• 제목/요약/키워드: multiple channel

검색결과 2,108건 처리시간 0.031초

Call Admission Control in Wireless Ad-hoc Networks with Multiple Channels and Radios

  • Ko, Sung-Won
    • 조명전기설비학회논문지
    • /
    • 제21권4호
    • /
    • pp.104-114
    • /
    • 2007
  • In this paper, an Ad-hoc Routing Protocol that works in wireless Ad-hoc communication networks with multiple radios and multiple channels and that controls call admission based on bandwidth measurement is proposed. Unlike the conventional Ad-hoc node with a single radio using a single channel, an Ad-hoc node of the protocol proposed, the MCQosR(Multiple Channel Quality of Service Routing), has multiple radios and uses multiple channels, which allows full duplex transmission between wireless Ad-hoc nodes, and reduces intra interference on the route. Also, a fixed channel only for reception at each node enables the estimation of the available bandwidth, which is used to control the call admission for QoS provision. The performance of the MCQosR was verified by simulation.

Channel Capacity for NOMA Weak Channel User and Capacity Region for NOMA with Gaussian Mixture Interference

  • Chung, Kyuhyuk
    • 전기전자학회논문지
    • /
    • 제23권1호
    • /
    • pp.302-305
    • /
    • 2019
  • Non-orthogonal multiple access (NOMA) has been considered for the fifth generation (5G) mobile networks to provide high system capacity and low latency. We calculate the channel capacity for the weak channel user in NOMA and the channel capacity region for NOMA. In this paper, Gaussian mixture channel is compared to the additive white Gaussian noise (AWGN) channel. Gaussian mixture channel is modeled when we assume the practical signal modulation for the inter user interference, such as the binary phase shift keying (BPSK) modulation. It is shown that the channel capacity with BPSK inter user interference is better than that with Gaussian inter user interference. We also show that the channel capacity region with BPSK inter user interference is larger than that with Gaussian inter user interference. As a result, NOMA could perform better in the practical environments.

하향링크 MIMO 시스템을 위한 공간분할 다중접속 기술 (A Space Division Multiple Access Technique for Downlink MIMO Systems)

  • 임민중
    • 한국통신학회논문지
    • /
    • 제29권9A호
    • /
    • pp.1022-1030
    • /
    • 2004
  • 차세대 이동 및 우선통신 시스댐은 현재보나 얘우 큰 고속의 데이터 전송과 시스템 용량을 요구하고 였으며 이러한 요구를 충족시키기 위해서 복수의 안테나를 사용하여 송수신을 하는 MIMO(m 비 tiple input, multiple output) 기술이 널리 연구되고 있다 이 논문은 다수의 안테나를 가지고 있는 기지국, 소수의 안테나를 가지고 있는 단말기의 하향 링크에서 스케터령과 변동이 적으며 평탄한 페이딩 채널을 가정한다. 단영 사용가 MIMO 시스템에서 가지국이 채널상태정보를 가지고 있다연 SVD(singular value decomposition) 와 water filling 읍 사용 한 MIMO 기숭이 최대의 채널용량을 이룬다. 그러나 복수 사용자 시스템의 경우에는 공간분할 다중접속 기술을 이용하여, 보다 큰 전체 채널용량을 얻는 것이 가능하다 이 논문은 복수 사용가 시스템에서 각 사용자에게 복수 의 데이터 스트림을 전송하는 MIMO 공간분할 다중접속 기술을 제안한다. 제안하는 기술은 SVD 기반의 MIMO 기술이나 스마트 안테나를 사용한 공간분항 다중정속 기술보다 더 큰 전체 채널용량을 얻을 수 있다.

