• Journal of Applied Reliability
• /
• v.5 no.3
• /
• pp.357-371
• /
• 2005

Nitrogen oxide gases which were produced by spontaneous reaction of nitrocellulose (NC) in the single base propellant accelerate the decomposition of propellant, and result in the reduction of shelf life, The amount of nitrogen oxide was reduced by the addition of $0.3wt\%$ CaCO3 to conventional stabilizer(DPA) which extended the shelf life of the single base propellant as much as twice compared with commercial propellant.

• Journal of Microbiology and Biotechnology
• /
• v.21 no.10
• /
• pp.1073-1080
• /
• 2011

In order to investigate and generalize the effects of carbon and nitrogen sources on the growth of and lipid production in Chlorella sp. 227, several nutritional combinations consisting of different carbon and nitrogen sources and concentrations were given to the media for cultivation of Chlorella sp. 227, respectively. The growth rate and lipid content were affected largely by concentration rather than by sources. The maximum specific growth was negatively affected by low concentrations of carbon and nitrogen. There is a maximum allowable inorganic carbon concentration (less than 500~1,000 mM bicarbonate) in autotrophic culture, but the maximum lipid content per gram dry cell weight (g DCW) was little affected by the concentration of inorganic carbon within the concentration. The lipid content per g DCW was increased when the microalga was cultured with the addition of glucose and bicarbonate (mixotrophic) at a fixed nitrogen concentration and with the lowest nitrogen concentration (0.2 mM), relatively. Considering that lipid contents per g DCW increased in those conditions, it suggests that a high ratio of carbon to nitrogen in culture media promotes lipid accumulation in the cells. Interestingly, a significant increase of the oleic acid amount to total fatty acids was observed in those conditions. These results showed the possibility to induce lipid production of high quality and content per g DCW by modifying the cultivation conditions.

• Journal of the Korean Society for Heat Treatment
• /
• v.13 no.3
• /
• pp.151-157
• /
• 2000

This study aims to investigate the effect of carbon content on the surface nitrogen permeation of 13%Cr-1.8%Al alloyed stainless steels. The surface nitrogen permeation was performed at $1050^{\circ}C{\sim}1200^{\circ}C$ in the $1kg/cm^2$ nitrogen gas atmosphere. The nitrogen permeated surface layer of the specimen containing 0.03%C consists of AlN, martensite and retained austenite phases. while the surface layer of the specimen containing 0.14%C appears the $AlFe_3C_x$ phase including former three phases. The specimen containing 0.14%C shows lower total case depth than that containing 0.03%C at the nitrogen permeation temperatures of $1050^{\circ}C$ and $1100^{\circ}C$, while the total case depth of the specimen containing 0.14%C is remarkably increased at the temperature of $1150^{\circ}C$ and $1200^{\circ}C$ due to the increase in the retained austenite content. Martensitic phase, AlN and $AlFe_3C_x$ precipitate of the nitrogen permeated surface layer cause to increase the surface hardness of 550~600Hv.

• Journal of agriculture & life science
• /
• v.52 no.6
• /
• pp.61-72
• /
• 2018

The aim of this present study was to investigate the impact of different seeding rate and nitrogen fertilizing levels on the seed yield and feed value of oats(Avena sativa L.) grown in Gyeongbuk area for two years. The experiment was arranged in split plot design with 3 main plots(100, 130 and 160 kg of seed/ha) and 4 subplots(0, 50, 70 and 90 kg N/ha), with 3 replicates. Heading, flowering, and maturing dates of oats sown in spring 2017, delayed by two days compared to that of spring 2016, and the plant height of spring 2017 were significantly shorter than that of spring 2016(18.1 ~ 23.4 cm). In addition, the highest number of stems and number of panicles according to different seeding rate and nitrogen fertilizing levels were achieved with the seeding rate of 160 kg/ha and 90 kg of N/ha in 2016 and 2017, respectively. In case of seed yield as affected by different seeding rate, the highest seed yield was achieved with a seeding rate of 130 kg/ha(p<0.05), and based on nitrogen fertilizing levels, the highest yield was obtained in 50 kg of N/ha compared to others. The crude fiber(CF), neutral detergent fiber(NDF) and total digestible nutrients(TDN) of oats cultivated and harvested in spring 2016 and 2017 according to different sowing rate were the highest in the seeding rate of 130 kg/ha. The crude protein(CP) content and total digestible nutrients(TDN) of 2016-2017 as influenced by nitrogen fertilizer levels were the highest in the nitrogen fertilizer level of 90 and 50 kg N/ha, respectively. In conclusion, the proper seeding rate and the optimal nitrogen fertilizing level in Gyeongju, Gyeongbuk province were considered to be the most appropriate in 130 kg/ha and 50 kg of N/ha, respectively.

