• Journal of the Korean Vacuum Society
• /
• v.4 no.3
• /
• pp.334-341
• /
• 1995

IB-AI-VIB2 및 IB-AI-VIB2 :Co2+ 결정을 고순도 원소를 출발 물질로 하고 iodine을 수송 매체로 사용하여 chemical transport reaction method로 성장시켰다. 성장된 결정의 결정구조는 chalcopyrite 구조였으며, energy gap은 direct band gap으로 3.514~1.814 eV 정도로 주어졌으며, cobalt를 불순물로 첨가할 때 energy gap은 감소하였다. IB-AI-VIB2 :Co2+ 결정에서 첨가된 cobalt가 모체결정의 Td symmetry site에 Co2+ ion으로 위치하여, Co2+ ion의 energy 준위 사이의 전자전이에 기인하는 불순물 광흡수 peaks가 나타났다. 이 불순물 광흡수 peaks에 결정장 이론을 적용하여 구산 1st-order spin-orbit coupling parameter(λ)는 -183~ -189cm-1정도였고, 2nd-order spin-orbit coupling parameter(P)는 225~239 cm-1정도였으며, crystal field parameter(Dq)는 328~395cm-1, Racah parameter(B)는 531~552cm-1정도였다.

• Journal of environmental and Sanitary engineering
• /
• v.15 no.2
• /
• pp.102-111
• /
• 2000

As IR-sensor for detecting pollution material, the iron silicide has a fit band gap, high physicochemical stability at high temperature and good acid resistance. The growing film was formed with the Fe-Si bond and the organic compound because plasma resolved the injected precursors into various active species. In the Raman scattering spectrum, the Fe-Si vibration mode showed at 250 {TEX}$cm^{-1}${/TEX}. The FT-IR peak indicated that the various organic compounds were deposited on the films. The iron silicide was epitaxially grown to β-phase by the high energy of plasma. The lattice structure of films had [220]/[202] and [115]. The thickness of the films increased with the flow rate of silane. But rf-power increased with decreasing the thickness. The optical gap energy and the band gap were shown about 3.8 eV and 1.182∼1.194 eV. The band gap linearly increased and the formula was below: {TEX}$E_g^{dir}${/TEX}= 8.611×{TEX}$10^{-3}N_{D}${/TEX}＋1.1775

• 한국신재생에너지학회:학술대회논문집
• /
• 2010.06a
• /
• pp.67.1-67.1
• /
• 2010

Triple junction solar cell을 위한 a-SiGe middle cell의 조건별 광학적 특성에 관한 연구를 실시하였다. a-SiGe I층은 GeH4 유량, 압력, H2 dilution ratio를 변화시켜 제조하였으며 전기적, 광학적 특성을 비교하여 최종적으로 선택된 조건을 triple junction solar cell에 적용하였다. a-SiGe I층은 Ge contents가 증가함에 따라 band gap은 감소하고 45% 이상의 조건에서는 700nm 전후 파장의 투과율이 감소하며, 압력이 감소함에 따라 band gap은 소폭 감소하나 700nm 전후 파장의 투과율은 증가하였다. 그리고 H2 ratio가 증가함에 따라 band gap은 소폭 감소하나 투과율에는 큰 변화가 없었다. 상기 결과를 바탕으로 최종적으로 선택된 조건에서 triple-junction solar cell을 제작하여 평가한 결과 초기 변환효율 9%의 결과를 얻었다.

• Applied Chemistry for Engineering
• /
• v.10 no.1
• /
• pp.105-111
• /
• 1999

When the preparation method of iron silicide films possess the annealing process, the interfacial state of the films is not fine. The good quality films were obtained as the plasma was used without annealing processing. Since the injected precursors were various active species in the plasma state, the organic compound was contained in the prepared films. We confirmed the formation of Fe-Si bonds as well as the organic compound by Fe and Si vibration mode in Raman scattering spectrum at $250cm^{-1}$ and Ft-IR. Because of epitaxy growth being progressed by the high energy of plasma at the low temperature of substrate, iron silicide was epitaxially grown to ${\beta}$-phase that had lattice structure such as [220]/[202] and [115]. Band gap of the prepared films had value of 1.182~1.174 eV and optical gap energy was shown value of 3.4~3.7 eV. The Urbach tail and the sub-band-gap absorptions were appeared by organic compound in films. We knew that the prepared films by plasma were obtained a good quality films because of being grown single crystal.

