• Korean Journal of Optics and Photonics
• /
• v.7 no.3
• /
• pp.238-243
• /
• 1996

We have developed XeCl laser pumped double-resonator Dye laser and two-stage amplifier system, and generated simultaneously of alternatively two wavelengths suitable in DIAL system. The developed double-resonator is composed of 1st and 2nd diffraction orders on light incidence angle in grazing-incidence grating method with 1200 g/mm. We have obtained spectral linewidth below 10 pm and the total efficiency dependent on pump energy over 6%. The tuning ranges dependent on 1st and 2nd diffraction orders are 434~470 nm and 436~468 nm, respectively. The amplification gain and rine-450 dye laser by using the double-resonator laser system and measured the distribution of $NO_2$ concentration over Suwon as the result of transmission of laser output of 6 mJ in this DIAL system. Consequently, we have confirmed that the developed dye laser system is very useful as the tunable source for DIAL.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.44 no.12
• /
• pp.63-72
• /
• 2007

This paper addresses the system development that can transfer data and TDM signals simultaneously by adding TDM pseudowires functions to E-PON system. E-PON technology is one of many technologies which can realize FTTH, has raised as next generation access network solution having both low-cost Ethernet technology and optical infrastructure. TDM pseudowires service is the new voice/data conversion technology which can transfer the existing TDM circuit switched voice and data over packet switching network. In this paper, this system can provide both data and TDM service without deteriorating QoS by adding TDM pseudowires service module to E-PON, and then implementing QoS control function. Therefore, the competitive system which can transfer both data and TDM signal, can be installed.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2004.08a
• /
• pp.1058-1061
• /
• 2004

Recently, According to companies of TFT LCD are making large sized products more and more. In the vortex of Products with a monitor and LCD TV is applied in a technique of a high viewing angle(FFS, IPS, VA). Also, as a high luminance, high speed response time, high degree of a color purity, and so on are continuing to develop a high performance, it is necessary to improve a specific character of high luminance that apply to LCD TV as a LCD BLU. Because a LCD panel for TV usually has a lower resolution that compare to a monitor, the structure of present backlight system can't put out its power even though it has a merit in transmission. Therefore, the examination of improvement about the high luminance direct typed BLU for LCD TV that presupposes several uses of CCFL(Cold Cathode Fluorescent Lamp) or EEFL(External Electrode Fluorescent Lamp)is actively being progressed. Although it is necessary to increase the number of lamps for applying high performance by the direct type, in this case, because we can design the character of luminance for adoption of high performance. We can satisfy with a level of luminance for LCD TV. Accordingly, we analyzed a change of the number of CCFL, mechanical and optical character to produce the direct typed backlight in 32inches spec. Consequently, we achieved luminance of 6597nit,which was including polarization film, and secured the standard for LCD TV.

• Journal of Advanced Marine Engineering and Technology
• /
• v.37 no.4
• /
• pp.425-430
• /
• 2013

Robust and high speed underwater communication is severely limited when compared to communications in terrestial. In free space, RF communication operates over long distances at high data rates. However, the obstacle in seawater is the severe attenuation due to the conducting nature. Acoustic modems are capable of long range communication up to several tens of kilometers, but it has low data-rate, high power consumption and low propagation speed. An alternative means of underwater communication is based on optics, wherein high data rates are possible. In this paper, the characteristics of underwater channel in the range of visible wavelength is investigated. And the possibility of optical wireless communication in underwater is also described. The LED-based transceiver and CMOS sensor module are integrated in the system, and the performance of image transmission was demonstrated.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2010.06a
• /
• pp.208-208
• /
• 2010

Indium zinc tin oxide (IZTO) thin films were studied as a possible alternative to indium tin oxide (ITO) films for providing low-cost transparent conducting oxide (TCO) for thin film photovoltaic devices. IZTO films were deposited onto glass substrates at room temperature. A dc/rf magnetron co-sputtering system equipped with a ceramic target of the same composition was used to deposit TCO films. Earlier studies showed that the resistivity value of $In_{0.6}Zn_{0.2}Sn_{0.2}O_{1.5}$ (IZTO20) films could be lowered to approximately $6{\times}10^{-4}ohm{\cdot}cm$ without sacrificing optical transparency and still maintaining amorphous structure through the optimization of process variables. The growth rate was kept at about 8 nm/min while the oxygen-to-argon pressure ratio varied from 0% to 7.5%. As-deposited films were always amorphous and showed strong oxygen pressure dependence of electrical resistivity and electron concentration values. Influence of forming gas anneal (FGA) at medium temperatures was also studied and proven effective in improving electrical properties. In this study, the chemical composition of the targets and the films varied around the $In_{0.6}Zn_{0.2}Sn_{0.2}O_{1.5}$ (IZTO20). It was the main objective of this paper to investigate how off-stoichiometry affected TCO characteristics including electrical resistivity and optical transmission. In addition to the composition effect, we have also studied how film properties changed with processing variables. IZTO thin films have shown their potential as a possible alternative to ITO thin films, in such way that they could be adopted in some applications where currently ITO and IZO thin films are being used. Our experimental results are compared to those obtained for commercial ITO thin films from solar cell application view point.

