• KSBB Journal
• /
• v.25 no.5
• /
• pp.449-452
• /
• 2010

L-Thyroxine possessing a chiral center, the naturally occurring thyroid hormone has been used for the treatment of thyroid dysfunctions and marketed as levothyroxine (L-thyroxine) sodium salt. In this study, after extraction of levothyroxine tablet as a pre-treatment process, direct enantiomer separation of thyroxine on crown ether derived chiral columns for determination of optical purity was performed using reversed mobile phase with acid additive. The chromatographic method developed in this study was applied in the determination of optical purity of several current domestic and foreign commercialized levothyroxine tablets. Optical purity values of these commercialized L-thyroxine sodium tablets except one were higher than 99 percents.

• Bulletin of the Korean Chemical Society
• /
• v.26 no.6
• /
• pp.998-1000
• /
• 2005

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.34 no.5
• /
• pp.149-155
• /
• 2024

Gallium, a key material in TFT (Thin-Film Transistor) targets and LED (Light Emitting Diode), is highly sought after due to its scarcity, making the recovering and recycling from waste resources. This study develops a process to recover high-purity gallium contained in an alkaline electrolyte and to produce gallium oxide nanopowder for IGZO (Indium Gallium Zinc Oxide) targets. Through an investigation of the electrowinning process conditions, the effects of various process factors and the optimal conditions are identified. It is found that the concentration of NaOH significantly affects purity. By employing two rounds of electrowinning followed by acid washing, gallium with a purity of over 99.995 % is successfully recovered. Using this recovered gallium as a starting material, gallium oxide is produced via a gas-phase synthesis. It is observed that while higher temperatures increase the yield, the purity decreases. Ultimately, at 1,260℃, gallium oxide nanopowder with a purity exceeding 99.995 % is obtained with a yield close to 90 %. The gallium oxide nanopowder predominantly exhibits a size of approximately 2 ㎛ and a spherical shape, suggesting favorable characteristics for subsequent processes such as sintering.

• Journal of the Korean Chemical Society
• /
• v.33 no.2
• /
• pp.263-270
• /
• 1989

Aluminum alkoxide, $Al(OC_3H_7\^i)_3\;and\;Al(OC_4H_9^s)_3$, were synthesized using aluminum sheet and corresponding alcohols to prepare various phase alumina in high purity. Aluminum hydroxides were prepared by hydrolysis of synthesized Al-alkoxides and from reagent $AlCl_3$. The catalytic properties of ${\gamma}$ and ${\eta}-Al_2O_3$ prepared at various temperatures were investigated and the reaction kinetics of ${\alpha}-Al_2O_3$ formation from $Al(OH)_3$ was considered.

• Journal of the Korean Ceramic Society
• /
• v.33 no.3
• /
• pp.277-284
• /
• 1996

The water test results indicated that the impurities had detrimetal effect on the wear resistance of silicon nitride and the effects were getting severe as the temperature increased. Especially when Ca existed as an impurity the detrimental effects was the most severe. These results were resulted from the fact that impurities lowered the mechanical properties of the grain boundary phase of silicon nitride. The wear test results of glass/glass-ceramic specimens having a similar composition to the grain boundary phase of silicon nitride revea-led that the specimen containing CaO showed the lowest wear resistance. The existence of Fe and Ca at the grain boundary phase assisted forming a grain boundary phase with relatively low refractoriness. Therefore at a given wear condition the removal of deformed layer would be easier. The results showed that the glass phases could be modified by heat-treatment and this modification improved tribological characteristics of the silicon nitride.

• Analytical Science and Technology
• /
• v.24 no.5
• /
• pp.360-367
• /
• 2011

Optical purities of 10 commercialized naproxens prepared from eight Korean drug companies were examined by an optimized chiral HPLC condition. The Chiralcel OD-H column and ChiralHyun-LE(S)-1 column were used as chiral stationary phases and the mixed eluent of hexane/isopropanol/acetic acid as 100:2.85:0.1 was used as a mobile phase for effective enantioseparation. Optical purity values of most samples were higher than 97 percents, only one of them was about 95 percents. The average relative standard deviation of them appeared very small (0.034%).

