• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.25 no.3B
• /
• pp.408-422
• /
• 2000

In this paper, we propose a generalized vector channel model for wireless communication systems using antenna arrays. The proposed channel model reflects path loss. spatial-temporal variation of shadowing, multipath fading , Doppler effect, spatial distribution of local scatterers and delay spread due to remote dominant scatterers. In addition, we use a discrete ray model in which respective ray signal experiences independent shadowing, fading and Doppler shift, and impinges on antenna arrays at a distinct angle. Based on the proposed mode. we derive the relations on the spatial and temporal correlations of the received signals and implement a spatial channel simulator. By comparing the theoretical values with the simulated ones, we verify the effectiveness of the implemented simulator. The simulator is then used to generate an arbitrary channel impulse response and to analyze the channel characteristics under various environments.

• Journal of the Korean Ceramic Society
• /
• v.29 no.8
• /
• pp.609-616
• /
• 1992

This study has been investigated on the milling of Aluminium Distearate (ADS) powder and characteristics of the ADS-doped UO2 pellets. As-received ADS powder of the agglomerated particles has not shown any milling effect because of heat generated during planetary milling. But the use of coolant to effectively remove heat generated during milling has been found an effective way in breaking up the agglomerates of ADS powder. The green density of the UO2 pellet decreases with the amount of ADS powder doped. Therefore, in order to get the sintered density of 95% pellet decreases with the amount of ADS powder doped. Therefore, in order to get the sintered density of 95% theoretical density, the 200 ppm ADS-doped UO2 pellet has to be pressed under higher compacting pressure of 3500~4000 kgf/$\textrm{cm}^2$ compared with the ADS-undoped UO2 pellet pressed under around 3000 kgf/$\textrm{cm}^2$. The ADS-dpoed UO2 pellet with even relatively low sintered density of 10.27 g/㎤ exhibits open porosity of 1% while open porosity of the ADS-undoped UO2 pellet is reduced to around 1% only after its sintered density increases to 10.43g/㎤. It is, therefore, concluded that doping of ADS powder significantly contributes to the decrease in open porosity of the UO2 pellet. The dilatometry of the ADS doped UO2 pellet shows the sintering rate curve with the bimodal mode, which could be attributed to a phase reaction between UO2 and ADS. The X-ray diffraction analysis indicates that there occurs not any new phase formed but the shift of the peaks. It would be expected that a phase reaction resulting in solid solution would happen in the temperature range of 130$0^{\circ}C$ to 150$0^{\circ}C$ between UO2 and ADS.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.13 no.10
• /
• pp.2039-2044
• /
• 2009

The PSK carrier signal recovery circuit using multi-layer coupled line was analyzed and designed. The fabricated carrier recovery 6 port element with multi-layer coupled line structure gets the simple architecture. It is possible to implement the carrier signal recovery circuit of the same structure with the multi-layer six port phase correlator of the direct receiver front-end. Based on the analysis of RML carrier recovery circuit using the multi-layer coupled line 6-port phase correlator, the multi-layer coupled line carrier signal recovery structure for multi-mode coherent demodulation was proposed. The fabricated multi-layer coupled line carrier signal recovery circuit for quadrature phase shift-keying shows a good carrier signal characteristic with a constant phase and phase error below ${\pm}3o$.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.9 no.5
• /
• pp.491-497
• /
• 2004

This paper presents a new rotor position estimation method for brushless DC motors. It is clear that the estimation error of the rotor position provokes the phase shift angle misaligned between the phase current and the back-EMF waveforms, which causes torque ripple in brushless DC motor drives. Such an estimation error can be reduced with the help of the proposed neutral voltage-based estimation method that is structured in the form of a closed loop observer. A neutral voltage appearing during the normal mode of the inverter operation is found to be an observable and controllable measure, which can be dealt with for estimating an exact rotor position. This neutral voltage is obtained from the DC-link current, the switching logic, and the motor speed values. The proposed algorithm, which can be implemented easily by using a single DC-link current and the motor terminal voltage sensors, is verified by simulation and experiment results.

• The KIPS Transactions:PartB
• /
• v.15B no.3
• /
• pp.205-210
• /
• 2008

A new approach is proposed for restoration of corrupted regions and segmentation in natural text images. The challenge is to fill in the corrupted regions on the basis of color feature analysis by second order symmetric stick tensor. It is show how feature analysis can benefit from analyzing features using tensor voting with chromatic and achromatic components. The proposed method is applied to text images corrupted by manifold types of various noises. Firstly, we decompose an image into chromatic and achromatic components to analyze images. Secondly, selected feature vectors are analyzed by second-order symmetric stick tensor. And tensors are redefined by voting information with neighbor voters, while restore the corrupted regions. Lastly, mode estimation and segmentation are performed by adaptive mean shift and separated clustering method respectively. This approach is automatically done, thereby allowing to easily fill-in corrupted regions containing completely different structures and surrounding backgrounds. Applications of proposed method include the restoration of damaged text images; removal of superimposed noises or streaks. We so can see that proposed approach is efficient and robust in terms of restoring and segmenting text images corrupted.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2010.02a
• /
• pp.124-124
• /
• 2010

