• International Journal of Naval Architecture and Ocean Engineering
• /
• v.13 no.1
• /
• pp.794-803
• /
• 2021

The instantaneous acceleration affects the performance of the water-jet pump obviously. Here, based on the user-defined function, the method to simulate the inner flow in water-jet pumps under acceleration conditions was established. The effects of two different acceleration modes (linear acceleration and exponential acceleration) and three kinds of different acceleration time (0.5s, 1s and 2s) on the performance of the water-jet pump were analyzed. The results show that the thrust and the pressure pulsation under exponential acceleration are lower than that under linear acceleration at the same time; the vapor volume fraction in the impeller under linear acceleration is 27.3% higher than that under exponential acceleration. As the acceleration time increases, the thrust gradually increases and the pressure pulsation amplitude at the impeller inlet and outlet gradually decreases, while the law of pressure pulsation is the opposite at the diffuser outlet. The main frequency of pressure pulsation at the impeller outlet is different under different acceleration time. The research results can provide some reference for the optimal design of water-jet pumps.

• Structural Engineering and Mechanics
• /
• v.83 no.6
• /
• pp.771-788
• /
• 2022

This research investigates the free vibration of porous advanced composite plates resting on Winkler/Pasternak/ Kerr foundations by using a new hyperbolic quasi three dimensional (quasi-3D) shear deformation theory. The present theory, which does not require shear correction factor, accounts for shear deformation and thickness stretching effects by parabolic variation of all displacements across the thickness, and satisfies the stress-free boundary conditions on the upper and lower surfaces of the plate. In this work, we consider imperfect FG plates with porosities embedded within elastic Winkler, Pasternak or Kerr foundations. Implementing an analytical approach, the obtained governing equations from Hamilton's principle according to FG plates are derived. The closed form solutions are obtained by using Navier technique, and natural frequencies of FG plates are found, for simply supported plates, by solving the results of eigenvalue problems. A comprehensive parametric study is presented to evaluate effects of the geometry of material, mode numbers, porosity volume fraction, Power-law index and stiffness of foundations parameters on free vibration characteristics of FG plates.

• International Journal of Contents
• /
• v.18 no.1
• /
• pp.76-84
• /
• 2022

Tidal power generation plays a critical role in reducing greenhouse gas emissions. It uses a tidal force generated by gravitational force between the moon, the earth, and the sun. The change of seawater height generates the tide-generating force, and the magnitude of the change is the tide level. The tide level change has the same period as the tide-generating force twice a day, every 29.5 days, every year, and every 18.6 years. Sihwa Lake Tidal Power Station is Korea's first tidal power plant that began commercial power generation in August 2011 and has been accumulating a large volume of data on electricity production, power generation sales, sluice displacement, and tide levels. The purpose of this paper was to analyze the impact of the inefficiency factors affecting production and the tidal level change on tidal power generation and their characteristics using Sihwa Lake Tidal Power's operational performance data. Throughout this paper we show that tidal power generating operation is accurately predicting the trends of magnitude of tidal force to be periodical for each day. determining the drop to initiate the water turbine generator factoring the constraints on the operation of Sihwa Lake, and reflecting the water discharge through the floodgate and water turbine during the standby mode in the power generation plan to be in the optimal condition until the initiation of the next power generation can maximize power generation.

• Coupled systems mechanics
• /
• v.13 no.4
• /
• pp.277-291
• /
• 2024

The objective of this work is to study the effects of the modification of material properties on the vibration of the FGM beam using an integral shear strain model. In the present theory, the rotational displacement is replaced by an integral term in the displacement fields. The use of a shear correction factor is not necessary because our model gives a parabolic description of shear stress through the thickness while satisfying the conditions of zero shear stresses on the bottom and top surfaces of the beam. The FGM beam is assumed that the beam is a mixture of metal and ceramic, and that its properties change depending on the power functions of the thickness of the beam such as: linear, quadratic, cubic and inverse quadratic. By applying Hamilton's principle, general formulas were obtained to obtain the frequencies of the FGM beam. The effects of changing compositional characteristics of materials presented by volume fraction of FGM beams with simply supported edges on free vibration and some mode shapes are investigated.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2012.08a
• /
• pp.184-184
• /
• 2012

