• Journal of environmental and Sanitary engineering
• /
• v.20 no.4 s.58
• /
• pp.45-50
• /
• 2005

Titania gel formations were prepared by sol-gel method using titanium(IV) chloride $(TiCl_4)$, and its characteristics were analyzed by varying the $epoxide/TiCl_4$ ratio and the amount of water In the end, titania $(TiO_2)$ aerogel were prepared using supercritical drying process. VOCs such as benzene, toluene, and m-xylene (BTX) were oxidized using prepared titania aerogel and commercially available $TiO_2$, and its performance was compared. The surface area, pore volume, and average pore diameter of 1,2-epoxybutane are significantly smaller than the propylene oxide. And the titania aerogels with 6 moi of epoxides have high surface areas, pore volumes, and average pore diameters. As a result of photo-oxidation, conversion of benzene was reached about $70\%$, and other reactants were reached about $60\%$ similarly. The conversion of BTX was increased as inlet concentration decreased. The reactivity of titania calcined at $600^{\circ}C$ was greater than $400^{\circ}C$ and $800^{\circ}C$. Water is required as a reactants for the oxidation of VOCs, and the continuous consumption of hydroxyl radicals required replenishments to maintain catalyst activity. The activity ratio increased with increasing reaction time when enough amount of water was present in the reactor.

• Analytical Science and Technology
• /
• v.18 no.2
• /
• pp.130-138
• /
• 2005

Volatile organic compounds (VOCs) have been recognized as major contributor to air pollution. Catalytic oxidation in VOCs can give high efficiency at low temperature. In this study, monometallic Pt, Ir and bimetallic Pt-Ir were supported to $TiO_2$. Xylene, toluene and methyl ethyl ketone (MEK) were used as reactants. The monometallic or bimetallic catalysts were prepared by the excess wetness impregnation method and characterized by XRD, XPS and TEM analysis. Result reveal that Pt catalyst has higher conversion than Ir catalyst and Pt-Ir bimetallic catalysts. The existence of multipoint actives in, Pt-Ir bimetallic catalysts gives improved performance for the Pt metalstate. Bimetallic catalysts have higher conversion for VOCs than monometallic ones. The addition, VOCs oxidation follows first order kinetics. The addition of small amount of Ir to Pt promotes oxidation conversion of VOCs.

• Journal of Electrochemical Science and Technology
• /
• v.2 no.2
• /
• pp.110-115
• /
• 2011

The effect of $TiO_2$ nanotube (TNT) and nanoparticle (TNP) composite photoelectrode and the role of TNT to enhance the photo conversion efficiency in dye-sensitized solar cell (DSSC) have investigated in this study. Results demonstrated that the increase of the TNT content (1-15 %) into the electron collecting TNP film increases the open-circuit potential ($V_{oc}$) and short circuit current density ($J_{sc}$). Based on the impedance analysis, the increased $V_{oc}$ was attributed to the suppressed recombination between electrode and electrolyte or dye. Photochemical analysis revealed that the increased Jsc with the increased TNT content was due to the scattering effect and the reduced electron diffusion path of TNT. The highest $J_{sc}$ (12.6 mA/$cm^2$), Voc (711 mV) and conversion efficiency (5.9%) were obtained in the composite photoelectrode with 15% TNT. However, $J_{sc}$ and $V_{oc}$ was decreased for the case of 20% TNT, which results from the significant reduction of adsorbed dye amount and the poor attachment of the film on the fluorine-doped tin oxide (FTO). Therefore, application of this composite photoelectrode is expected to be a promising approach to improve the energy conversion efficiency of DSSC.

• Applied Chemistry for Engineering
• /
• v.20 no.2
• /
• pp.227-233
• /
• 2009

Recently, dye-sensitized solar cell (DSSC), one of the solar cells, has been widely investigated. Studies on DSSCs can be classified into 4 fields such as $TiO_2$ nanocrystalline materials, dyes, electrolytes and conductive plate. In this work, $TiO_2$ nanoparticles for dye adsorption were synthesized, and added into the photo-electrode paste with different phosphor types and contents. Then, the influence of phosphor additives on the conversion efficiency of DSSCs was investigated. It was found that the maximum conversion efficiency was 8.81% when 0.5% of YAG phospher having the particle size of 400 nm was used.

• Journal of Korean Ophthalmic Optics Society
• /
• v.10 no.3
• /
• pp.185-191
• /
• 2005

Photo-reactive $TiO_2$ thin films on soda-lime-silica slide glass were prepared by spin coating technique with a Ti-naphthenate precursor. Optical, structural and photo-catalytic properties of the films after annealing at $500^{\circ}C{\sim}600^{\circ}C$ were evaluated. As increase with annealing temperature, absorption bands and total transmittance of the films showing an average transmittance (about 80%) at visible spectra range were shifted to UV spectra range and slightly decreased. Refractive index and thickness of the films were increased from 2.16 to 2.63 and decreased from 484 nm to 439 nm, respectively, with increase of annealing temperature. Anatase phase was visible at all annealing temperature. More rougher surface structure was obtained at $600^{\circ}C$ than those of films annealed at $500^{\circ}C$ and $550^{\circ}C$. The hydrophilic conversion was found within 45 min by UV stimulation and optical activation was UVC>UVA>UVB at the case of $500^{\circ}C{\sim}550^{\circ}C$ and UVA>UVC>UVB at the annealing temperature of $600^{\circ}C$. The lowest initial contact angle was obtained at $600^{\circ}C$.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.58 no.7
• /
• pp.1386-1392
• /
• 2009