Much interest has been focused on InGaN-based materials and their quantum structures due to their optoelectronics applications such as light emitting diode (LED) and photovoltaic devices, because of its high thermal conductivity, high optical efficiency, and direct wide band gap, in spite of their high density of threading dislocations. Build-in internal field-induced quantum-confined Stark effect in InGaN/GaN quantum well LED structures results in a spatial separation of electrons and holes, which leads to a reduction of radiative recombination rate. Therefore, many growth techniques have been developed by utilizing lateral over-growth mode or by inserting additional layers such as patterned layer and superlattices for reducing threading dislocations and internal fields. In this work, we investigated various characteristics of InGaN multiple quantum wells (MQWs) LED structures grown on selectively wet-etched porous (SWEP) GaN template layer and compared with those grown on non-porous GaN template layer over c-plane sapphire substrates. From the surface morphology measured by atomic force microscope, high resolution X-ray diffraction analysis, low temperature photoluminescence (PL) and PL excitation measurements, good structural and optical properties were observed on both LED structures. However, InGaN MQWs LED structures grown on SWEP GaN template layer show relatively low In composition, thin well width, and blue shift of PL spectra on MQW emission. These results were explained by rough surface of template layer, reduction of residual compressive stress, and less piezoelectric field on MQWs by utilizing SWEP GaN template layer. Better electrical properties were also observed for InGaN MQWs on SWEP GaN template layer, specially at reverse operating condition for I-V measurements.

• Journal of Neurogastroenterology and Motility
• /
• v.24 no.4
• /
• pp.512-527
• /
• 2018

This review provides a comprehensive overview of brain imaging studies of the brain-gut interaction in functional gastrointestinal disorders (FGIDs). Functional neuroimaging studies during gut stimulation have shown enhanced brain responses in regions related to sensory processing of the homeostatic condition of the gut (homeostatic afferent) and responses to salience stimuli (salience network), as well as increased and decreased brain activity in the emotional response areas and reduced activation in areas associated with the top-down modulation of visceral afferent signals. Altered central regulation of the endocrine and autonomic nervous responses, the key mediators of the brain-gut axis, has been demonstrated. Studies using resting-state functional magnetic resonance imaging reported abnormal local and global connectivity in the areas related to pain processing and the default mode network (a physiological baseline of brain activity at rest associated with self-awareness and memory) in FGIDs. Structural imaging with brain morphometry and diffusion imaging demonstrated altered gray- and white-matter structures in areas that also showed changes in functional imaging studies, although this requires replication. Molecular imaging by magnetic resonance spectroscopy and positron emission tomography in FGIDs remains relatively sparse. Progress using analytical methods such as machine learning algorithms may shift neuroimaging studies from brain mapping to predicting clinical outcomes. Because several factors contribute to the pathophysiology of FGIDs and because its population is quite heterogeneous, a new model is needed in future studies to assess the importance of the factors and brain functions that are responsible for an optimal homeostatic state.

• Journal of English Language & Literature
• /
• v.58 no.2
• /
• pp.279-304
• /
• 2012

Since the publication of Foucault's Discipline and Punish, theatricality has become one of the key concepts in New Historicism. By defining theatricality as the most definitive feature of early modern society and culture, New Historicists have promoted the idea that theatrical practices in every day life were eventually replaced by textual practices as the western society started to undergo modernization with the advent of print culture and technologies. This paper questions this linear model of English literature, the shift of literary practices from theatricality to textuality in the event of modernization, by closely looking at the ways in which newsbooks and playlets during the English civil wars appealed to their target readers. The early print-based literary commodities during the English civil war (i.e. newsbooks and playlets) were able to win the attention of their audience not by breaking away from theatrical energy and creativity but instead by embracing and taking advantage of them through the use of dramatic conventions, dialogues, and many others. The newsbooks and the playlets during the time, however, did not simply replicate the dramatic forms and experiences of the previous generation. Instead, as the case study of Craftie Cromwell exemplifies, they went further to produce a different mode of theatricality by reshaping everyday lives into serialized drama, whose resolution is always already delayed and postponed into the ever-receding future. In conclusion, the study of the newsbook and playlets during the civil wars suggests that the textuality of modern times, materialized in print forms, have been co-evolved with the development of new theatricality, whose contents and forms are susceptible to the changes of everyday reality.

• Tribology and Lubricants
• /
• v.38 no.5
• /
• pp.179-184
• /
• 2022

The power train of transmission for 21-ton grade wheel excavator makes use of a complex gear train composed of a planetary and helical gear system to drive the wheel excavator by transmitting power to the axle. The complex gear train with a shift mode is an important part of the transmission because of strength problems in an extreme environment. To calculate the specifications of the complex gear train and analyze the gear bending and compressive stresses of the complex gear train, this study analyzes gear bending and compressive stresses accurately for the optimal design of the complex gear train with respect to cost and reliability. In this article, the gear bending and compressive stresses of the complex gear train are calculated using the Lewes and Hertz equation. Evaluating the results with the data of the allowable bending and compressive stress from the stress and number of cycles curves of the gears verified the calculated specifications of the complex gear train. A computer structure analysis is performed with the 3D model of the planetary and helical gears to analyze the structure strength of the complex gear train. The results demonstrate that the durability and strength of the complex gear train are safe, because the safety factors of the bending and compressive stresses are more than 1.0.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.35 no.6
• /
• pp.626-630
• /
• 2022

A 100 mm × 50 mm-sized (100) gallium oxide (Ga₂O₃) single crystal ingot was successfully grown by edge-defined film-fed growth (EFG). The preferred orientation and the quality of grown Ga₂O₃ ingot were compatible with a commercial Ga₂O₃ substrate by showing strong (100) orientation behaviors and 246 arcsec in X-ray rocking curve. Raman characterization was also performed for both samples; thereby providing various Raman-active characteristics of Ga₂O₃ crystals. In particular, we observed A_g(5) and A_g(10) peaks of Raman active mode, directly related to the impurity of the grown Ga₂O₃ crystal. Hence, the comparison of the crystal quality and Raman analysis might be useful for further enhancement of Ga₂O₃ single crystal quality in the future.