• Korean Journal of Agricultural Science
• /
• v.48 no.4
• /
• pp.975-985
• /
• 2021

The sufficient amount of protein supply is crucial for improving the growth performance of growing beef cattle. In addition, due to the improvement in the genetic potential of the carcass weight of Hanwoo steers, dietary protein requirements may be increased during the rapid growth period. Accordingly, the dietary crude protein (CP) level in growing Hanwoo steers has been increasing in the field. However, little scientific evidence is available in relation to this. Therefore, this study was conducted to test whether a higher dietary CP level than convention would improve the growth performance and body metabolism in growing Hanwoo steers. Fifty growing Hanwoo steers were randomly divided into two groups and fed either a commercial diet (CON) or a higher CP (HCP) concentrate mix, provided with a similar level of dietary energy. Tall fescue hay was provided ad libitum. The dietary CP level did not affect growth performance and blood metabolite. Nitrogen intake, predicted nitrogen excretion, and retained nitrogen were higher in the HCP group than in the CON group (p < 0.01). Although there was no difference in the nitrogen utilization efficiency, the growth efficiency per retained nitrogen decreased in the HCP group (p = 0.02). A higher dietary CP level may increase nitrogen retention in growing Hanwoo steers without improving growth performance, which leads to reduced growth efficiency per retained nitrogen. Furthermore, considering the high price of feed protein and increased nitrogen excretion to the environment, a further increase in the protein level may not be sustainable.

• Corrosion Science and Technology
• /
• v.13 no.2
• /
• pp.70-80
• /
• 2014

Duplex stainless steels with nearly equal fraction of the ferrite(${\alpha}$) phase and austenite(${\gamma}$) phase have been increasingly used for various applications such as power plants, desalination facilities due to their high resistance to corrosion, good weldability, and excellent mechanical properties. Hyper duplex stainless steel (HDSS) is defined as the future duplex stainless steel with a pitting resistance equivalent (PRE=wt.%Cr+3.3(wt.%Mo+0.5wt.%W)+30wt.%N) of above 50. However, when HDSS is welded with gas tungsten arc (GTA), incorporation of nitrogen in the Ar shielding gas are very important because the volume fraction of ${\alpha}$-phase and ${\gamma}$-phase is changed and harmful secondary phases can be formed in the welded zone. In other words, the balance of corrosion resistance between two phases and reduction of $Cr_2N$ are the key points of this study. The primary results of this study are as follows. The addition of $N_2$ to the Ar shielding gas provides phase balance under weld-cooling conditions and increases the transformation temperature of the ${\alpha}$-phase to ${\gamma}$-phase, increasing the fraction of ${\gamma}$-phase as well as decreasing the precipitation of $Cr_2N$. In the anodic polarization test, the addition of nitrogen gas in the Ar shielding gas improved values of the electrochemical parameters, compared to the Pure Ar. Also, in the erosion-corrosion test, the HDSS welded with shielding gas containing $N_2$ decreased the weight loss, compared to HDSS welded with the Ar pure gas. This result showed the resistance of erosion-corrosion was increased due to increasing the fraction of ${\gamma}$-phase and the stability of passive film according to the addition $N_2$ gas to the Ar shielding gas. As a result, the addition of nitrogen gas to the shielding gas improved the resistance of erosion-corrosion.