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.21 no.12
• /
• pp.3235-3245
• /
• 1996

A DDFS(Direct Digital Frequency Synthesizer) used in spread spectrum communication systems must need fast switching speed, high resolution(the step size of the synthesizer), small size and low power. The chip has been designed with four parallel sine look-up table to achieve four times throughput of a single DDFS. To achieve a high processing speed DDFS chip, a 24-bit pipelined CMOS technique has been applied to the phase accumulator design. To reduce the size of the ROM, each sine ROM of the DDFS is stored 0-.pi./2 sine wave data by taking advantage of the fact that only one quadrant of the sine needs to be stored, since the sine the sine has symmetric property. And the 8 bit of phase accumulator's output are used as ROM addresses, and the 2 MSBs control the quadrants to synthesis the sine wave. To compensate the spectrum purity ty phase truncation, the DDFS use a noise shaper that structure like a phase accumlator. The system input clock is divided clock, 1/2*clock, and 1/4*clock. and the system use a low frequency(1/4*clock) except MUX block, so reduce the power consumption. A 107MHz DDFS(Direct Digital Frequency Synthesizer) implemented using 0.8.mu.m CMOS gate array technologies is presented. The synthesizer covers a bandwidth from DC to 26.5MHz in steps of 1.48Hz with a switching speed of 0.5.mu.s and a turing latency of 55 clock cycles. The DDFS synthesizes 10 bit sine waveforms with a spectral purity of -65dBc. Power consumption is 276.5mW at 40MHz and 5V.

• Journal of Korean Society for Atmospheric Environment
• /
• v.20 no.1
• /
• pp.99-110
• /
• 2004

In order to investigate the performance of carbon dioxide PSA over zeolite adsorbent, the present study showed results of isotherm measurement, cyclic operation of 3-bed apparatus, and the corresponding numerical simulation. The experiment data of bed temperature, purity, recovery were matched well with that of numerical simulation. Purity of both gas and adsorbent phase increased rapidly with rinse rate but the degree of increase was retarded for large rinse rate The total amount of adsorbed increased only 10% even if rinse rate was enlarged to 4 times. Optimal rinse rate was 7N㎥/hr in this study. The heating rinse led to augments in recovery and productivity, possibly thanks to ease of description resulting from increased volumetric rinse rate and temperature rise in the column.

• 제어로봇시스템학회:학술대회논문집
• /
• 2001.10a
• /
• pp.97.5-97
• /
• 2001

This paper presents development of a user-friendly automatic control system for ESR(Electro-Slag Remelting or Refining) process. It is a second-phase refining one, commonly applied to production of high-purity specialty steel. A primarily refined castingot acts as a consumable electrode and melts by the electric resistance heat generated when high current is induced through a slag bath. The quality of product is evaluated by its chemical composition, purity, micro-structure, uniformity, mechanical property, etc. To meet the standards, above all things, the process should be kept sound and the melt rate should track the optimum profile irrespective of environment variations. Current ESR system is manually operated ...

• Journal of the Korean Ceramic Society
• /
• v.35 no.2
• /
• pp.129-136
• /
• 1998

The effects of MgO on the resistance to corrosion and oxidation of Al2O3-SiC-C refractory have been in-vestigated. The resistance to oxidation was improved as the amount of MgO increased. The resistance to corrosion was enhanced until 2 wt% MgO content but degraded over that content. From the dependence of temperatuer on the oxidation resistance oxidation was suppressed by the microstructural densification caused by spinel formation over 1200~130$0^{\circ}C$and the formation MgO-Al2O3-SiO2 liguid-phase over 130$0^{\circ}C$ The weight loss of specimens containing MgO with various purity at range of 95 to 99% and par-ticle size of -0.045 mm to -0.074 mm was examined. The oxidation resistance was not changed signficantly with the particle size and purity of MgO powders.