• Proceedings of the Korean Society for Technology of Plasticity Conference
• /
• 2009.05a
• /
• pp.266-269
• /
• 2009

Iron-based soft magnetic materials are widely used as cores, such as transformer transformers, motors, and generators. Reducing losses generated from soft magnetic materials of these applications results in improving energy conversion efficiency. Recently, the new P/M soft magnetic material realized an energy loss of 68 W/kg with a drive magnetic flux of 1 T, at a frequency of 1 kHz, rivaling general-purpose electromagnetic steel sheet in the low frequency range of 200 Hz to 1 kHz. In this research, the effect of rolling parameters on soft magnetic properties of Fe-based powder cores was investigated. The Fe-based soft magnetic plates were produced by the hot powder rolling process after both pure Fe and Fe-4%Si powders were canned, evacuated, and sealed in Cu can. The soft magnetic properties such as energy loss and coercive power were measured by B-H curve analyzer. The soft magnetic properties of rolled sheets were measured under conditions of a magnetic flux density of 1 T at a frequency of 200 kHz. It was found that rolling reduction ratio is the most effective parameter on reducing both energy loss and coercivity because of increasing aspect ratio with reduction ratio. By increasing aspect ratio from 1 to 9 through hot rolling of pure Fe powder, a significant loss reduction of one-third that of SPS sample was achieved.

• Korean Journal of Veterinary Research
• /
• v.45 no.2
• /
• pp.223-231
• /
• 2005

A quantitative risk assessment tool was used to provide estimates of the probability that foot-and-mouth (FMD) virus-contaminated, smuggled animal products are fed to susceptible swine in Korea. Sensitivity analyses were conducted to attempt to distinguish between parameter uncertainty and variability, using different assumptions on the effect of cooking at home, the effect of the fresh meat, and the effect of heat treatment at garbage processing facility. The median risk estimate was about 20.1% with a mean value of 27.4%. In a scenario regarding all beef and pork were considered as fresh meat the estimated median risk was 3.4%. The risk was greatly dependent on the survival parameters of the FMD virus during the cooking or heat treatment at garbage processing facility. Uncertainty about the proportion of garbage that is likely contaminated with FMD had a major positive influence on the risk, whereas conversion rate representing the size of a load had a major negative effect. This model was very useful in assessing the risk explored. However, the model also requires enhancements, such as the availability of more accurate data to verify the various assumptions considered such as FMD prevalence in a specific country, proportion of garbage which is recycled as feed, proportion of food discarded as garbage. Other factors including the effect of selection of animals for slaughter, ante- and post-mortem inspection, the domestic distribution of the smuggled products, and susceptible animals other than pigs, are need to be taken into account in the future model development.

• Journal of Korean Society of societal Security
• /
• v.4 no.2
• /
• pp.41-48
• /
• 2011

Pedestrian environment not only affects the quantitative degree in pedestrian movement, but also an impact on the local economics and environment that speaks within the greater dialogue of the qualitative life in an urban context. Recent urban planning issues have matured from a linear street development to a conversion of pedestrian friendly streets that synchronizes the entire pedestrian movement structures as a whole. Subject cases, Myung-Dong and Kwanchul-Dong, were selected from time regulated pedestrian streets in Seoul. Analysis of these streets was done through field studies and interviews. From the research, the outcome was helpful in providing the developers a greater perspective with the pedestrian movement structure that is not confined to a certain parameter, but in a larger scale within the urban environment. It was also useful in justifying ambiguous locations of pedestrian-only streets and crosswalks. Also, It aided in planning optimal scheme that concurs with the predictable pedestrian movement.

• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.36D no.8
• /
• pp.54-61
• /
• 1999

This paper proposes a new optic link structure applicable to broad-band wireless access microcellularsystem servicing in the millimeter wave frequency band. The proposed structure utilizes photonic mixing by exploiting the nonlinear property of EOMs, which leads to the frequency up-conversion at the CS and thus, electrical mixing at a BS is not required. Moreover, via transmitting an additional optical millimeter wave carrier into the Bs, the dispenses with an active optic source, which miniaturizes the BS. We analyze CNR, IM3/C in the downlink and SFDR in the uplink. Through simulation using the typical parameter values we also show the feasibility of the proposed system based on the requirements in the current microcellular system.

• Ocean Systems Engineering
• /
• v.10 no.1
• /
• pp.87-110
• /
• 2020

Catamaran has recently been a choice to support a typical vertical axis turbine in floating tidal current energy conversion system. However, motion responses associated with the catamaran can reduce the turbines efficiency. The possibility to overcome this problem isto change the catamaran parameter by varying and simulating the demi-hull separations to have lower motion responses. This simulation was undertaken by Computational Fluid Dynamic (CFD) using potential flow analysis. Cases of demi-hull separation were considered, with ratios of demi-hull separation (S) to the breadth of demi-hull (B), ^S/_B of 3.45, 4.95, 6.45, 7.2 and 7.95. In order to compare to the previous works in the literature, the regular wave was set with wave height of 0.8 m. Furthermore, the analysis was carried out by irregular waves with significant wave height, H_s, of about 0.09 to 1.5 m and the wave period, T, of about 1.5 to 6 s or corresponding to the wave frequency, ω, of about 1.1 to 4.2 rad/s. The wave spectrum was derived from the equation of the International Towing Tank Conference (ITTC). For the case of turbines-loaded catamaran under consideration, the new finding is that the least significant amplitude response can be satisfied at the ratio ^S/_B of 7.2. This study indicates that selecting a right choice of demi-hull separation ratio could contribute in reducing motion responses of the tidal current turbines-loaded catamaran.

