• Korean Journal of Agricultural and Forest Meteorology
• /
• v.9 no.2
• /
• pp.100-108
• /
• 2007

The Gwangneung KoFlux supersite, located in a rugged mountain region, is characterized by a low wind speed due to a mountain-valley circulation and rolling terrain. Therefore, it is essential to understand the effect of coordinate rotation on flux measurements by the eddy-covariance method. In this paper, we review the properties of three orthogonal coordinate frames (i.e., double, triple, and planar fit rotations) and apply to flux data observed at the Gwangneung supersite. The mean offset of vertical wind speed of sonic anemometer was inferred from the planar fit (PF) coordinate rotation, yielding the diurnal variation of about $\pm0.05ms^{-1}$. Double rotation $(\bar{v}=\bar{w}=0)$ produced virtually the same turbulent fluxes of heat, water, and $CO_2$ as those from the PF rotation under windy conditions. The former, however, resulted in large biases under calm conditions. The friction velocity, an important scaling parameter in the atmospheric surface layer, was more sensitive to the choice of coordinate rotation method.

• Journal of Mechanical Science and Technology
• /
• v.15 no.3
• /
• pp.309-319
• /
• 2001

This paper demonstrates the development of optical temperature sensor based on the etched silica-based planar waveguide Bragg grating. Topics include design and fabrication of the etched planar waveguide Bragg grating optical temperature sensor. The typical bandwidth and reflectivity of the surface etched grating has been ∼0.2nm and ∼9%, respectively, at a wavelength of ∼1552nm. The temperature-induced wavelength change is found to be slightly non-linear over ∼200$^{\circ}C$ temperature range. Typically, the temperature-induced fractional Bragg wavelength shift measured in this experiment is 0.0132nm/$^{\circ}C$ with linear curve fit. Theoretical models with nonlinear temperature effect for the grating response based on waveguide and plate deformation theories agree with experiments to within acceptable tolerance.

• Bulletin of the Korean Chemical Society
• /
• v.24 no.9
• /
• pp.1281-1283
• /
• 2003

Proteins in highly oriented lipid bilayer samples are useful to study membrane protein structure determination. Planar lipid bilayers aligned and supported on glass slide were prepared. These stack of glass slide with planar lipid bilayers are not well fit for commercial solid-state NMR probe with round coil. Therefore, homebuilt solid-state NMR probe was built and used for a stack of thin glass plates and RF coil is wrapping directly around the flat square sample. The overall filling factor of the coil is much better and the large surface area enhances the extent to orientation by providing uniform environments for the phospholipids and the high ratio of circumference to area reduces edge effects. $^1H\;and\;^{15}N$ double resonance probe for 400 MHz NMR (9.4T) with a flat coil (coil size: 11 mm ${\times}$ 20 mm ${\times}$ 4 mm) is constructed and tested.

• Journal of the Korean Society of Costume
• /
• v.52 no.5
• /
• pp.61-77
• /
• 2002

The purpose of this study is to investigate difference and likeness on the form in women's Hanbok between the later Chosun Dynasty and modern times based on Belong's observing system for 'Apparel-Body Construct'. Belong's framework is composed 5 pairs of contrast word -'Closed or Open', 'Whole or Par', 'Planar Separation or Planar integration'. 'Flat or Rounded', and 'Determinate or Indeterminate'. Major findings of this study are as follows. First, the form of women's Hanbok in later Chosun Dynasty is 'Variably Closed', 'Part' and 'Rounded', whereas that in modern is 'Open', 'Whole' and 'Flat' Women's Hanbok of modern is lesser convex, and more open than that of later Chosun Dynasty according to increasing use of transparent textiles. Moreover, in comparison with old style, that of modern has the tendency of perceiving primarily whole feature by organic linkage of parts. Because of loose fit of Jeogori and rigid DongJong etc, characteristic of 'Plat' strengthened in modern Hanbok. Secondly, women's Hanbok in the later Chosun Dynasty and modern has common properties of 'Planar Seperation' and 'Determinate'. Women's Hanbok belongs to 'Planar Seperation', because the effect cognized to figure and ground. can be found between small parts and whole of Jegori, or can be found between the head and face. Jeuori and waist band, and Chima and under ware. Further more. it can be classified into 'Determinate'. because it use textiles which have no pattern un it or which show a subtle surface effect by texture changing.

