• Journal of the Institute of Convergence Signal Processing
• /
• v.21 no.4
• /
• pp.162-169
• /
• 2020

In this paper, we attempted a qualitative understanding of mutual injection locking without rigorous mathematics, and analyzed the proposed mutual injection locked light source. Also, a low-cost WDM-PON light source based on mutual injection locking using two unpolarized Fabry-Perot Laser Diodes (F-P LDs), was implemented. The RIN (Relative Intensity Noise) characteristic for the wavelength change of the F-P LD was measured, and when the variable wavelength range was 2.07 nm, it showed a RIN of at least -110 dB/Hz.

• The KIPS Transactions:PartC
• /
• v.8C no.5
• /
• pp.629-636
• /
• 2001

Network is changed from voice-based network into multimedia-based network by development of communication technology and multimedia service. We need a large bandwidth for multimedia service. The optical fiber is a more suitable medium than existing copper-based cable for large bandwidth. But, it is so expensive than copper-based cable. So, Minimizing total cost becomes a more important concept. In order to construct a minimum cost network, we have to consider existing conduits in network. On the other hand, optical fiber network allows that larger amount of traffic can be transmitted than copper-based network does. However, a failure of a node or link can make a serious damage to the network service. Thus, we have to get multiple paths to support continuous service even if a loss of failure occurs in some point of the network. The network survivability problem is to design the network that can provide reliable service to customers anytime with minimum total cost. In an existing solution of the network survivability problem with conduits, a conduit is considered only one time. But, the conduit is reusable if the network satisfies the required survivability. Proposed algorithm can more effectively considered already existed conduit. Network survivability and edge cost is predetermined. The proposed algorithm finds the best solution by conduit sharing within the limits of network survivability. According to the simulation result, the proposed method can decrease 7% of total cost than an existing method by effective conduits adaption.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.10 no.4
• /
• pp.718-723
• /
• 2006

Optical module plays an important role in the construction of high speed communication network. Laser diode is a component of optical module, and its characteristics are dependent of temperature, so many researches are reported. In this paper, we proposed the electrical equivalent circuit of PBH-LD based on the rate equations. And, the two leakage paths exit outside the active region. One path is converted pn-diode and the other path is converted two transistors using npn-Tr and pnp-Tr. In order to reduce the leakage currents, we observed the dependence of carrier concentrations of current blocking layers using PSPICE simulator.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.10 no.4
• /
• pp.1519-1534
• /
• 2016

In this paper, we study how to optimize the data shuffle phase by leveraging the flow relationship in datacenter networks (DCNs). In most of the clustering computer frameworks, the completion of a transfer (a group of flows that can enable a computation stage to start or complete) is determined by the flow completing last, so that limiting the rate of other flows (not the last one) appropriately can save bandwidth without impacting the performance of any transfer. Furthermore, for the flows enter network late, more bandwidth can be assigned to them to accelerate the completion of the entire transfer. Based on these characteristics, we propose the flow chasing algorithm (FCA) to optimize the completion of the entire transfer. We implement FCA on a real testbed. By evaluation, we find that FCA can not only reduce the completion time of data transfer by 6.24% on average, but also accelerate the completion of data shuffle phase and entire job.

• Proceedings of the KIEE Conference
• /
• 2001.11b
• /
• pp.395-398
• /
• 2001

Recently, the increasing need for internet and the activation of hiring business of communication line makes the demand for OPGW cable which can construct the optical communication network in the basis of existing overhead power transmission line. Especially, the demand is focused on the high fiber count OPGW due to high capacity transmission. In step with the trend toward high fiber count cable we have developed the Stainless Steel Loose Tube type OPGW within which have 144core firstly in KOREA. This paper describes the cable design and manufacturing process which gives the stable operation in very severe conditions and the long-term reliability test results conducted in according to dominant specification IEEE Std. 1138-1194.