Recently, InGaN/GaN multi-quantum well grown on GaN pyramid structures have attracted much attention due to their hybrid characteristics of quantum well, quantum wire, and quantum dot. This gives us broad band emission which will be useful for phosphor-free white light emitting diode. On the other hand, by using quantum dot emission on top of the pyramid, site selective single photon source could be realized. However, these structures still have several limitations for the single photon source. For instance, the quantum efficiency of quantum dot emission should be improved further. As detection systems have limited numerical aperture, collection efficiency is also important issue. It has been known that micro-cavities can be utilized to modify the radiative decay rate and to control the radiation pattern of quantum dot. Researchers have also been interested in nano-cavities using localized surface plasmon. Although the plasmonic cavities have small quality factor due to high loss of metal, it could have small mode volume because plasmonic wavelength is much smaller than the wavelength in the dielectric cavities. In this work, we used localized surface plasmon to improve efficiency of InGaN qunatum dot as a single photon emitter. We could easily get the localized surface plasmon mode after deposit the metal thin film because lnGaN/GaN multi quantum well has the pyramidal geometry. With numerical simulation (i.e., Finite Difference Time Domain method), we observed highly enhanced decay rate and modified radiation pattern. To confirm these localized surface plasmon effect experimentally, we deposited metal thin films on InGaN/GaN pyramid structures using e-beam deposition. Then, photoluminescence and time-resolved photoluminescence were carried out to measure the improvement of radiative decay rate (Purcell factor). By carrying out cathodoluminescence (CL) experiments, spatial-resolved CL images could also be obtained. As we mentioned before, collection efficiency is also important issue to make an efficient single photon emitter. To confirm the radiation pattern of quantum dot, Fourier optics system was used to capture the angular property of emission. We believe that highly focused localized surface plasmon around site-selective InGaN quantum dot could be a feasible single photon emitter.

• Journal of Veterinary Clinics
• /
• v.32 no.5
• /
• pp.422-425
• /
• 2015

This study evaluated the myocardial performance on echocardiography after the sedation/anesthesia of medetomidine (D), the combination of medetomidine and tiletamine/zolazepam (DZ), and the combination of medetomidine, tiletamine/zolazepam and tramadol (DZT) in Beagle dogs. Ten healthy adult Beagle dogs (weighing $8.6{\pm}1.0kg$) were enrolled in this study. Heart rate (HR), fractional shortening (%FS), left ventricular ejection fraction (%LVEF), stroke volume (SV), cardiac output (CO), left ventricular internal diameter in systole (LVIDs) and left ventricular internal diameter in diastole (LVIDd) using M-mode echocardiography were measured prior to anesthesia, then every 10 min for 60 min. The HR, %FS, %LVEF, SV and CO were significantly decreased during sedation/anesthesia with D, DZ and DZT combination of anesthesia. Although those anesthetic protocols provided acceptable quality of sedation/anesthesia, levels of cardiovascular suppression were substantial and persistent and thus the continuous monitoring on vital signs should be accompanied in any situation. Close attention is required for dogs with pre-existing heart diseases, when those anesthetic protocols were applied.

• Progress in Medical Physics
• /
• v.21 no.4
• /
• pp.360-366
• /
• 2010

To generate on-board digital tomosynthesis (DTS) for three-dimensionalimage-guided radiation therapy (IGRT) as an alternative to conventional portal imaging or on-board cone-beam computed tomography (CBCT), two clinical cases (liver and bladder) were selected to illustrate the capabilities of on-board DTS for IGRT. DTS images were generated from subsets of CBCT projection data (45, 162 projections) using half-fan mode scanning with a Feldkamp-type reconstruction algorithm. Digital tomosynthesis slices appeared similar to coincident CBCT planes and yielded substantially more anatomic information. Improved bony and soft-tissue visibility in DTS images is likely to improve target localization compared with radiographic verification techniques and might allow for daily localization of a soft-tissue target. Digital tomosynthesis might allow targeting of the treatment volume on the basis of daily localization.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.39 no.6
• /
• pp.617-624
• /
• 2015