• Journal of the Korea Fashion and Costume Design Association
• /
• v.21 no.4
• /
• pp.127-137
• /
• 2019

Nail art, which has been popularized recently, has increased convenience in the direction of nail art design harmonized with clothing and the increased interest and usage of nail art decoration. This study set out to propose practical planar and three-dimensional nail art designs in harmony with modern clothes by applying trimmings common in 18th century women's clothing, which used a variety of attachable decorations. As for the methodology, the investigator examined theories in previous studies, literature, and analyzed the types of trimming in female portraits from the 18th century at the museum at the Palace of Versailles in France. Planar and three-dimensional nail art designs were created for each of the top three trimming types- braids, laces, and ribbons, which were identified through analysis. The study applied the trimmings of the 18th century women's clothes to nail art design and had the following results: First, the top three trimming types were identified based on the analysis of the 18th century portraits. They were then used as motifs in the production of planar and three-dimensional nail art designs. The results show that the motifs of the clothes trimmings were fit for and had practical possibilities for expression in nail art designs. Secondly, diversity and the expansion of ideas in the study of nail art design were promoted. In addition, elements were increased to have mutually complementary effects with clothes. Finally, the study made various attempts at nail design methods by adopting a range of nail art expression techniques including hand painting, 2D & 3D art techniques, and using planar and three-dimensional nail decorations, thus proposing a positive direction for the organization of a curriculum to make use of 18th century women's clothing motifs in nail art education.

• Atmosphere
• /
• v.26 no.3
• /
• pp.473-482
• /
• 2016

An accurate determination of turbulent fluxes over an urban area is a challenging task due to its morphological diversity and associated flow complexity. In this study, an eddy covariance (EC) method is applied over a highly heterogeneous urban area in a small city (Gongju), South Korea to investigate the quantitative influence of 'coordinate tilt' in determining the turbulent fluxes of sensible heat, latent heat, momentum, and carbon dioxide mass. Two widely-used coordinate transform methods are adopted and applied to eight directional sections centered on the site to analyze a 1-year period EC measurement obtained from the urban site: double rotation (DR) and planar fit (PF) transform. The results show that mean streamline planes determined by the PF method are distinguished from the sections, representing morphological heterogeneity of the site. The sectional pitch angles determined by the DR method also compare well with those in the PF method. Both the PF and DR methods show large variabilities in the determined streamline planes at each directional section, implying that flow patterns may form in a complicate way due to the surface heterogeneity. Resulting relative differences of the turbulent fluxes, defined by $(F_{DR}-F_{PF})/F_{DR}$, are found on average +13% in sensible heat flux, +21% in latent heat flux, +37% in momentum flux, and +26% in carbon dioxide mass flux, which are larger values than those reported previously for fairly homogeneous natural sites. The fractional differences depend significantly on wind direction, showing larger differences in northerly winds at the measurement site. It is also found that the relative fractional differences are negatively correlated with the mean wind speed at both stable/unstable atmospheric conditions. These results imply that EC turbulent fluxes determined over heterogeneous urban areas should be carefully interpreted with considering the uncertainty due to 'coordinate tilt' effect in their applications.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2012.05a
• /
• pp.274-274
• /
• 2012