• Asian-Australasian Journal of Animal Sciences
• /
• v.17 no.7
• /
• pp.1026-1032
• /
• 2004

In this study, we assess the recent changes in the amount of excretion by the livestock industry, and discuss the effects of increasing the ratio of cultivated land on the reduction of surplus nitrogen from a cost-performance perspective. Nitrogen has contributed to acidification of ecosystems and nitrate concentrations in groundwater, especially in Europe. Therefore, we assessed the level of nitrogen waste from the domestic Japanese livestock industry, including cattle, swine and poultry during the period 1987-2001. This assessment assumed that 40% of the nitrogen from the domestic livestock industry was emitted as gas into the air and that 60% of the nitrogen was contained in manure used on domestic cultivated land. Nitrogen excreted from livestock, excluding gas emission, decreased by 11% from 0.504 million tons to 0.447 million tons during 1993-2001. Thus, the peak period of nitrogen excretion from livestock is already past in Japan. However, the area of cultivated land under management also decreased during 1990-2000. In addition, the area of paddy and upland fields left unplanted for a year increased during 1990-2000. Therefore, if all manure from the domestic livestock industry had been utilized on the fields as organic fertilizer, but not on arable land left uncultivated for the past year, the nitrogen per net area of cultivated land would have increased by 5%, from 125 to 131 N kg/ha, during 1990-2000. To reduce the nitrogen ratio on cultivated land through the planting of feed grain to utilize the nitrogen, a comparison of the cost performance of feed grains indicated that barley would be more suitable than wheat, rice or soybean. Had barley been planted in 100% of the land left fallow for the past year in 2000, 4% (20,000 tons) of the nitrogen from livestock waste would have been used in the harvest, and the nitrogen per land unit would have not increased but decreased from 125 to 121 N kg/ha during the same decade. Furthermore, when converted into Total Digestible Nutrients, 7% of imported feed corn could have been replaced with the harvested barley in 2000. Planting barley on this fallow land had three benefits; reducing the risk of manure overload on the land, slowing down the decrease in cultivated land, and raising the feed self-sufficiency ratio. Thus, it would be beneficial to plant feed grain such as barley in land left fallow for the past year through utilization of manure.

• Journal of the East Asian Society of Dietary Life
• /
• v.20 no.1
• /
• pp.69-76
• /
• 2010

This study was performed to examine the effects of salt addition level on changes in the physicochemical properties and color values of salted shrimp during fermentation. Fresh shrimp were salted with different concentrations (8, 18, 28%) of Chunil salt and fermented at $20^{\circ}C$ for 160 days. In the 8% salted shrimp treatment, volatile basic nitrogen (VBN), amino nitrogen (AN), and trimethylamine (TMA) contents rapidly increased during the fermentation period, while in the 18 and 28% salt groups these increases were reduced throughout the 160 days of fermentation. Thiobarbituric acid (TBA) values increased rapidly for 120 days of fermentation and then decreased. The thiobarbituric acid values of the 18, and 28% salted and fermented shrimp groups were lower than the that of the 8% group. In addition, Hunter's color L, a, and b values decreased as the fermentation period increased.

• The Korean Journal of Ceramics
• /
• v.5 no.4
• /
• pp.390-394
• /
• 1999

Al2O3 particles were dispersed into carbon fiber reinforced epoxy composites to fabricate hybrid epoxy based composites. Interface behavior and mechanical properties of these hybrid composites were studied at room and liquid nitrogen temperature and liquid nitrogen temperature and the results were compared with the those of carbon fiber reinforced composites to investigate their applicability at room and cryogenic temperature. Young's modulus in-perpendicular to fiber direction and interlaminar shear strength at room temperature and the thermal contraction down to cryhogenic temperature were improved significantly by the addition of AL2O3 filler into the epoxy matrix. The effect of Al2O3 particle addition on mechanical properties were discussed.

• Journal of the Korean Ceramic Society
• /
• v.23 no.5
• /
• pp.61-66
• /
• 1986

The gas mixtures ($H_2$/$N_2$, He/$N_2$) having a high thermal conductivity allow the heat generated by the nitriding exotherm to be dissipated from the compact in to the nitriding atmosphere permitting a more accurate control of temperature and produces a more uniform microstructure. In order to observe the effect of the mixed gas atmosphere on the microsturcture of RBSN. the specimen was nitrided in the mixed gas atmosphere which was containe up to 50vol% $H_2$ or He for 0-12 hrs at 135$0^{\circ}C$. The addition of hydrogen to nitrogen gas resulted in the growth of a-needle at the early stage of nitrding increase of the reaction rate and a finer and more uniform microstructure. in case of the addition of helium the behaviour of reaction was similar to the one with pure nitrogen. As the amount of helium was increased a coarse microstructure was formed.