• Journal of Biosystems Engineering
• /
• v.36 no.3
• /
• pp.217-222
• /
• 2011

This study was carried out in order to reduce the amount of underground water which is used in the double layered single span plastic greenhouse for retaining heat. For this research, two plastic green houses of the double layered single span plastic greenhouse were installed. There was equipped of internal small tunnel for keeping warm air in the interior of the house. Then the internal small tunnel for keeping warm air was fitted with PVC duct of 50 cm in diameter filled with subsurface water. The surplus solar energy in the greenhouse was stored in the water in the PVC duct. Four FCUs (Fan Coil Unit), which has the capacity of 8,000 kcal per hour, were installed in the middle of the house, and a circulation motor in heat storage water tank was operated from 10:30 a.m. to 16:00 p.m. in order to circulate water between the water tank and the FCUs. Consequently about 5 degrees celsius could be maintained in the interior of the internal small tunnel for keeping warm air with the external temperature of lower than minus 5 degrees celsius. It appeared that the alteration of an internal temperature of the house was flexible depending on the sunlight during daytime. To prevent the water freezing, mixing antifreezing liquid in the water or operating FCU continuously was needed. Also, in order to use the surplus solar thermal energy on plastic green house of water curtain system efficiently, storing the surplus heat during daytime simultaneously finding a method of using water curtain systematic underground water happened to be important. As a result of this research, when the house's interior temperature is below zero the operation of FCU appeared to be impossible. Considering the amount of water used in the house with water-curtain-heating system is 150~200 ton per day, using the system mentioned in this research showed that reducing the underground water more than 80% in order to maintain the internal temperature as the level of 5 degree celsius at the extreme temperature of minus 5 degrees celsius.

• Korean Journal of Food Science and Technology
• /
• v.49 no.5
• /
• pp.469-473
• /
• 2017

The objective of this study was to develop methods for the discrimination of new and stale rice by using an electronic eye. To develop the discriminant, 107 rice samples produced in the years 2015 and 2016 were investigated. After the rice was treated with guaiacol, oxydol, and p-phenylenediamine reagents, an electronic eye was applied to discriminate between newly harvested rice and rice stored for 1 year. Out of the 4,096 color codes of the electronic eye, 31 color codes were identified for the discrimination of newly harvested rice and rice stored for 1 year. The classification ratio of newly harvested rice and rice stored for 1 year was 100% and the discrimination accuracy for unknown samples was 100%. In a total of 150 mixtures of new rice and stale rice, the discrimination accuracy was between 16.7 and 95.6%, depending on the mixing ratio. This capability of the electronic eye will be useful as a tool for discriminating the production year of rice.

• Korean journal of food and cookery science
• /
• v.17 no.4
• /
• pp.353-358
• /
• 2001

The leaves of Duchung(Eucommia ulmoides), an oriental medicinal plant, have a peculiar aroma of Chinese medicine and astringent taste, which make the consumer be reluctant to Duchung leaf tea. Therefore, the purpose of this study was to develop a mild flavored Duchung leaf tea by mixing with other plants. The flavor patterns of developed tea were analyzed using an electronic nose. Polygonatum odoratum and Elsholtzia splendens were used for improving the flavor of Duchung leaf tea. The addition of 20, 30 and 40% of Polygonatum odoratum improved the overall acceptance in hedonic sensory evaluation. The flavor pattern of the tea was described by principal component analysis(PCA) and the resistance ratio(R/cub gas/R$\_$air/) of sensors. The PCA plot was also used to explain the mild flavor of the tea, which was extended from the right side(positive value of the first principal component) to the left side(negative value). Analysis by using an electronic nose with metal oxide sensors could be applied to detect whether mixed Duchung leaf tea was acceptable or not.