• Journal of the Microelectronics and Packaging Society
• /
• v.14 no.3
• /
• pp.15-20
• /
• 2007

Low temperature processed ZnO-TFTs on glass below $270^{\circ}C$ for plastic substrate applications were fabricated and their electrical properties were investigated. Films in ZnO-TFTs with bottom gate configuration were made by RF magnetron sputtering system except for $SiO_2$ gate oxide deposited by ICP-CVD. ZnO channel films were grown on glass with various Ar and $O_2$ flow ratios. All of the fabricated ZnO-TFTs showed perfectly the enhancement mode operation, a high optical transmittance of above 80% in visible ranges of the spectrum. In the ZnO-TFTs with pure Ar process, the field effect mobility, threshold voltage, and on/off ratio were measured to be $1.2\;cm^2/Vs$, 8.5 V, and $5{\times}10^5$, respectively. These characteristic values are much higher than those of the ZnO-TFTs of which ZnO channel layers were processed with additional $O_2$ gas. In addition, ZnO-TFT with pure Af process showed smaller swing voltage of 1.86v/decade compared to those with $Ar+O_2$ process.

• Bulletin of the Korean Space Science Society
• /
• 2004.10b
• /
• pp.372-375
• /
• 2004

The UV radiometer payload was launched successfully from the west coastal area of Korea Peninsula aboard KSR-III on 28, Nov 2002. KSR-III was the Korean third generation sounding rocket and was developed as intermediate step to larger space launch vehicle with liquid propulsion engine system. UV radiometer onboard KSR-III consists of UV and visible band optical phototubes to measure the direct solar attenuation during rocket ascending phase. For UV detection, 4 channel of sensors were installed in electronics payload section and each channel has 255, 290, 310nm center wavelengths, respectively. 450nm channel was used as reference for correction of the rocket attitude during the flight. Transmission characteristics of all channels were calibrated precisely prior to the flight test at the Optical Lab. in KARI (Korea Aerospace Research Institute). During a total of 231s flight time, the onboard data telemetered to the ground station in real time. The ozone column density was calculated by this telemetry raw data. From the calculated column density, the vertical ozone profile over Korea Peninsula was obtained with sensor calibration data. Our results had reasonable agreements compared with various observations such as ground Umkhr measurement at Yonsei site, ozonesonde at Pohang site, and satellite measurements of HALOE and POAM. The sensitivity analysis of retrieval algorithm for parameters was performed and it was provided that significant error sources of the retrieval algorithm.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.8 no.6
• /
• pp.1234-1242
• /
• 2004

In this paper, the characteristics of compensation for interferenced mid-channel signal by neighbor channels through four-wave mixing (FWM) process dominantly is investigated as a function of channel input power, fiber dispersion coefficient and transmission length in WDM system with equally spaced channels. The compensation method used in this research is mid-span spectral inversion(MSSI). The highly nonlinear dispersion shifted fiber (HNL-DSF) is used as a nonlinear medium of optical phase conjugator (OPC) in order to compensate wideband WDM signals. First, we confirmed that the effect of FWM on channel interference is gradually reduced as fiber dispersion coefficient becomes gradually smaller, independent of signal format. And, we confirmed that RZ is better than NRZ as a modulation format for transmitting high power channel with allowable reception quality. But realization of flexible WDM systems regardless of channel number variation is possible by using NRZ rather than RZ format.

• Current Optics and Photonics
• /
• v.2 no.5
• /
• pp.474-481
• /
• 2018

We propose a polarization phase-shifting technique to investigate the thickness of $Ta_2O_5$ thin films deposited on BK7 substrates, using a modified Sagnac interferometer. Incident light is split by a polarizing beam splitter into two orthogonal linearly polarized beams traveling in opposite directions, and a quarter-wave plate is inserted into the common path to create an unbalanced phase condition. The linearly polarized light beams are transformed into two circularly polarized beams by transmission through a quarter-wave plate placed at the output of the interferometer. The proposed setup, therefore, yields rotating polarized light that can be used to extract a relative phase via the self-reference system. A thin-film sample inserted into the cyclic path modifies the output signal, in terms of the phase retardation. This technique utilizes three phase-shifted intensities to evaluate the phase retardation via simple signal processing, without manual adjustment of the output polarizer, which subsequently allows the thin film's thickness to be determined. Experimental results show that the thicknesses obtained from the proposed setup are in good agreement with those acquired by a field-emission scanning electron microscope and a spectroscopic ellipsometer. Thus, the proposed interferometric arrangement can be utilized reliably for non-contact thickness measurements of transparent thin films and characterization of optical devices.

• Journal of Space Technology and Applications
• /
• v.4 no.2
• /
• pp.87-104
• /
• 2024

CubeSats are being utilized in various fields such as Earth observation, space exploration, and verification of space science and technology due to their low cost, short development period, enhanced mission-oriented performance, and ability to perform various missions through constellation and formation flights. Recently, as the availability of CubeSats has increased and their application areas have expanded, the demand for high-speed transmission of large amounts of data obtained by CubeSats has increased unprecedentedly. Laser-based free space optical communication technology is capable of transmitting large amounts of data at high speeds compared to the existing radio communication methods, and provides various advantages such as use of unlicensed spectrum, low cost, low power, high security characteristics, and of use a small communication platform. For this reason, it is suitable as a high-performance communication technology to support CubeSat missions. In this paper, we will present the core components and characteristics of CubeSat-based space laser communication system, and recent research trends, as well as representative technology development results.