• Tribology and Lubricants
• /
• 제22권2호
• /
• pp.99-104
• /
• 2006

The dielectric constants of fresh engine oils were obtained according to various types of oil, temperatures and frequencies. Through analyzing the characteristics of dielectric constant, the related correlation between the changes in dielectric constant of oil and the degree of oil deterioration is going to be found. The dielectric constant was calculated by cross capacitances measured by a sensor tube. Before finding the correlation, as a prerequisites study, the best condition measuring the dielectric constant was found. In general, it was found that the value of dielectric constant became stable below $60^{\circ}C$ regardless frequency variation. Further, above 6kHz, the dielectric constant became stable even if temperature had been above $100^{\circ}C$.

• 대한조선학회 특별논문집
• /
• 대한조선학회 2005년도 특별논문집
• /
• pp.134-137
• /
• 2005

Recently, in VLCC, shafting system is stiffer due to large engine power whereas hull structure is more flexible due to scantling optimization, which can be suffered from alignment damage by incompatibility between shafting and hull, In this study, shafting system without stern tube forward bush was adapted for less sensitive system against external factors. Also, shaft alignment analysis was considered with hull deflection at various ship loading conditions and stern tube after bush of long journal bearing was evaluated by static squeezing pressure and dynamic oil film pressure with sloping control. Whirling vibration was also reviewed to avoid resonance with propeller blade order. So, reliable shafting design for VLCC could be achieved through optimized alignment analysis for the system without stern tube forward bush.

• 한국대기환경학회지
• /
• 제22권3호
• /
• pp.353-360
• /
• 2006

This study identified a particle size distribution (PSD) of fine particulate matter and emission characteristics of V and Ni by the comparison between anthropogenic sources of oil combustion (industrial boiler, oil power plant, etc.) and lab-scale combustion using a drop-tube furnace. In oil combustion source, the mass fraction of fine particles (less than 2.5 micrometers in diameter) was higher than that of coarse particles (larger than 2.5 micrometers in diameter) in $PM_{10}$ (less than 10 micrometers in diameter) as like in lab-scale oil combustion. In addition to this, it was identified that ultra-fine particles (less than 0.1 micrometers in diameter) had a large distribution in fine particles. Toxic metals like V and Ni had large mass fractions in fine particles, and most of all was distributed in ultra-fine particles. Most of ultra-fine particles containing toxic metals have been emitted into ambient by combustion source because it is hard to control by the existing air pollution control device. Hence, we must be careful on these pollutants because it is obvious that these are associated with adverse health and environmental effect.

• 대한조선학회지
• /
• 제26권3호
• /
• pp.51-61
• /
• 1989

최근(最近)의 배는 에너지 절약(節約)을 도모하기 위하여 프로펠러 회전수(回轉數)의 저속화(低速化)와 더불어 대형화(大型化)되고 있다. 이와 같은 결과(結果)로 선미관(船尾管)의 후부(後部) 베어링에는 집중하중(集中荷重)이 작용(作用)하게 되어 선박(船舶)의 운항능력(運航能力)을 상실할 정도의 대형사고(大型事故)가 일어나고 있는 예(例)가 많다. 이와 관련하여 최근(最近) 유막(油膜)을 고려한 선미관(船尾管) 베어링 해석(解析)에 관(關)한 연구(硏究)가 활발하게 이루워지고 있다. 본(本) 연구(硏究)에서는 지금까지 연구발표(硏究發表)된 유막(油膜)을 고려한 선미관(船尾管) 베어링에 대한 축(軸)의 위치(位置)를 추정(推定)하는 방법(方法)을 수정보완(修正補完)한 새로운 방법(方法)을 제시(提示)하였다. 즉 축계(軸系)에 대해서는 유한요소법(有限要素法)에 의한 삼차원(三次元) 구조해석방법(構造解析方法), 베어링 유막(油膜)은 유한요소법(有限要素法)에 의한 이차원(二次元) 유체역학해석방법(流體力學解析方法), 그리고 축계(軸系)와 베어링 유막간(油膜間)의 준정적(準靜的) 평형점(平衡點)을 구하기 위해서는 최적화(最適化) 기법(技法)이 사용된다. 본(本) 해석방법(解析方法)의 타당성(妥當性) 여부(與否)를 확인(確認)하기 위하여 Vorus 등이 사용(使用)한 시산대상선(試算對象船)에 대한 일련의 수치계산(數値計算)을 수행하고 동(同) 결과(結果)를 Vorus등의 연구 결과와 비교검토(比較檢討)하여 본 결과(結果), 비교적(比較的) 잘 일치(一致)하고 있음을 미루어 보아 본(本) 해석방법(解析方法)의 타당성(妥當性)이 확인(確認)되었다.

• 한국응용곤충학회지
• /
• 제51권4호
• /
• pp.389-395
• /
• 2012

본 연구는 쌀을 비롯한 저장곡물을 가해하는 어리쌀바구미(Sitophilus zeamais) 성충에 대해서 8종의 식물정유의 훈증독성과 Y-tube를 이용한 후각반응으로 기피효과를 조사하였다. $10{\mu}{\ell}/L$ air의 농도에서 훈증독성시험 결과 pennyroyal과 tea tree 오일에서 각각 97%, 63%의 높은 살충효과를 보였다. 특히, pennyroyal oil($LT_{50}$, hour=3.87)은 tea tree oil($LT_{50}$, hour=4.09)보다 높고 빠른 살충력을 보였다. $10{\mu}{\ell}$/filter paper의 농도에서 후각계를 이용한 기피효과는 Cedarwood(80%), Cinnamon(83.3%), Cypress(81.1%), pennyroyal(97.1%) oil이 높은 기피활성을 보였으며, 이보다 낮은 $1{\mu}{\ell}$/filter paper의 농도에서도 Cinnamon(82.4%), Cypress(80.0%), pennyroyal(86.7%) 오일은 높은 기피활성을 나타냈다.