This paper describes the development of a wearable robot to assist the elbow muscle for use by elderly workers in aging societies. Various previously developed wearable robots have drawbacks in terms of their price, portability, and slow recognition of the wearer's intention. In this paper, emphasis is placed on the following features to minimize these drawbacks. The first feature is that an actuator is attached only at the elbow joint that withstands the highest moment during arm motion to reduce the weight, volume, and price of the robot and increase its practicality. The second is that operation of the wearable robot is divided into two modes, a tracking mode and a muscle strengthening mode, and the robot can automatically switch between these modes by analyzing the wearer's intention through the brachial muscle strength measuring device developed in this study. The assistive performance of the developed wearable robot is experimentally verified by motion tracking experiments without an external load and muscle strengthening experiments with an external load. During the muscle strengthening experiments, the power of the muscle of the upper arm is measured by a commercial electromyography (EMG) sensor. Motion tracking performance at a speed of $120^{\circ}/s$ and muscle assistance of over 60 % were obtained using our robot.

• Journal of East Asia Management
• /
• v.1 no.1
• /
• pp.65-87
• /
• 2020

In recent years, with the rapid development of network live streaming, with the popularization of mobile Internet and mobile terminal equipment, the live streaming industry has ushered in great development. A sudden outbreak of the COVID-19 makes the PC end live streaming which has been developed for many years enter a new era, giving birth to the rapid development of mobile end live streaming. Not only because of the expansion of the live streaming industry market, the rise of the trend of the national live streaming, but also because the mobile live streaming is more and more valued by the brand, becoming an important tool for brand communication and product promotion. It is because of its unique communication characteristics that some scholars believe that the era of precision marketing has been opened by live network. Mobile live from the initial fans to reward and promote the brand, to now in the form of live marketing, consumers can "buy while watching". The time period from the understanding of the goods to the final completion of the purchase behavior has been greatly shortened. It is conducive to improving sales volume and brand awareness. Marketing communication through mobile live platform has become a popular way of brand marketing. This paper mainly studies the current situation, methods, problems and development strategies of brand marketing activities with the help of live streaming platform under the background of mobile internet. Taking Tmall live streaming platform as an example, this paper analyzes several ways of brand marketing with the help of live streaming and some universal characteristics of live streaming marketing by using the relevant theories of marketing. In view of the problems existing in live streaming brand marketing, it puts forward relevant Improvement measures. First of all, the paper puts forward the innovation in content and form. Second, the paper suggests that we should make full use of new technologies such as AR and VR to effectively combine with mobile live broadcasting. Third, the paper explores the integration of multiple channels to create intelligent marketing, and further optimize the live interface of mobile terminals. Finally, the paper emphasizes that the government departments and the platform itself should jointly supervise the mobile network live streaming platform and establish a good live broadcasting environment for mobile terminals. With the help of mobile live streaming, the marketing mode has an important impact on the promotion of brand marketing. How to make better use of this business mode and accurately use mobile live broadcast to promote brand marketing, so that enterprises can create greater profits, is also of profound research significance.

• Journal of the Korean earth science society
• /
• v.26 no.8
• /
• pp.790-799
• /
• 2005

We investigate the optical properties of aerosols over Gongju by an indirect method using the pound measurement, Sky-radiometer. The analysis period is from January to December, 2004. Skyrad. pack.3 is used to estimate the optical properties, such as the aerosol optical thickness (AOT), single scattering albedo (SSA), ${\AA}ngstron$ exponent $({\alpha})$ and size distribution, of aerosols from the ground measured radiance data. And qualify control is applied to minimize the cloud-contaminated data and improve the quality of analysis results. The 12-month average of AOT, ${\alpha}$, and SSA are 0.46, 1.14, and 0.91, respectively. The average volume spectra of aerosols shows a bi-modal distribution, the first peak at fine mode and the second peak at coarse mode. AOT and coarse particles clearly increases while SSA decreases during the Asian dust events. The optical properties of aerosols at Gongju vary with?seasons, but those are not influenced by the wind direction.