production (crude glycerol) and waste from food industry (spent coffee grounds). Cells cultured in nitrogen-limited minimal medium supplemented crude glycerol and waste spent coffee grounds extract accumulated P(3HB) to the contents of 2.4% and 1.0% of DCW. This is the first report demonstrating the capability of B. cereus to produce P(3HB) from waste raw materials such as crude glycerol and spent coffee grounds.