• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2014.11a
• /
• pp.40-41
• /
• 2014

As a result of strength test on BFS concrete, those mixed with 30% and 50% of BFS8000, respectively, showed higher or equivalent strength compare to OPC. As a result of test of chloride penetration on BFS, diffusion coefficients of concrete mixed with 30% FA4000 and FA5000, respectively, showed to restrain average 6.5% of diffusion coefficient compared to OPC. And in case of BFS concrete, those mixed with BFS6000 and BFS8000, restrained diffusion of chloride ions 253% and 336%, respectively, compared to OPC. Therefore, Mixing 50% of BFS was most efficient in order to maximize restraint of chloride penetration according to metathesis of large amount. In this study, when mixing BFS to concrete for long-run durability and restraint against chloride penetration, for BFS, as fineness was higher and mixing it to concrete with less or equivalent 50% of replacement rate, there were results of higher strength compared to OPC and more efficient restraint of chloride ions.

• Advances in concrete construction
• /
• v.11 no.5
• /
• pp.409-417
• /
• 2021

The incorporation of non-biodegradable tyre waste in cement-based material has gained more interest towards sustainable construction these days. Crumb rubber (CR) from waste tyre is an alternative for sand replacement in low strength applications. Many researchers have studied CR cement-based materials produced by normal mixing (NM) method and reported a significant decrease in compressive strength due to CR. To compensate this strength loss, this research aims to study the innovative incorporation of CR in cement composite via the preplaced mixing (PM) method. In this investigation, cement composite was produced with NM and PM methods by replacing sand with 0%, 50%, and 100% CR by volume. The test results showed no significant difference in terms of densities of cement composite prepared with both mixing methods. However, cement composite prepared with PM method had lower strength reduction (about 10%) and lowered drying shrinkage (about 20%). In addition, the sound absorption coefficient and noise reduction coefficient of CR cement composite prepared by PM method were in similar range as those prepared with NM method. Overall, the results demonstrate that the PM method is promising, and the maximum replacement level of 50% is recommended for CR in the cement composite.

• ETRI Journal
• /
• v.41 no.5
• /
• pp.658-669
• /
• 2019

For dual-channel time-frequency (TF) overlapped signals with low sparsity in underdetermined blind source separation (UBSS), this paper proposes an effective method based on interval probability to estimate and expand the types of mixing matrices. First, the detection of TF single-source points (TF-SSP) is used to improve the TF sparsity of each source. For more distinguishability, as the ratios of the coefficients from different columns of the mixing matrix are close, a local peak-detection mechanism based on interval probability (LPIP) is proposed. LPIP utilizes uniform subintervals to optimize and classify the TF coefficient ratios of the detected TF-SSP effectively in the case of a high level of TF overlap among sources and reduces the TF interference points and redundant signal features greatly to enhance the estimation accuracy. The simulation results show that under both noiseless and noisy cases, the proposed method performs better than the selected mainstream traditional methods, has good robustness, and has low algorithm complexity.

• 한국해양학회지
• /
• v.10 no.2
• /
• pp.57-66
• /
• 1975

Structure of thermocline, characteristics of stability and intensity of vertical transfer have been studied with hourly oceanographic data in each layers on Line 207 from 1968 to 1969. It is found that a typical thermocline is formed at depths of 10 to 50 meters in summer and early autumn and its core is located near depths of 25 meters. The maximum diffusion coefficient of vertical turbulent is found to be 140$\textrm{cm}^2$/sec at the surface layer(i.e., 0-10 meters), while the minimum is 5$\textrm{cm}^2$/sec at depths of 25 meters, consistent with characteristics of stability and structure of thermocline layers. Our computed diffusion coefficient and stability indicate that the mixing hardly takes place below depths of 80 meters during summer and early autumn, but for the rest of the season mixing could move up to the depth of 50 meters. It appears that the Western Channel of the Korea Strait consist of three different water masses during summer and autumn, and for the rest of the season, two kinds are present.