분리된 예약채널에 의한 요구할당 다중접근방법에 관한 연구 (A Study on Demand Assignment Multiple Access Algorithm based on Seperated Reservation Channel)

  • 한정항;송주석
    • 한국통신학회논문지
    • /
    • 제17권7호
    • /
    • pp.696-708
    • /
    • 1992
  • 본 연구에서는 전송프레임에 대한 예약과 데이터 전송이 순차적으로 반복되는 기존의 다중접근방식에서의 채널효율의 저하와 지연특성의 불안정성을 개선하기 위해 위상채널 구조에서 예약 채널과 데이터전송 채널을 논리적으로 분리하여 서로 독립적으로 운영되도록 구성하고, 그 위에서 요구할당 다중접근 알고리즘을 설계했다. 이것은 예약과 데이터 전송을 각각 서로에 대해 독립적으로 수행하게 하고, 데이터전송 채널에서의 프레임 구조를 제거하여 예약을 슬롯단위로 수행함으로써 일정한 수준의 \ulcorner즉 예약 채널 용량-고정적인 대역폭 낭비를 감수하면서 데이터 전송 채널의 효율을 극대화 시키고, 각 지구국에서의 트래픽 변동을 보다 효과적으로 수용하며, 안정된 전송지연 특성과 공평성을 획득함으로써 시스템의 전체적인 성능을 향상시키는데 목적이 있다.

  • PDF

Channel Quantization for Block Diagonalization with Limited Feedback in Multiuser MIMO Downlink Channels

  • Moon, Sung-Hyun;Lee, Sang-Rim;Kim, Jin-Sung;Lee, Inkyu
    • Journal of Communications and Networks
    • /
    • 제16권1호
    • /
    • pp.1-9
    • /
    • 2014
  • Block diagonalization (BD) has been proposed as a simple and effective technique in multiuser multiple-input multiple-output (MU-MIMO) broadcast channels. However, when channel state information (CSI) knowledge is limited at the transmitter, the performance of the BD may be degraded because inter-user interference cannot be completely eliminated. In this paper, we propose an efficient CSI quantization technique for BD precoded systems with limited feedback where users supported by a base station are selected by dynamic scheduling. First, we express the received signal-to-interference-plus-noise ratio (SINR) when multiple data streams are transmitted to the user, and derive a lower bound expression of the expected received SINR at each user. Then, based on this measure, each user determines its quantized CSI feedback information which maximizes the derived expected SINR, which comprises both the channel direction and the amplitude information. From simulations, we confirm that the proposed SINR-based channel quantization scheme achieves a significant sum rate gain over the conventional method in practical MU-MIMO systems.

A Channel State Information Feedback Method for Massive MIMO-OFDM

  • Kudo, Riichi;Armour, Simon M.D.;McGeehan, Joe P.;Mizoguchi, Masato
    • Journal of Communications and Networks
    • /
    • 제15권4호
    • /
    • pp.352-361
    • /
    • 2013
  • Combining multiple-input multiple-output orthogonal frequency division multiplexing (MIMO-OFDM) with a massive number of transmit antennas (massive MIMO-OFDM) is an attractive way of increasing the spectrum efficiency or reducing the transmission energy per bit. The effectiveness of Massive MIMO-OFDM is strongly affected by the channel state information (CSI) estimation method used. The overheads of training frame transmission and CSI feedback decrease multiple access channel (MAC) efficiency and increase the CSI estimation cost at a user station (STA). This paper proposes a CSI estimation scheme that reduces the training frame length by using a novel pilot design and a novel unitary matrix feedback method. The proposed pilot design and unitary matrix feedback enable the access point (AP) to estimate the CSI of the signal space of all transmit antennas using a small number of training frames. Simulations in an IEEE 802.11n channel verify the attractive transmission performance of the proposed methods.