• 설비공학논문집
• /
• 제23권1호
• /
• pp.73-79
• /
• 2011

A portion of oil for lubrication of compressor flows together with refrigerant in the refrigeration system. If the oil discharge from a compressor is increased in the refrigeration system, not only pressure drop is increased in other components, such as evaporator and gas cooler, but also heat transfer coefficient in the heat exchangers is decreased. Oil discharge rate from a compressor may strongly depend on operating conditions of a compressor. In this study, one stage single rotary compressor is employed for measuring oil circulation ratio(OCR). Carbon dioxide and PAG oil are used as refrigerant and lubricant. Using a U-tube densimeter, mixture density is measured. Oil circulation ratio(OCR) can be estimated by measured mixture density. The results obtained indicate that the oil circulation ratio(OCR) is increased as the suction temperature or compressor operating frequency is increased. Oil circulation ratio(OCR) correlation of the compressor is also suggested.

• 대한설비공학회:학술대회논문집
• /
• 대한설비공학회 2008년도 하계학술발표대회 논문집
• /
• pp.136-141
• /
• 2008

Due to environmental concerns $CO_2$ has been reintroduced as a potential candidate to replace HFCs in refrigeration systems since 1990s. In a refrigeration cycle, oil is utilized in lubricating a compressor. However, although oil separators are installed after a compressor oil is prone to leak to the whole system. The mixing of $CO_2$ and oil, even a small amount of oil, the heat transfer performance in heat exchanger deteriorated and the pressure drop inside tube increases. Therefore, it is needed to precisely estimate the mixture thermodynamic properties of $CO_2$-lubricant oil to correctly design a $CO_2$ refrigeration system. The commonly used method in estimating the mixture properties is the mole based weighting model. However, the accuracy of the method can not be assured. In the present study, $CO_2$-lubricant oil mixture properties including viscosity and density were estimated by using the mixture models, based on the equation of state (EOS).

• 대한설비공학회:학술대회논문집
• /
• 대한설비공학회 2009년도 하계학술발표대회 논문집
• /
• pp.893-898
• /
• 2009

The quantity of discharged oil from a compressor is one of the most important issues for proper operation of refrigeration system. If the oil is increased in the system not only pressure drop is increased in other components, such as evaporator and gas cooler but also heat transfer coefficient in the heat exchangers is decreased. In addition, the lack of oil in the compressor may cause a critical of the system failure. In this study, one stage single rotary compressor is used for measuring oil circulation ratio(OCR). Carbon dioxide and PAG oil are used as refrigerant and lubricant. Using a U-tube densimeter, mixture density is measured. Characteristics of oil circulation ratio have been investigated for $CO_2$ rotary compressor in the range of operation frequency 45 Hz to 63 Hz and the suction temperature range of $0^{\circ}C$ to $15^{\circ}C$. The results obtained indicate that the oil circulation ratio is increased as the suction temperature or compressor operating frequency is increased.

• 수산해양기술연구
• /
• 제52권3호
• /
• pp.257-262
• /
• 2016

Flexible two-phase thermosyphons are devices that can transfer large amounts of heat flux with boiling and condensation of working fluid resulting from small temperature differences. A flexible two-phase thermosyphon consists of a evaporator, an insulation unit, and a condenser. The working fluid inside the evaporator is evaporated by heating the evaporator in the lower part of the flexible two-phase thermosyphon and the evaporated steam rises to the condenser in the upper part to transfer heat in response to the cooling fluid outside the tube. The resultant condensed working fluid flows downward along the inside surface of the tube due to gravity. These processes form a cycle. Using R134a refrigerant as the working fluid of a loop type flexible two-phase thermosyphon heat exchanger, an experiment was conducted to analyse changes in boiling heat transfer performances according to differences in the temperature of the oil for heating of the evaporator, the temperature variations of the refrigerant, and the mass flows. According to the results of the present study, the circulation rate of the refrigerant increased and the pressure in the evaporator also increased proportionally as the temperature of the oil in the evaporator increased. In addition, the heat transfer rate of the boiler increased as the temperature of the oil in the evaporator increased.

• E2M - 전기 전자와 첨단 소재
• /
• 제10권4호
• /
• pp.334-341
• /
• 1997

Streaming electrification on insulating paper and pressboard under D.C. and A.C. electric field was investigated by using paper tubes and oil circulation apparatus. At first, flowing of static charges as measured with no electric field. As the temperature of oil increased, the measured current curve hows peak. As the velocity increased, it shows increasing exponential curve. Then, we applied A.C. and D.C. electric field on paper tube and the current from relaxation tank to earth was measured, which other factors such as temperature and velocity were varied like case of no electric field. The ions in oil carry the charges. So electric field makes asymmetry effect, and electrophoretic effect on ions in oil. We find that as the electric field intensity increased, the charges which were made by electric double layer were increased. The charge vs. velocity curve made peak point at a velocity.