• Geophysics and Geophysical Exploration
• /
• v.5 no.4
• /
• pp.272-279
• /
• 2002

During field survey of ground penetrating radar or borehole radar, we often encounter some problems which could be solved easily by modifying structure of the system such as antenna length, shape or array. In addition, it is necessary that the user could easily modify configuration of the radar system na test various array of antennas in order to verify and confirm numerical modeling results concerning radar antennas. We have developed network-analyzer-based, stepped-frequency georadar system. This system had been comprised with coaxial cable to confirm possibility of the system, then we have upgraded the system to use optical cable that is composed of optical/electric transducers, electric/optical transducers, amp, pre-amp and antennas. The software for the aquisition of data has been developed to control the system automatically using PC with GPIB communication and to display the obtained data graphically. We have tested the system in field survey na the results have been compared with those of RAMAC/GPR system.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.33A no.2
• /
• pp.50-58
• /
• 1996

This paper proposes the channel-access protocol suitable to a very high speed photonic WDM network with star configuration, which can provide a high channel utilization and insensitivity to the propagation delay. The proposed protocol employs a control channel and a simple status table to deal with the propagation delay which has been a major limiting factor in the performance of the very high speed optical communication networks. The control channel transmits control information in order to reserve access on data channels, and each node constitutes a status table after the reception of control pckets which holds information about the availbility of destination node and data channel. The proposed protocol is insensitive to the propagation delay time by removing necessity of the retransmission and by allowing parallel transmission of control packet and data packets. It is proved in analysis and discrete event simulation that the proposed protocol is superior in throughput and mean delay, especially at the high load conditions compared to the existing high speed channel-access protocols.

• Current Optics and Photonics
• /
• v.3 no.2
• /
• pp.119-127
• /
• 2019

A new secret-key-sharing cryptosystem using optical phase-shifting digital holography is proposed. The proposed secret-key-sharing algorithm is based on the Diffie-Hellman key-exchange protocol, which is modified to an optical cipher system implemented by a two-step quadrature phase-shifting digital holographic encryption method using orthogonal polarization. Two unknown users' private keys are encrypted by two-step phase-shifting digital holography and are changed into three digital-hologram ciphers, which are stored by computer and are opened to a public communication network for secret-key-sharing. Two-step phase-shifting digital holograms are acquired by applying a phase step of 0 or ${\pi}/2$ in the reference beam's path. The encrypted digital hologram in the optical setup is a Fourier-transform hologram, and is recorded on CCDs with 256 quantized gray-level intensities. The digital hologram shows an analog-type noise-like randomized cipher with a two-dimensional array, which has a stronger security level than conventional electronic cryptography, due to the complexity of optical encryption, and protects against the possibility of a replay attack. Decryption with three encrypted digital holograms generates the same shared secret key for each user. Schematically, the proposed optical configuration has the advantage of producing a kind of double-key encryption, which can enhance security strength compared to the conventional Diffie-Hellman key-exchange protocol. Another advantage of the proposed secret-key-sharing cryptosystem is that it is free to change each user's private key in generating the public keys at any time. The proposed method is very effective cryptography when applied to a secret-key-exchange cryptosystem with high security strength.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.13 no.2
• /
• pp.275-280
• /
• 2013

With rapidly growing mobile wireless services, the existing copper-based mobile backhaul technologies suffer from reaching the capacity limits. PON technologies is drawing attention as a key solution to replace the existing mobile backhaul technologies due to not only providing innovative network capacity but also cost-effective maintenance caused by the bandwidth gain from optical fibers. With a PON-based mobile backhaul, broadband wireless multimedia services such as a video conference and IPTV can be seamlessly provided. In this paper, we first introduce overview of the PON-based mobile backhaul technology. For a example of practical integration, three types of EPON-WiMAX integrated architectures are proposed and comparatively analyzed in term of costs and network performance. Then, applicable plan and anticipated effects are presented when applying network coding on the PON-based mobile backhaul to improve the performance of delivering multicast traffic.

• Journal of Advanced Navigation Technology
• /
• v.10 no.3
• /
• pp.262-267
• /
• 2006

For growing need for the multimedia application in the vehicles, the MOST protocol has been focused on. The MOST protocol supports three kinds of communication modes; short control message, asynchronous packets, and reserved synchronous stream data. Because of a variety of transportation, the MOST is suitable for various applications in vehicle environment. In this paper, we implemented embedded system which is MOST-enabled AMS platform and tested the network communication operation through the control port and the synchronous channel of the source port. We implemented the prototype platforms which communicate each other on the MOST's POF network. Moreover we implemented the DivX decoder attached AMS platform and verified the operation by transferring the video stream and the control messages through the MOST network.