• Korean Journal of Hydrosciences
• /
• v.8
• /
• pp.1-17
• /
• 1997

Prandtl's mixing length theory was modified to obtain a power velocity distribution in which the coefficient and the exponent are variable over a range from : $$ A simple suspended-sediment concentration distribution was developed from the modified velocity distribytion : $ With nominal values of $\beta$=1.0, $\kappa$=0.4 and visual accumulation tube values of the fall velocity, the comparison between the theory and field measurements by the USGS on the Rio Grande is fair. Doubling the value of the exponent results in a good comparison. Further researches are needed for choosing the values of $\beta$, $\kappa$, and fall velocity values, and consideration on the effects of large-scale turbulence and secondary flows are necessary for them. In a pragmatic sense, on any gaging sites the close analysis of very detailed measurements can establish its specific coefficient and exponent.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2018.05a
• /
• pp.136-137
• /
• 2018

The properties of concrete produced by ready mixed concrete company in Busan were measured. Because the concrete was mixed with blast furnace slag and fly ash etc., the compressive, tensile strength and chloride ion diffusion coefficient were lower than OPC concrete even though the specified concrete strength was same. If the durability about salt attack were satisfied, the concrete of lower specified concrete strength would be adopted to concrete mixing design. FEM analysis was carried out to predict the life time expectancy.

• Proceedings of the KAIS Fall Conference
• /
• 2001.05a
• /
• pp.290-291
• /
• 2001

The relationship between velocity, viscosity, diffusion coefficient, mass transfer coefficient and characteristic length and mass transfer data can be correlated by dimensionless relationship in electrolytic process. The performance of dyestuff removal was decreased as the flow rate of electrolyte was increased. It was due to the effect of retention time decreasing was superior to that of turbulent inlet mixing. Sh/Sc$\^$1/3/ vs Re plot for Al flat electrode did not showed the general tendency of the relationship between Sh/Sc$\^$1/3/ and Re. It can be thought that flow rate was not sufficiently high to increase the effect of mixing.

• Biomedical Science Letters
• /
• v.1 no.1
• /
• pp.73-79
• /
• 1995

The effect of prior cumulative mixing was evaluated by means of a simple regression model which used as a dependent variable percentage(%) change of each repeated observed value for the initial value. The red blood cell count (RBC), hematocrit (Hct), and mean corpuscular volume(MCV) showed a significant decrease (p<.01), but % of basophils had a significant increase (p<.05). The ratios of rate of change (regression coefficient/SD) were .0012 for RBC, .0020 for Hct, .0024 for MCV, and .0011 for % of basophils. Of the 19 parameters evaluated, 21% changed.

• 한국전산유체공학회:학술대회논문집
• /
• 2005.10a
• /
• pp.55-59
• /
• 2005

CFD analysis has been conducted to find the two stage impeller configuration which is the most suitable for a stirred tank with an internal helical cooling coil and a cooling jacket, which is frequently used in chemical industries for highly exothermic reactions ranged from low to medium viscosity. Two typical types of impellers are considered; pitched paddle impellers and Rushton turbine impellers. Interestingly, pitched paddle impellers show a good mixing performance for multi-species, whereas Rushton turbine impellers achieve a good mixing performance for multi-phases. Besides the type of an impeller, the location of an impeller is another important factor to be considered in order to accomplish an effective mixing. The best set of types and locations of two impellers is recommended based on the coefficient of variation(CoV) value and the heat removal capability obtained from CFD results. The former is a measure to quantify the degree of mixing.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.18 no.12
• /
• pp.3377-3385
• /
• 1994

This paper introduces empirical correlations to obtain the gas/liquid flow rates and the spray drop size of low viscosity liquid injected by Y-jet twin-fluid atomizers. The gas flow rate is well correlated with the gas injection pressure and the mixing point pressure, based on the compressible flow theory. Similarly, the liquid flow rate is determined by the liquid injection pressure and the mixing point pressure, and a simple correlation for the liquid discharge coefficient at the liquid port was deduced from the experimental results. The mixing point pressure, which is one of the essential parameters, was expressed in terms of the gas/liquid flow rate ratio and the mixing port length. Disintegration and atomization mechanisms both within the mixing port and outside the atomizer were carefully re-examined, and a "basic" correlation form representing the mean diameter of drops was proposed. The "basic" correlation was expressed in terms of the mean gas density within the mixing port, gas/liquid mass flow rate ratio and the Weber number. Though the correlation is somewhat complicated, it represents the experimental data within an accuracy of ${\pm}15%$.EX>${\pm}15%$.