• Journal of IKEEE
• /
• v.15 no.4
• /
• pp.319-323
• /
• 2011

In this paper presents a new model of dual-mode synchronous buck converter with dynamic control for mobile applications was proposed. The proposed circuit can operate at 2.5MHz with supply voltage 2.5V to 5V for low ripple and minimum inductor and capacitor size, which is suitable for single-cell lithium-ion battery supply mobile applications. For high efficiency, the proposed circuit adopts synchronous type and dynamic control. The proposed circuit is designed by using the device parameter of TSMC 0.18um BCD process and the performance is evaluated by Cadence spectre. Experimental board level results show the maximum conversion efficiency is 96% at 100mA load current.

• Current Photovoltaic Research
• /
• v.3 no.4
• /
• pp.135-139
• /
• 2015

$Cu_2SnS_3$ (CTS) based thin film solar cells (TFSCs) are of great interest because of its earth abundant, low-toxic and eco-friendly material with high optical absorption coefficient of $10^4cm^{-1}$. In this study, the DC sputtered precursor thin films have been sulfurized using rapid thermal annealing (RTA) system in the graphite box under Ar gas atmosphere for 10 minute. The systematic variation of sulfur powder during annealing process has been carried out and their effects on the structural, morphological and optical properties of CTS thin films have been investigated. The preliminary power conversion efficiency of 1.47% with a short circuit current density of $33.9mA/cm^2$, an open circuit voltage of 159.7 mV, and a fill factor of 27% were obtained for CTS thin film annealed with 0.05g of S powder, although the processing parameter s have not yet been optimized.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.26 no.3
• /
• pp.198-203
• /
• 2013

Dye-sensitized solar cells (DSSCs) based on titanium dioxide ($TiO_2$) have been extensively studied because of their promising low-cost alternatives to conventional semiconductor based solar cells. DSSCs consist of molecular dye at the interface between a liquid electrolyte and a mesoporous wide-bandgap semiconductor oxide. Most efforts for high conversion efficiencies have focused on dye and liquid electrolytes. However, interface engineering between dye and electrode is also important to reduce recombination and improve efficiency. In this work, for interface engineering, we deposited semiconducting ferroelectric $BiFeO_3$ with bandgap of 2.8 eV on $TiO_2$ nanoparticles and nanotubes. Photovoltaic properties of DSSCs were characterized as a function of thickness of $BiFeO_3$. We showed that ferroelectric $BiFeO_3$-coated $TiO_2$ electrodes enable to increase overall efficiency of DSSCs, which was associated with efficient electron transport due to internal electric field originating from electric polarization. It was suggested that engineering the dye-$TiO_2$ interface using ferroelectric materials as inorganic modifiers can be key parameter for enhanced photovoltaic performance of the cell.

• The Journal of Internal Korean Medicine
• /
• v.22 no.3
• /
• pp.321-330
• /
• 2001

Objectives: This study was undertaken to investigate the action mechanism of Holotrichia (HT) at parameter related to dementia. Methods: HT was tested for the effects on acetylchonine esterase and monoamine oxidase activities, lipid peroxidation, antioxidation in brain of lead acetate-treated rats. Lead acetate were treated firstly into samples for 10 days, and then lead acetate and HT were set with them for 20 days. Results: The level of lipid peroxide, acetylcholine esterase and monoamine oxidase activities, enzyme activities and ratio of type conversion of xanthine oxidase increased in lead acetate-treated rats were decreased as highly as normal group by HT. Superoxide dismutase, catalase and glutathione peroxidase activities, the level of acetylcholine decreased in lead acetate-treated rats were increased as lowly as normal group by HT. Conclusions : These results suggest that HT might have an effect on treatment of dementia according to decreasing the activities of acetylcholine esterase, monoamine oxidase and level of lipid peroxide in brain.

• Applied Chemistry for Engineering
• /
• v.23 no.2
• /
• pp.204-209
• /
• 2012

In this study, kinetics data was obtained for steam reforming reaction of ethane over the commercial ruthenium catalyst. The variables of ethane steam reforming were the reaction temperature, partial pressure of ethane, and steam/ethane mole ratio. Parameters for the power rate law kinetic model and the Langmuir-Hinshelwood model were obtained from the kinetic data. Also, sizing of steam reforming reactor was performed by using PRO/II simulator. The reactor size calculated by the power rate law kinetic model was bigger than that of using the Langmuir-Hinshelwood model for the same conversion of ethane. Reactor size calculated by the Langmuir-Hinshelwood model seems to be more suitable for the reactor design because the Langmuir-Hinshelwood model was more consistent with the experimental results.