증발산량 관측은 오랜 기간 연구되어 왔으며, 미기상 관측 시스템의 최적화와 상호 공동비교 실험 및 자료 처리의 일관성을 유지를 위해 한국에는 KoFlux라고 하는 플럭스 네트워크가 2002년 1월에 구축되었다. 이를 시작으로 미기상 관측에 대한 관심이 많은 연구자들이 관측망 구축에 힘쓰고 있으며, 에디공분산 방법을 이용해 증발산량을 산정하고 있다. 에디 공분산 방법은 다른 방법에 비해 연직농도 차이가 적은 산림 위에서의 플럭스 값을 측정 할 수 있으며, 측정 시 식물 환경에 방해를 주지 않는 등의 장점이 있다. 하지만 자료 처리와 품질관리에 있어 연구자의 주관성에 의해 상당 부분 불확실성을 초래한다. 또한 다른 관측지점과의 일관적인 비교를 위해 좌표보정을 수행하며, 일반적으로 바람이 평평한 지역 위로 분다는 가정 하에 이루어진다. 좌표보정은 일반적으로 Planar Fit Rotation방법을 사용하며, 평판 분할은 지형에 따라 12개까지 분할하여 분석한다. 하지만 덕유산 플럭스관측 타워지점처럼 산지 특성이 뚜렷하고 1 m/s이하의 풍속 데이터의 빈도가 큰 경우 평판 분할 수의 제한이 발생한다. 이러한 문제를 해결하기 위해 좌표보정계수산정 방법에 따라 등간격의 평판분할 방법(Scenario A), 주풍향을 고려한 평판분할 방법(Scenario B)과 빈도에 의한 평판분할방법(Scenario C)으로 수행하였다. 또한 각 Scenario는 풍속의 제한 조건에 따라 CASE A(0.5 m/s 이상), CASE B(1.0 m/s이상)로 구분하여 분석하였다. 본 연구를 통해 제안 한 자료처리 절차는 첫째, 바람자료의 빈도 분석을 통한 지역특성 파악 둘째, 풍속제한 조건 설정 셋째, 바람과 수증기의 공분산 계산으로 요약된다. 덕유산 플럭스관측 타워지점의 경우 풍속 제한을 1.0 m/s이상에서 0.5 m/s이상으로 하향 조정하였으며, 평판 분할 방법은 Scenario C의 평판 수 12개를 채택하였다.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2014.05a
• /
• pp.45-46
• /
• 2014

In this paper, measurement methods for the characteristics of antennas for indoor digital TV (DTV), having 75-ohm port impedance, are introduced. Reference impedance of typical radio frequency (or microwave) systems and measurement equipments is 50 ohm. However, the reference impedance of antennas for indoor DTV is 75 ohm, and the characteristics of the antennas cannot be measured directly using the measurement equipments. Measurement methods, using test equipments with reference impedance of 50 ohm, for the characteristics(impedance, radiation patterns, and gains) of antennas designed to fit for 75 ohm port are introduced.

• Journal of Positioning, Navigation, and Timing
• /
• v.5 no.4
• /
• pp.213-219
• /
• 2016

Most existing studies on the wide-area differential global positioning system (WADGPS) employed a grid ionosphere model for error correction in the ionospheric delay. The present study discusses the application of satellite-based ionospheric delay model that provides an error model as a plane function with regard to individual satellites in order to improve accuracy in the WADGPS. The satellite-based ionospheric delay model was developed by Stanford University in the USA. In the present study, the algorithm in the model is applied to the WADGPS system and experimental results using measurements in the Korean Peninsula are presented. Around 1 m horizontal accuracy was exhibited in the existing planar fit grid model but when the satellite-based model was applied, correction performance within 1 m was verified.

• Economic and Environmental Geology
• /
• v.31 no.6
• /
• pp.547-555
• /
• 1998

A new trigonometrical method for calculating total slip (T) of faulting is presented. The parameters for the calculations are used rake of fault striation, strike and dip of fault and of index planar structure such as bedding plane. The faults are groupped into three types. The direction of plunging of fault striation is out of a range ${\pm}90^{\circ}$ to the bedding dip direction in $360^{\circ}$ system, which is groupped into the type I. Meanwhile, the case of the direction lies in the above range can be separated into two different types, type II and type III, according to relative largeness of the angles rake of fault striation and i (see text). The type II has smaller rake than angle i and the type III has larger rake than angle i. Here I propose a few equations for calculating not only total slip (T) but strike slip (L) or dip slip (S) of the faulting. The equations are adapted selectively to the types of fault mentioned before. The limitation of the method is that the equations do not fit to polyphase faulting.