Delay and Doppler Profiler based Channel Transfer Function Estimation for 2×2 MIMO Receivers in 5G System Targeting a 500km/h Linear Motor Car

  • Suguru Kuniyoshi;Rie Saotome;Shiho Oshiro;Tomohisa Wada
    • International Journal of Computer Science & Network Security
    • /
    • 제23권9호
    • /
    • pp.8-16
    • /
    • 2023
  • In Japan, high-speed ground transportation service using linear motors at speeds of 500 km/h is scheduled to begin in 2027. To accommodate 5G services in trains, a subcarrier spacing frequency of 30 kHz will be used instead of the typical 15 kHz subcarrier spacing to mitigate Doppler effects in such high-speed transport. Furthermore, to increase the cell size of the 5G mobile system, multiple base station antennas will transmit identical downlink (DL) signals to form an expanded cell size along the train rails. In this situation, the forward and backward antenna signals are Doppler-shifted in opposite directions, respectively, so the receiver in the train may suffer from estimating the exact Channel Transfer Function (CTF) for demodulation. In a previously published paper, we proposed a channel estimator based on Delay and Doppler Profiler (DDP) in a 5G SISO (Single Input Single Output) environment and successfully implemented it in a signal processing simulation system. In this paper, we extend it to 2×2 MIMO (Multiple Input Multiple Output) with spatial multiplexing environment and confirm that the delay and DDP based channel estimator is also effective in 2×2 MIMO environment. Its simulation performance is compared with that of a conventional time-domain linear interpolation estimator. The simulation results show that in a 2×2 MIMO environment, the conventional channel estimator can barely achieve QPSK modulation at speeds below 100 km/h and has poor CNR performance versus SISO. The performance degradation of CNR against DDP SISO is only 6dB to 7dB. And even under severe channel conditions such as 500km/h and 8-path inverse Doppler shift environment, the error rate can be reduced by combining the error with LDPC to reduce the error rate and improve the performance in 2×2 MIMO. QPSK modulation scheme in 2×2 MIMO can be used under severe channel conditions such as 500 km/h and 8-path inverse Doppler shift environment.

SAGE 알고리즘을 이용한 MIMO 채널 파라미터 추정과 분석 (Estimation and Analysis of MIMO Channel Parameters using the SAGE Algorithm)

  • 김주석;여봉구;최홍락;김경석
    • 한국인터넷방송통신학회논문지
    • /
    • 제17권5호
    • /
    • pp.79-84
    • /
    • 2017
  • 본 논문은 다중 경로 다중입력 (Multiple-input multiple-output : MIMO) 채널에서 space alternating generalized expectation-maximization(SAGE) 알고리즘을 이용하여 채널 파라미터 추정 성능을 확인한다. 성능을 비교하기 위해 781 대역의 제주도 측정지역에서의 채널 파라미터로부터 시변 채널 환경 채널 파라미터 추정을 SAGE 알고리즘을 통해 추정하고 원본 데이터와 비교한다. 이를 통해 SAGE 알고리즘의 성능을 확인할 수 있으며 일반적인 파라미터 계산보다 SAGE 알고리즘을 통해 추정하는 것이 지연 확산(Delay Spread), 도래각 확산(Arrive of Angular Spread)이 적어 정확 측면에서 성능이 뛰어나고 안정적이다.

FDD Massive MIMO 시스템에서의 적응 채널 추정 기법 (Adaptive Channel Estimation Techniques for FDD Massive MIMO Systems)

  • 정진주;한용희;이정우
    • 한국통신학회논문지
    • /
    • 제40권7호
    • /
    • pp.1239-1247
    • /
    • 2015
  • Frequency-division duplex (FDD) massive multiple-input multiple-output (MIMO) 시스템에서 하향 링크 채널 추정의 계산 복잡도는 기지국의 안테나 개수와 비례한다. 그러므로 이러한 시스템에서의 효율적인 채널 추정 방식이 연구 될 필요가 있다. 본 논문에서는 채널이 시간적, 공간적 상관관계를 가지는 모델에서 Kalman 필터와 least mean square (LMS) 등과 같은 적응 신호처리 기법을 이용한 채널 추정 방식을 제안한다.