• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.31 no.5
• /
• pp.421-427
• /
• 2013

In general, it can be assumed that the tropospheric effect are removed through double-differencing technique in short-baseline GPS data processing. This means that the high-accuracy positioning can be obtained because various error sources can be eliminated and the number of unknown can be decreased in the adjustment computation procedure. As a consequence, short-baseline data processing is widely used in the fields such as deformation monitoring which require precise positioning. However, short-baseline data processing is limited to achieve high positioning accuracy when the height difference between the reference and the rover station is significant. In this study, the effects of tropospheric delays on the determination of short-baseline is analyzed, which depends on the orientation of baseline. The GPS measurements which include tropospheric effect and measurement noises are generated by simulation, and then rover coordinates are computed by short-baseline data processing technique. The residuals of rover coordinates are analyzed to interpret the tropospheric effect on the positioning. The results show that the magnitudes of the biases in the coordinate residuals increase as the baseline length gets longer. The increasing rate is computed as 0.07cm per meter in baseline length. Therefore, the tropospheric effects should be carefully considered in short-baseline data processing when the significant height difference between the reference and rover is observed.

• Journal of the Korean Vacuum Society
• /
• v.20 no.6
• /
• pp.442-448
• /
• 2011

Self-assembled InAs/InAlGaAs quantum dots (QDs) grown on an InP (001) substrate have been investigated by using photoluminescence (PL) and time-resolved PL measurements. The single layer (QD1) and seven stacks (QD2) of InAs/InAlGaAs QDs grown by the conventional S-K growth mode were used. The PL peak at 10 K was 1,320 nm for both QD1 and QD2. As the temperature increases from 10 to 300 K, the PL peaks for QD1 and QD2 were red-shifted in the amount of 178 and 264 nm, respectively. For QD1, the PL decay increased with increasing emission wavelength from 1,216 to 1,320 nm, reaching a maximum decay time of 1.49 ns at 1,320 nm, and then decreased as the emission wavelength was increased further. However, the PL decay time for QD2 decreased continuously from 1.83 to 1.22 ns as the emission wavelength was increased from 1,130 to 1,600 nm, respectively. These PL and TRPL results for QD2 can be explained by the large variation in the QD size with stacking number caused by the phase separation of InAlGaAs.

• Food Science and Preservation
• /
• v.30 no.4
• /
• pp.630-641
• /
• 2023

The quality characteristics of muffins with different types of rice flour, such as soft flour (CON), soft rice flour (SRF), floury rice flour (FRF), and rice flour (RF) were assessed by using Image J program, which includes their particle size analysis, moisture content, pH, color, specific volume, baking loss rate, texture. (D[4, 3]) is weighted mean diameter, which is directly obtained in particle size measurements showed large values in the order of rice flour, floury rice flour, soft rice flour, and soft flour. The moisture content was high in the CON and SRF groups with small particle sizes. There was no significant difference in pH, L and b value. The a value was significantly low only in the RF group with large particle size. The smaller the particle size, the higher the specific volume and baking loss rate. Image J showed that the number of pores decreased when fewer smaller particles were the powder, but the pores were larger. Among the rice flours, the SRF group, excluding the CON group, scored high in all the acceptability elements. The results from this study can be used as basic data that can contribute to research on various rice-processed foods.

• The Proceeding of the Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.5
• /
• pp.87-103
• /
• 2008

In recent years, the field of THz photonics based on THz pulse technology has gained tremendous, world-wide interest as a new exciting research subject. With a possibility of many commercial applications as well as fundamental scientific achievements in the field, many advanced nations are stepping up their effort in advancing the field of THz photonics. This fact is supported by the observation of the significant increase in the number of papers on THz pulse technology presented in renowned international journals and conferences. The subject that is interesting for the THz application is the development of THz pulse sources and detectors, and other passive devices. In this paper, we present a brief review on some of the key devices and their relavant measurement techniques such as THz photoconductive antennas, optical rectification, difference frequency geneneration with quasi-phase matching structures, electro-optic sampling, high speed real time measurements, THz transmission lines, and other various waveguide structures.

• Korean Journal of Agricultural and Forest Meteorology
• /
• v.14 no.4
• /
• pp.246-253
• /
• 2012

Despite frequent freezing injury to tea trees due low temperature, drought, and strong wind during wintertime, no comprehensive measurements have been taken. We selected and examined 9 locations in Hwagae-myeon and 4 places in Agyang-myeon, Hadong-gun, Gyeonsanggnam-do where low temperature damage had occurred between December 2010 and February 2011. Our objective is to examine the effect of frost damage on the morphological symptom and harvest of a tea tree exposed to a constant low temperature environment during wintertime. The results of our analyses on meteorological environment, tea leaf chromaticity, water content and trypan blue are as follows: (1) the number of days with temperature of $-10^{\circ}C$ or less, which were subject to frost damage to a tea tree were 8 and 13.6% during the winterization period in 2011; (2) the accumulated time was 1,308 minutes, and the longest duration at $-10^{\circ}C$ was 588 minutes from 21:08 p.m. 15 January to 7:30 a.m. $16^{th}$ January. The rainfall was only 104 mm which was 306 mm less than the previous year; (3) the lightness L values in 2011 were higher than in 2012 due to dehydration and necrosis by blue discoloration and red discoloration at all areas in chromaticity measurement; (4) the water content in a tea leaf in 2011 was higher than in 2012 due to low rainfall and strong wind, and almost no cell death phenomenon was observed from normal tea leaves subject to no low temperature stress in a trypan blue analysis; and (5) partial coloration due to cell death, however, took place in the leaves damaged by blue discoloration subject to low temperature stress, and most coloration due to cell death took place in the leaves damaged by red discoloration.

