• ETRI Journal
• /
• v.41 no.6
• /
• pp.715-730
• /
• 2019

We propose a switched beam-forming antenna that satisfies not only ultra-wideband characteristics but also beam-forming in the WLAN frequency band using an ultra-wideband antenna and passive parasitic elements applying a broadband optimal reactance load algorithm. We design a power and phase estimation function and an error correction function by re-analyzing and normalizing all the components of the parasitic array using control system engineering. The proposed antenna is compared with an antenna with a pin diode and reactance load value, respectively. The pin diode is located between the passive parasitic elements and ground plane. An antenna beam can be formed in eight directions according to the pin diode ON (reflector)/OFF (director) state. The antenna with a reactance load value achieves a better VSWR and gain than the antenna with a pin diode. We confirm that a beam is formed in eight directions owing to the RF switch operation, and the measured peak gain is 7 dBi at 2.45 GHz and 10 dBi at 5.8 GHz.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.29 no.7
• /
• pp.22-27
• /
• 2015

In this paper, the problem of voltage unbalancing in series-connected multiple electric double-layer capacitors(EDLCs) is studied. Good understanding of this problem is required in order to increase reliability and stability of an energy storage system comprising EDLCs. Existing methods to settle voltage unbalancing cannot mitigate the problem enough for each cell, since most method have been applied to each module. For equalizing between cells, Zener diode which is one of passive method have been well examined in literature. However, Zener have well not used in balancing due to heating problem. In addition, It is difficult to choose Zener diode fitted rating voltage of EDLC, because of its internal resistance. Thus, we proposed passive balancing using Zener diode by analyzing parasitic element of Zener and EDLC. To experimentally confirm the balancing effect, we compared in two occasions which are with and without passive. As a result, proposed passive balancing circuit mitigated unbalanced voltage gap between EDLCs.

• Proceedings of the KIEE Conference
• /
• 1998.07f
• /
• pp.2039-2041
• /
• 1998

In this paper, Operation characteristics of the active clamp(ACL) zero-voltage-switching(ZVS) forward converter(FC) and active clamp hard- switching(HS) forward converter are compared with respect to loss analysis. The losses of semiconductor (including conduction losses and switching losses), transformer(containing the core loss and copper loss) and parasitic element of passive element (capacitor, inductor) are measured and compared for each type. For an experiment we have built 50W ACL ZVS-FC and ACL HS-FC, in which the switching frequency is 200kHz, and test it. The experimental results show that both types of operation have nearly same characteristics.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.3
• /
• pp.315-320
• /
• 2010

In this paper, an internal TDMB(Terrestrial Digital Multimedia Broadcasting) antenna for mobile phone is proposed. The overall dimension of designed antenna with substrate is 30 mm$\times$5 mm$\times$0.6 mm. The proposed antenna consists of a meander type radiator which is connected front- and back-plane of Kapton substrate by via hole and parasitic element for tuning the resonant frequency. And to compensate the electric length of desired frequency, passive inductor is used for matching element. Measured gain of the implemented antenna -17.6 dBi at 174 MHz, -13.01 dBi at 195 MHz, and -14.9 dBi at 216 MHz.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.14 no.5
• /
• pp.223-230
• /
• 2014

In this paper, the single-fed microstrip parasitic array antenna for low-cost three-dimensional beam steering in 5.8GHz ISM(5.725GHz~5.825GHz) band is designed and implemented. The antenna is comprised of one feed active element and four passive elements with variable reactance loads. The beam steering range of implemented antenna is achieved three-dimensional beam steering of ${\pm}28^{\circ}$ at azimuth angle ${\Phi}=0^{\circ}$, ${\Phi}=45^{\circ}$, ${\Phi}=90^{\circ}$, and ${\Phi}=135^{\circ}$ by adjusting variable reactance loads. The maximum gain of the antenna in the beam steering range have within 7.23dBi~9.36dBi and the bandwidth of return loss lower than -10dB covers 5.8GHz ISM band regardless of the beam steering angles.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.45 no.8
• /
• pp.114-120
• /
• 2008

In this paper, we extract the parasitic elements of the metal-insulate-metal(MIM) capacitor using short-open calibration (SOC). The scattering matrixes of short, open, and MIM structures in strip lines are measured by full electro-magnetic (EM) simulator and vector network analyser. The full EM simulations are performed by finite element method (FEM) that was fitted three dimensional structure analysis. The electro-magnetic effects of MIM capacitor laminated in the multi-layered structures are proposed the II equivalent circuit with lumped elements, and the relations between the measured scattering parameters of the MIM structures and lumped elements in the circuits are shown by performing 2 port network analysis. The extracted lumped elements using the proposed SOC method are independent to frequencies.