• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.5A
• /
• pp.441-449
• /
• 2011

Sample timing offset (STO) and carrier frequency offset (CFO) are caused by inter-symbol interference (ISI), inter-carrier interference (ICI) and phase error in orthogonal frequency division multiplexing (OFDM) system. OFDM characteristic is sensitive about STO and CFO. So when ICI occurs, compensation is hard and complex equalizer is needed. In this paper, we propose an effective correction method using feedback process with pilot and synchronization symbol. After feedback with estimated value in frequency domain, STO and CFO are corrected by control sample & and holder and oscillator. As a result of simulation, we confirm that STO and CFO can be corrected without equalizer through feedback.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.7 no.2
• /
• pp.327-332
• /
• 2012

In this paper, we analyzed the influence of different observation stations distributions on satellite clock offset estimation based on the PANDA software. The result shows that, when the distance between stations is shorter than 200km, the correlation of troposphere parameter and satellite clock offset parameter is strong, the accuracy of satellite clock offset estimation will be up to 0.8ns; when the distance between stations is up to 500km, as the correction of troposphere parameter and satellite clock offset parameter is significantly reduced, and the two kinds of parameters can be distinguished.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.66 no.6
• /
• pp.949-954
• /
• 2017

Multiple input, multiple output orthogonal frequency division multiplexing (MIMO OFDM) systems are the candidate for the future wireless communications. However, the main drawback of MIMO OFDM systems is their sensitivity to carrier frequency offset (CFO) similar to the single input, single output OFDM (SISO OFDM) systems. The demodulation of a signal with CFO causes large bit error rate and degrade the performance of a symbol synchronizer. It is important to estimate the frequency offset and minimize or eliminate its impact. In this paper, we propose a technique based on observation training symbols for estimating CFO by employing block-by-block estimation for SISO OFDM systems. The technique of SISO OFDM is extended to the MIMO OFDM systems. Simulation results show that the proposed techniques have a superior performance and better accuracy compared to the conventional techniques in the sense of mean square error.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.7 no.12
• /
• pp.3055-3070
• /
• 2013

This paper proposes an improved carrier frequency offset (CFO) and sampling frequency offset (SFO) estimation scheme for orthogonal frequency division multiplexing (OFDM) based broadcasting system with cyclic delay diversity (CDD) antenna. By exploiting a periodic nature of channel transfer function, cyclic delay and pilot pattern with a maximum channel power are carefully chosen, which helps to enable a robust estimation of CFO and SFO against the frequency selectivity of the channel. As a performance measure, a closed-form expression for the achievable mean square error of the proposed scheme is derived and is verified through simulations using the parameters of the digital radio mondiale standard. The comparison results show that the proposed frequency estimator is shown to benefit from properly selected delay parameter and pilot pattern, with a performance better than the existing estimator.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.41 no.9
• /
• pp.47-54
• /
• 2004

The previous works for WLAN system based on OFDM is mainly individual study for independent frequency offset or symbol synchronization. In this paper, the performance of IEEE 802.11a WLAN(Wireless Local Area Network) system in the realistic indoor multipath channel models is analyzed with frequency offset compensation and channel estimation methods. For the performance analysis of the WLAN system indoor Rayleigh multipath channels are adopted, and the BER(Bit Error Rate) of WLAN system is calculated with y2 code-rate 16-QAM based on standard specification. From the simulation results, the difference of required Eb/No for BER of 10-3 is 1-2dB between the channel estimation and frequency offset compensation, and perfect channel estimation and no frequency offset.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.7A
• /
• pp.627-634
• /
• 2011

In this paper, a new frequency offset estimation method in OFDM system is suggested. To measure fractional part of frequency offset, the repetition feature of cyclic prefix and that of training sequence is adopted. Both method shows relatively large frequency offset estimation error under low SNR circumstances, but this error can be greatly reduced by joint measurement of cyclic prefix and inversely repeated training symbol such as primary advanced preamble (PA-preamble) of IEEE 802.16m IMT-Advanced WiMax system. In this paper, the performance of suggested frequency offset estimation method is verified in IEEE 802.16m IMT Advanced WiMax system, using its PA-preamble and cyclic prefixes of A-preambles.

• Proceedings of the KSRS Conference
• /
• 2008.10a
• /
• pp.92-95
• /
• 2008

The Geostationary Ocean Color Imager (GOCI) is under development to provide a monitoring of ocean-color around the Korean Peninsula from geostationary platforms. It is planned to be loaded on Communication, Ocean, and Meteorological Satellite (COMS) of Korea. The GOCI has been designed to provide multi-spectral data to detect, monitor, quantify, and predict short term changes of coastal ocean environment for marine science research and application purpose. The target area of GOCI observation covers sea area around the Korean Peninsula. Based on the nonlinear radiometric model, the GOCI calibration method has been derived. The radiometric model of GOCI has been validated through radiometric ground test. From this ground test result, GOCI radiometric model has been changed from second order to third order. In this paper, the radiometric test performed to evaluate the radiometric nonlinearity is described and the GOCI radiometric error propagation is analyzed. The GOCI radiometric calibration is based on onboard calibration devices; solar diffuser, DAMD (Diffuser Aging Monitoring Device). The radiometric model error due to the dark current nonlinearity is considered as a systematic error. Also the offset correction error due to gain/offset instability is considered. The radiometric accuracy depends mainly on the ground characterization accuracies of solar diffuser and DAMD.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.8C
• /
• pp.627-632
• /
• 2008

The timing offset is one of the main error sources in estimating the frequency offset in orthogonal frequency division multiplexing (OFDM) systems. Although some works have been done to mitigate the influence of the timing offset on the frequency offset estimation, most of the investigations require the knowledge of the timing offset range, which is not generally available in practical systems. In this paper, we propose a new frequency offset estimation scheme using differential combining between two successive correlation samples, which does not require the knowledge of the timing offset range, and thus, is robust to the timing offset variation. The simulation results show that the proposed scheme is not only robust to the timing offset variation, but also generally performs better than the conventional scheme on the average, in the case of the timing offset range being not known exactly.

• Proceedings of the KIEE Conference
• /
• 1987.07b
• /
• pp.869-873
• /
• 1987

In this study, we have examined the multi-level QPRS system in point of error rate, which requires narrow bandwidth and has Little ISI. The generalized error rate equations of multi-level QPRS signal have been derived in the presence of Gaussian noise and co-channel CW interference. And the error rate performance of 9, 49, 225 QPRS system is investigated as parameters of carrier power-to-noise power, carrier power-to -interference power. Also, we have investigated the effect of carrier offset.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.65 no.7
• /
• pp.1204-1210
• /
• 2016

The phase currents must be accurately measured to achieve the instantaneous torque control of AC motors. In general, those are measured using the current sensors. However, the measured current signals can include the offset errors and scaling errors by several components such as current sensors, analog amplifiers, noise filter circuits, and analog-to-digital converters. Therefore, the torque-controlled performance can be deteriorated by the current measurement errors. In this paper we have analyzed the influence caused by vector control of 2-phase induction motor when two errors are included in measured phase currents. Based on analyzed results, the compensation method is proposed without additional hardware. The proposed compensation method was applied vector-controlled inverter for 2-phase induction motor of 360[W] class and verified through computer simulations and experiments.