• ETRI Journal
• /
• v.30 no.4
• /
• pp.615-617
• /
• 2008

A novel and compact elliptic-function bandpass filter is proposed in this letter. The techniques of slot etching and the addition of open stubs are applied to enhance the self-inductance and self-capacitance of hexagonal open-loop resonators. Thus, size reduction and improved transmission performance are obtained. Compared to the performance of the conventional design, the central frequency and insertion loss are reduced by 28% and 3.1 dB, respectively. Measurements show that the proposed filter has a fraction bandwidth of 23% at the central frequency of 1.84 GHz, and its insertion loss in the passband is less than -1.5 dB. The bandpass filter occupies only 12 mm${\times}$21.2 mm (approximately $0.24{\lambda}_g{\times}0.14{\lambda}_g$).

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.23 no.5
• /
• pp.365-374
• /
• 2011

For the first time, the present study has measured the velocity distribution function in circular open channel flow in a three-dimensional shape using a stereoscopic PIV system. For a given channel slope, water depth was varied from 30% to 80% of the channel diameter. Then, the characteristics of the velocity distribution function was compared according to the change of the water depth. Unlike a rectangular channel, the present experiment exhibited quite different shapes in the velocity distribution function whether the water depth is higher than 50% or not. Especially, the position of maximum velocity in the central and side wall changes in a different manner for the water depth above 50%. By differentiating the velocity distribution function, local wall friction coefficient was evaluated as a function of wall position. If the water depth goes down, the difference between the maximum and minimum values in the local wall friction coefficient increases, and the averaged value a1so increases.

• Journal of The Korean Astronomical Society
• /
• v.35 no.1
• /
• pp.29-34
• /
• 2002

We have conducted UBVI CCD photometry of an intermediate-age open cluster NGC 559 to investigate the effect of dynamical evolution on the stellar distributions in NGC 559. Our photometry allows better estimates of distance and age of the cluster owing to much deeper photometry (V $\le$ 21) than previous ones. It is found that the luminosity function and mass function as well as the spatial stellar distributions are affected by the dynamical evolution. Mass segregation leads to the central concentration of the high mass stars, which results in the flattened mass function inside the half mass radius.

• IEIE Transactions on Smart Processing and Computing
• /
• v.6 no.1
• /
• pp.60-65
• /
• 2017

Network virtualization enables us to make efficient use of resources in a physical network by embedding multiple virtual networks in the physical network. In this paper, we develop a prototype of a virtual network embedding system. Our system consists of OpenStack, which is an open source cloud service platform, and shell scripts. Because OpenStack does not provide a quality of service control function, we realize bandwidth reservation for virtual links by making use of the ingress policing function of Open vSwitch, which is a virtual switch used in OpenStack. The shell scripts in our system automatically construct the required virtual network on the physical network using the OpenStack command-line interface, and they reserve bandwidth for virtual links using the Open vSwitch command. Experimental evaluation confirms that our system constructs the requested virtual network and appropriately allocates node and link resources to it.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2010.10a
• /
• pp.101-109
• /
• 2010

This paper reports active control of clamped beams using acceleration feedback controllers (AF). The equations of motion of clamped beam under force and moment pairs were derived and the equations of AF controllers were formulated. The effect of the parameters - gain and damping ratio - of the AF controllers on the open loop transfer function was investigated mainly in terms of the system stability. Increasing the gain of the AF controller tuned at a mode, the magnitude of the open loop transfer function is increased at all frequencies. The increase of the damping ratio of the AF controller leads to decrease the magnitude of the open loop transfer function and modifies its phase characteristics to be more stable. Three AF controllers connected in parallel were then proposed. Each AF controller is tuned at the $2^{nd}$, $3^{rd}$ and $4^{th}$ modes, respectively. Their parameters were determined to remain the system to be stable based on the results of the parametric study. A significant reduction in vibration at the 3 modes can be obtained.

• Journal of KIISE
• /
• v.44 no.10
• /
• pp.1019-1025
• /
• 2017

Binary similarity analysis is used in vulnerability analysis, malicious code analysis, and plagiarism detection. Proving that a function is equal to a well-known safe functions of different versions through similarity analysis can help to improve the efficiency of the binary code analysis of malicious behavior as well as the efficiency of vulnerability analysis. However, few studies have been carried out on similarity analysis of the same function of different versions. In this paper, we analyze the similarity of function units through various methods based on extractable function information from binary code, and find a way to analyze efficiently with less time. In particular, we perform a comparative analysis of the different versions of the OpenSSL library to determine the way in which similar functions are detected even when the versions differ.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2012.04a
• /
• pp.527-535
• /
• 2012

This paper reports the active vibration control of plates using positive position feedback controller (PPF). The equations of motion of the plate under force and moment pairs were derived and the equations of PPF controllers were formulated. The effect of the parameters - gain and damping ratio - of the PPF controllers on the open loop transfer function was investigated mainly in terms of the system stability. Increasing the gain of the PPF controller tuned at a mode, the magnitude of the open loop transfer function is increased at all frequencies without changing the phase behavior. The increase of the damping ratio of the PPF controller leads to decrease the magnitude of the open loop transfer function and to modify its phase characteristics to be more stable. Two PPF controllers connected in parallel, Each PPF controller is tuned at the $1^{st}$ and $2^{nd}$ modes, respectively. Their parameters were determined to remain the system to be stable based on the results of the parametric study. A significant reduction in vibration at the 2 modes can be obtained.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.20 no.12
• /
• pp.1190-1199
• /
• 2010

This paper reports active control of clamped beams using acceleration feedback controllers (AF). The equations of motion of clamped beam under force and moment pairs were derived and the equations of AF controllers were formulated. The effect of the parameters - gain and damping ratio - of the AF controllers on the open loop transfer function was investigated mainly in terms of the system stability. Increasing the gain of the AF controller tuned at a mode, the magnitude of the open loop transfer function is increased at all frequencies. The increase of the damping ratio of the AF controller leads to decrease the magnitude of the open loop transfer function and modifies its phase characteristics to be more stable. Three AF controllers connected in parallel were then proposed. Each AF controller is tuned at the 2nd, 3rd and 4th modes, respectively. Their parameters were determined to remain the system to be stable based on the results of the parametric study. A significant reduction in vibration at the 3 modes can be obtained.

• Journal of the Korea Institute of Information Security & Cryptology
• /
• v.27 no.4
• /
• pp.721-729
• /
• 2017

In order to take rapid action against malware, efficiency in malware analysis is essential. For instance, it would be helpful to identify and eliminate open-source function bodies or other safe portions out of the target binary codes. In this paper, we propose an tool to create open source dynamic link library files in Windows environment, extract signature information by opensource and compiler version, and compare open source function information to find suspicious function. In addition, the tool can save the information used in the comparison to the DB and use it later, reducing the analysis time overhead.

• Journal of the Korean Society for Geothermal and Hydrothermal Energy
• /
• v.13 no.2
• /
• pp.9-15
• /
• 2017

When applying geothermal systems in cities such as seoul where high density development prevails, the selection of geothermal system capable of obtaining a large capacity in the limited grounds is necessary. In this study, an easy-to-use design tool is developed in the form of spreadsheet by applying the calculation theory of existing closed-loop vertical ground heat exchanger that can be used in the early design stage of the open-loop ground heat exchanger. By only using the maximum cooling and heating load, it is possible to calculate optimal design open-loop ground heat exchanger. Further research is needed, we are plan to improve the program considering the heat loss of groundwater flowing in the inner casing, G-Function for Open-Loop, and verification by applying actual projects.