• Journal of the Society of Naval Architects of Korea
• /
• v.39 no.3
• /
• pp.48-56
• /
• 2002

The flow characteristics around KRISO 3600TEU container ship model have been experimentally investigated in a circulating water channel. The instantaneous velocity vectors were measured using 2-frame PIV measurement system. The mean velocity fields and turbulent statistics including turbulent kinetic energy and vorticity were obtained by ensemble-averaging 400 instantaneous velocity fields. The free stream velocity was fixed at 0.6m/s and the corresponding Reynolds number was $9{\times}10^5$. The test sections were divided into two regions, three transverse sections of the wake region(Station -0.5767, -1, -3) and five longitudinal sections of the wake((Z/(B/2)=0, 0.1, 0.2, 0.4, 0.6). In the wake region, large-scale longitudinal vortices of nearly same strength are symmetric with respect to the wake centerline and a relatively weak secondary vortex is formed near the waterline. With going downstream, the strength of longitudinal vortex is decreased and the wake region expands.

• Spatial Information Research
• /
• v.20 no.3
• /
• pp.27-38
• /
• 2012

As the necessity of forest conservation and management has been increased, various forest studies using LIDAR data have been actively performed. These studies often utilize the tree height as an important parameter to measure the forest quantitatively. This study thus attempt to apply two representative methods to estimate tree height from airborne LIDAR data and compare the results. The first method based on the detection of the individual trees using a local maximum filter estimates the number of trees, the position and heights of the individual trees, and the mean tree height. The other method estimates the maximum and mean tree height, and the crown mean height for each grid cell or the entire area from the canopy height model (CHM) and height histogram. In comparison with the field measurements, 76.6% of the individual trees are detected correctly; and the estimated heights of all trees and only conifer trees show the RMSE of 1.91m and 0.75m, respectively. The tree mean heights estimated from CHM retain about 1~2m RMSE, and the histogram method underestimates the tree mean height with about 0.6m. For more accurate derivation of diverse forest information, we should select and integrate the complimentary methods appropriate to the tree types and estimation parameters.

• Journal of Navigation and Port Research
• /
• v.43 no.1
• /
• pp.23-32
• /
• 2019

In this paper, we proposed a multi-chain Time of Arrival (ToA) positioning method to estimate positions using all received Loran-C signals from multiple chains without constraining to a single chain. Conventionally, we have to choose only one chain among several available chains for position estimation using Loran-C. Therefore, the number of signals to be used for positioning is limited to three to five. In general, if more signals are used for positioning estimation, its performance tends to be improved in terms of accuracy and availability. To validate the proposed method for multi-chain Loran-C, we firstly carried out a static positioning test in land. By analyzing the test results, we confirmed that the proposed method works well under a multi-chain Loran-C scenario. Subsequently, another mobile positioning test was conducted on board a vessel under a practical application scenario. From this second test, we successfully demonstrated that the multi-chain ToA positioning method even in situations where the conventional single-chain Loran-C approach fails for positioning.

• The Journal of the Convergence on Culture Technology
• /
• v.7 no.1
• /
• pp.570-575
• /
• 2021

Since humans live while feeling rich in their five senses, care must be taken not to damage their hearing in order to lead a happy life. Hearing damage suffered in a living environment is common in a partial band where a specific frequency band is first damaged. However, since the initial pain of hearing damage does not appear much, it is difficult to determine the symptoms in the early stages. In this paper, we proposed a high-speed measurement method that can easily and quickly self-measure hearing damage through a simple app. In this method, 9 pure tones compensated for gain for each voice soub-band are alternately heard in both ears, so that one's own hearing damage can be detected at high speed. When 18 tone pulses were heard for 30 seconds per person, 1 out of 12 subjects was identified as suspected of partial hearing damage. And when the test subjects were informed of the hearing determination method for the number of hearings, the participants themselves immediately determined whether their hearing was damaged. This measurement method simply judges the hearing of both ears within 30 seconds with a smart phone, so that hearing measurements that took more than 10 minutes in hospitals are relatively accurate, and it was found that hearing health can be maintained while reducing time and costs.

• Korean Journal of Ichthyology
• /
• v.35 no.2
• /
• pp.141-147
• /
• 2023

The genus Cottiusculus Jordan and Starks 1904 (Cottoidei: Cottidae) comprises four species worldwide, three species in Japan, and two species in Korea. Cottiusculus species are characterized by a compressed head and body without scales, except for lateral-line scales, a preopercle with four spines, a curved uppermost preopercular spine with small dorsal spines, and teeth on the upper jaws, vomer, and palatines. Two Cottiusculus species have been recorded in Korea: Cottiusculus gonez and Cottiusculus nihonkaiensis. Among these, "jeom-jul-hoet-dae" specimens were initially identified as Cottiusculus schmidti by many Korean Ichthyologists. However, since C. nihonkaiensis was reported by Kai and Nakabo (2009), most such specimens have been identified as C. nihonkaiensis. To clarify the taxonomic status of "jeom-jul-hoet-dae", we conducted morphological and molecular analyses collected from the coasts of South Korea, and compared our findings with previous reports. Japanese and Korean C. nihonkaiensis specimens mostly consistent in some proportional measurements, our molecular results indicate that they are the same species. C. nihonkaiensis, "jeom-jul-hoet-dae" distinguished from other congers by combination of following characters: simple nasal spines, two branched cirri at the upper jaw, cirri at the opercular, preopercular, and lateral lines, and a number of blotches below the lateral line.