• New & Renewable Energy
• /
• v.3 no.4
• /
• pp.54-62
• /
• 2007

In this paper, we report the research highlight on the preparation and characterization of Indium-free $Cu_2ZnSnSe_4$ and Indium-reduced $CulnZnSe_2$ thin films in order to seek the viability of these absorber materials to be applied in thin film solar cells. The films of $Cu_2ZnSnSe_4\;and\;CulnZnSe_2$ were prepared using mixed binary chalcogenides powders. It was observed that Cu concentration was a function of substrate temperature as well as CuSe mole ratio in the target. Under an optimized condition, $Cu_2ZnSnSe_4\;and\;CulnZnSe_2$ thin films grew with strong [112]. [220/204] and [312/116] reflections. Both $Cu_2ZnSnSe_4\;and\;CulnZnSe_2$ films were found to exhibit a high absorption coefficient of $104^4cm^{-1}\;Cu_2ZnSnSe_4$ film showed a band gap of 1.5eV which closes to the optimum band gap of an ideal solar absorber for a solar cell. On the other side, an increase of optical band gap from 1.0 to 1.25eV was found to be proportional with an increase of Zn concentration in the $CulnZnSe_2$ film. All films in this study revealed a p-type semiconductor characteristic.

• Journal of Korean Ophthalmic Optics Society
• /
• v.4 no.2
• /
• pp.97-103
• /
• 1999

Zinc sulfide is a ll-VI compound with a large direct band gap in the near-UV region and a promising material for blur-light emitting diode and laser diode. It was identified that the structure had zinc blonde structure through the analysis of X-ray diffraction patterns. It's lattice constant was measured to be $a_o=5.411{\AA}$. The optical absorption, photocurrent, and photoluminescence spectra were measured to investigate the optical properties of zinc sulfide single crystal. The optical energy band gap measured at room temperature was 3.61eV The energy band gap of zinc sulfide annealed in zinc vapor at $800^{\circ}C$ was lower 0.1eV than that of as-grown zinc sulfide through the analysis of the photocurrent spectra. The photoluminescence spectra were measured ranging from 30K to 293K for the two cases of as-grown and annealed zinc sulfide. As-grown ZnS single crystal had peaks at 350nm, 392nm, 465nm, and annealed zinc sulfide had peaks at 349nm.

• Journal of Sensor Science and Technology
• /
• v.5 no.5
• /
• pp.85-95
• /
• 1996

Based on the transmission of coupled gap solitons in nonlinear periodic media, we present an all-optical switching scheme which has a novel architecture and principle. The proposed switch with an extremely small switching element can be realized on a semiconductor waveguide. We here investigate the switching performance with a GaAs waveguide in order to give criteria for the experimental realization of the all-optical switching phenomena. We also suggest a variation of an index-matching scheme to solve the technical problem such as the input-energy coupling into a periodic waveguide.

• Proceedings of the KIEE Conference
• /
• 1995.07c
• /
• pp.1178-1180
• /
• 1995

In this paper, structual, optical and electrical properties of CdTe thin films prepared by electron beam evaporation method were studied. The crystal structure of CdTe films deposited at substrate temperature of $100{\sim}400^{\circ}C$ was zincblend type with preferential orientation of the (111)plane parallel to the substrate. The result of optical absoption and transmittance show that solar radiation with energy larger than band gap is almost completely absorbed within an about $2{\mu}m$ thickness of the evaporated CdTe layer and optical band gap of the CdTe film was larger with increasing substrate temperature. The resistivity of CdTe films deposited on the glass substrate was about $10^5{\sim}10^7{\Omega}cm$.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2008.06a
• /
• pp.307-308
• /
• 2008

Zinc oxide is a direct band gap wurtzite-type semiconductor with band gap energy of 3.37eV at room temperature. the n-type doped ZnO oxides, B doped ZnO (BZO) is widely studied in TCOs materials as it shows good electrical, optical, and luminescent properties. we focused on the fabrication of B doped ZnO films with glass substrate using the LSMCD at low temperature. And Novel boron-doped ZnO thin films were deposited and characterized from the structural, optical, electrical point of view. The structure, morphology, and optical properties of the films were studied as a function of by employing the XRD, SEM, Hall system and micro Raman system.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.13 no.10
• /
• pp.817-821
• /
• 2000

In this work, we have investigated the dependence of annealing temperature(T$\_$a/) on optical and electrical properties of amorphous hydrogenated SiC(a-SiC:H) films. The a-SiC:H films were deposited on corning glass and p-type Si(100) wafer by PECVD (plasma enhanced vapor deposition) using SiH$_4$+CH$_4$+N$_2$ gas mixture. The experimental results have shown that the optical energy band gap(E$\_$opt/)of the thin films annealed at high temperatures have shown that the graphitization of carbon clusters and micro-crystalline silicon occurs. The current-voltage characteristics have shown good electrical properties at the annealed films.