• Journal of the Korean Ceramic Society
• /
• v.39 no.7
• /
• pp.704-709
• /
• 2002

To improve the mechanical properties of $Al_2$O$_3$/ZrO$_2$composites, the homogeneous dispersion of ultra low size ZrO$_2$ particles in $Al_2$O$_3$ceramics have been controlled by coprecipitation method. In case of mechanical mixing of ZrO$_2$ powders with $Al_2$O$_3$, homogeneous dispersion and controlling the ZrO$_2$ size were relatively difficult due to high sintering temperature. So nanosized Zr hydroxide was coprecipitated from ZrOCl$_2$/Y(NO$_3$)$_3$ solution with commercial sub-micron sized $\alpha$-alumina (Sumitomo : AES-11(0.4 ${\mu}{\textrm}{m}$)) and high purity ultra low sized $\alpha$-alumina (Taimei Chemical (0.22 ${\mu}{\textrm}{m}$)) for low temperature sintering. By this partial coprecipitation method, relatively low sized ZrO$_2$ dispersion in $Al_2$O$_3$/ZrO$_2$ composites was achieved at 150$0^{\circ}C$-1$600^{\circ}C$ of sintering temperature range and their mechanical properties were measured.

• The Korean Journal of Food And Nutrition
• /
• v.20 no.1
• /
• pp.1-8
• /
• 2007

Tortillas were prepared using rice and wheat flour. The experimental design incorporated thee independent variables(rice, wheat flour and moisture content) producing 14 samples of different proportions of each variable for each tortilla. The following were analysed using Design Expert 6 to unveil the influences of these variables on tensile strength and color(L, a, b). Results indicated that tensile strength increased with increasing rice and wheat flour content, however, decreased with increasing moisture content. Lighteness(L), of the tortilla increased with increased rice content whereas yellowness(b) increased with increased wheat flour content. The model suggests that tensile strength and color(L, a, b) in tortillas are highly correlated(SD Comment - give correlation coefficient and p-value). As well, the numerical optimization method suggests that the ratio of wheat flour to rice flour to moisture content which maximizes the three responses(tensile strenth, L and b) is 18.26 : 33.92 : 39.24%, 28.15 : 25.77 : 37.50%.

• Journal of the Korea Organic Resources Recycling Association
• /
• v.9 no.3
• /
• pp.104-110
• /
• 2001

In this study, the effect of physico-chemical variables on sludge conditioning was determined to enhance dewaterability of effluent produced from the thermophilic anaerobic digestion of food waste. The gas production rate and methane content during the anaerobic digestion of food waste were $1.1m^3/kg$ VS and 63%, respectively, and the biodegradability of volatile solids was 87.5%. The concentrations of CODcr, TKN and TP of effluent from digestor were 18,500mg/L, 2,800mg/L, and 582mg/L, respectively. At the jar test to screen the flocculant for the dewatering of effluent from digestor, $FeCl_3$ and strong cationic polymer were effective on making flocs in the effluent. The condition of flocculation of effluent were 500mg/L of $FeCl_3$ and 50-100 mg/L of strong cationic polymer, respectively. As the result of measuring of dewaterability potential of effluent to determine the mixing ratio between $FeCl_3$ and polymer by capillary suction time(SCT), optimum condition was 500mg/L of $FeCl_3$ and 80mg/L of strong cationic polymer.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.19 no.4
• /
• pp.18-24
• /
• 2015

Non-destructive testing (NDT) methods are widely used in the construction industry to diagnose the defects/strength of the concrete structure. However, it has been reported that the results obtained from NDT are having low reliability. In order to resolve this issue, four kinds of NDT test (ultrasonic velocity measurements by P-wave and S-wave and the impact resonance methods by longitudinal vibration and deformation vibration) were carried out on 180 concrete cylinders made with two kinds of mix proportions. The reliability of the NDT results was analyzed and compared through the measurement of the actual compressive strength of the concrete cylinders. The statistical analysis of the results was revealed that the ultrasonic velocity method by S-wave is having lowest coefficient of variation and also most capable of stable observation. Analytical equations were established to estimate the compressive strength of the concrete from the obtained NDT results by relating the actual compressive strength. Moreover the equation established by the ultrasonic velocity method by S-wave had the highest coefficient of determination. Further studies on the stability of non-destructive testing depending on various mixing conditions will be necessary in the future.