An analysis is presented for super-high-speed optical demodulation by an avalanche photodiode(APD) with electric mixing. A normalized gain is defined to evaluate the performance of the optical mixing detection. Unlike previous work, we include the effect of the nonlinear variation of the APD capacitance with bias voltage as well as the effect of parasitic and amplifier input capacitance. As a results, the normalized gain is dependent on the signal frequency and the frequency difference between the signal and the local oscillator frequency. However, the current through the equivalent resistance of the APD is almost independent of signal frequency. The mixing output is mainly attributed to the nonlinearity of the multiplication factor. We show also that there is an optimal local oscillator voltage at which the normalized gain is maximized for a given avalanche photodiode.

• Journal of Radiation Protection and Research
• /
• v.26 no.3
• /
• pp.177-181
• /
• 2001

The conversion efficiency of a cesium iodine coated micro-channel plate is studied. We use the EGS4 code to transport photons and generated electrons until their energies become less than 1keV and 10keV respectively. Among the generated electrons, the emission from the secondary electrons located within the escape depth of 56nm from the photo-converter boundary is estimated by integrating the product of the secondary electrons with a probability depending only on their geometric locations. The secondary electron emission from the generated electrons of energy higher than 100eV is estimated by the 'universal yield curve'. The sum of these provides an estimate for the secondary electron yield and we show that results of applying this algorithm agree with known experimental results. Using this algorithm, we computed secondary electron emissions from a micro-channel plate used in a gas electron multiplier detector that is currently being developed at Korea Atomic Energy Research Institute.

• Electrical & Electronic Materials
• /
• v.5 no.4
• /
• pp.361-373
• /
• 1992

이온이나 플라즈마를 사용해서 박막형성이나 MBE진공증착법에 비해서 분자배열이나 고차구조의 제어 및 그의 다양성에 있어서 LB법에 대한 기대가 크다. 특히 습식법인 점에서 생체기능을 짜넣을 수 있는 분자소자의 개발에는 불가능하다. 역으로 생체분자의 자기조직화나 정보전달기능을 분자 Level로 이해하는 점에서도 LB법은 중요하다고 본다. 또 저차원자성체 전도체 여기자등 물리량에 의한 차원성을 고찰하는 점에서도 LB막의 거동이 주목되고 있다. 또 자발분극된 강유전성의 고분자 즉 Poly등의 박막에 광조사를 하면 광생성된 캐리어가 내부전계에 따라서 이동하고 ~$10^{4}$V 정도의 높은 광기전력을 발생시키는 것도 나타났다. 얻어진 전류는 단지 초전효과를 상회하고 광전류라고 할 수 있다. 쇼트키형 소자의 금속-반도체의 절연막층을 MIS형이라고 하며 특성이 향상된다. SnO$_{2}$/NiPc/Polyethylene막/Al형 광전지가 만들어졌다. 광전변환막이 다양한 목적에 사용되리라 사료되며 지금은 초기 연구단계이나 실용화하는데는 많은 시간이 소요되나 간단한 디바이스 등과 같은 것은 제작이 가능할 것이며 광에너지로 힌한 화학, 전기, 역학 에너지로 변환되는 데는 시간 문제인것 같다. 1년간 일본 동경공업대학 생명이공학부에서 연구한 내용을 정리하여 보았으며 이에 협조하여 주신 문교부 학술진흥재단에 감사드리며 또 등평연구실에 감사드린다.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2010.08a
• /
• pp.294-294
• /
• 2010

Over the last decade, dye-sensitized solar cell (DSSC) has attracted much attention due to the high solar-to-electricity conversion efficiency up to 10% as well as low cost compared with p-n junction photovoltaic devices. DSSC is composed of mesoporous TiO2 nanoparticle electrodes coated with photo-sensitized dye, the redox electrolyte and the metal counter electrode. The performances of DSSC are dependent on constituent materials and interface as well as device structure. Replacing the heavy glass substrate with plastic materials is crucial to enlarge DSSC applications for the competition with inorganic based thin film photovoltaic devices. One of the biggest problems with plastic substrates is their low-temperature tolerance, which makes sintering of the photoelectrode films impossible. Therefore, the most important step toward the low-temperature DSSC fabrication is how to enhance interparticle connection at the temperature lower than $150^{\circ}C$. In this talk, the key issues for high efficiency plastic solar cells will be discussed, and several strategies for the improvement of interconnection of nanoparticles and bendability will also be proposed.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2011.02a
• /
• pp.383-383
• /
• 2011

We fabricated thermal annealing-free polymer solar cells (PSC) by processing with additive and applied to flexible substrates. The 1, 8-Diiodooctane of 3 vol% blended with active solution resulted in enhancement of $J_{SC}$ due to increase of light absorption and hole mobility as improving the crystallinity of P3HT. In addition, the $V_{OC}$ of PSCs with additive was improved by inserting $TiO_2$ layer without any treatment. The $TiO_2$ layer prevented the direct contact between active layer and Al electrode and reduced the charge recombination near Active/Al interface. It was confirmed by calculation of J0 and photo-voltage transient measurement. The power conversion efficiencies of annealing-free PSCs using additive for ITO glass and flexible (ITO PEN) substrate were obtained 3.03% and 2.45%, respectively.