• Journal of the Korean Geophysical Society
• /
• v.3 no.2
• /
• pp.127-138
• /
• 2000

This study was conducted to examine the differences between dynamic and static elastic constants by use of some laboratory tests of cement mortar specimens which have different water/cement mixing ratios. Specific gravity measurement, ultrasonic velocity estimating and uniaxial compression test were adopted to acquire the dynamic and static elastic constants. Digital data acquisition and processing enhanced the accuracy of estimating the velocities of specimens drastically, Also, the method using the gradient of propagation delay time in according to increment of specimen length more enhanced the accuracy than the method using the only one specimen length over total propagation time. The correlation between density and the P and S wave velocity of specimens shows reliable positive relation and the correlation between density and the strength of uniaxial compression has the similar relationship. The dynamic Young's modulus $(E_D)$ is alway greater than the static Young's modulus $(E_S)$ and there is increasing tendency of the ratio $(E_D/E_S)$ according to the increase of density or strength of the specimens. On the other hand, there is no typical relationship between dynamic Poisson's ratio $({\nu}_D)$ and static Poisson's ratio $({\nu}_S)$ and just the ratio of ${\nu}_D/{\nu}_S$ ranges front 69 to 122 %.

• Journal of Environmental Science International
• /
• v.16 no.10
• /
• pp.1179-1187
• /
• 2007

This paper represents the statistical characteristics of sources and receptors for road traffic noise in apartment complex. Also we suggested that the site-specific characteristics of vertical and horizontal distributions in the complex apartment have been derived using a different analysis for evaluating levels of Leq1h by the apartment floor at a given distance from a road in terms of the flow rate, the mean speed of the traffic, and the percentage of the type vehicles in the day and night periods. As a result, the contribution orders of traffic quantity by the type of vehicles showed as followed: light vehicle>medium vehicle>heavy vehicle>motorcycle. Especially, the mixing ratio of entering the road on the heavy vehicle in the daytime was two times higher than that of in the night. The speed in all types of vehicle is in the range of 41 and 81 km/hr and noise level was not significantly different in day and night-time. The sources of road traffic noise had different variations and uncertainties using a random variable and probability distribution. The sound distribution to receptors by the apartment floor showed S curve between 1st floor and $15^{th}$ floor With the normality test, the normal distributions using Anderson-Darling Test followed $1^{st},\;3^{th},\;13^{th}$ and $15^{th}$, floor in the daytime and all floors except $7^{th}$ floor in the night (p>0.05). And also, the value of the pearson correlation coefficient (r) obtained in this study have significantly different at the range of floor. In conclusion, the results suggested that the distribution characteristics of levels of $Leq_{1h}$ on the sources and receptors of road traffic noise in apartment complex must be improved and developed on the guideline of regulation of road traffic noise.

• Journal of Periodontal and Implant Science
• /
• v.37 no.4
• /
• pp.859-869
• /
• 2007

Naked DNA and standard vectors have been previously used for gene delivery. Among these, PEI can efficiently condense DNA and has high intrinsic endosomal activities. The aim of this study is to investigate whether the cationic polycation PEI could increase the transfection efficiency of BMP expressing DNA using a vector-loaded collagen sponge model. BMP-2/pcDNA3.1 plasmid was constructed by subcloning human BMP-2 cDNA into the pcDNA3.1 plasmid vector. PEI/DNA complexes were prepared by mixing PEI and BMP-2/pcDNA3.1 and the constructed complexes were loaded into the collagen sponges. In vitro studies, BMSCs were transfected with the PEI/BMP-2/pcDNA3.1 complexes from collgen sponge. The level of secreted BMP-2 and alkaline phosphatase activities of transfected BMSCs were significantly higher in PEI/BMP-2/pcDNA3.1 group than in BMP-2/pcDNA3.1 group (p<0.05). Transfected BMSCs were cultured and mineralization was observed only in cells treated with PEI/BMP-2/pcDNA3.1 complexes. In vivo studies, PEI/BMP-2/pcDNA3.1/collagen, BMP-2/pcDNA3.1/collagen and blank collagen were grafted in skeletal muscle of nude mice. Ectopic bone formation was shown in PEI/BMP-2/pcDNA3.1/collagen grafted mouse 4 weeks postimplantation, while not in BMP-2/pcDNA3.1 grafted tissue. This study suggests that PEI-condensed DNA encoding for BMP-2 is capable of inducing bone formation in ectopic site and might increase the transfection rate of BMP-2/pcDNA3.1. As a non-viral vector, PEI offers the potential in gene therapy for bone engineering.